• Proceedings of the Korea Institute of Fire Science and Engineering Conference
• /
• 2011.11a
• /
• pp.397-400
• /
• 2011

건축외장용 접착제 중 일반적으로 사용되는 접착제를 용도별로 선정하였으며, 접착제의 종류는 스티로폼용, 목공용, 석재용, 타일용, 창호전용 등 총 5가지이다. 본 연구에서는 건축외장용 접착제를 대상으로 콘칼로리미터를 이용하여 발열특성을 알아보았다. 실험 조건은 ISO 5660 규격에 맞춰 각각의 접착제를 100 mm${\times}$100 mm 크기의 성형틀에 굳힌 다음 복사열 50 $kW/m^2$의 조건으로 실험을 실시하였다. 건축외장용 접착제의 연소특성을 정량적으로 나타낸 연구결과는 각각의 화재위험 정도를 분류하는 기초자료로 활용하는데 의의를 두었다.

• Proceedings of the Korea Institute of Fire Science and Engineering Conference
• /
• 2011.11a
• /
• pp.486-489
• /
• 2011

건축물 내 외벽에 주로 사용되는 건축용 자재 중 샌드위치 패널은 양면으로 도장한 철판 사이에 심재로 단열재를 넣어 구성된 합성복합자재이다. 샌드위치 패널의 사용범위는 창고시설 및 공업용 건축 등의 용도로 많이 사용되고 있으며, 최근에는 시공에 따른 이점으로 주택 및 상업용등으로 널리 확대되어 사용되고 있다. 본 연구에서는 화재초기의 연기밀도는 인명 대피 시 시야확보에 있어 중요한 역할을 하기에 현재 국내에서 사용되는 건축용 외장재를 용도별로 선정하여 시간에 따른 연기밀도의 값을 구하고 용도에 따른 화재 연기의 확산 정도를 예측하는데 목적을 두었다.

• Fire Science and Engineering
• /
• v.32 no.4
• /
• pp.86-94
• /
• 2018

A sports center fire in Jecheon caused 29 deaths and 40 injuries. This study focused only on the structural factors of the building and equipment to investigate the causes of casualties based on the fire investigation results at the sports center. The structural factors of the building and equipment were a piloti-type parking lot, lack of a fire compartment between the piloti-type parking lot and lobby, lack of an installed sprinkler system, lack of an installed fire door in the main stairs on the $1^{st}$ floor, lack of an installed fire water tank on the rooftop, an installed pocket fire door in the main entrance on the $2^{nd}$ floor, poor fire compartments in an EPS space and a pipe pit and on each floor, a leak in the joint of a drain pipe, plywood installed in the hoistway of the freight elevator and interior wall, illegal remodeling of a closed rooftop structure, which cannot discharge smoke and heat, installed styrofoam insulation in the inside of the parking lot ceiling, an installed tempered glass window, which cannot be opened in the ladies bathroom on the $2^{nd}$ floor, and a finished dryvit exterior wall.

• Journal of the Korea Safety Management & Science
• /
• v.26 no.1
• /
• pp.91-97
• /
• 2024

When a fire breaks out in a distribution center, it causes a lot of damage. And the most casualties are caused by Fire accidents. Therefore, training for fire prevention should be mandatory at the distribution center. Also, the contents of education should be different in room temperature warehouses and low temperature warehouses. Fire education in low-temperature warehouses should be more emphasized. This is because many fires occur in low-temperature warehouses. In this study, a study was conducted to determine the important order of training hours and contents for fire prevention education according to the type of distribution center. The importance of time and content for safety education in all types of warehouses did not differ significantly. It was first decided that safety prevention training should be conducted periodically in all types of warehouses

• Journal of Sensor Science and Technology
• /
• v.25 no.6
• /
• pp.394-398
• /
• 2016

In this paper, a fire detection system based on quantitative risk estimation is presented. Multiple sensors are used to build a comprehensive indicator that represents the risk of fire quantitatively. The proposed fire risk estimation method consists of two stages which determines the occurrence of fire and estimates the toxicity of the surveillance area. In the first stage, fire is reliably detected under diverse fire scenarios. The risk of fire is estimated in the second stage. Applying Purser's Fractional Effective Dose (FED) model which quantitates harmfulness of toxic gases, the risk of the surveillance area and evacuation time are calculated. A fire experiment conducted using four different types of combustion materials for the verification of the system resulted in a maximum error rate of 12.5%. By using FED calculation and risk estimation methods, the proposed system can detect various signs of fire faster than conventional systems.

