• 한국수산과학회지
• /
• 제9권1호
• /
• pp.74-78
• /
• 1976

연료분사시기와 회전속도를 일정하게 했을때 3종류의 연료를 사용하여 압축비와 기관의 성능관계를 조사한 결과 다음과 같은 것이 밝혀졌다. 1. 4 cycle디젤기관의 압축비는 기관마력과 연료소자율과의 관계에서 A, B, C 3종류의 연료에 대해 각각 16, 18, 19의 최적압축비가 존재했으며, 이보다 압축비를 높이면 오히려 기관성능이 저하하고 최대출력도 감소한다. 2. 매시공급열량을 일정하게 했을때 연료 A, B에 대해서 16, 18의 최적압축비가 존재했으며 연료 C에 대해서는 정할수 없었다. 따라서 저 cetane number의 연료에서는 출력에 관계없이 가장 좋은 압축비는 결정할 수 없었다. 3. 발화지연은 압축비가 높을 수록 작았고, 감소율은 압축비가 클수록 작았다.

• 대한기계학회논문집B
• /
• 제34권12호
• /
• pp.1121-1126
• /
• 2010

1.9L 커먼레일 직접분사 디젤 엔진을 이용하여 1500rpm 2.6bar BMEP 에서 다량의 EGR (약 41%)과 연료분사 제어를 통한 저온디젤연소 영역에서 연료의 특성이 연소와 배기가스에 미치는 영향을 분석하 였다. 사용한 연료는 세탄가 30 에 대하여 방향족 성분 (20%: A20, 45%: A45)과 T90 온도($270^{\circ}C$: T270, $340^{\circ}C$: T340)의 조합으로 네 개이다. 주어진 엔진 운전 영역에서 실험계획법을 이용하여 방향족 성분 및 T90 온도에 따른 연소 및 배기가스에 미치는 영향을 분석하였다. 착화지연 기간은 T90 온도가 지배적인 인자로 T90 온도 증가에 따라 착화지연 기간도 증가하였다. 저세탄가에 의한 착화지연 기간의 증가로 네 가지 연료 모두 PM 배출은 거의 없었다. NOx 배출은 방향족 성분이 지배적인 인자로 방향족 성분증가에 따라 NOx 배출이 증가하였다.

• 한국자동차공학회논문집
• /
• 제19권6호
• /
• pp.17-22
• /
• 2011

This study is to investigate the effect of the cetane number in ultra low sulfur diesel fuel on combustion characteristics and exhaust emissions at 1500 rpm and 2.6bar BMEP in low-temperature diesel combustion with 1.9L common rail direct injection diesel engine. Low-temperature diesel combustion was achieved by adopting external high EGR rate with the strategic injection control without modification of engine components. Test fuels are ultra low sulfur diesel fuel (sulfur less than 12 ppm) with two cetane numbers (CN), i.e., CN30 and CN55. For the CN30 fuel, as a start of injection (SOI) timing is retarded, the duration of an ignition delay was decreased while still longer than $20^{\circ}CA$ for all the SOI timings. In the meanwhile, the CN55 fuel showed that an ignition delay was monotonically extended as an SOI timing is retarded but much shorter than that of the CN30 fuel. The duration of combustion for both fuels was increased as an SOI timing is retarded. For the SOI timing for the minimum BSFC, the CN30 produced nearly zero PM much less than the CN55, while keeping the level of NOx and the fuel consumption similar to the CN55 fuel. However, the CN30 produced more THC and CO than the CN55 fuel, which may come from the longer ignition delay of CN30 to make fuel and air over-mixed.

