• Applied Chemistry for Engineering
• /
• v.19 no.6
• /
• pp.690-692
• /
• 2008

Pure glycerol could be obtained from a biodiesel byproduct by separation processes including neutralization, precipitation, and distillation. The contents of distilled glycerol through the above separation processes were measured and the results were compared according to experimental conditions such as acid concentration and precipitation temperature. Neutralization processes were carried out in the concentration range of 5~37 wt% hydrochloric acid, 5~95 wt% sulfuric acid, and 5~85 wt% phosphoric acid, respectively. Precipitation temperatures in neutralization were controlled in the range of 293~333 K. Higher values of the distilled glycerol content were obtained due to the salt removal in the pretreatment case of neutralization with 10 wt% sulfuric acid and precipitation of 313 K with 85 wt% phosphoric acid, respectively. The variations of acid concentration and precipitation temperature in pretreatment steps affected to some extent glycerol recovery from the biodiesel byproduct.

• Journal of Microbiology and Biotechnology
• /
• v.17 no.6
• /
• pp.1031-1035
• /
• 2007

Prostate specific $antigen-{\alpha}_1-antichymotrypsin$ was detected by a double-enhancement strategy involving the exploitation of both colloidal gold nanoparticles (AuNPs) and precipitation of an insoluble product formed by HRP-biocatalyzed oxidation. The AuNPs were synthesized and conjugated with horse-radish peroxidase-PSA polyclonal antibody by physisorption. Using the protein-colloid for SPR-based detection of the PSPJACT complex showed their enhancement as being consistent with other previous studies with regard to AuNPs enhancement, while the enzyme precipitation using DAB substrate was applied for the first time and greatly amplified the signal. The limit of detection was found at as low as 0.027 ng/ml of the PSA/ACT complex (or 300 fM), which is much higher than that of previous reports. This study indicates another way to enhance SPR measurement, and it is generally applicable to other SPR-based immunoassays.

• Bulletin of the Korean Chemical Society
• /
• v.35 no.11
• /
• pp.3239-3243
• /
• 2014

We have developed a simple method for tuning the morphologies of $Cu_2O$ microcrystals. $Cu_2O$ microcrystals were prepared by precipitation at room temperature from a mixture of $Cu(CH_3COO)_2{\cdot}H_2O$, N,N,N',N'-tetramethyl ethylenediamine (TMEDA), ascorbic acid, and polyethylene glycol (PEG). TMEDA was used to promote the formation of copper-TMEDA complexes. A variety of $Cu_2O$ microcrystal morphologies were obtained simply by varying the concentrations of TMEDA and ascorbic acid. Aggregated $Cu_2O$ microspheres are formed at higher concentrations of ascorbic acid in the absence of TMEDA. Aggregated $Cu_2O$ microcubes are formed at lower concentrations of ascorbic acid and higher concentrations of TMEDA. The crystal growth mechanism of these $Cu_2O$ morphologies is explained.

• Journal of Pharmaceutical Investigation
• /
• v.6 no.2
• /
• pp.95-100
• /
• 1976

A study on the effect of the pH of precipitation on the acid consuming capacity, aging stability, physical and chemical properties of hydrous aluminum oxide prepared by the reaction of aluminum chloride and ammonium hydroxide solution was carried out by means of X-ray diffraction, IR spectra and differential thermal analysis. The results from these experiments are as follows: 1. Hydrous aluminum oxide precipitated at lower pH showed better acid consuming capacity, higher stability and more anion contained in the structure than that prepared at higher pH. 2. The hydrous aluminum oxide prepared at lower pH is amorphous and that prepared at higher pH is crystalline hydrated hydrous aluminum oxide, i.e., Bayerite and these results are conformed to Rhee's hypothesis. 3. The rate of loss of reactivity and the end-point reactivity are related to the pH of precipitation.

• Korean Chemical Engineering Research
• /
• v.53 no.6
• /
• pp.831-835
• /
• 2015

This study evaluated the influence of the zeta potential of silica-alumina on the behavior in terms of purity, yield, and precipitate shape and size of fractional precipitation in the fractional precipitation process for the purification of (+)-dihydromyricetin. The optimal silica-alumina amount (surface area per working volume of reacting solution) for zeta potential control was $100mm^{-1}$. As the zeta potential value of silica-alumina increased, (+)-dihydromyricetin yield and precipitate size were increased. The use of silica with the highest value of the zeta potential (+4.99 mV) as a zeta potential-controlling material increased the (+)-dihydromyricetin yield by 2-fold compared with that of the use of alumina with the lowest value of the zeta potential (-19.00 mV). In addition, the (+)-dihydromyricetin yield and precipitate size was inversely correlated with the absolute value of the zeta potential. On the other hand, the purity of (+)-dihydromyricetin had almost no effect on changes in the zeta potential of silica-alumina.

