• 한국생물공학회:학술대회논문집
• /
• 2002.04a
• /
• pp.515-518
• /
• 2002

The method of foam fractionation can be applied to enrich proteins from a dilute protein solution if the proteins are hydrophobic and foam. If a protein, such as invertase, is hydrophilic, a dilute solution containing this protein may not foam. In that case, a batch foam fractionation process may not be appropriate for recovering a concentrated solution of that protein. In this paper, various concentrations of invertase were added to a dilute solution containing bromelain (a hydrophobic protein), in order to determine how the presence of a hydrophilic protein can affect the recovery of the desired hydrophobic protein. The effect of invertase on bromelain recovery was studied here at an initial bulk solution pH of 5 and an air superficial velocity of 4.6 cm/s.

• Journal of the Korean Society of Mineral and Energy Resources Engineers
• /
• v.55 no.6
• /
• pp.660-669
• /
• 2018

Enhanced oil recovery (EOR) is a method used to improve the recovery factor of remaining hydrocarbon in reservoir. Polymer and surfactant EOR techniques have limitations depending on reservoir or production conditions (temperature, salinity, etc.) because the polymer and surfactant are highly affected by the reservoir conditions. In this study, analysis of the current improvements to chemical substances and application technologies was performed based on recent research data. Conventional polymer is readily degraded by the conditions of high temperature and high salinity. Therefore, new polymers and injection techniques have been developed to remediate such problems. In addition, surfactant applicable to shale and carbonate reservoirs is developed as petroleum recovery expands to unconventional reservoirs. However, these chemical substances are not widely used in the current oil fields due to high costs. Therefore, further studies must be conducted to reduce the cost and thus increase the effectiveness of EOR techniques.

• Journal of Powder Materials
• /
• v.25 no.3
• /
• pp.232-239
• /
• 2018

In this paper, the recovery and nanoparticle synthesis of Ag from low temperature co-fired ceramic (LTCC) by-products are studied. The effect of reaction behavior on Ag leaching conditions from the LTCC by-products is confirmed. The optimum leaching conditions are determined to be: 5 M $HNO_3$, a reaction temperature of $75^{\circ}C$, and a pulp density of 50 g/L at 60 min. For the selective recovery of Ag, the [Cl]/[Ag] equivalence ratio experiment is performed using added HCl; most of the Ag (more than 99%) is recovered. The XRD and MP-AES results confirm that the powder is AgCl and that impurities are at less than 1%. Ag nanoparticles are synthesized using a chemical reduction process for recycling, $NaBH_4$ and PVP are used as reducing agents and dispersion stabilizers. UV-vis and FE-SEM results show that AgCl powder is precipitated and that Ag nanoparticles are synthesized. Ag nanoparticles of 100% Ag are obtained under the chemical reaction conditions.

• Biotechnology and Bioprocess Engineering:BBE
• /
• v.6 no.6
• /
• pp.419-425
• /
• 2001

A dense pellicular solid matrix has been fabricated by coating 4% agarose gel on to dense zironia-silica(ZS) spheres by watr-in-oil emulsification . The agarose evenly laminated the ZS bead to a depth of 30㎛, and the resultin gpellicular assembly was characterised by densities up to 2.39g/mL and a mean particle dimeter of 136 ㎛. In comparative fluidisation tests, the pellicular solid phase exhibited a two-fold greater flow velocity than commercial benchmark ad-sorbents necessary to achieve common values of bed expansion. Furthermore, the perlicular parti-cles were characterised by improved qualities of chromatographic behaviour, particularly with re-spect to a three-fold increase in the apparent effective diffusivity of lysozyme within a pellicular assembly modified with Cibacron Blue 3GA. The properties of rapid protein adsorption/desorp-tion were attributed to the physical design and pellicular deployment of the reactive surface in the solid phase. When combined with enhanced feedstock throughput, such practical advantages recommend the pellicular assembly as a base matrix for the selective recovery of protein products from complex, particulate feedstocks(whole fermentation broths, cell disruptates and biological extracts).

