• Journal of the Korea institute for structural maintenance and inspection
• /
• v.6 no.4
• /
• pp.157-167
• /
• 2002

In most cases, quantity of reinforcement is determined without regard to the difference of initial strain, and status of damages when calculated the strengthening in flexure at beams. Thus, the purpose of this study is to investigate the flexural strengthening efficiency and behavior of RC beams strengthened with carbon fiber sheets(CFS) considering different status of damages. in this paper, a nonlinear analysis program considering rip-off strength and residual stress of steel bars and concrete in different status of damages is developed to predict the flexural behavior of CFS strengthened beams. Rip-off strength equation is obtained by modifying moment of inertia in the Robert's equation. And conformed developed nonlinear analysis program in variable of strengthening CFS amount and status of damages(initial, case1, case2, case3) and tension reinforcement ratio(0.2~1.0%).

• Journal of the Korea institute for structural maintenance and inspection
• /
• v.6 no.4
• /
• pp.243-254
• /
• 2002

This study investigates the structural behavior of cracked or uncracked RC columns retrofitted with CFS and evaluates the shear retrofit performance through experiment. Experimental works were conducted for sixth specimens varied in the adhesion method of CFS, the ratio of shear reinforcement bar, and the existence of crack before retrofitting. Throughout cyclic test, the strength, stiffness, failure modes, and ductility are discussed. The test results show that the retrofitting method with CFS improve the shear strength and ductility. The crack width below 2mm, occurred before retrofitting, didn't reduce the shear strengthening effect.

• Steel and Composite Structures
• /
• v.33 no.2
• /
• pp.225-243
• /
• 2019

Cold-formed steel (CFS) sections when used as primary load carrying members often require additional strengthening for retrofitting purposes. In some cases, it is also necessary to reduce deflections in order to satisfy serviceability requirements. The introduction of angle sections, screwed to the webs so as to act as external stiffeners, has the potential to both increase flexural strength as well as reduce deflections. This paper presents the results of ten four-point bending tests, on built-up CFS sections, both open and closed, with different stiffening arrangements. In the laboratory tests, the stiffening arrangements increased the moment capacity and stiffness of the CFS beams by up to 85% and 100% respectively. The increase in moment capacity was more evident for the open sections, while that reduction in deflection was largest for the closed sections.

• Korean Journal of Cognitive Science
• /
• v.27 no.1
• /
• pp.1-25
• /
• 2016

The present study investigated the effect size of attention and consciousness on change detection. We confirmed the effect size of consciousness by comparing the condition which combined attention and consciousness and the condition of attention without consciousness. Then, we confirmed the effect size of attention by comparing the condition of attention without consciousness and the control condition which excluded attention and consciousness. For this purpose, change detection task and continuous flash suppression (CFS) were used. CFS renders a highly visible image invisible. In CFS, one eye is presented with a static stimulus, while the other eye is presented with a series of rapidly changing stimuli, such as mondrian patterns. The result is that the static stimulus becomes suppressed from conscious awareness by the stimuli presented in the other eye. We used a customized device with smartphone and google cardboard instead of stereoscope to trigger CFS. In Experiment 1-1, we reenacted some study to validate our experimental setup. Our experimental setup produced the duration of stimulus suppression that were similar to those of preceding research. In Experiment 1-2, we reenacted a study for attention without consciousness using an customized device. The results showed that attention without consciousness more strongly work as a cue. We think that it is reasonable to use CFS treatment employing smartphone and google cardboard for a follow-up study. In Experiment 2, when performing the change detection task, we measured the effect size of consciousness and attention by manipulating the consciousness level of cue. We used the method in which everything but the variable of interest kept being fixed. That way, the difference this independent variable makes to the action of the entire system can be isolated. We found that there was significant difference of correct response rate on change detection performance among different consciousness level of cue. In this study, we investigated that not only the role of attention and consciousness were different also we were able to estimated the effect size.

• Korean Journal of Soil Science and Fertilizer
• /
• v.44 no.1
• /
• pp.118-126
• /
• 2011

Ester-linked fatty acid methyl ester (EL-FAME) profiles were used to describe differences in soil microbial communities influenced by conventional farming system (CFS), and organic farming system (OFS) in controlled horticultural land. Soil physicochemical properties and soil microbial communities were determined in the experimental fields. Higher organic matter content in OFS reduced soil bulk density which in turn increased the soil porosity. Generally, soil chemical properties in OFS were higher than those of CFS, but EC value in OFS was significantly lower than that of CFS. With the exception of Fe content, other macronutrient contents and pH in both farming system decreased with the soil depth. Soil microbial biomass of OFS was approximately 1.3 times in topsoil and 1.8 times in subsoil higher than those of CFS. Lower ratios of cy17:0 to $16:1{\omega}7c$ and cy19:0 to $18:1{\omega}7c$ were found in the CFS soils than the OFS soils, indicating that microbial stress decreased. The ratio of MUFA to SFA was higher in OFS due to organic input to the soil. In principal components analysis (PCA), the first variable accounted for 54.3%, while the second for 27.3%, respectively. The PC1 of the PCA separated the samples from CFS and OFS, while the PC2 of the PCA separated the samples from topsoil and subsoil. EL-FAMEs with the positive eigenvector coefficients for PC1 were cy17: 0 to $16:1{\omega}7c$ ratio, cy19:0 to $18:1{\omega}7c$ ratio, soil pH, soil organic matter, and soil $NO_3$-N content. Our findings suggest that the shifting cy19:0 to $18:1{\omega}7c$ ratio should be considered as potential factors responsible for the clear microbial community differentiation observed between different cultivation systems and soil depth in controlled horticultural land.