• Journal of Korean Society on Water Environment
• /
• v.22 no.1
• /
• pp.51-58
• /
• 2006

The effluent limitations for individual industry based on the best available technology economically achievable (BAT) have been required to achieve effective regulation. BAT assessment criteria that are suitable for the circumstances of Korean industry were developed in the previous study. The criteria were applied to determine the BAT for leather tanning and finishing industry. For the evaluation BAT, a subcategorization for the industry considering wastewater characteristics, source equipments, raw material and so on should be suggested. Three subcategories: A) Unharing, Chrome Tan, Retan-Wet Finish, B) Chrome Tan, Retan-Wet Finish, and C) Furskins were proposed in this study. Wastewater discharged from the each category contains high concentration of COD, chrome, nitrogen and sulfide. In particular, the concentration of nitrogen from the subcategory A is significantly greater. Twenty sites were surveyed and wastewater qualities were analyzed. Therefore, six different technologies were applied to the subcategory A for the end-of-pipe treatment technology, and a technology was used in the subcategory B and C, respectively. The technology candidates were evaluated in terms of environmental impacts, economically achievability, treatment performance and economical reasonability. As the result, the technology options for each subcategories: A) primary chemical precipitation + modified Ludzack-Ettinger process (MLE) + secondary chemical precipitation, B) chemical precipitation + typical activated-sludge process + Fenton oxidation, C) chemical precipitation + typical activated-sludge process + batch Fenton oxidation or batch activated carbon treatment were selected as the BAT, respectively.

• Proceedings of the KSEEG Conference
• /
• 2002.04a
• /
• pp.59-61
• /
• 2002

• Korean Chemical Engineering Research
• /
• v.46 no.5
• /
• pp.868-874
• /
• 2008

The Ni based adsorbent was prepared by co-precipitation method and its performance for removing carbon monoxide was investigated. Here, silica, aluminium silicate and ${\gamma}$-alumina were used for carriers of catalyst. $Ni(NO_3)_2{\cdot}6H_2O$ and $Ni(CH_3COO)_2{\cdot}4H_2O$ were utilized for Ni precursors. Precipitants were urea and citric acid. After precipitation of Ni salt on the carrier and following reduction using $H_2$ gas, adsorbent was prepared and its performance was analyzed based on EDS, TPR and XRD experiments. In accordance with change of precipitation agents, Ni salts on carrier, carriers and reduction condition. Adsorbent performance for removing carbon monoxide was investigated. The adsorbent with 54.8 wt% Ni prepared using urea precipitant under reduction condition at $500^{\circ}C$ for 3 h exhibited the best CO removal performance.

• Macromolecular Research
• /
• v.17 no.5
• /
• pp.339-345
• /
• 2009

The core/shell type structure of the highly crosslinked poly(glycidylmetharylate-co-divinylbenzene) microspheres prepared in the precipitation polymerization in acetonitrile was thoroughly verified by means of swelling, $^1H$ NMR, XPS, TEM and TGA measurements. In the XPS measurement, the higher the GMA content, the higher the oxygen content was observed, implying that the higher content of GMA is observed in the particle surface. The further verification of the core/shell structure of the poly(GMA-co-DVB) particles was carried out using $^1H$ NMR and TEM techniques, resulting in the poly(GMA-co-DVB) particles with the GMA rich-phase and DVB rich-phase. In overall, the poly(GMA-co-DVB) microspheres consist of a highly crosslinked DVB rich-phase in the core and slightly or non-crosslinked GMA rich-phase in the shell part due to the different reaction ratios between two monomers and self-crosslinking density of DVB.

• Journal of Environmental Science International
• /
• v.7 no.2
• /
• pp.157-164
• /
• 1998

preliminary study on the chemical compositions of forty seven precipitations from March 1994 to May 1995 In Yeoncheon-gun, which Is adjacent to the southern boundary of demilitarized zone (DMZ) in the northernmost tip of Kyunggi Province has been Performed. The metal cation and anion concentrations were measured by atomic absorption spectrometer and ion chromatography, respectively. pH/lon meter and direct nesslerization method were used for the concentration measurements of $H^+$ ion and $NH_46+$ ions, respectively Based on the data, the quantitative orders of the cation and anion average concentrations were $Ca^{2+}>NH_4^+>Na^+>K^+>Mg^{2+}>H^+ and SO_4^{2+}>Cl^-> NO_3^-$, respectively..The ratio of average total anion concentration to average total cation concentration was 0.97. The average pH value of the precipitations was 5.60. These results, correlation coefficients between the ion concentrations, and monthly variations of pH value and precipitation amount are used for chemical analysis on the environmental Pollution and Pollutant sources In Yeoncheon-gun of Kyunggi province near DMZ.