• Journal of The Korean Society of Grassland and Forage Science
• /
• v.10 no.3
• /
• pp.158-163
• /
• 1990

This experiment was to study the effect of pure mineral nitrogen fertilizing on seasonal distribution of dry matter yield and the advisable mineral nitrogen amounts on grassland. The results were as follows: 1. With longer regrowth periods the absolute dry matter yields and the nitrogen-efficiences due to nitrogen fertilizing increased substantially, whereas the quality declined at the relatively lesser cutting frequencies. 2. The first cut at 3-cut regimes, the first and fourth cut at 4-cut regimes, and the second and last cut at 5-and 6-cut regimes showed the highest nitrogen-efficiency, respectively. 3. By the sigmaformed process of production curve the most efficient mineral N-dressing rate per ha and cut was calculated: 42-56kg N on the 3-cut areas, 39-55kg N on the 4-cut areas, 38-47kg N on the 5-cut areas and 35-48kg N/ha/cut on the &cut areas. 4. In dependence on site and kind of calculation the economical borders were reached with the following dressings of mineral N/ha/cut: 90-100kg on the 3-cut areas, 70-100kg on the 4-cut areas and 50- 90kg on the 5-and 6-cut areas.

• Journal of Magnetics
• /
• v.21 no.4
• /
• pp.652-659
• /
• 2016

In this study, the efficiencies for both the angular aligned and unaligned positions of the receiver and transmitter coils of wireless power transfer (WPT) systems are examined. Some parameters of the equivalent circuit were calculated with Maxwell 3D software. The analytical solution of the circuit was calculated in MATLAB program through the composition of the system's mathematical modeling. The numerical solution of the system, however, was calculated using PSIM, which is circuit simulation software. In addition, with the use of the finite element method (FEM) in Maxwell 3D software, transient analysis of the three-dimensional system was performed. The efficiency of the system was estimated through the calculation of input and output power. The results demonstrated that power was efficiently transmitted to a certain extent in aligned and unaligned positions. The results also revealed that, for aligned positions, high efficiency with air gaps of 15-20 cm can be obtained and that the efficiency quickly dropped with air gaps of more than 20 cm. For spatially unaligned positions, it was observed that wireless power transfer could be realized with high efficiency with air gaps of up to 10 cm and that efficiency quickly dropped with air gaps of more than 10 cm.

• Nuclear Engineering and Technology
• /
• v.51 no.4
• /
• pp.1176-1179
• /
• 2019

Measurements of activity concentrations of radionuclides in atmospheric releases were performed in 2017-2018 at vent stacks of seven Russian nuclear power plants. The selected instruments and research methods, with detection limits significantly lower than the existing detection limit of Russian NPPs routine control, allowed to reliably determine up to 26 radionuclides. Analysis of experimental data allows to determine the list of radionuclides for calculation the effective dose rates to public and the permissible annual discharge levels for each Russian NPP. Radiocarbon is determined as major contributor for the dose from the atmospheric releases of LWGR reactors - up to 98% for EGP-6 and RBMK-1000 (Smolensk NPP) reactors. For PWR reactors (VVER) radionuclides contribution to the annual dose from atmospheric releases is more complicated, but, in general, dose is formed by tritium, $^{14}C$ and noble gases. The special monitoring results with ranking of measured radionuclides according to their contribution to the effective dose makes it possible to optimize the list of controlled radionuclides in airborne releases of Russian NPPs from 94 to 8-16 for different NPPs.

• Journal of Information Processing Systems
• /
• v.15 no.2
• /
• pp.305-319
• /
• 2019

The prediction of the sum of container is very important in the field of container transport. Many influencing factors can affect the prediction results. These factors are usually composed of many variables, whose composition is often very complex. In this paper, we use gray relational analysis to set up a proper forecast index system for the prediction of the sum of containers in foreign trade. To address the issue of the low accuracy of the traditional prediction models and the problem of the difficulty of fully considering all the factors and other issues, this paper puts forward a prediction model which is combined with a back-propagation (BP) neural networks and the support vector machine (SVM). First, it gives the prediction with the data normalized by the BP neural network and generates a preliminary forecast data. Second, it employs SVM for the residual correction calculation for the results based on the preliminary data. The results of practical examples show that the overall relative error of the combined prediction model is no more than 1.5%, which is less than the relative error of the single prediction models. It is hoped that the research can provide a useful reference for the prediction of the sum of container and related studies.

