• Journal of the Korean Ceramic Society
• /
• v.41 no.1
• /
• pp.92-95
• /
• 2004

Using the Micro-Pulling Down (${\mu}$-PD), $MnO_2$ and $Tb_4O_7$ co-doped crack-free stoichiometric $LiNbO_3$ single crystals were grown in 1.0 mm diameter and 25-30 mm length for c-axis. The homogeneous distributions of $MnO_2$ and $Tb_4O_7$ concentration were confirmed by the Electron Probe Microanalysis (EPMA). Also, the infrared OH absorption band of the single crystals observed by using a Fourier Transform-Infrared Spectrophotometer (FT-IR) at room temperature and the photoluminescence spectra was measured with respect to the $MnO_2$ and $Tb_4O_7$ doping.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.9 no.4
• /
• pp.377-380
• /
• 1999

Erbium (Er) doped $LiNbO_{3}(Er:LiNbO_{3})$ single crystal fibers were grown free of creacks along the c-axis by micro-pulling down method. The $Er^{3+}$ concentration was distributed homogeneously along the growth axis. The samples for optical characterization were cut from as-grown single crystal fibers and polished. When the 980nm light was incident on the sample, upconversion phenomena were observed at the green range of wavelength 510~570nm. In addition, the intensity of upconversion was remarkably increased by increasing the concentration of $Er_{2}O_{3}$ dopant in as-grown $Er:LiNbO_{3}$ crystals.

• Journal of the Korean Institute of Gas
• /
• v.5 no.4 s.16
• /
• pp.33-39
• /
• 2001

This paper was studied on corrosion behavior of absorption refrigeration systems using $LiBr-H_2O$ working fluids. In the various concentration of lithium bromide solution, polarization test of SS 400, Cu(C1220T-OL) and Al-Ni bronze is carried out. And the corrosion behavior of materials forming absorption refrigeration systems is investigated. The main results are as following: 1) As concentration of lithium bromide solution increases, polarization resistance of materials of each kinds is low. And open circuit potential becomes less noble, the corrosion current density is high drained 2) Open circuit potential of SS 400 is less noble than that of Cu and Al-Ni bronze, corrosion current density of SS5 400 is high drained than that of Cu and Al-Ni bronze. 3) Anodic polarization of Cu and Al-Ni bronze in $62\%$ LiBr solution continues the active state. that of Cu and Al-Ni bronze in the natural sea water maintains the active state and the critical current for passivation appears.

• Journal of the Korean Ceramic Society
• /
• v.39 no.10
• /
• pp.977-980
• /
• 2002

Using the micro-pulling down method, $Nd_2O_3$ doped crack-free stoichiometric $LiNbO_3$ single crystals were grown in 1 mm diameter and 30∼35 mm length. The homogeneous distributions of $Nd_2O_3$ concentration were confirmed by the electron probe micro analysis. The absorption and photoluminescence spectra were measured with respect to the $Nd_2O_3$ doping.

• Proceedings of the Korea Association of Crystal Growth Conference
• /
• 1997.06a
• /
• pp.139-143
• /
• 1997

The doping effects of Mg and/or Fe ions on congruent LiNbO$_3$ single crystal growth were studied in order to clarify the roles of MgO in Fe doped LiNbO$_3$ single crystals. The effective distribution coefficienct of Fe was found decreased drastically from 0.85 to 0.5 by the addition of MgO into the LiNbO$_3$ melt. M ssbauer spectra revealed that the addition of MgO reduces the occurrence of Fe2+ ions during growth in air. Therefore, it is likely that there would be two important roles of MgO in Fe doped LiNbO$_3$. One is to suppress the incorporation of all Fe ions, and the other is to reduce the concentration of Fe2+ ions among the total Fe ions.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.2 no.1
• /
• pp.11-26
• /
• 1990

The first kind LiBr -$H_2O$ absorption heat pump system was simulated and the performances of it were predicted. The elements of heat pump system, evaporator, absorber and generator were analysed by solving the energy balance equations and concentration equations which describe the reactions between working fluids. The results show that the temperature gain of absorber and condenser and the COP of the system are affected considerably by the operating conditions of heat pump system.

