• The Journal of Advanced Prosthodontics
• /
• v.3 no.1
• /
• pp.43-46
• /
• 2011

Flabby ridges commonly occur in edentulous patients. Inadequate retention and stability of a complete denture are the often encountered problems in these patients. A liquid supported denture due to its flexible tissue surface allows better distribution of stress and hence provides an alternate treatment modality in such cases. This case report presents the use of a liquid supported denture in a patient with completely edentulous maxillary arch with flabby tissue in anterior region opposing a partially edentulous mandibular arch.

• Journal of Chest Surgery
• /
• v.18 no.2
• /
• pp.360-370
• /
• 1985

A case of complete interruption of aortic arch with aortopulmonary window, patent ductus arteriosus, and aberrantly originated right subclavian artery from proximal descending aorta, in a four year old boy is reported in detail. This is the only reported case in Korea, who has had a successful one-stage total anatomical correction of this combination of defects. Under deep hypothermia and total circulatory arrest, aortic continuity was established using patent ductus arteriosus and anterior wall of pulmonary artery, which was anastomosed obliquely to anteromedial side of ascending aorta. Aortopulmonary window was closed using Impra patch via pulmonary arteriotomy. Then pulmonary arteriotomy was reconstructed primarily except at the junction of right pulmonary artery and main pulmonary artery, where a small piece of pericardium was used to close the defect to prevent kinking and narrowing of right pulmonary artery. Postoperative cardiac catheterization demonstrated a good reconstruction.

• Archives of Plastic Surgery
• /
• v.35 no.4
• /
• pp.465-470
• /
• 2008

Purpose: Reduction malarplasty is a popular aesthetic surgery for contouring wide and prominent zygoma. However a few patients complain postoperative results and want to revise the midfacial contour. We analyzed the etiology of unfavorable results and treated unsatisfied midfacial contours after reduction malarplasty. Methods: Total 53 patients were performed secondary operation for correction of unfavorable results after primary reduction malarplasty from elsewhere. Midfacial contour was evaluated with plain films and three-dimensional computed tomography. Unfavorable midfacial contours were corrected by secondary malarplasty. Flaring of zygomatic arch was reduced with infracturing technique and prominent zygomatic body was reduced with shaving. Drooped or displaced zygoma complex has been suspended to higher position and fixed with interosseous wiring. As adjuvant procedure, autologous fat injection has been performed in the region of depressed zygomatic body region. Results: The etiology of unfavorable midfacial contour after reduction malarplasty was classified into 7 categories: undercorrection of zygomatic arch(n=8), undercorrection of zygomatic arch and undercorrection of zygomatic body(n=6), undercorrection of zygomatic arch and overcorrection of zygomatic body(n=28), overcorrection of zygomatic body(n=3), simple asymmetry(n=4), malunion(n=2) or nonunion(n=2). Slim and balanced malar contour was achieved with treatment. And most of the patients were satisfied with the results of the surgery. Conclusion: To prevent the unfavorable results after reduction malarplasty, complete analysis of facial contour, choice of appropriate operation technique, precise osteotomy under direct vision, and security of zygoma position are important.

