• Transactions on Control, Automation and Systems Engineering
• /
• 제4권1호
• /
• pp.43-48
• /
• 2002

We show that humans execute the postural control ingeniously by regulating the impedance properties of the musculo-skeletal system as the motor command against the alteration of the environment. Adjusting muscle activity can control the impedance properties of the musculo-skeletal system. To quantify the changes in human arm viscoelasticity on the vertical plane during interaction with the environment, we asked our subject to hold an object. By utilizing surface electromyographic(EMG) studies, we determined a relationship between the perturbation and a time-varying muscle co-activation. Our study showed when the subject lifts the object by himself the muscle stiffness increases while the torque remains the same just before the lift-off. These results suggest that the central nervous system(CNS) simultaneously controls not only the equilibrium point(EP) and the torque, but also the muscle stiffness as themotor command in posture control during the contact task.

• 한국군사과학기술학회지
• /
• 제24권2호
• /
• pp.219-227
• /
• 2021

In the present study, the effect of command signals of the flow control valve on performance of underwater discharge systems using a linear pump was investigated numerically. For that, the improved mathematical model was developed. The improvement is to calculate the flow leakage between the water cylinder and the piston. Also the model of the hydraulic cylinder is simplified. To validate the improved model, calculation results were compared with experiment results. The results of the study is as follows: Double ramp command signals of the flow control valve had an advantage over single ramp signals. The parametric study on the effect of double ramp command signals on performance of the system was performed. In case of using double ramp signals, the maximum acceleration of the underwater vehicle was reduced by approximately 50 % compared with using single ramp signals.

• 제어로봇시스템학회:학술대회논문집
• /
• 제어로봇시스템학회 2001년도 ICCAS
• /
• pp.47.3-47
• /
• 2001

This paper describes the control of a health care robot (called Welfare Liferobot) with voice commands. The welfare liferobot is an intelligent autonomous mobile robot with its own control system on-board and the set of sensors to perceive an environment. It is a natural way to control the welfare liferobot by use of voice command for the usage of keyboard and mouse may present a difficult problem to the elderly and the handicapped. Voice input as the main control modality can offer many advantages. A set of oral commands is included, and each command has its associated function. These control words (commands) have to be chosen by user. Each time a voice command is recognized by the robot, it executes the pre-assigned action ...

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1999년도 추계학술대회 논문집 학회본부 B
• /
• pp.552-554
• /
• 1999

In this paper, a robust control system with the disturbance observer is proposed for BLDC servo system. The overall control system consists of the speed controller which is implemented with PI controller and the disturbance observer with free parameters. The proposed control system is designed the command input response and the closed loop characteristics independently by using two-degrees-of-freedom concept, so it can improve the closed loop characteristics with no influence on the command input response. The effective suppression of disturbance with the observer improves the characteristics of the closed loop of the system. And also, by fluting the bandwidth of free parameters, measurement noise is considered. To verify the better performance of the proposed control system than that of the conventional PI controllers, the performance of the controller is analyzed theoretically and some simulation results are presented.

• 대한전기학회논문지:전기기기및에너지변환시스템부문B
• /
• 제52권12호
• /
• pp.616-623
• /
• 2003

Conventional P/PI speed controller of today's servo drives should be manually tuned the controller switching set-point by trial-and-errors, which may translate the drive system down-time and loss of productivity. The adjustable drive performance is heavily dependent on the quality of the expert knowledge and becomes inadequate in applications where the operating conditions change in a wide range, i.e., tracking command, acceleration/deceleration time, and load disturbances. In this paper, the demands on simple controls/setup are discussed for industry servo drives. Analyzing the frequency content of motor torque command, P/PI control mode switching is automatically performed with some prior knowledge of the mechanical dynamics. The dynamic performance of the proposed scheme assures a desired tracking response curve with minimal oscillation and settling time over the whole operating conditions. For comprehensive comparison of traditional P/PI control scheme, extensive test is carried out on actual servo system.

