• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.34 no.5
• /
• pp.1477-1488
• /
• 2014

Prevalent construction of impermeable pavements in urban areas causes diverse water-related environmental issues, such as lowering ground water levels and shortage of water supply for the living. In order to resolve such problems, a rainwater reservoir can be an effective and useful solution. The rainwater reservoir facilitates the hydrologic cycle in urban areas by temporarily retaining precipitation-runoff within a shallow subsurface layer for later use in a dry season. However, in order to use the stored water of precipitation-runoff, non-point source pollutants mostly retained in initial rainfall should be removed before being stored in the reservoir. Therefore, the purification system to filter out the non-point source pollutants is essential for the rainwater reservoir. The conventional soil filtration technology is well known to be able to capture non-point source pollutants in a economical and efficient way. This study adopted a sand filter layer (SFL) as a non-point source pollutant removal system in the rainwater reservoir, and conducted a series of lab-scale chamber tests and field tests to evaluate the pollutant removal efficiency and applicability of SFL. During the laboratory chamber experiments, three types of SFL with the different grain size characteristics were compared in the chamber with a dimension of $20cm{\times}30cm{\times}60cm$. To evaluate performance of the reservoir systems, the concentration of the polluted water in terms of TSS (Total Suspended Solids) and COD (Chemical Oxygen Demand) were measured and compared. In addition, a reduction in hydraulic conductivity of SFL due to pollutant clogging was indirectly estimated. The optimum SFL selected through the laboratory chamber experiments was verified on the in-situ rainwater reservoir for field applicability.

• The Korean Journal of Malacology
• /
• v.30 no.4
• /
• pp.421-428
• /
• 2014

Total 20 surface sediments were collected in Anjung bay to investigate the physicochemical environment and heavy metal contents. The physicochemical investigation ranged from 6.41% to 11.68% (average $9.52{\pm}1.28%$) for ignition loss (IL), from 17.99 mg/g to 43.84 mg/g (average $27.53{\pm}6.39mg/g$) for chemical oxygen demand (COD), and from 0.05 mg/g to 0.61 mg/g (average $0.17{\pm}0.14mg/g$) for acid volatile sulfide (AVS) with significant correlation between water content (W/C) and COD. A contour of spatial distribution indicated higher organic pollution at the bottom of ascidian, Stylea clava, cultural waters. Most of metals contents was not exceeded the NOAA's effect range-low (ERL). Estimated enrichment factor (EF) ranging 0.96-1.12 indicated that the sediment environment of the studied waters was relatively pristine from heavy metal pollution in spite of increased vessel traffics, so far.

• Journal of the Korean Society for Marine Environment & Energy
• /
• v.11 no.2
• /
• pp.63-69
• /
• 2008

As a basic study on the creation of artificial tidal flats using dredged sediments, the pilot-scale artificial tidal flats with 4 different mixing ratio of ocean dredged sediment were constructed in Nakdong river estuary. The phragmites australis was transplanted from the adjacent phragmites australis community after construction, and then the survival and growth rate of the planted phragmites australis were measured. Also the changes of soil chemical oxygen demand (COD), ignition loss (IL), and the heterotrophic microbial numbers were monitored. The survival rate of the planted phragmites australis decreased as the mixing ratio of dredged sediment increased but there was little difference of length and diameter of the shoots. 30% of COD and 9% of IL in the tidal flat with 100% dredged sediment decreased after 202 day, however, fluctuations of COD and IL concentrations were also observed possibly due to the open system. It was suggested that the construction of tidal flats using ocean dredged sediment and biological remediation of contaminated ocean dredged sediment can be possible considering the growth rate of transplanted phragmites australis, decrease of organic matter and increased heterotrophic microbial number in the pilot plant with 100% dredged sediment. However, the continuous monitoring on the vegetation and various environmental factors in the artificial tidal flat should be necessary to evaluate the success of creation of artificial flats using dredged sediments.

