• Journal of the Korea Organic Resources Recycling Association
• /
• v.4 no.2
• /
• pp.19-25
• /
• 1996

A fundamental study on composting garbage was performed in a laboratory scale of a high-speed composting reactor. Major parameters were moisture content, temperature and C/N ratio. The results are as follows; pH of the compost was the highest at moisture 60% and anaerobic condition occurred at 70%. It was, also, found that C/N ratio, caused a nitrogen loss due to an occurrence of plentiful $NH_3$. Under controlling Temperature, pH was the highest at $60^{\circ}C$ and an inverse effect for Composting occurred under excessive Temperature as pH at $70^{\circ}C$ was lower than that of soil. The variation of pH and C/N ratio was the lowest when C/N ratio was 25. The results obtained from composting garbage revealed that the best condition of composting occurred under 50 to 60% of moisture content, $60^{\circ}C$ of temperature, and 25 of C/N ratio. It is believed that composting may be finished with in 56 hours if an optimal condition is setting up.

• KSBB Journal
• /
• v.9 no.4
• /
• pp.365-371
• /
• 1994

The effects of ratios of initial concentration of carbon source to the initial concentration of nitrogen source in the fermentation media on both the yields of PHB fermentation variables and the accumulation of poly-${\beta}$-hydroxybutyric acid(PHB) were investigated. The fermentation media were composed of the combination of varing glucose concentrations, 10, 20, 25, 30, 40, $50g/\ell$ and the NH4Cl concentrations 0.33, 0.4, 0.5, 1.5, 3, $5g/\ell$. The yield of biomass on glucos, Yx/s, decreased very slowly according to the increase of the ratio of C to N. And the yield became constant at 0.35(g biomass/g glucose) with the ratio higher than 70. The yield of residual biomass, Yx/s, also decreased with the ratio of C to N and finally showed a constant value of 0.065(g residual biomass/g glucose) when the ratio was higher than 65. In accordance with the augmentation of the ratio, the yield of PHB, YPHB/S, however, increased and showed the maximum value of 0.35 (g PHB/g glucose) between 40 and 60 of the ratio. The maximum yield of PHB to the change of biomass, YPHB/S, was 0.87(g PHB/g biomass), and the yie1d YPHB/RX, was 4.2(g PHB/g residual biomass). The maximum accumulation percent of PHB to the final biomass was 81% when the ratio was higher than 67.

• Journal of the Korea Organic Resources Recycling Association
• /
• v.7 no.2
• /
• pp.105-111
• /
• 1999

This study was performed about composting in a batch reactor of laboratory scale using garbage waste and swine waste. Sawdust and coconut peat were materials to control optimum moisture, C/N ratio and specific gravity in the study. Comparing compost using only sawdust with compost using sawdust and coconut peat, the latter was higher at reduction rate and decomposition rate. Coconut peat was accelerated aerobic fermentation, because it had moisture holding ability, initial moisture was low, ventilation was good and control of optimum specific gravity was possible. Compost by only garbage waste was under standard of manure. but mixtures in same proportion of garbage waste and swine waste producted high quality compost. CEC value was average 63.8me/100g. The initial C/N ratio of compost was regulated effectively because of high C/N ratio of sawdust. As the C/N ratio(>40) was higher, reduction rate was higher. During the composting C/N ratio was improved more and more.

• Journal of the Microelectronics and Packaging Society
• /
• v.3 no.2
• /
• pp.51-56
• /
• 1996

각종 통신기기의 주파수 합성기 등에 광범위하게 응용되고 있는 전압제어 발진기에 서 캐리어 대 잡음비(C/N비:Carrier noise Ratio)특성이 매우 중요하다. 특히 휴대용 단말기 에 쓰이는 소형 저소비전려의 VCO는 위상 잡음의 억제가 필수적이다. VCO의 C/N비 특성 은 공진회로의 선택도 Q와 능동소자의 각종 파라미터들 그리고 발전전력과 밀접한 관계가 있다. 본 논문에서는 CAD를 이용하여 우수한 C/N비를 갖는 900MHz대 VCO의 최적화 설 계방버을 제시하고 그 결과를 기초로 우수한 저잡은 VCO를 실현하였다.

• Journal of Animal Environmental Science
• /
• v.5 no.3
• /
• pp.197-202
• /
• 1999

퇴비화 재료를 혼합하는 목적은 재료를 퇴비황에 최적조건으로 조성하여 퇴비화 성능을 향상 시키고 취기발생을 억제하기 위함이다. 퇴비화성능에 미치는 요인으로서는 C/N비, 수분 함량, 산도(pH), 산물밀도, 입자크기 등이 있다. 이 중에서 C/N비는 적정값으로 조성하기 어렵다. 본 자료는 퇴비재료의 적정 수분 함량 및 C/N비를 조성하기 위해 각 요소재료의 혼합비율을 제시하고 있다.