• 대한임베디드공학회논문지
• /
• 제15권2호
• /
• pp.95-101
• /
• 2020

In situations where mobile robots are operated either by autonomous systems or human operators, such as smart factories, priority-based teleoperation is crucial for the multiple operators with different priority to take over the right of the robot control without conflict. This paper proposes a priority-based teleoperation system for multiple operators to control the robots. This paper also introduces an efficient joystick-based robot control command generation algorithm for differential-drive mobile robots. The proposed system is implemented with ROS (Robot Operating System) and embedded control boards, and is applied to Pioneer 3AT mobile robot platform. The experimental results demonstrate the effectiveness of the proposed joystick control command algorithm and the priority-based control input selection.

• 대한토목학회논문집
• /
• 제44권3호
• /
• pp.417-423
• /
• 2024

This study compared and analyzed the importance of command priority between railway traffic controllers through pairwise comparison of AHP analysis. 27 railway traffic controllers working on metropolitan railway control center, urban railway control center, and unmanned driving control center responded. As a result of the analysis, all the railway traffic controllers generally recognized the train driving control and train signal control as the most important priorities. For the controller in the manned driving system, a train driving control was the highest at 0.375. On the other hand, the controller based on unmanned driving recognized train signal control as the highest priority at 0.469. In the result of the AHP analysis considering all the variables, the braking system was the highest priority at 0.19 based on manned train driving. On the other hand, the controller based on unmanned train driving recognized wired and wireless network systems and SCADA as the highest priority at 0.267.

• Journal of Power Electronics
• /
• 제9권2호
• /
• pp.320-333
• /
• 2009

A Photovoltaic (PV) system's power output varies with the change of climate. Frequency deviations, tie line voltage swings are caused by the varying PV power when large PV power from several PV systems is fed in the utility. In this paper, to overcome these problems, a simple coordinated control method for smoothing the variations of combined PV power from multiple PV systems is proposed. Here, output power command is formed in two steps: central and local. Fuzzy control is used to produce the central smoothing output power command considering insolation, variance of insolation and absolute average of frequency deviation. In local step, a simple coordination is kept between the central power command and the local power commands by producing a common tuning factor. Power converters are used to achieve the same output power as local command power employing PI control law for each of the PV generation systems. The proposed method is compared with the method where conventional Maximum Power Point Tracking (MPPT) control is used for each of the PV systems. Simulation results show that the proposed method is effective for smoothing the output power variations and feasible to reduce the frequency deviations of the power utility.

• 전력전자학회논문지
• /
• 제21권3호
• /
• pp.238-248
• /
• 2016

In this study, an automatic command mode transition strategy of direct power control (DPC) is proposed for permanent magnet synchronous generators (PMSGs) medium-voltage (MV) offshore wind turbines (WTs). Benchmarking against the control methods are performed based on a three-level neutral-point-clamped (NPC) back-to-back type voltage source converter (VSC). The ramping rate criterion of complex power is utilized to select the switching vector in DPC for a three-level NPC converter. With a grid command and an MPPT mode transition strategy, the proposed control method automatically controls the generated output power to satisfy a grid requirement from the hierarchical wind farm controller. The automatic command mode transition strategy of DPC is confirmed through PLECS simulations based on Matlab. The simulation result of the automatic mode transition strategy shows that the proposed control method of VOC and DPC achieves a much shorter transient time of generated output power than the conventional control methods of MPPT and VOC under a step response. The proposed control method helps provide a good dynamic performance for PMSGs MV offshore WTs, thereby generating high quality output power.

• 대한기계학회:학술대회논문집
• /
• 대한기계학회 2007년도 춘계학술대회A
• /
• pp.1120-1125
• /
• 2007

Experimental study on the control of randomly disturbing system is conducted. External and internal disturbances are imposed to the system in combined manner. A vertical propeller system exposed horizontal weak turbulent air flow is chosen as an experimental model. The aim of the control system is to maintain the angular position of vertical propeller in parallel to air flow. Trajectory Tracking Stochastic Controller (TTSC) is designed to ensure system's stability while following system command. The Trajectory Tracking Stochastic Controller is composed of two controller, one is stochastic controller to suppress internal random noise and the other one is trajectory-tracking controller to follow the command having random noise. The proposed hybrid controller, TTSC, shows remarkable performance in pitch control of vertical propeller system in wind-tunnel test