• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.30 no.1A
• /
• pp.35-43
• /
• 2010

The panels are used as a composite part of the completed deck. They replace the main bottom transverse deck reinforcement and also serve as a form surface for the cast-in-place concrete upper layer that contains the top of deck reinforcement. However, in order to apply the precast panels to bridges properly, it is necessary to fully understand the structural characteristics of joint in precast panels. Particularly, since the bridge deck is under repeated loads such as traffic loads, fatigue behavior and characteristics of joint should be investigated. In this paper, fatigue tests of composite deck with shear ties and loop joints were conducted. The fatigue tests were conducted with an application of repeated loading and wheel loading. Test results were analyzed to examine the current design code for fatigue of reinforcement bar and serviceability under repeated loading.

• Computers and Concrete
• /
• v.32 no.1
• /
• pp.61-74
• /
• 2023

This article investigates the wave propagation analysis of the imperfect functionally graded (FG) sandwich plates based on a novel simple four-variable integral quasi-3D higher-order shear deformation theory (HSDT). The thickness stretching effect is considered in the transverse displacement component. The presented formulation ensures a parabolic variation of the transverse shear stresses with zero-stresses at the top and the bottom surfaces without requiring any shear correction factors. The studied sandwich plates can be used in several sectors as areas of aircraft, construction, naval/marine, aerospace and wind energy systems, the sandwich structure is composed from three layers (two FG face sheets and isotropic core). The material properties in the FG faces sheet are computed according to a modified power law function with considering the porosity which may appear during the manufacturing process in the form of micro-voids in the layer body. The Hamilton principle is utilized to determine the four governing differential equations for wave propagation in FG plates which is reduced in terms of computation time and cost compared to the other conventional quasi-3D models. An eigenvalue equation is formulated for the analytical solution using a generalized displacements' solution form for wave propagation. The effects of porosity, temperature, moisture concentration, core thickness, and the material exponent on the plates' dispersion relations are examined by considering the thickness stretching influence.

• Geophysics and Geophysical Exploration
• /
• v.26 no.4
• /
• pp.199-210
• /
• 2023

The physical properties of rocks in reservoirs change after CO₂ injection, we modeled a reservoir with a transition zone within which the physical properties change linearly. The function of the Wolf reflection coefficient consists of the velocity ratio of the upper and lower layers, the frequency, and the thickness of the transition zone. This function can be used to estimate the thickness of a reservoir or seafloor transition zone. In this study, we propose a method for predicting the thickness of the transition zone using deep learning. To apply deep learning, we modeled the thickness-dependent Wolf reflection coefficient on an artificial transition zone formation model consisting of sandstone reservoir and shale cap rock and generated time-frequency spectral images using the continuous wavelet transform. Although thickness estimation performed by comparing spectral images according to different thicknesses and a spectral image from a trace of the seismic stack did not always provide accurate thicknesses, it can be applied to field data by obtaining training data in various environments and thus improving its accuracy.

• The Sea:JOURNAL OF THE KOREAN SOCIETY OF OCEANOGRAPHY
• /
• v.6 no.4
• /
• pp.218-224
• /
• 2001

Water movement in the Young San River Estuary where a sea dyke was constructed, was observed using anacoustic doppler profiler (ADP) and two TGPS buoys for 25 hours on 27-28 July 2000. Hydrographic observations were simultaneously taken using CTD to understand the characteristic of the spacial structure of temperature and salinity. A large quantity of fresh water was discharged from the sea dyke on 26 July 2000. The observation period fell on neap tide. The amplitude of the tidal elevation and the maximum velocity of the tidal current were about 4 m and 12 cm/sec respectively. The water movement at the surface layer is mainly controlled by wind, and those at the other layers are controlled by semidiurnal tide. The low salinity water less than 22 psu was observed along the northern part during the early observation period while southerly wind prevails. The less saline water moves westward and finally leaves the estuary by easterly wind early on the second day. We can divide the vertical structure into four layers by hydrography and current structure. Mean velocity structure shows that relatively less saline waters at the surface and the middle layer move seaward, and the waters at the upper and the bottom layers move landward. It is thought that the intermittent discharge of river water from the sea dyke makes vertical structure of four layers.