• Physical Therapy Korea
• /
• v.26 no.4
• /
• pp.70-76
• /
• 2019

Background: An excessive pronated foot is defined as a flattening or complete loss of the medial longitudinal arch. Excessive foot pronation is considered to have high risk factors of overuse injuries in the lower limb. Various treatments have been investigated in attempts to control excessive pronation. Objects: This meta-analysis identifies the effects of an anti-pronation taping technique using different materials. Methods: The electronic databases used include MEDLINE, the Physiotherapy Evidence Database (PEDro), Science Direct, the Korean Studies Information Service System (KISS), the Research Information Sharing Service (RISS), the Korea National Library, and the Korean Medical Database (studies published up to July 31, 2019). The database search used the following keywords: "foot drop" OR "foot arch" OR "foot pronation" OR "flat foot (pes planus)" AND "taping" OR "support." Eight eligible studies were analyzed to determine the effectiveness of anti-pronation taping in study and control groups. Results: The overall random effect size (Hedges'g) of the anti-pronation taping technique was 0.147 (95% confidence interval [CI]: -.214 to .509). When the effect (Hedges' g) was compared by the type of tape material, rigid tape (RT; Lowdye taping) was .213 (95% CI: -.278 to .704) and kinesiotape (KT; arch support taping) was -.014 (95% CI: -.270 to .242). Based on this meta-analysis, it was not possible to identify the extent to which anti-pronation taping was effective in preventing navicular drop, improving balance, or changing foot pressure. Only three of the eight eligible studies applied KT on excessive pronated feet, and the outcome measure areas were different to those of the RT studies. The KT studies used EMG data, overall foot posture index (FPI) scores, and rear foot FPI scores. In contrast, the RT studies measured navicular heights, various foot angles, and foot pressure. Conclusion: This review could not find any conclusive evidence about the effectiveness of any taping method for patients with pronated feet. Future studies are needed to develop the anti-pronation taping technique based on the clinical scientific evidence.

• Journal of Korean Dental Science
• /
• v.15 no.1
• /
• pp.84-91
• /
• 2022

An all-on-4 restoration allows edentulous patients to use a fixed prosthesis with a minimum number of implants. These implant-supported fixed complete dentures have traditionally been fabricated as screw-retained or cement-retained prostheses. However, it is difficult to passively fit the long-span full-arch prosthesis using the screw-retained type restoration, and predictable retrievability is not obtained with the cement-retained type. This case report describes a prosthesis fabricated using a combination of the two retention types. The screwmentable method allows the implant-supported fixed complete denture to achieve a passive fit at the connection with retrievability. In addition, a framework with an optimized size was designed by using digital dental technology.

• The Journal of Korean Academy of Prosthodontics
• /
• v.56 no.2
• /
• pp.120-125
• /
• 2018

Conventional denture impression techniques have limitations for edentulous patients with severe alveolar bone resorption and can cause problems from excessive border extension. Especially when a patient has movable tissue it is difficult to make accurate impression, thus might interrupt stable seating of complete denture. Fabrication of complete denture using closed mouth technique for edentulous patient with severe ridge resorption is thought to provide better stability and retention. In this case, an 86-year-old patient had both edentulous jaws with epulis fissuratum on maxillary anterior ridge and severe mandibular ridge resorption. Thus, tentative vertical dimension was determined by using Centric trayand individual tray attached with gothic arch tracer was fabricated. Complete denture was fabricated using closed mouth technique and the patient was satisfied with better stability and retention of the complete denture.

• Journal of Dental Rehabilitation and Applied Science
• /
• v.33 no.4
• /
• pp.321-328
• /
• 2017

Treatment options for edentulous patients are complete denture and implant prosthesis. A two implant-retained overdenture can be considered the first treatment in the edentulous mandible, but there is no clear consensus of treatment for edentulous maxilla. Implant-retention/support overdenture shows better retention and stability than complete denture and is less expensive and more esthetic than implant-supported fixed prosthesis. CM $LOC^{(R)}$ $Pekkton^{(R)}$ attachment is a solitary type attachment and evaluated to have excellent abrasion resistance and retention with a female part made of poly-ether-ketone-ketone. Meanwhile, SR Ivocap system is injection molding method and discussed to show few changes in the vertical dimension of denture and have excellent fracture resistance. In this case, we restored maxillary arch with a four implant-retained overdenture using CM $LOC^{(R)}$ $Pekkton^{(R)}$ and SR Ivocap system, and mandibular arch with a removable partial denture. Through this procedure, satisfactory outcomes were achieved both in functional and esthetic aspects.