• Bulletin of the Korean Chemical Society
• /
• 제32권6호
• /
• pp.1965-1969
• /
• 2011

1,2,4,5-tetraoxane, mono and dinitrate glycerol carbonate ester derivatives of stearic acid were synthesized along with the known 9(10)-keto methyl sterate, methoxy mono-nitrate and dinitrate of methyl stearate. Their cetane numbers (CNs) were investigated to evaluate their viability for use as CN improvers. The CN performances of tetraoxane and all of the nitrate derivatives were investigated at 500 and 1000 ppm concentrations and compared to that of a traditional CN improver 2-ethylhexyl nitrate (2-EHN). The experimental results suggest that all derivatives evaluated in this study showed better CN improvement than base diesel fuel. Specifically, the 1,2,4,5-tetraoxane derivative of stearic methyl ester was superior to all derivatives studied, also being superior to 2-EHN. We also discussed the correlations between the observed CN trends and thermo-analytical data resulted from thermo gravimetric analysis curves (TGA) and differential scanning calorimetry (DSC).

• 한국자동차공학회논문집
• /
• 제25권3호
• /
• pp.380-388
• /
• 2017

Wood pyrolysis oil(WPO) has been regarded as an alternative fuel for diesel engines. However, WPO is not feasible for use directly in diesel engines due to its poor fuel quality such as low energy density, high acidity, high viscosity and low cetane number. The most widely used approach to improve WPO fuel quality is to blend WPO with other hydrocarbon fuels that have a higher cetane number. However, WPO and fossil fuels are not usually blended because of their different polarity. Also, clogging and polymerization problems in the fuel supply system can occur when the engine is operated with WPO. Polymerization can be prevented by diluting WPO with other alcohol fuels. However, WPO-alcohol blended fuel does not produce self-ignition. Therefore, additional cetane enhancement to the blended fuel is required to enhance auto-ignitability. In this study, WPO was blended with n-butanol and two cetane enhancements(PEG 400 and 2-EHN) for application to a diesel generator. Experimental results showed that the WPO-butanol blended fuel achieved a very stable engine operation under maximum WPO content of 20 wt%.

• 대한기계학회논문집B
• /
• 제35권4호
• /
• pp.371-377
• /
• 2011

1.9L 커먼레일 직접분사 디젤 엔진을 이용하여 1500rpm 2.6bar BMEP 에서 다량의 EGR(약 41%)과 연료분사 제어를 통한 저온디젤연소 영역에서 연료의 특성이 연소와 배기가스에 미치는 영향을 분석하였다. 사용한 연료는 세탄가 55 에 대하여 방향족 성분(20%, 45%, vol. %)과 T90 온도($270^{\circ}C$, $340^{\circ}C$)의 조합으로 네 개이다. 주어진 실험 조건에서 모든 연료에 대하여 착화지연 기간이 증가함에 따라 PM 은 단조적으로 저감되었다. 동일한 착화지연 기간에 대하여 T90 온도가 높은 연료들의 PM 발생이 높았다. NOx 는 동일한 MFB50% 위치에서 모든 연료가 동등 수준이었다. THC, CO 발생은 연료 조성에 관계없이 동일한 착화지연 기간에 대하여 동등 수준이었다. 또한 착화지연 기간 증가에 따라 THC, CO 배출이 증가하였는데 이는 과혼합 증가가 주 원인으로 판단된다.

• Tribology and Lubricants
• /
• 제36권6호
• /
• pp.385-390
• /
• 2020

It rains heavily, such as long rain and typhoons, during a typical rainy season in Korea. In this season, several fuel contamination accidents by water and vehicular problems caused by water contaminated fuel occur. Many research groups have studied the effects of water contaminated fuel on vehicles and environment. However the characteristics of water contaminated fuel have not been studied. In this study, we prepared diesel samples with a constant ratio of water (0~30 volume %) using an emulsifier. Then, we analyzed these diesel samples for their representative fuel properties. In the analytical results, diesel with 30% water showed an increase in fuel properties such as density (823→883 kg/㎥), kinematic viscosity (2.601→6.345 ㎟/s), flash point (47→56℃), pour point (-22→2℃), CFPP (cold filter plugging point) (-17→20℃) and copper corrosion number (1a→2a). The low temperature characteristics, such as low pour point and CFPP, blocks the fuel filter in the cold season. In addition, water contaminated diesel decreases lubricity (190→410 ㎛) under high frequency reciprocating rig (HFRR) and derived cetane number (54.81→34.25). The low lubricity of fuel causes vehicle problem such as pump and injector damage owing to severe friction. In addition, the low cetane diesel fuel increases exhaust gases such as NOx and particulate matters (PM) owing to incomplete combustion. This study can be used to identify the problems caused by water contamination to vehicle and fuel facilities.