• Progress in Medical Physics
• /
• v.32 no.4
• /
• pp.159-164
• /
• 2021

Purpose: We investigated the properties of CLEANBOLUS based on silicone with suitable characteristics for clinical use. Methods: We evaluated the characteristics of CLEANBOLUS and compared the results with the commercial product (Super-Flex bolus). Also, we conducted physical evaluations, including shore hardness, element composition, and elongation break. Transparency was investigated through the measured absorbance within the visible region (400-700 nm). Also, dosimetric characteristics were investigated with surface dose and beam quality. Finally, the volume of unwanted air gap was investigated based on computed tomography images for breast, chin, and nose using Super-Flex bolus and CELANBOLUS. Results: CLEANBOLUS showed excellent physical properties for a low shore hardness (000-35) and elongation break (>1,000%). Additionally, it was shown that CLEANBOLUS is more transparent than Super-Flex bolus. Dosimetric results obtained through measurement and calculation have an electron density similar to water in CLEANBOLUS. Finally, CLEANBOLUS showed that the volume of unwanted air gap between the phantom and each bolus is smaller than Super-Flex bolus for breast, chin, and nose. Conclusions: The physical properties of CLEANBOLUS, including excellent adhesive strength and lower shore hardness, reduce unwanted air gaps and ensure accurate dose distribution. Therefore, it would be an alternative to other boluses, thus improving clinical use efficiency.

• Journal of the Korean institute of surface engineering
• /
• v.56 no.1
• /
• pp.84-93
• /
• 2023

The spent nuclear fuel is burned during the planned cycle in the plant and then generates elements such as actinide series, fission products, and plutonium with a long half-life. An 'interim storage' step is needed to manage the high radioactivity and heat emitted by nuclides until permanent-disposal. In the case of Korea, there is no space to dispose of high-level radioactive waste after use, so there is a need for a period of time using interim storage. Therefore, the intensity of neutrons and gamma-ray must be determined to ensure the integrity of spent nuclear fuel during interim storage. In particular, the most important thing in spent nuclear fuel is burnup evaluation, estimation of the source term of neutrons and gamma-ray is regarded as a reference measurement of the burnup evaluation. In this study, an analysis of spent nuclear fuel was conducted by setting up a virtual fuel burnup case based on CE16×16 fuel to check the total amount and spectrum of neutron, gamma radiation produced. The correlation between BU (burnup), IE (enrichment), and CT (cooling time) will be identified through spent nuclear fuel burnup calculation. In addition, the composition of nuclide inventory, actinide and fission products can be identified.

• Journal of Nuclear Fuel Cycle and Waste Technology(JNFCWT)
• /
• v.21 no.3
• /
• pp.397-410
• /
• 2023

This study examined the efficacy of various chlorinating agents in partitioning light water reactor spent fuel, with the aim of optimizing the chlorination process. Through thermodynamic equilibrium calculations, we assessed the outcomes of employing MgCl₂, NH₄Cl, and Cl₂ as chlorinating agents. A comparison was drawn between using a single agent and a sequential approach involving all three agents (MgCl₂, NH₄Cl, and Cl₂). Following heat treatment, the utilization of MgCl₂ as the sole chlorinating agent resulted in a moderate separation. Specifically, this method yielded a solid separation with 96.9% mass retention, 31.7% radioactivity, and 44.2% decay heat, relative to the initial spent fuel. In contrast, the sequential application of the chlorinating agents following heat treatment led to a final solid separation characterized by 93.1% mass retention, 5.1% radioactivity, and 15.4% decay heat, relative to the original spent fuel. The findings underscore the potential effectiveness of a sequential chlorination strategy for partitioning spent fuel. This approach holds promise as a standalone technique or as a complementary process alongside other partitioning processes such as pyroprocessing. Overall, our findings contribute to the advancement of spent fuel management strategies.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.45 no.5
• /
• pp.771-777
• /
• 2016

Accurate food composition data are essential for calculation of nutrient intake of a population based on its consumption statistics. In the Korean food composition database, there is a lack of reliable analytical data for tocopherols and tocotrienols. Therefore, this study was conducted to provide information on contents on vitamin E in agricultural processed foods in Korea. Tocopherols and tocotrienols were determined by the saponification extraction method followed by high performance liquid chromatography. Analytical method validation parameters were calculated to ensure the method's validity. Samples were obtained in the years of 2013 and 2014 from the Rural Development Administration. The samples included 34 grains and grain products, 14 snacks, 25 fruits, 5 oils, and 11 sources and spices. All vitamin E isomers were quantitated, and the results were expressed as ${\alpha}$-tocopherol equivalent (${\alpha}-TE$). ${\alpha}-TE$ values of cereal and cereal products, snacks, fruits, oils and sauces and spices ranged from 0.03 to 17.53, 1.01 to 12.84, 0.01 to 1.52, 1.09 to 8.15, and 0.01 to $27.53{\alpha}-TE/100g$, respectively. Accuracy was close to 100% (n=3). Repeatability and reproducibility were 2.04% and 4.69%, respectively. Our study provides reliable data on the tocopherol and tocotrienol contents of agricultural and processed foods in Korea.