• Journal of Korean Society of Environmental Engineers
• /
• v.27 no.5
• /
• pp.499-506
• /
• 2005

This study was performed to investigate the effects of influent C/N ratio on the removal of organic and nitrogenous compounds by two nonwoven fabric filter bioreactors. The reactors were alternately aerated at an aeration/nonaeration period ratio of 60 min/60 min, and fed with wastewater only during nonaeration period. The influent C/N ratio (COD/TKN) was gradually reduced from 10 to 2. The influent was prepared by diluting the leachate from a foodwaste treatment facility in I city so that the COD concentration could be about 2,500 mg/L. The C/N ratio of the wastewater was adjusted by adding ammonium chloride. The results of the experiment showed that the COD and BOD concentration of the effluent was $40{\sim}54\;mg/L$ and $1{\sim}4\;mg/L$, respectively at the C/N ratios of $10{\sim}3$, and the effluent SS concentration was always below 2.0 mg/L. The T-N removal efficiencies were 96% or higher at C/N ratios of $10{\sim}5$, but decreased to 83% and 81%, respectively at the C/N ratios of 3 and 2.8. At the C/N ratios of 2.6 and 2, the effluent quality deteriorated due to ammonia toxicity. The fraction of nitrifying microorganism in the reactors increased from 10% to 20% as the C/N ratio decreased from 5 to 2.6. Alkalinity consumed were $3.12{\sim}3.49\;g$ alkalinity/g T-N removed at the C/N ratios of $10{\sim}5$, which are lower than the theoretical value of 3.57. However, the ratio increased to 4.63 and 4.87 g alkalinity/g T-N removed, respectively at the C/N ratios of 3 and 2.8.

• Proceedings of the Korean Environmental Sciences Society Conference
• /
• 2008.11a
• /
• pp.503-506
• /
• 2008

질소제거 능력이 있는 Pseudomonas aeruginosa을 고분자물질인 PEG 에 포괄고정화하였으며 제조된 고정화 미생물을 이용하여 질소제거에 미치는 C/N비, 농도, 충진율, 탄소별 제거율을 검토한 결과 다음과 같은 결론을 얻었다. 1) C/N비 10이상이면 NH$_4$-N 와 NO$_3$-N의 동시 제거가 가능하였으며 2) 탄소 원으로는 glucose를 사용하였을 때 NH$_4$-N 와 NO$_3$-N의 동시 제거가 가능하였으나 methanol은 탄소원으로 사용할 수 없었다. 3) 저농도의 NO$_3$-N(50 mg/L)는 완전히 제거 가능하였으나 NH$_5$-N인 경우에는 초기 NH$_4$-N 100 mg/L에서 60%정도만 제거되었다. 4) 연속처리 결과 NH$_4$-N는 HRT 변동에도 불구하고 유출수 농도 변화가 거의 없었으나, 오히려 C/N비를 증가시키면 NH$_4$-N 제거 효율이 높았고, NO$_3$-N인 경우도 마찬가지로 C/N비를 증가시키면 NO$_3$-N 제거 효율이 높았다.

• Journal of Korean Society of Environmental Engineers
• /
• v.29 no.2
• /
• pp.220-228
• /
• 2007

In this study, effective simultaneous nitrification and denitrification reaction was accomplished in a completely mixed single bioreactor. As the important factors on the reaction, optimal DO concentration and effective range of influent C/N ratio was investigated with the synthetic wastewater. Experimental results show that stable nitrogen removals were accomplished with 0.5 mg/L DO concentration and over 7 C/N ratio. Nitrogen removal efficiency of the real municipal wastewater was low with 0.5 mg/L DO concentration because of its low C/N ratio. The increment of the C/N ratio at the inflow of the municipal wastewater with addition of external carbon source (glucose) over 7(up to 14) shows over 70% nitrogen removal in the single bioreactor.

• Microbiology and Biotechnology Letters
• /
• v.20 no.2
• /
• pp.196-202
• /
• 1992

Zoogloea ramigera 115 was selected for the production of viscous microbial polysaccharide for bioflocculants usage. Batch, fed-batch, and continuous culture processes were examined with regard to the high biopolymer production. Several carbon sources were tested, including glucose, lactose, molasses, and cheese whey. The C/N ratio of 90 was most effective for biopolymer production from glucose, while the C/N ratios of 30 for lactose and 60 for both molasses and cheese whey substrate gave a maximum production. Fed batch culture proved more effective to increase final biopolymer concentration than batch culture. Continuous fermentation with two stages modifying C/N ratio increased the productivity. The production rates were a maximum at dilution rate of 0.048 $hr^{-1}$ for molasses and at 0.096 $hr^{-1}$for cheese whey.

• 한국방재학회:학술대회논문집
• /
• 2008.02a
• /
• pp.823-826
• /
• 2008

Statistical methods were used in the analysis of data, which are the SNR and SDNR in describing the various natures, and the methodology relating the results with the operation was developed. Multiple regression analysis based on the results of statistics of data were SNR = 0.0219 + 0.000044BOD lording - 0.00600C/N ratio and SDNR = 0.0226 + 0.000044BOD lording - 0.00602C/N ratio. It were concluded that the variability of the process performance should be reflected to the operation condition procedure through the analysis based on the statistics methods.