• Korean Journal of Chemical Engineering
• /
• v.35 no.12
• /
• pp.2413-2420
• /
• 2018

Sida acuta, a common type of weed in Thailand, contains relatively high cellulose (42.7%) content. We pretreated NaOH to improve glucose recovery from S. acuta. The effect of pretreatment temperature and NaOH concentration was fundamentally investigated based on hydrolysis efficiency with recovery of solid fraction. The pretreatment condition was determined to be 3% NaOH at $60^{\circ}C$ for 9 h, which showed the highest glucose recovery. The hydrolysates obtained by enzymatic hydrolysis of S. acuta were applied to the fermentation of Saccharomyces cerevisiae K35, and a theoretical yield of 97.6% was achieved at 18 h. This indicated that the hydrolysates medium without detoxification had no negative effects on the fermentation. The production of biomass into bioethanol was evaluated based on the material balance of 1,000 g basis. Following this estimation, approximately 28 g and 110 g bioethanol could be produced by untreated and pretreated S. acuta, respectively, and this production was improved about 3.9-fold by NaOH pretreatment. These results again show the importance of pretreatment in biorefinery process.

• Korean Journal of Environmental Biology
• /
• v.23 no.4
• /
• pp.390-397
• /
• 2005

The inhibition of cell recovery might be proceeded via either the damage of the mechanism of the recovery itself or via the formation of irreversible damage which could not be repaired at all. Both these processes may take place at the same time. Any of these possibilities would result in a decrease in both the rate and extent of cell recovery. To distinguish them, a quantitative approach describing the process of recovery as a decrease in the effective radiation dose was applied to experimental data on the recovery from potentially lethal damage in Chinese hamster cells exposed to X-rays alone or combined with various chemicals (pyruvate, novobiocin, lactate, nalidixic acid, 3-aminobenzamide). For these particular cases, it is concluded that the recovery process itself is not damaged and the inhibition of the recovery is entirely due to the enhanced yield of the irreversibly damaged cells.

• Korean Chemical Engineering Research
• /
• v.60 no.4
• /
• pp.473-477
• /
• 2022

In this study, candidate technologies for lithium recovery from the process waste liquid generated in the waste battery recycling process were reviewed, and technologies applicable to the process from the commercialization point of view were reviewed from a qualitative point of view. The evaporation method is difficult to apply because it requires a large-scale land and shows a low recovery rate due to the loss of Li during the concentration process. In the case of precipitation, a commercially available technology shows a high recovery rate due to the high Li/Na selectivity of phosphoric acid, but there are disadvantages in that the process is complicated due to the use of expensive phosphoric acid, requiring a recovery step, and continuous operation is impossible because solids are handled in the Li concentration process. In the case of solvent extraction, if we find an inexpensive extractant with high Li/Na selectivity, continuous operation is possible with the method used in extraction of other metals in the previous step, and when Li is concentrated, continuous operation is possible because it is in a liquid state. If it shows a similar recovery rate compared to precipitation technology, commercialization will be the most likely.

• Bulletin of the Korean Chemical Society
• /
• v.29 no.9
• /
• pp.1787-1789
• /
• 2008

• Journal of the Korean Institute of Gas
• /
• v.16 no.3
• /
• pp.35-41
• /
• 2012

Manifold researches for carbon capture and storage (CCS) have been developed and large scale-carbon capture system can be performed recently. Hence, the technologies for $CO_2$ sequestration or storage become necessary to handle the captured $CO_2$. Among them, enhanced oil recovery using $CO_2$ can be a solution since it guarantees both oil recovery and $CO_2$ sequestration. In this study, the miscible flow of oil and $CO_2$ in porous media is modeled to analyze the effect of enhanced oil recovery and $CO_2$ sequestration. Based on Darcy-Muskat law, the equation is modified to consider miscibility of oil and $CO_2$ and the change of viscosity. Finite volume method is used for numerical modeling. As results, the pressure and oil saturation changes with time can be predicted when oil, water, and $CO_2$ are injected, respectively, and $CO_2$ injection is more efficient than water injection for oil recovery.

• Journal of Industrial and Engineering Chemistry
• /
• v.67
• /
• pp.210-218
• /
• 2018

Ethylenediaminetetraacetic acid (EDTA)-functionalized KIT-6 and KCC-1 mesoporous silicas were prepared via post-synthesis grafting and examined for their ability to promote the recovery of rare earth metal ions such as $Nd^{3+}$ from an aqueous medium. The obtained adsorption isotherms were fitted to the Langmuir model, which gave a maximum adsorption of $Nd^{3+}$ ions of 109.8 and 96.5 mg/g for KIT-6-EDTA and KCC-1-EDTA, respectively, at $25^{\circ}C$ and pH 6. The adsorption kinetic profile of KIT-6 was faster than KCC-1. KIT-6 was also proved to be more stable against desorption under acidic regeneration conditions.