• Journal of the Korean Geotechnical Society
• /
• v.23 no.3
• /
• pp.5-13
• /
• 2007

The performance of innovative prestressed support (IPS) earth retention system applied in soft clay was investigated and presented. The IPS wale system provides a high flexural stiffness to resist the bending by lateral earth pressure, and transfers lateral earth pressure to strut supports. The IPS wale system provides a larger spacing of support than conventional braced and anchored systems. The IPS earth retention system was selected for temporary earth support in a building construction in North Busan area. The excavation was made 28.8 m wide, 52.0 m long, and 16.1 m deep through loose fill to soft clay. The IPS system consists of 650 mm thick slurry walls, and five levels of IPS wales and struts. Field monitoring data were collected including wall deflections at six locations, ground water levels at four locations, IPS wale deflections at thirty locations, and axial loads on struts at twenty locations, during construction. The IPS earth retention system applied in soft clay performed successfully within a designed criterion. Field measurements were compared with design assumptions of the IPS earth retention system. The applicability and stability of the IPS earth retention system in soft clay were investigated and evaluated.

• Journal of the Korean Geosynthetics Society
• /
• v.22 no.1
• /
• pp.87-96
• /
• 2023

There are a lot of difference between the surface settlement and the differential settlement measured at the Busan New Port, where the dredged and reclaimed clay layer exists and below the clay is originally thickly distributed. To find the cause and solution of this, the actual conditions of each differential settlement used for the soft ground improvement, characteristics, installation method, measurement frequency, measurement data management, and data analysis of each type were considered. In the deep soft ground improvement work where large deformation occurs, the bending deformation of the screw-type differential settlement gauge is less than that of other types of measuring instruments, so there is less risk of loss, and the reliability of data is relatively high as the instruments are installed by drilling for each stratum. Since the greater the amount of high-precision settlement measurement data, the higher the settlement analysis precision. It is necessary to manage with higher criteria than the measurement frequency suggested in the standard specification. For the data management of the differential settlement gauge, it is desirable to create graphs of the settlement and embankment height of the relevant section over time, such as surface, differential, and settlement of pore water pressure gauge for each point. In the case of multi-layered ground with different compression characteristics, it is more appropriate to perform settlement analysis by calculating the consolidation characteristics of each stratum using a differential settlement data.

• Proceedings of the Korean Society of Surveying, Geodesy, Photogrammetry, and Cartography Conference
• /
• 2003.04a
• /
• pp.513-516
• /
• 2003

This study was performed in two ways, which are 'Before' 'After' carrying out trench search through GPR which is called 'Non Destructive Geophysical' to the expected area where the remains of historic interest could be distributed within the construction site from Dae-gu to Busan. As a result, the layer containing gravel and sand has more irregular specular surface then others containing silt and clay. And, this paper, irregular specular surfaces of prominence and depression patter appeared. After performing trench search, verified that the site yield dolmens and lots of stone implements.

• Journal of Korean Society for Geospatial Information Science
• /
• v.11 no.1 s.24
• /
• pp.45-49
• /
• 2003

This study was peformed in two ways, which are 'Before' 'After' carrying out trench search through GPR which is called 'Non Destructive Geophysical' to the expected area where the remains of historic interest could be distributed within the highway construction site from Dae-gu to Busan. As a result, the layer containing gravel and sand has more irregular specular surface then others containing silt and clay, And, apart block irregular specular surfaces of prominence and depression patter appeared. After performing trench search, verified that the site yield dolmens and lots of stone implements.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2008.10a
• /
• pp.1204-1211
• /
• 2008

Compression index is one of the important characteristic numbers in soft soil engineering. Since 1940's, many researchers have suggested various practical solutions to define the compression index of clay using other soil properties. But, these results are only can give us an outline of soft soil behavior. In this study, the relationships between pore water pressure dissipation test results and compression index were suggested using comparison results of both tests. This relationships are based on basic concept of consolidation phenomena, essential difference between pore water pressure dissipation test and consolidation test, and disagreements between theoretical time factor and real time factor. To identify proportional factor of proposed equation, Geotechnical investigation results of Kwang-Yang(KY) site and Busan New Port(BN) site were used. The proportional factor was 0.0031 from 20 to 50% of consolidation rate where correlation parameter($R^2$) is 0.9051.

• 보존과학연구
• /
• s.33
• /
• pp.109-124
• /
• 2012

Jangan-eup, located in Busan, South Korea,is a famous pottery-producing area in the Joseon Dynasty period. The aim of this paper was to determine the correlation of the pottery from each kiln site of Jangan-eup by analyzing the ingredients of clay as well as its production technique and firing condition. The materials that were used for the study were fragments of inlaid celadon, white porcelain, and white porcelain painted with underglazed iron excavated from six kiln sites of Jangan-eup:Sil-li, Daeryong-li, Hajangan-li, Sangjangan-li, Yongso-li, and Dumyeong-li. In each of the samples from the six kilns, cristobalite, mullite, and quats were found. The firing temperature distinguished from the crystal structure was higher in the following order: Dumyeongli>Sangjangan-li>Daeryong-li>Hajangan-li>Yongso-li>Sil-li. The samples were divided into four groups based on the ingredients of the clayfound therein: the Sil-li andDaeryong-li group, the Hajangan-li and Sangjangan-li group, the Yongso-li group, and the Dumyeong-li group. It was also found that the sample of Dumyeong-li was made using the most homogeneous clay compared with the other samples. The pottery of Jangan-eup had $40-400{\mu}m$ glaze, had bubbles in their bodies, and had $10-150{\mu}m$ sizes.