• Journal of Korean Society of Environmental Engineers
• /
• v.27 no.7
• /
• pp.777-784
• /
• 2005

The first flush phenomenon is defined as the initial period of road runoff during which the concentration of pollutants was significantly high. Road runoff contains significant loads of micro-particles, heavy metals and organic constituents. There were two major objectives of this study. The first objective was to characterize the road runoff. The second objective was to measure and evaluate particle sire distribution of the road runoff, Stormwater runoff was monitored on two sites of four lane road areas along with traffic volume. A total six storm events were monitored to characterize the road runoff. The quantity of road runoff and quality constituents, including chemical oxygen demand ($COD_{Cr}$), suspended solids(SS), total Kjeldahl nitrogen (TKN), ortho-phosphorus ($PO_4-P$), total phosphorus(TP), heavy metals and particle size distribution were analyzed. The results indicate that the concentration of SS, $COD_{Cr}$, TKN and TP ranges were $45{\sim}2,396\;mg/L$, $40{\sim}931\;mg/L$, $0.1{\sim}19.6\;mg/L$, and $0.2{\sim}25.1\;mg/L$, respectively. The results of the regression analysis between SS and the others constituents shows that $COD_{Cr}$, TP, Cu, Pb were highly correlated. And the results showed that the mean range of particle size and uniformity coefficient for road runoff were $6.7{\sim}23.4{\mu}$ and $6.4{\sim}10.2$, respectively.

• 한국해양학회지
• /
• v.29 no.2
• /
• pp.132-144
• /
• 1994

The relationship of zooplankton communities and distributions of copepods as indicator species to environmental variables, such as temperature, salinity, chemical oxygen demand (COD) and total inorganic nitrogen (TIN) was studied in Pusan Harbor in October 1990 and January, April and July 1991. Zooplankton communities were analysed by using cluster analysis and species diversity index. Four groups of copepods as indicator species were Acrocalanus gacilis, Euchaeta plana, pareuchaeta russell and Pleuromamma gracilis as the oceanic warm water species; Cemtropages abdominalis as the neritic cold water species; Meridian lucens as the oceanic cold water species Acartia omorii as the polluted water species. the offshore waters of Pusan harbor was dominated by the oceanic warm water species in October and by the neritic cold water species in January and April. This area showed the low values of COD and Tin. the inshore waters of Pusan harbor, where the high values of cod And Tin and the low value of diversity were recorder was represented by A.. omorii. Cluster analysis of the zooplankton community revealed two or three regional areas in Pusan harbor. Area I, the offshore area of Pusan harbor, not only was represented high species diversity and low density of A. omorii but also was dominated copepods in zooplankton roups. Areas II and III were grouped horizontally from offshore to inshore of Pusan harbor. Area II was showed intermediate values in diversity, density of A. omorii and percentage composition of copepods. Area III was revealed the lowest diversity,density of A.omorii and percentage composition of Cladocerans.Coperpoda was a dominant zooplankton group in each area during the study periods except two special cases.Area II was dominated by Noctiluca scintillans in April and Area III was occupied by Cladocerans in July.Distribution of Indicator species and areas demarcated based on cluster analysis showed a close relationship with environments.

• Journal of Environmental Health Sciences
• /
• v.22 no.2
• /
• pp.96-103
• /
• 1996

The objectives of this study were to examine the biodegradation of phenol using the anaerobic fluidized bed reactor(AFBR). Mixed microorganisms were selected from the anaerobic digestion tank, and could be adapted to high concentration of phenol by increasing the phenol concentration 600-3600 mg/l step by step. The results were summarized as follows: 1. The average removal efficiency of phenol was 90%, decreased by increasing concentration of phenol, and then a shock range was 1200~2400 ppm. 2. The production rate of biogas in overall limits was proportional to the concentration of influent phenol. 3. At steady state, compositions of gases were $CH_4$ 55~60%, $C0_2$ 34~43%, respectively. These were similar to that of the theoretical estimates. 4. The production rates of biogas and methane per the molarity of phenol removed were linearly increased, 56.45 l gas/mol-phenol and 29.20 l $CH_4/mol$-phenol. Using this biogas, the recoverable energy was 269.1 kcal/mol phenol. It was 120.2 kcal/g-COD, transforming into the chemical oxygen demand. 5. The bulk of microorganisms existed in suspended section of fluidized bed with type of biofilm and its concentration was 340 mg/g-media. In conclusion, the anaerobic treatment of pure phenol was possible and its removal efficiency, introducing the AFBR, was successful. Also toxic organic compound such as phenol was biodegradable and was recoverable as resource of energy.

