• Journal of Korean Society of Environmental Engineers
• /
• v.34 no.5
• /
• pp.316-325
• /
• 2012

In this study, we suggested adequate control technology by analyzing emission process and main chemical of VOC/HAPs generated from four paint factories in Busan area. And we estimated whether Kapok fiber, which is a natural material, can be commercially used for an absorbent by testing adsorption ability. As a result of this sturdy, above 60% of VOC/HAPs was volatilized and dispersed inside the working place without conducting control system of facilities during manufacturing paints. Concentration profile of VOC/HAPs, which is volatile naturally outside the factories, is surveyed above 70% at Toluene, Ethylbenzene, and Xylene. And a result of evaluation of odor attribution level about the component whose Odor Threshold is known, it is estimated that major cause material of A, B, C factories is Toluene and that of D factory is m/p-Xylene. And that result presented design arguments such as facilities specifications, activated carbon filling volume, and replace cycle of activated carbon as control technology. Also, that result presented emission process improvement such as adsorption of central-controlled ventilation device, installation of inlet flenge, and potable cleaning process. The rate of pollutant adsorption of Kapok fiber, which is natural material, is indicated about 91.9%, 66.7%. That result validated the possibility as replacement of activated carbon.

• Journal of the Korean Institute of Landscape Architecture
• /
• v.26 no.3
• /
• pp.199-212
• /
• 1998

The ultimate goal of this study can be summed up as follows: First, the utility of Time-Lapse that observes and records people's behavior will be shown and its merits and demerits will be discussed through comparing with other data-collecting methods such as the naked- eye observation, and the specific way in which Time-Lapse can be put to use will be suggested. Second, analysis of use behavior boserved in the plaza of Chungryangri station by Time-Lapse will be made, on the basis of which suggestions will be made concerning planing, designing, layout, and management of the station plaza. Time-Lapse can observe and records the plaza of Chungryangri Staton through 6 different ways of recording in Time-Lapse: 30 seconds, every minute, every two minutes, second every five minutes, every one tenth of a second, and every one fifth of a second, and these different ways of recording were analyzed through comparison from one to each other to check their respective utilities. And also analysis of tracks of pedestrians, density, and use behavior of users were made, according to which the way in which Time-Lapse can be utilized was examined. Several useful results obtained from this study are shown as follows. First, Time-Lapse made it possible to continuously observe for a long time using minimu efforts, and a single tape which is able to cover from 12 hours up to 25 days is useful for observing variation of behavior in space with the passage of time and seasons. Second, among six ways of recording, the recording every one tenth of a second and every one fifth of a second are useful for finding the tracks of pedestrians, the number of users, the member compositions, the time spent in one place, and manner of use. And besides the moving direction and its purpose can be recognized in a short time, which makes it possile to see where crossings of moving directions occur. Third, the recording every thirty seconds, every minute, every two minutes, and every five minutes are useful for analyzing the density in space as well as for finding the number of users and frequency of facilities use. In particular the recording every thirty seconds made it possible to keep the track of pedestrians' walking, and to observe even slowly moving motions such as cleaning. But when the recording interval exceeds one minute, this was not possible. Fourth, time-lapse has advantages over the naked eye observation in several respects. Time-lapse can measure observed behavior and density in terms of number, and locate the position of users. Time-Lapse, if accompanied by other methods such as interviewing and question that can examine psychological aspects like satisfaction or the purpose of use and be a useful device for space studies.

• Journal of the Korean Society of Marine Environment & Safety
• /
• v.27 no.6
• /
• pp.898-904
• /
• 2021

This experimental study aims to investigate the use of a wet electrostatic precipitator as a post-treatment device to satisfy the strict emission regulations for sulfur oxides and particulate matter (PM). The inlet/outlet of a wet electrostatic precipitator was installed in a funnel using a marine four-stroke diesel engine (STX-MAN B&W) consuming marine heavy fuel oil (HFO) with a sulfur content of about 2.1%. Measurements were then obtained at the outlet of the wet electrostatic precipitator; an optical measuring instrument (OPA-102), and the weight concentration measurement method (Method 5 Isokinetic Train) were used for the PM measurements and the Fourier transform infrared (FT-IR; DX-4000) approach was used for the sulfur oxide measurements. The experimenst were conducted by varying the engine load from 50%, to 75% and 100%; it was noted that the PM reduction efficiency was a high at about 94 to 98% under all load conditions. Additionally, during the process of lowering the exhaust gas temperature in the quenching zone of the wet electrostatic precipitator, the sulfur dioxide (SO₂) values reduced because of the cleaning water, and the reduction rate was confirmed to be 55% to 81% depending on the engine load.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.20 no.6
• /
• pp.427-446
• /
• 2008

A review on the papers published in the Korean Journal of Air-Conditioning and Refrigeration Engineering in 2006 has been accomplished. Focus has been put on current status of research in the aspect of heating, cooling, ventilation, sanitation and building environments. The conclusions are as follows. (1) The research trends of fluid engineering have been surveyed as groups of general fluid flow, fluid machinery and piping, etc. New research topics include micro heat exchanger and siphon cooling device using nano-fluid. Traditional CFD and flow visualization methods were still popular and widely used in research and development. Studies about diffusers and compressors were performed in fluid machinery. Characteristics of flow and heat transfer and piping optimization were studied in piping systems. (2) The papers on heat transfer have been categorized into heat transfer characteristics, heat exchangers, heat pipes, and two-phase heat transfer. The topics on heat transfer characteristics in general include thermal transport in a cryo-chamber, a LCD panel, a dryer, and heat generating electronics. Heat exchangers investigated include pin-tube type, plate type, ventilation air-to-air type, and heat transfer enhancing tubes. The research on a reversible loop heat pipe, the influence of NCG charging mass on heat transport capacity, and the chilling start-up characteristics in a heat pipe were reported. In two-phase heat transfer area, the studies on frost growth, ice slurry formation and liquid spray cooling were presented. The studies on the boiling of R-290 and the application of carbon nanotubes to enhance boiling were noticeable in this research area. (3) Many studies on refrigeration and air conditioning systems were presented on the practical issues of the performance and reliability enhancement. The air conditioning system with multi indoor units caught attention in several research works. The issues on the refrigerant charge and the control algorithm were treated. The systems with alternative refrigerants were also studied. Carbon dioxide, hydrocarbons and their mixtures were considered and the heat transfer correlations were proposed. (4) Due to high oil prices, energy consumption have been attentioned in mechanical building systems. Research works have been reviewed in this field by grouping into the research on heat and cold sources, air conditioning and cleaning research, ventilation and fire research including tunnel ventilation, and piping system research. The papers involve the promotion of efficient or effective use of energy, which helps to save energy and results in reduced environmental pollution and operating cost. (5) Studies on indoor air quality took a great portion in the field of building environments. Various other subjects such as indoor thermal comfort were also investigated through computer simulation, case study, and field experiment. Studies on energy include not only optimization study and economic analysis of building equipments but also usability of renewable energy in geothermal and solar systems.