• Journal of Dental Rehabilitation and Applied Science
• /
• v.30 no.2
• /
• pp.176-183
• /
• 2014

Severely absorbed edentulous ridge cannot bear mechanical stress, causes undesired transformation of oral environment and makes patients difficult to adapt to dentures. Nowadays implant overdenture can be a treatment of choice in order to relieve patients' discomfort and improve stability and retention of the denture. Placement of implant on maxilla is difficult because of its bone quality and anatomic structure. It also has wide supportive tissue and convenience of border sealing, which provides sufficient support and stabilization with conventional complete denture. Mandible, on the other hand, is difficult to obtain sufficient support, retention and stabilization with conventional complete denture. Therefore, implant overdenture is recommended on mandible. Locator attachment has been improved for convenience of use and male parts of various retention enabled it to replace ball type attachment clinically. In this study, we restored maxillary arch with conventional denture, and mandibular arch with implant and tissue-supported overdenture and Locator attachment system.

• The Journal of Advanced Prosthodontics
• /
• v.13 no.4
• /
• pp.191-204
• /
• 2021

PURPOSE. The purpose of this study is to present a methodology to evaluate the accuracy of intraoral scanners (IOS) used in vivo. MATERIALS AND METHODS. A specific feature-based gauge was designed, manufactured, and measured in a coordinate measuring machine (CMM), obtaining reference distances and angles. Then, 10 scans were taken by an IOS with the gauge in the patient's mouth and from the obtained stereolithography (STL) files, a total of 40 distances and 150 angles were measured and compared with the gauge's reference values. In order to provide a comparison, there were defined distance and angle groups in accordance with the increasing scanning area: from a short span area to a complete-arch scanning extension. Data was analyzed using software for statistical analysis. RESULTS. Deviations in measured distances showed that accuracy worsened as the scanning area increased: trueness varied from 0.018 ± 0.021 mm in a distance equivalent to the space spanning a four-unit bridge to 0.106 ± 0.08 mm in a space equivalent to a complete arch. Precision ranged from 0.015 ± 0.03 mm to 0.077 ± 0.073 mm in the same two areas. When analyzing angles, deviations did not show such a worsening pattern. In addition, deviations in angle measurement values were low and there were no calculated significant differences among angle groups. CONCLUSION. Currently, there is no standardized procedure to assess the accuracy of IOS in vivo, and the results show that the proposed methodology can contribute to this purpose. The deviations measured in the study show a worsening accuracy when increasing the length of the scanning area.

• Journal of Chest Surgery
• /
• v.27 no.7
• /
• pp.581-586
• /
• 1994

From February 1985 to February 1993, 18 operations were performed in 17 patients for treatment of aneurysmal disease [n=12] and/or dissection of the ascending aorta [n=6]. The ages ranged from 26 to 69 years [mean 44.3 $\pm$ 11.0 years].The proposed operations include composite graft replacement of aortic valve and ascending aorta with coronary reimplantation in 11, graft replacement of ascending aorta alone in 5, aortic valve replacement and supracoronary graft replacement in 1 and ascending aorta to abdominal aorta bypass with thromboexclusion of descending aorta in one patient. Both Bentall [n=6] and Cabrol [n=5] technique were utilized for reimplantation of coronary arteries.Concomitant replacement of aortic arch and arch vessel reconstruction was necessary in two patients. Hypothermic circulatory arrest was utilized in 6 patients. Recently, four patients were managed on warm blood continuous cardioplegia via retrograde route. There were no operative deaths. No significant postoperative complications were noted. Postoperative follow up was complete in 15 patients from 1 month to 72 months. Redo operation was necessary in one patient who had suffered from distal recurrence of dissection 5 years after successful Bentall operation. The other patients are all in excellent clinical condition. From our early experience with those 17 cases, we assume that satisfactory operative result could be achieved with a variety of surgical technique including hypothermic circulatory arrest. In addition, continuous perfusion of warm blood cardioplegia via retrograde route is supposed to be beneficial in selected cases.