• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.39C no.8
• /
• pp.746-755
• /
• 2014

In this paper, we propose the structure of a dual polarized system for a wireless communication. The proposed dual polarized antenna is formed by one vertical antenna and two horizontal antennas that are orthogonal to each other. Vertical and horizontal polarized antennas transmit different signals, but two orthogonal horizontal polarized antennas transmit the same data signals. So, the signals of the proposed dual polarized system construct two dual-polarization planes. And, only one dual-polarization plane with a large signal power is selected at the side of a receiver. The simulation results show that the proposed dual polarized system could obtain a higher capacity compared to an ordinary $2{\times}2$ MIMO (Multi-input Multi-output) system.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.34 no.8C
• /
• pp.750-755
• /
• 2009

Tomlinson-Harashima precoding (THP) is considered as a prominent precoding scheme due to its capability to cancel out the known interference at the transmitter side. Therefore, the information rates achieved by THP are superior to those achieved by conventional linear precoding schemes. In this paper, a new lower bound on the achievable information rate by the regularized THP under additive white Gaussian noise (AWGN) channel with multiuser interference is derived. Analytical results show that the lower bound derived in this paper is tighter than the original lower bound particularly at low SNR range, while both lower bounds converge to the same lower limit as SNR$\rightarrow$$\infty$.

• Journal of electromagnetic engineering and science
• /
• v.16 no.2
• /
• pp.119-125
• /
• 2016

In this paper, a method for identifying the appropriate position on the ground plane for antennas is proposed based on the current correlation coefficient ($C^3$). This method explains that the mutual coupling between antennas when locating several antennas on the same ground plane is necessary. Given the current distribution on the ground plane induced by each antenna, easily estimating the coupling between antennas is possible. This paper also demonstrates that the proposed method can be used in the design of a multi-input multi-output system. The measured data are in good agreement with the simulation results.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.33 no.4C
• /
• pp.330-335
• /
• 2008

This paper proposes a packet detection algorithm for IEEE802.11n system. IEEE802.11n is a multiple input multiple output (MIMO) system and we have to consider several combining techniques which are used in multiple receive antenna system. In this paper, we propose a hybrid packet detection algorithm which combines double sliding window algorithm or delay and correlation algorithm, that is used in single input single output (SISO) system, and multiple receive antenna combining algorithms, and simulated their performances in Iin system environments and shows the results.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.36 no.1C
• /
• pp.37-47
• /
• 2011

In this paper, we propose a novel ML decoding scheme based on the combination of depth- and breadth-first search methods on a partitioned tree for multiple input multiple output systems. The proposed scheme first partitions the searching tree into several stages, each of which is then searched by a depth- or breadth-first search method, possibly exploiting the advantages of both the depth- and breadth-first search methods in an organized way. Numerical results indicate that, when the depth- and breadth-first search algorithms are adopted appropriately, the proposed scheme exhibits substantially lower computational complexity than conventional ML decoders while maintaining the ML bit error performance.

• ETRI Journal
• /
• v.45 no.6
• /
• pp.952-962
• /
• 2023

In this study, a space-time transmission scheme is proposed to tackle the limitations of channel estimation with orthogonal pilot information in colocated multiple-input multiple-output systems with several transmitting and receiving antennas. Channel information is obtained using orthogonal pilots. Channel estimation introduces pilot heads required to estimate a channel. This leads to bandwidth insufficiency. As a result, trade-offs exist between the number of pilots required to estimate a channel versus spectral efficiency. The detection of data symbols is performed using the maximum likelihood decoding method as it provides a consistent approach to parameter estimation problems. The moment-generating function of the instantaneous signal-to-noise ratio is used to drive an approximate expression of the symbol error rate for the proposed scheme. Furthermore, the order of diversity is less by one than the number of receiver antennas used in the proposed scheme. The effect of the length of a pilot sequence on the proposed scheme's performance is also investigated.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.31 no.7C
• /
• pp.680-690
• /
• 2006

In this paper, we present a bit allocation scheme based on grouped sub-channels for MIMO-OFDM (Multiple Input Multiple Output-Orthogonal Frequency Division Multiplexing) systems using V-BLAST (Vertical-Bell laboratories LAyered Space-Time) detector. A fully adaptive modulation and coding scheme may provide optimal performance in the MIMO-OFDM systems, however it requires excessive feedback information. Instead, SBA (Simplified Bit Allocation) scheme for reduction of feedback overhead, which applies the same modulation and coding to all the good sub-channels, may be considered. The proposed scheme in this paper named SBA-GS (Simplified Bit Allocation based on Grouped Sub-channels) groups sub-channels and assigns the same modulation and coding to the set of selected sub-channel groups. Simulation results show that the proposed scheme achieves comparable bit error rate performance of the conventional SBA scheme, while significantly reducing the feedback overhead in multipath channels with small delay spreads.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.35 no.11C
• /
• pp.889-895
• /
• 2010

MIMO system generally requires more than one antenna at the communication device. However, many wireless devices are limited by size, cost or hardware complexity to one antenna. To overcome such restrictions, we used a new technique, called cooperative communication. We propose a new cooperative transmission strategy system using cross-layer coding method base on H-ARQ for optimal communication. Proposed cooperative H-ARQ system that can improve the above problems and can get the better performance. In proposed cooperative system with H-ARQ method, if the received signal from source node is satisfied by the destination preferentially, the destination transmit ACK message to both relay node and source node, and then recovers the received signal. In addition, if ARQ message indicates NACK message, relay node operates selective retransmission. Based on the simulation results in aspect to BER performance and throughput, the proposed method which combined cooperative system with H-ARQ based on cross-layer coding can improve spectral efficiency reliability of system compared with that of general one by one system.

• Journal of Communications and Networks
• /
• v.6 no.3
• /
• pp.258-268
• /
• 2004

We demonstrate rotationally invariant space-time (ST) trellis codes with a 4-D rectangular signal constellation for data transmission over fading channels using two transmit antennas. The rotational invariance is a good property to have that may alleviate the task of the carrier phase tracking circuit in the receiver. The transmitted data stream is segmented into eight bit blocks and quadrature amplitude modulated using a 256 point 4-D signal constellation whose 2-D constituent constellation is a 16 point square constellation doubly partitioned. The 4-D signal constellation is simply the Cartesian product of the 2-D signal constellation with it-self and has 32 subsets. The partition is performed on one side into four subsets A, B, C, and D with increased minimum-squared Euclidian distance, and on the other side into four rings, where each ring includes four points of equal energy. We propose both linear and nonlinear ST trellis codes and perform simulations using an appropriate multiple-input multiple-output (MIMO) channel model. The 4-D ST codes constructed here demonstrate about the same frame error rate (FER) performance as their 2-D counterparts, having however the added value of rotational invariance.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.35 no.2C
• /
• pp.229-237
• /
• 2010

The conventional detection methods developed for spatially-multiplexed MIMO systems such as OSIC and QRD-M show performance difference for each user depending on the order of detection when they are applied to detection of multi-user signals in uplink multiuser systems based on collaborative spatial multiplexing. In this paper, a signal detection method for uplink multiuser systems based on collaborative spatial multiplexing is proposed to provide similar performance for each user while its performance is close to the case of ML detection. Compared with QRD-M method, computational complexity of the proposed signal detection method is similar in the case of QPSK, and significantly lower in the case of high modulation order with 16-QAM and 64-QAM.