• 한국안전학회지
• /
• 제9권2호
• /
• pp.12-17
• /
• 1994

Smoke evolved from burning cellulose insulation treated with boric acid-borax-alum as combustion retardants has been studied using a light absorption method. It has been shown that the quantity of smoke are decreased with the increase of oxygen concentration. Applied fire retardants did not increase smoke generation from investigated cellulose insulation in range of themal degradation without flaming. These same fire retardants increased from in the range of flaming combustion. The results of this work have been analysed using imperical equation, which correlated the smoke density at oxygen content of combustion transition. This equation may be. $\sigma$=$\sigma$$_{T}$ exp｛-7.24$\times$10$^{-7}$ ( $O_2$ $O_{2.T}$)｝Where $O_2$is the concentration of oxygen in the oxidizing gas, and $O_{2.T}$ refers to oxygen concentration of combustion transition.n.n.n.

• Bulletin of the Korean Chemical Society
• /
• 제24권7호
• /
• pp.943-947
• /
• 2003

We have studied the migration behavior of single-stranded DNA using capillary gel electrophoresis under various conditions. It was found that optimum electric fields should be less than 150 V/cm for the good tradeoff between the separation time and the resolution. It seems that the gel matrix with the combination of different polymer average molecular weights is important to extend the maximum readable DNA bases. The total gel concentration less than 3.1% in the mixed gel system showed good separation efficiency up to 600 bases. The best result was obtained with the poy(ethylene)oxide (PEO) gel concentration of 1.2% of Mr 8,000,000 and 1.8% of Mr 600,000. We observed that the capillary length between 50 cm to 100 cm (effective length) should be employed for the optimization between the total DNA migration time and the maximum readable length. A trizma base-boric acid-ethlyenediaminetetraacetic acid (EDTA) (TBE) buffer was commonly used for DNA sequencing, but we found that 3-[tris(hydroxymethyl)methyl amino]-1-propane sulfonic acid (TAPS) buffer worked as well for the single-stranded DNA separation. Especially, TAPS buffer showed a good resolution for very short DNA bases (1 to 30 bases).

• Journal of Electrochemical Science and Technology
• /
• 제3권4호
• /
• pp.165-171
• /
• 2012

An experimental study of mass transfer to an amalgamated copper rotating disc electrode has been employed to determine an empirical correlation for the mass transfer rate in laminar flow. The study was performed in a three-electrodes configuration using 0.1 M boric acid and 0.1M potassium chloride as supporting electrolyte with Zn (II) concentration in the range (25-100 mg $dm^{-3}$). Polarization curves at different zinc ion concentration are reported. Hydrogen and oxygen reduction has also been considered.The diffusion coefficients and mass transfer coefficient were obtained using limiting diffusion current technique based on zinc ion reduction. A least squares analysis indicates that the laminar flow results for 13067 < Re > 57552 and 550 < Sc > 1390 can be correlated by the following equation with correlation coefficient (CR) equal to 0.98: $sh=0.61Re^{0.5}Sc^{1/3}$.

• 한국화재소방학회논문지
• /
• 제32권3호
• /
• pp.19-26
• /
• 2018

붕산과 5붕산암모늄으로 처리한 편백목재 시험편의 연소특성에 관한 실험을 ISO 5660-1 표준에 따른 콘칼로리미터를 이용하여 수행하였다. 그 결과 붕소화합물로 처리한 시험편의 화재성능지수(FPI)는 공시편보다 1.2~2.1배 증가하였고, 화재성장지수(FGI)는 공시편보다 1.6~8.4% 증가하였다. 또한 총연기발생률(TSR)은 공시편보다 9.0~28.3.% 낮았다. 이것은 붕소화합물로 처리한 시험편이 난연효과로 탄화층을 생성하기 때문으로 이해된다. 공시편은 418 s에서 가장 높은 CO농도인 0.01112%를 보였으나 붕소화합물로 처리한 시험편은 공시편보다 13.2~37.5% 감소하였다. 따라서 붕소화합물로 처리한 목재는 화재위험성과 위해성이 낮아질 것으로 예상된다.

• KSBB Journal
• /
• 제10권1호
• /
• pp.63-70
• /
• 1995

실험실에서 자체 제작한 자유유통 전기이동 장치 에서 등전집속법을 이용한 대두 단백질의 분리를 통 해 운전 조건들이 분리에 미치는 영향을 조사하였 다. 매 실험마다 pH, 전기전도도, uv 흉광도 (280nm) 등을 측정하였고 시료의 순도는 SDS­P PAGE 분석을 통해 점검하였다. Tris와 boric acid로 처리한 대두단백질 추출액에 g glutamic acid, histidine, argmme, glycine 등 아 미노산 각 ImM과 dipeptide로 glycyl-glycine 2mM, 배경 전해액으로서 KCI ImM로 구성된 시료 의 완충액을 혼합하여 시료로 사용하였다. 분리막을 셀룰로오스 아세테이트를 사용할 경우 pH는 양극쪽에서 3, 음극쪽에서 8 정도의 값을 보였으며 2개의 변곡점을 나타내었다. 가해준 전압은 3 300V에서 lOOOV의 범위였으며 전압이 높을수록 더 나은 분리도를 얻었으나 전압을 더 높일 경우 과도한 Joule열의 발생으로 인해 한계가 있었다. 시간이 지남에 따라 단백질들은 분리조 중앙 부근에서 집속이 일어났으며 pH와 전기전도도의 변화로부터 분리 조내의 이온들이 막을 통해 전극쪽으로 이통해 가고 있음을 알 수 있었다. 완충용액의 농도를 5배로 증 가시킬 경우 300V에서 좋은 집속을 얻었으냐 10배 이상으로 농도를 높일 경우에는 분리조 입구와 출구 의 유체 온도차가 $25^{\circ}C$ 이상이 되어 단백질의 변성 이 일어날 수 있어 더 높일 수 없었다. 이온교환막을 사용할 경우 이온의 분극화현상을 일으켜 U자 형태 의 전기전도도 분포를 나타내었다. 아미노산 혼합물 대신 상용의 ampholyte를 사용하더라도 분리도에 있어 큰 차이가 없었다.