• Journal of the Korean Society of Safety
• /
• v.35 no.4
• /
• pp.32-39
• /
• 2020

The fire compartments with fire-resistant construction are installed in the principal structural parts of a building in order to reduce damage in the event of a building fire. As a fire may spread through a crack in the fire compartment, the firestop with secured performance is used according to the procedure, methods, and standards specified in the detailed operation guideline. According to the current detailed operation guideline, vertical members (wall penetration) and horizontal members (floor penetration) are classified into different categories respective to each other for the classification of the firestop. Therefore, an accreditation applicant must apply for the performance test for each structure even if the wall and the floor have the same structure. Also, Grade T is used for the firestop that penetrates the fire compartment. However, in the case of foreign countries, the use of Grade F for the firestop is allowed even if it penetrates the fire compartment. The result of the precedent studies also showed that there was a significantly low possibility of fire to spread even if Grade F was applied for a metallic duct that penetrated the fire compartment. In this study, the improved scheme for the classification and performance standard of firestops was presented by analyzing the results of precedent studies regarding the firestop and domestic and overseas firestop qualification systems.

• Proceedings of the Korea Institute of Fire Science and Engineering Conference
• /
• 2005.11a
• /
• pp.21-34
• /
• 2005

• Journal of the Korean Society of Safety
• /
• v.19 no.1
• /
• pp.18-22
• /
• 2004

The Fire Dynamics Simulator (FDS) was applied to a center fire in a room, of which dimensions were 1.8m${\times}$1.38m with an opening of 0.45m${\times}$1.2m doorway, to evaluate the numerical method. The time-variation of temperature at a top point of thedoorway centerline and distributions of evaluate the numerical method. The time-variation of temperature at a top point of the doorway centerline and distributions of average temperature along the doorway centerline and corner stack were compared with measurements for three different fire sizes, 7.65, 21.25 and 51.71kW. The results showed FDS predicted a very rapid fire growth compared with the experiment for all the three fire sizes, that is an importand shortcoming of FDS in compartment fire simulations. The average temperature distributions, and heights of hot gas layers and neutral planes in steady state were in reasonable agreement with the measurements.

• Journal of Mechanical Science and Technology
• /
• v.16 no.11
• /
• pp.1485-1496
• /
• 2002

In order to investigate the fire-induced smoke movement in a three-dimensional room with an open door, numerical and experimental study was performed. The center, wall, and corner fire plumes for various sized fires were studied experimentally in a rectangular pool fire using methanol as a fuel. The numerical results from a self-developed SMEP (Smoke Movement Estimating Program) field model were compared with experimental results obtained in this and from literature. Comparisons of SMEP and experimental results have shown reasonable agreement. As the fire strength became larger for the center fires, the air mass flow rate in the door, average hot layer temperature, flame angle and mean flame height were observed to increase but the doorway-neutral-planeheight and the steady-state time were observed to decrease. Also as the wall effect became larger in room fires, the hot layer temperature, mean flame height, doorway-neutral-planeheight and steady-state time were observed to increase. In the egress point of view considering the smoke filling time and the early spread of plume in the room space, the results of the center fire appeared to be more dangerous as compared with the wall and the corner fire. Thus it is necessary to consider the wall effect as an important factor in designing efficient fire protection systems.

• Journal of Acupuncture Research
• /
• v.30 no.3
• /
• pp.87-99
• /
• 2013

Objectives : The objective of this study is to find out the method and effects of fire needling on frozen shoulder in China. Methods : We searched journals using the China National Knowledge Infrastructure(CNKI) and PubMed. The keywords were a combination of "fire needling", "fire needle", "burning acupuncture", "frozen shoulder", "adhesive capsulitis", "periarthritis". Results : There were 23 studies finally selected, 7 were case control studies and 16 were case series studies. There were 9 out of 14 main meridians and 31 kinds of acupoints. The most frequently adopted meridians were LI, SI and TE. The most frequently used acupoints were $LI_{15}$, $SI_9$ and $TE_{14}$. Adjacent points were used more often than distant points. They usually heated the needle before insertion and needle retention was mostly not done. 7 case control studies showed that fire needling reported better results than the filiform needle or electro-acupuncture treatment. 15 case series studies reported a significant improvement in fire needling on frozen shoulder patients. Conclusions : There have been many studies regarding fire needling on frozen shoulder in China. Further studies should be required and these can be applied to clinical practices in Korea.