• Journal of the Korean Geotechnical Society
• /
• v.27 no.4
• /
• pp.21-32
• /
• 2011

A series of in-situ and laboratory tests were performed for the clayey soils of Busan area in order to develop the methods to evaluate the compressibility using CPT and DMT results. The laboratory tests show that the clayey layers of Busan areas are normally consolidated, and their compression indices are turned out to be 0.5~1.3. From the analysis of test results, correlation factors between the cone resistance and constrained modulus (${\alpha}_m$ and ${\alpha}_n$) are observed to decrease with increasing plasticity index, and the correlation factor between the dilatometer modulus and constrained modulus $(R_M)$ increases with $1/I_D$. Based on these relationships, the methods evaluating the constrained modulus from CPT and DMT results are suggested. It is shown that the prediction method by CPT underestimates the constrained modulus of improved ground, whereas the prediction method by DMT is suitable for evaluating the constrained modulus of improved and unimproved ground.

• Journal of Aquaculture
• /
• v.20 no.4
• /
• pp.239-247
• /
• 2007

We studied spawning, hatching and larval growth of Amphiprion melanopus under laboratory conditions. Each time a fish spawned about 440 to 650 eggs. The eggs were hatched 9 days later. Nest colour of the eggs changed from clear yellow orange to greyish violet with processing of embryogenesis. With regard to spawning according to the substrates, the fish prefered red clay pot and ceramic pot to volcanic scoria and live rock. Hatching rate (%) of the eggs on the former substrates was significantly higher than that on the latter. The number of eggs varied with the food stuff supplied to the fish. The fish fed Tetra bits (commercial diet), meat of short necked clams and mussels, and astaxanthin showed significantly higher fecundity with 638 eggs than that fed only Tetra bits (477 eggs) or Tetra bits with meat of shellfish without astaxanthin ($549{\sim}553\;eggs$). Higher temperature ranging from 24 to $30^{\circ}C$ induced shorter incubation period and smaller total length, but higher hatching rate. The optimum salinity and L:D cycle with $60\;{\mu}mol$ photon $m^{-2}s^{-1}$ for hatching were 33 psu and 16:8, respectively. The newly hatched larvae about 4.6 mm in total length grew to 7.5 mm in one week, 18.8 mm in a month and 37.9 mm in 70 days after hatching.

• Journal of the Korean Geotechnical Society
• /
• v.22 no.12
• /
• pp.67-76
• /
• 2006

The reasonable assessment of the shear stiffness of a dredged soft ground and soft clay is difficult due to the soil disturbance. This study addresses the development and application of a new in-situ shear wave measuring apparatus (field velocity probe: FVP), which overcomes several of the limitations of conventional methods. Design concerns of this new apparatus include the disturbance of soils, cross-talking between transducers, electromagnetic coupling between cables, self acoustic insulation, the constant travel distance of S-wave, the rotation of the transducer, directly transmitted wave through a frame from transducer to transducer, and protection of the transducer and the cable. These concerns are effectively eliminated by continuous improvements through performing field and laboratory tests. The shear wave velocity of the FVP is simply calculated, without any inversion process, by using the travel distance and the first arrival time. The developed FVP Is tested in soil up to 30m in depth. The experimental results show that the FVP can produce every detailed shear wave velocity profiles in sand and clay layers. In addition, the shear wave velocity at the tested site correlates well with the cone tip resistance. This study suggests that the FVP may be an effective technique for measuring the shear wave velocity in the field to assess dynamic soil properties in soft ground.

• Journal of the Korean Geotechnical Society
• /
• v.25 no.10
• /
• pp.99-110
• /
• 2009

In order to provide the design criteria, the characteristics of consolidation for soft ground improvement have been investigated using the field banking test performed by the vertical drain method at the northern container section in Busan New Port. Field test results indicated that the estimated degree of consolidation in design stage decreased by about 7% compared with the measured one. This difference is attributed to the fact that the conservative geological properties were applied with relatively high amount of maximum clay mixture ratio during the design stage. Based on this findings, another laboratory oedometer test was implemented to consider various combination of mixture ratio. It was found that the consolidation degree increased in accordance with the increase of sand/silt mixture ratio. Also, the proportion of 10%, 50%, and 40% for sand, silt, and clay, respectively, was observed as the best combination of mixture ratio to the actual measurement, which is very similar to the average grain size distribution in the banking test area. Therefore, it is suggested that the overall geological characteristics as well as the grain size distribution should be considered in design stage to improve the soft ground that contains mixture of sand, silt, and clay.