• Asian-Australasian Journal of Animal Sciences
• /
• v.13 no.5
• /
• pp.605-612
• /
• 2000

Four young swamp buffalo cows of similar age ranging in weight between 280 to 380 kg and trained to do physical work were used in a study to determine energy and protein requirements for draught using a $4{\times}4$ Latin square designed experiment. The experiment consisted of field trials employing 4 levels of work load, e.g. no work as control, and loads amounting 450 to 500 Newton (N) pulled continuously for 1, 2 and 3 h daily for 14 consecutive days. Cows were fed king grass (Penisetum purpuroides) ad libitum and were subjected to materials balance trials. Body composition was estimated in vivo by the body density method and daily energy expenditure (EE) was calculated from ME minus retained energy (RE). The results show that EE while not working ($EE_{resting}$) was $0.42kgW^{0.75}MJ/d$ and maintenance ME ($ME_m$) was $0.37kgW^{0.75}MJ/d$. ME requirement increased to 1.65 times maintenance for the work of 3 hours. The energy expended for doing exercise ($E_{exercise}$) was 9.56, 20.0 and 25.86 MJ/cow for treatments 1, 2 and 3 II, respectively. Fat retention was absent in all groups of working cows, but protein retention was only negative for cows undertaking 3 h work. The relationship between $E_{exercise}$ (MJ), work load (F, kN), work duration (t, h) and body mass (W, kg) was found to be: $E_{exercise}=(0.003F^{1.43}t^{0.93})/W^{0.09}MJ$. The maintenance requirement for digestible protein was $2.51kgW^{0.75}g/d$, whereas digestible protein for growth ($DP_{growth}$) and for work ($DP_{work}$) followed the equations: $DP_{growth}=[(258+1.25W^{0.75}){\Delta}Wkg/d]g$ and $DP_{work}=[12.59e^{0.95t}]g$, respectively The coefficients a, b and c for the calculation of $E_{exercise}$ components according to the Lawrence equation were found to be 2.56 J/kgW.m, 5.2 J/kg load carried.m and 0.29, respectively, thus efficiencies to convert ME into work were 0, 16.09, 27.3 and 32.44% for control, 1, 2 and 3 h/d work, respectively. ME and DP requirements for a 250 to 400 kg working buffalo cow allowing to growth up to 0.5 kg/d are presented.

• Korean Journal of Human Ecology
• /
• v.9 no.3
• /
• pp.69-79
• /
• 2006

The previous studies on the intake of trace elements performed in Korea were only concerned about major elements like Fe, Zn or Cu. There is little data about the intake of minor elements like Mn, Se, Mo or Cr. And most of the data were obtained by calculation using Food Composition Tables or by analysis using atomic absorption spectrophotometers (AAS). The purpose of this study, therefore, was to evaluate the dietary intake of seven trace elements, Fe, Zn, Cu, Mn, Se, Mo, and Cr of Korean adult wonmen and to compare the data between analyzed using ICP-MS (or ICP-AES) and calculated by the CAN-Pro (or Food Composition Table). A total of nineteen adult women participated voluntarily in this study and collected one-tenth of the foods that they consumed for three consecutive days. Analyzed intake of Fe of the subjects was $6.94{\pm}2.18$ (calculated, $18.87{\pm}4.50$) mg/day, that of Ze was $9.35{\pm}4.95$ (calculated, $8.35{\pm}2.87mg/day$), that of Cu was $1.18{\pm}0.26\;(1.11{\pm}0.32mg/day)$, that of Mn was $3.69{\pm}0.69\;(2.83{\pm}1.68mg/day)$, that of Se was $41.93{\pm}9.28$ (calculated, $27.58{\pm}6.97{\mu}g/day$), that of Mo was $134.0{\pm}49.1{\mu}g/day$, and that of Cr was $136.5{\pm}147.9{\mu}g/day$. The analyzed Fe intake of the subjects did not meet Estimated Average Requirement (EAR) nor Recommended Intakes (RI) for Korean women aged 20-29 years old. However, the analyzed intakes of the other six elements, Zn, Cu, Mn, Se, Mo, and Cr, seemed to meet each of the respective RIs. The analyzed Fe intake was significantly lower than the calculated one, in fact by 2.72 times, however, the analyzed intakes of the other elements, Mn and Se, were significantly higher and those of Zn and Cu were similar than each of the calculated ones. The difference of the data between analyzed and calculated intakes indicates that it is necessary to set up database on trace element contents of foods of the Food Composition Table and the CAN-Pro so as to have accuracy.