• Membrane and Water Treatment
• /
• v.5 no.2
• /
• pp.73-86
• /
• 2014

Membrane fouling is a major challenge limiting the use of membrane applications. In this study high induced shear rates were utilized at the membrane surface in order to reduce the organic and inorganic scaling by using the torsional vibration of flat sheet membranes. The performances of a vibratory shear-enhanced processing (VSEP) system for the ultrafiltration (UF), nanofiltration (NF) and reverse osmosis (RO) membrane filtration of industrial dairy wastewater were investigated. The vibration and non-vibration methods were compared with the same membrane and operational parameters during the purification of real dairy industrial process wastewater. In the initial experiments, short-term tests were carried out in which the effects of vibration amplitude, recirculation flow rate and transmembrane pressure were measured and compared. The permeate flux, turbidity, conductivity and chemical oxygen demand (COD) reduction of dairy wastewater were investigated by using UF, NF and RO membranes with vibration and non-vibration methods. In the subsequent experiments, concentration tests were also carried out. Finally, scanning electron microscopy (SEM) revealed that the vibration method gave a better performance, which can be attributed to the higher membrane shear rate, which reduces the concentration of solids at the membrane, and the transmission.

• Biotechnology and Bioprocess Engineering:BBE
• /
• v.6 no.3
• /
• pp.194-199
• /
• 2001

Chlorella kessleri cultivated in artificial wastewater using diurnal illumination of 12h light/12h dark (L/D) cycles. The inoculum density was 10(sup)5 cells/mL and the irradiance in light cycle was 45$\mu$mol㎡s(sup)-1 at the culture surface. As a control culture, another set of flasks was cultivated under continuous illumination. Regardless of the illumination scheme, the total organic carbon (TOC) and chemical oxygen demand (COD) was reduced below 20% of the initial concentration within a day. However, cell concentration under the L/D lighting scheme was lower tan that under the continuous illuminating scheme. Thus the specific removal rate of organic carbon under L/D cycles was higher than that under continuous illumination. This result suggested that C. kessleri grew chemoorganotrophically in the dark periods. After 3 days, nitrate was reduced to 136.5 and 154.1mg NO$_3$-N/L from 168.1mg NO$_3$-N/L under continuous illumination and under diurnal cycles, respectively. These results indicate nitrate removal efficiency under continuous light was better than that under diurnal cycles. High-density algal cultures using optimized photobioreactors with diurnal cycles will save energy and improve organic carbon sources removal.

• Journal of Korean Society on Water Environment
• /
• v.23 no.6
• /
• pp.993-997
• /
• 2007

The upflow anaerobic sludge blanket (UASB) reactor can be effective for treating simple organic compounds containing high concentration of ammonia nitrogen. The chemical oxygen demand (COD) removal efficiency was about 80% at ammonia nitrogen concentration up to 6,000 mg-N/L. This result also showed that it would be possible to treat propionate effectively at free ammonia nitrogen concentration up to 724 mg-N/L if sufficient time was allowed for adaptation. However the specific methanogenic activity (SMA) of granule was lower than that of granule in the reactor with lower ammonia nitrogen concentration. At 8,000 mg-N/L, the inhibition of high ammonia concentration was observed with evidence of increase of the volatile suspended solids (VSS) concentration in the effluent. It might be ascribed to the decrease in the content of extracellular polymer (ECP), which resulted to the sloughing off of obligated proton-reducing acetogens and heterogenotrophic methanogens from the exterior of granular sludge. This caused a great portion of the finely sludge to be easily washed out. Therefore, failure to maintain the balance between these two groups of microorganism cause accumulation of the hydrogen partial pressure in the reactor, which could have inhibited the growth of acetate utilizing methanogens.

• Journal of The Korean Society of Agricultural Engineers
• /
• v.49 no.1
• /
• pp.89-97
• /
• 2007

Simple regression models for pollutants load estimation of paddy developed by the Ministry of Environment in 1995 were tested with the data (T-N, T-P, $COD_{Mn}$, and SS) collected from Yeongsan and Seomjin river watersheds, and improvement measures were suggested. Overall, the simulated values showed a great difference from the measured values except for T-P according to the statistical analyses (RMSE, root mean square error; RMAE, root mean absolute error; RB, relative bias; EI, efficiency index). Such difference was assumed due to the fact that the models use only hydrologic factors (quantity factor) associated with precipitation and run-off as input parameters, but do not consider other factors which are likely to affect pollutant concentration (quality factor) including days after fertilization. In addition, in terms of accessibility of the models, some parameters in the models such as run-off depth and run-off amount which can not be obtained from the weather database but should be collected by on-site measurements need to be replaced with other variables.