• Korean Journal of Soil Science and Fertilizer
• /
• v.48 no.2
• /
• pp.125-131
• /
• 2015

Phenyllactic acid (PLA) which is known as antimicrobial compound can be synthesized through the reduction of phenylpyruvic acid (PPA) by lactate dehydrogenase (LDH) of lactic acid bacteria (LAB). LAB producing PLA was isolated from Korea Kimchi and identified to Lactobacillus plantarum SJ21 by 16 rRNA gene sequence analysis. Cell-free supernatant (CFS) from L. plantarum SJ21 was assessed for both the capability to produce the antimicrobial compound PLA and the antifungal activity against four fungal pathogens (Rhizoctonia solani, Aspergillus oryzae, Botrytis cinerea, and Collectotricum aculatum). PLA concentration was investigated to be 3.23mM in CFS when L. plantarum SJ21 was grown in MRS broth containing 5mM PPA for 16 h. PLA production also could be promoted by the supplement of PPA and phenylalanine in MRS broth, but inhibited by the supplement of 4-hydroxyphenylpyruvic acid and tyrosine as precursors. Antifungal activity demonstrated that all fungal pathogens were sensitive to 5% CFS (v/v) of L. plantarum SJ21 with average growth inhibitions ranging from 27.32% to 69.05% (p<0.005), in which R. solani was the most sensitive to 69.05% and followed by B. cinerea, C. aculatum, and A. oryzae. The minimum inhibitory concentration (MIC) for commercial PLA was also investigated to show the same trend in the range from $0.35mg\;mL^{-1}$ (2.11 mM) to $0.7mg\;mL^{-1}$ (4.21 mM) at pH 4.0. The inhibition ability of CFS against the pathogens was not affected by heating or protease treatment. However, pH modification in CFS to 6.5 caused an extreme reduction in their antifungal activity. These results may indicate that antifungal activities in CFS were caused by acidic compounds like PLA or organic acids rather than proteins or peptides molecules.

• Journal of Digital Convergence
• /
• v.17 no.3
• /
• pp.107-117
• /
• 2019

In the era of SNS, many people relies on it to express their emotions about various kinds of products and services. Therefore, for the companies eagerly seeking to investigate how their products and services are perceived in the market, emotion mining tasks using dataset from SNSs become important much more than ever. Basically, emotion mining is a branch of sentiment analysis which is based on BOW (bag-of-words) and TF-IDF. However, there are few studies on the emotion mining which adopt feature selection (FS) methods to look for optimal set of features ensuring better results. In this sense, this study aims to propose FS methods to conduct emotion mining tasks more effectively with better outcomes. This study uses Twitter and SemEval2007 dataset for the sake of emotion mining experiments. We applied three FS methods such as CFS (Correlation based FS), IG (Information Gain), and ReliefF. Emotion mining results were obtained from applying the selected features to nine classifiers. When applying DT (decision tree) to Tweet dataset, accuracy increases with CFS, IG, and ReliefF methods. When applying LR (logistic regression) to SemEval2007 dataset, accuracy increases with ReliefF method.

• Proceedings of the Korea Concrete Institute Conference
• /
• 1999.10a
• /
• pp.705-708
• /
• 1999

Advanced composite materials such as carbon fiber, aramid, and glass fiber sheet, are widely used recently to strengthening existing reinforced concrete structures. The purpose of this paper was to investigate the mechanical characteristics of concrete compressive members confined with carbon fiber sheet and evaluate the efficiency of the strengthening under load actions. Uniaxal compression tests of concrete compressive members confined with carbon fiber sheet were experimentally used to develop a relationship between the axial stresses and the lateral stresses. The resulting axial and lateral strains were used to determine the confinement effect of concrete compressive members.

• Proceedings of the Korean Institute of Communication Sciences Conference
• /
• 2006.07a
• /
• pp.581-581
• /
• 2006

• Proceedings of the Korea Concrete Institute Conference
• /
• 1997.10a
• /
• pp.462-471
• /
• 1997

In this study, we studied the compression test of laterally confined concrete cylinder by the carbon-fiber sheet(CFS), and compared the test results with previous test results and relationships by other researchers. Our objectives is to find the stress-strain characteristics and the enhancement of strength of the confined concrete to the lateral pressure offered by CFS.