• Transactions of the Korean hydrogen and new energy society
• /
• v.16 no.2
• /
• pp.136-141
• /
• 2005

Li-doped NiO was synthesized by molten salt method. $LiNO_3$-LiOH flux was used as a source for Li doping. $NiCl_2$ was added to the molten Li flux and then processed to make the Li-doped NiO material. Li:Ni ratios were maintained from 5:1 to 30:1 during the synthetic procedure and the Li doping amount of synthesized materials were found between 0.086-0.190 as a Li ion to Ni ion ratio. Li doping did not change the basic cubic structural characteristics of NiO as evidenced by XRD studies, however the lattice parameter decreased from 0.41769nm in pure NiO to 0.41271nm as Li doping amount increased. Hydrogen gas sensors were fabricated using these materials as thick films on alumina substrates. The half surface of each sensor was coated with the Pt catalyst. The sensor when exposed to the hydrogen gas blended in air, heated up the catalytic surface leaving rest half surface (without catalyst) cold. The thermoelectric voltage thus built up along the hot and cold surface of the Li-doped NiO made the basis for detecting hydrogen gas. The linearity of the voltage signal vs $H_2$ concentration was checked up to 4% of $H_2$ in air (as higher concentrations above 4.65% are explosive in air) using Li doped NiO of Li ion/Ni ion=0.111 as the sensor material. The response time T90 and the recovery time RT90 were less than 25 sec. There was minimum interference of other gases and hence $H_2$ gas can easily be detected.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2005.11a
• /
• pp.336-337
• /
• 2005

This study shows the effect of addition of $LiCoO_2$, with different milling time ranging from 0, 30, 200 hours, to the activated carbon electrode. Test cells consisting of activated carbon (100-X%) and $LiCoO_2$ (X%)were made (where X=10, 20, and 40). Test cells with varying concentrations of $LiCoO_2$ which differ in the milling time showed improved specific capacity compare with the cells fabricated using activated carbon alone. The enhanced capacity may be caused due to the addition of $LiCoO_2$ powders at varying concentration. An improved ESR value obtained may be caused by the smaller particle size of $LiCoO_2$. It was concluded that finer the particle size higher will be the efficiency.

• Clean Technology
• /
• v.12 no.2
• /
• pp.101-106
• /
• 2006

HT-$LiCoO_2$ powders were synthesized from hydroxide precursors in this study. The cobalt hydroxide compounds with hydrotalcite-like(${\alpha}$-phase) and/or brucite-like(${\beta}$-phase) structures as a component of the precursor were prepared in various PH conditions using precipitation method. It was found that various phase and compositions of cobalt hydroxides could be tailor-prepared via a careful control of preparation parameters such as the concentration ratio of $[OH^-]/[CO^{2+}]$ and aging time. The hydroxides $Co(OH)_2$ and LiOH were mixed with aqueous methyl-alcohol. The precursor of a HT-$LiCoO_2$ was synthesized via subsequent processes including evaporation, drying and aging. The transformation of tailor-made ${\beta}$-phase $Co(OH)_2$ to CoOOH and formation of solid solution in the precursor were achieved during aging. These results cause HT-$LiCoO_2$ to be synthesized at low temperature($600^{\circ}C$ ) for a short time(10min).

• Korean Journal of Materials Research
• /
• v.3 no.6
• /
• pp.614-623
• /
• 1993

Electrical characteristics of LiF-$Li_{2}O-B_{2}O_{3}-P_{2}O_5$ glasses with fixed $Li_2O$ content have been investigated by using AC impedance spectroscopy. Part of the total lithium ions present in these glasses contributes to conduction, and the changes in electrical conductivity with composition was inconsistent with the weak electrolyte model. The power law could not be used to determine the hopping ion concentration in these glasses. Both mobile carrier density and mobility have been modified as Li were added in the form of LiF. The formation of $(B-O-P)^-,di^-$, and metaborate group gave additional available sites for Li+ diffusion causing the enhancement of conductivity. The observed maximum conductivity was $2.43 \times 10^{-4}$S/cm at $150^{\circ}C$ at the composition containing 8mol% LiF. The decomposion potential amounted to 5.94V. The Li/glass electrolyte/$TiS_2$ solid-state cell showed open circuit voltage of 3.14V and energy density of 22 Wh/Kg at $150^{\circ}C$.