• Journal of the Korea Institute of Military Science and Technology
• /
• v.11 no.5
• /
• pp.42-48
• /
• 2008

In this paper, we have introduced a Code Division Multiplexing transmission method which is similar to OFDM and analyze ECCM performances. We have verified CDM transmission method has a good LPI performance and a feasible ECCM performance. This capability could be useful for reduction of RF interference which occurs when many equipments operate densely in small area. The equipment that uses CDM transmission method supports variable transmission rate and order-wire effectively and conveniently to user. This CDM method has similar ECCM performance comparing to serial DS method. CDM method has good multi-path signal processing capability and could be useful for mobile communication environment.

• Journal of Communications and Networks
• /
• v.8 no.1
• /
• pp.1-7
• /
• 2006

Quadrature amplitude modulation-spread spectrum (QAM-SS) and code division multiplexing (CDM) are multi-level modulation schemes with high performance but they cause a large peak-average power ratio (PAPR). Therefore, this paper proposes a novel modulation scheme for high-rate transmission which follows a sequence of CDM-mapping-CDM not only to correct the above-mentioned problem but also offer a high flexibility in obtaining arbitrary multilevel modulation with very low implementation complexity and high performance.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.14 no.6
• /
• pp.729-743
• /
• 1989

A spread spectrum(ss) communication system has a lot of advantage, such as realzation of asynchronous code division multiplexing(CDM), robutness to narrow-band interference, impulse noise, privacy function, and so on. We have considered utilization of these advantage to develop a local area network(LAN) using such a transmission channel as power-line. In a power-line, however, restricted bandwidth under the law makes it difficult to carry out CDM, and in a radio channel the sysstem has a near-far problem. These problems originate in co-channel interference, which is due to cross-correlation among pseudo-noise sequences of every channel in CDM. In this paper, we propose a new scheme of easily cancelling co-channel interference and investigate its performance by constructing a LAN using SS technique.

• Journal of the Korea Society of Computer and Information
• /
• v.3 no.4
• /
• pp.103-109
• /
• 1998

Domastic telephony transmission networks mainly using El in 2.048Mb㎰ is composed to 30 channels and each channel is assigned to 64Kb㎰ voice coding rate. El method always uses TDM, so it is fixed channels. In this paper, it shows that using CDM enlarge the subscribers and voice channels

• Journal of Communications and Networks
• /
• v.16 no.4
• /
• pp.447-457
• /
• 2014

In this paper, we investigate the frequency domain channel estimation for multiple-input multiple-output (MIMO) single-carrier frequency-division multiple-access (SC-FDMA) systems. In MIMO SC-FDMA, code-division multiplexed (CDM) pilots such as cyclic-shifted Zadoff-Chu sequences have been adopted for channel estimation. However, most frequency domain channel estimation schemes were developed based on frequency-division multiplexing of pilots. We first develop a channel estimation error model by using CDM pilots, and then analyze the mean-square error (MSE) of various minimum MSE (MMSE) frequency domain channel estimation techniques. We show that the cascaded one-dimensional robust MMSE (C1D-RMMSE) technique is complexity-efficient, but it suffers from performance degradation due to the channel correlation mismatch when compared to the two-dimensional MMSE (2D-MMSE) technique. To improve the performance of C1D-RMMSE, we design a robust iterative channel estimation (RITCE) with a frequency replacement (FR) algorithm. After deriving the MSE of iterative channel estimation, we optimize the FR algorithm in terms of the MSE. Then, a low-complexity adaptation method is proposed for practical MIMO SC-FDMA systems, wherein FR is performed according to the reliability of the data estimates. Simulation results show that the proposed RITCE technique effectively improves the performance of C1D-RMMSE, thus providing a better performance-complexity tradeoff than 2D-MMSE.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.38 no.8
• /
• pp.27-33
• /
• 2001

The performance of the ordinary Fiber Bragg Grating(FBG) sensor strain measurement system, which uses Fabry-Perot filter for scanning wavelength, has limitation for application because of hysteresis characteristics of PZT element in the filter, slow scan rate of the filter and the high cost of system. We proposed and experimented a multiple FBG sensor system using light emitting diode(LED) as a light source and adapting Code Division Multiplexing(CDM) method to separating out individual sensor signal. Output signals for a applied static and dynamic strain and crosstalk levels between sensor signals were measured. The price of the system is very loss and the response speed is very fast. Crosstalk levels between sensor signals below - 30 dB were demonstrated.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.25 no.8A
• /
• pp.1206-1212
• /
• 2000

The subscriber loop subnet at domestic wired telephony networks uses one circuit per one subscriber and the transmission network subnet uses TDM that is composed to 30 voice channels and is assigned to 64kbps per one voice channel of 2.048Mbps in El. On the contrary, the subscriber networks for cellular networks is extent to channel capacity and make it efficiency use CDMA method but the transmission network is used to the same as telephony. In this paper, The subscriber loop at wired network also is shown to increasing effective and lower expensive using CDM.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.50 no.7
• /
• pp.34-42
• /
• 2013

In this paper, we compare the performance of wavelet OFDM (Orthogonal Frequency Division Multiplexing) and FD-OFDM(Frequency diversity OFDM) system with conventional OFDM system. Wavelet OFDM system uses wavelet transform rather than Fourier transform and contains intermediate characteristics of CDM (Code Division Multiplexing) and OFDM. In wavelet OFDM system, inter-symbol interference (ISI) can be suppressed effectively and adjacent channel interference can be also minimized well. In FD-OFDM system, each parallel branch symbol is multiplied by the orthogonal sequence and distributed into all sub-carriers. Then, each sub-carrier transmits information composed of the symbol components of all parallel branches in the given frame. FD-OFDM contains the frequency diversity characteristic and, therefore, FD-OFDM can be robust to the narrowband interference. For the comparison among different systems, BER (Bit-Error Rate) performances are evaluated in the presence of narrow-band interference and a harmonic noise channel. From the evaluation results, compared to the conventional OFDM, wavelet OFDM and FD-OFDM shows better robustness against the interference and, especially, wavelet OFDM is the most robust in harmonic noise channel.

• Journal of Internet Computing and Services
• /
• v.7 no.3
• /
• pp.41-51
• /
• 2006

In the case of CDMA-based packet data systems such as 1xEV-DO which are designed to support high rate services, BSs transmit data packets with a maximum power based on time multiplexing mode such that only one user can be serviced at a time. In this paper, we propose a joint power allocation and scheduling algorithm for 1xEV-DO-like systems in which we adopt a code division multiplexing (CDM) transmission method in the downlink common channel in order to utilize channel orthogonality such that we can serve more than one user at a time slot especially when there exist remaining resources after serving the firstly selected user by the scheduler. Simulation results demonstrate that the proposed scheme can improve the performances of conventional schemes such as the maximum rate and the proportional fair algorithms.