• 한국표면공학회지
• /
• 제19권2호
• /
• pp.31-43
• /
• 1986

The properties of the electroless nickel deposit mainly depends on the pH of the bath, the plating temperature, and the molar ratio of nickel to hypophosphite but they are also affected by its formulation and concentration of complexing and buffering agents. According to changeing the concentration of triethanolamine and boric acid, phosphorous contents, microsturcture, crystalline, hardness and wear resistance of deposits obtained from ammoniacal alkaline bath were investigated by EPMA, differential thermal analyser, X-ray diffractometer and wear tester. The results are as follows; (1) Increasing concentration of triethanolamine in the bath, the deposits is slightly inclined to increase its phosphorous content(3.7% P). (2) In the as-plated state, the deposits are not crystallized state but they are thermally unstable phase, and they are crystallized with precipitating $Ni_3P$ at 400$^{\circ}C$. (3) The deposit containing 2.3% P has higher hardness value in the as plated and heat treated state at below 300$^{\circ}C$ than those of 3.7% phosphorous deposit (1090Hk). But in the case of heat treating at 400$^{\circ}C$, the former has lower hardness value (1000Hk) than the latter and has remarkably Ni(III) orientation by heat treatment. (4) The 3.7% phosphorous deposit heat treated at 400$^{\circ}C$ has better wear resistance than hard chromium plating.

• 대한화학회지
• /
• 제39권4호
• /
• pp.288-293
• /
• 1995

chromotropic acid (1,8-Dihydroxynaphthalene-3,6-disulfonic acid)를 착화제로 이용한 붕소에 대한 분리 정량을 이온쌍 액체 크로마토그래피로 연구하였다. 이동상$(MeOH\; 61{\%},\;H_2O\;39{\%}$, 인산완충용액 pH=8.5)에 tetrabutylammonium bromide를 첨가하므로서 붕소-chromotropic acid 착물과 chromotropic acid를 poly(styrene-devinylbenzene) 역상컬럼(PRP-1, 15 $cm{\times}4.6$ mm i.d.) 상에서 분리할 수 있었으며, 또한 시료 용액중에 0.1 M의 tetrabutylammonium bromide를 첨가하므로 붕소와 chromotropic acid간의 착물형성을 촉진시켜 감도를 높일수가 있었다. 0.5~1000 ${\mu}g/L$ 농도범위에서 좋은 직선성을 나타내었고 검출 한계는 0.5 ${\mu}g/L$ (S/N=2)이었다. 제안된 방법으로 시판용 시약, $Na_2SO_4,\; NaOH,\; KCl$에 있는 미량의 붕소를 정량하였다.

• 대한용접접합학회:학술대회논문집
• /
• 대한용접접합학회 1997년도 특별강연 및 춘계학술발표 개요집
• /
• pp.35-38
• /
• 1997

In order to investigate quantitative behavior of galvanic corrosion in the weld joint between stainless steel and carbon steel, electrochemical polarization experiments are performed for various pH, water temperature with boric acid concentration 4000ppm. The corrosion rate of stainless steel was almost independent of the variation of pH. The significant corrosion rates of carbon steel and the weld joint of carbon-carbon steel were observed at pH 4. The corrosion rates in the weld joint of the carbon-stainless steel were observed depending on the variation of pH level.

• 한국환경과학회지
• /
• 제10권3호
• /
• pp.233-237
• /
• 2001

Immobilized nitrifier bead in airlift bioreactor were used to remove high levels of ammonia nitrogen from synthetic wastewater. Polyvinylalcohol(PVA) bead for immmobilization of nitrifier consortium were prepared by PVA-boric acid method by varying concentration of PVA and nitrifier consortium. By determining viscosity, sphercity and tailing, the characteristics of prepared beads were investigated and the continous immobilization process was developed. Synthetic wastewater containg 25g/$\textrm{m}^3$ of ammonia nitrogen could be treated within 0.5 hour and the highest removal rate of ammonia nitrogen was 934.2g/$\textrm{m}^3{\cdot}$ day.

• Journal of Welding and Joining
• /
• 제17권3호
• /
• pp.66-70
• /
• 1999

In order to investigate the quantitative behavior of galvanic corrosion in weld joints between stainless std이 and carbon steel, electrochemical polarization experiments were performed at pH4, pH7 and pH10 with boric acid concentration 4000ppm, and water temperature were selected as $35^{\circ}$C and $60^{\circ}$C. As the results, the galvanic corrosion phenomena of carbon steel weld material at $60^{\circ}$C was revealed $2{1\over2}$ times higher corrosion rate than that at $35^{\circ}$C condition. The corrosion rate of stainless steel was almost inedependent of the variation of pH. The significant corrosion rates of carbon steel and the weld joint of carbon-carbon steel were observed at pH 4.