• 한국분무공학회지
• /
• 제18권4호
• /
• pp.188-195
• /
• 2013

An investigation on spray characteristics of fuels which diesel and di-methyl ether (DME) with change of injection pressure used the multi-injection in constant volume combustion chamber (CVCC). Diesel was already used famous fuel which we could use. DME showed similar features with diesel like as cetane number, auto-ignition temperature. High cetane number of diesel and DME could make possible to compression ignition. DME showed different atomization from diesel due to evaporating pressures and boiling points. Experiments were carried out in CVCC equipped with Delphi solenoid 6-hole type injector and the spray characteristics of diesel and DME were tested the various pre and pilot injection. Terms of injections and a number of injections in multi-injection has been controlled. Experiments were performed in 2 types that 1500 rpm, 2000 rpm and under the condition of injection ranging from 100 bar to 500 bar. From the results of this experiment diesel showed longer spray penetration than DME. That result showed different of atomization speed DME and diesel. Result of high injection pressure condition showed similar spray characteristics diesel and DME. After this investigation, new conditions and experiments using laser light to go forward and add the fuels like as the biodiesel and diesel and DME blend.

• 한국자동차공학회논문집
• /
• 제19권4호
• /
• pp.72-77
• /
• 2011

This study is to investigate the effect of the distillation temperature in ultra low sulfur diesel fuel on exhaust emissions in the low-temperature diesel combustion with 1.9L common rail direct injection diesel engine. Low temperature diesel combustion was achieved by adopting an external high EGR rate with a strategic injection control. The engine was operated at 1500 rpm 2.6 bar BMEP. The 90% distillation recovery temperature (T90) was $270^{\circ}C$ and $340^{\circ}C$ for the respective cetane number (CN) 30 and 55. It was found that there exists no distinctive discrepancy on exhaust emissions with regards to the different T90s. The high CN (CN55) fuels follow the similar trend of exhaust emissions as observed in CN30 fuels' except that high T90 fuel (CN55-T340) produced higher PM compared to low T90 fuel (CN55-T270). This may come from that high T90 plays an active role in aggravating the degree of fuel-air mixture preparedness before ignition.

• 한국자동차공학회논문집
• /
• 제19권3호
• /
• pp.106-112
• /
• 2011

This study is to investigate the effect of an aromatic content in high cetane number (CN) fuels on exhaust emissions under low temperature diesel combustion, which expands the previous research about an aromatic content in low CN fuels. A 1.9L common rail direct injection diesel engine was run at 1500 rpm 2.6 bar BMEP with four fuel sets: an aromatic content of 20% (A20) or 45% (A45) with CN30, i.e. low CN fuels, and CN55, i.e. high CN fuels. Given experimental conditions, the trend of exhaust emissions in high CN fuels was inconsistent with that of low CN fuels which all produced nearly zero smoke but higher NOx for the high aromatic fuel (CN30-A45). For high CN fuels, however, the low aromatic fuel (CN55-A20) produced lower smoke than the high one (CN55-A45) while NOx was similar to each other. The cause of this discrepancy between high CN and low CN fuels is unclear whether it comes from that CN may be a dominant factor to govern exhaust emissions rather than an aromatic content or that the actual CN value of CN55-A45 is lower than CN55-A20. More decent fuel matrix should be prepared and further experiments are needed to confirm it.