• Korean Journal of Ichthyology
• /
• v.29 no.3
• /
• pp.218-223
• /
• 2017

Using both light and scanning electron microscopies, it was investigated on the visual cells as well as the eyes of Macropodus ocellatus (Pisces, Osphronemidae). This species had a circular lens and yellowish cornea. The eyes had $3.5{\pm}0.2mm$ which is $31.1{\pm}3.0%$ in a percentage of eye diameter relative to head length. The retina ($158.2{\pm}10.6{\mu}m$) was built of several layers, including the visual cell layer which consists of three types of cells: single cons ($27.8{\pm}1.6{\mu}m$) and equal double cone ($33.9{\pm}3.7{\mu}m$), and large rods ($57.3{\pm}1.3{\mu}m$). The visual cell layer then was classified into the correct pattern. All visual cells were clearly distinguished from two parts (inner and outer segments). The elongated rod cells were extend to the bottom of the retinal pigment epithelium. In scanning electron microscopy, the outer segment links to inner segment by so-called calyceal piles. The M. ocellatus single and double cones appearance form a flower-petal arrangement, which is a regular mosaic pattern that contains quadrilateral units by four double cones surrounding a single cone.

• Conservation Science in Museum
• /
• v.15
• /
• pp.78-95
• /
• 2014

To examine the materials, production techniques, and key features of Goryeo wooden lacquerwares, scientific analysis was conducted on six relevant lacquerware items. All of the items, except for a lacquered bowl ^{duksu 4123}, were found to have been made by first covering the surface of the wood with cloth and then varnishing with lacquer. The wooden frames of flower-shaped lacquered case and pine leaves shape lacquered case were made by wrapping thin wood around either the lid or bottom panel. In most cases, microscopic analysis revealed a lower layer of lacquer mixed with bone ash and bone dust, followed by an upper varnish layer of lacquer. SEM-EDS analysis and μ-XRF ^{Micro-X-ray Fluorescence} analysis showed that vermilion lacquer mixed with cinnabar was used on the surface. A lid decorated with a dot pattern was made by first varnishing the surface with yellow lacquer mixed with orpiment, and then irregular dot pattern with a mixture of black lacquer and soot. The vermilion lacquer used to varnish the side of the lacquered bowls was composed of lacquer mixed with cinnabar and minium ^{Red Lead}.

• Journal of the Korea Concrete Institute
• /
• v.23 no.2
• /
• pp.169-176
• /
• 2011

In this study, the flexural test for reinforced high performance fiber reinforced cementitious composites (R/HPFRCC) members has been conducted in order to investigate the flexural behavior including the effect of an ordinary tensile reinforcing bar. Through the test, it was observed that the flexural strength increased due to the stable tensile stress transfer of HPFRCC, even up to the ultimate state. In addition, no localized crack appeared until the yielding of the reinforcement. From the layered section analysis of the tested members, it was found that the analysis with the tensile model obtained from the tension stiffening test showed better agreement with the flexural test results, whereas the analysis with direct tension test results overestimated the flexural capacity. Through the experimental and analytical studies, two flexural failure modes have been defined in this paper; concrete crushing at the top compression layer or tensile failure at the bottom tensile layer of the beam section. Based on these two flexural failure modes, a simple formula that estimates the ultimate flexural strength of the member has been proposed in this paper. The proposed equations can be useful in a design and an analysis of R/HPFRCC members.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.16 no.4
• /
• pp.343-349
• /
• 1987

This study was executed to investigate proper storage conditions for freshness of lunch-box and prevention of lunch-box borne illness. When boiled rice was put into the empty lunch-box without cooling, temperature of the lunch-box was $70^{\circ}C$ to be able to destroy vegetative cell of microoganism in the lunch-box. Temperature of the side-dish canister that is placed on the hot lunch-box was increased from $15^{\circ}C$ to $53^{\circ}C$. The use of the insulator(one to two layer) between the lunch-box and side-dish canister was effective in insulation of the heat that is conducted from the hot lunch-box to the side-dish canister. The insulation layer(asbestos) was also effective to inhibit the decrease of pH value and growth of microoganisms in the toiled rice and side-dish during storage of the lunch-box. The number of microoganisms in the lunch-box covered without cooling was less than in the case of lunch-box covered after cooling; however, the amount of generation in condensed water that is responsible for swelling of boiled rice in the lunch-box occurred much more in the one than in the other, and was a little generated in the case of high temperature storage, insulator use, and when covering the lunch-box after cooling, and pre-evaporation by stirring boiled rice in the cooking pot before filling it. In addition, inserting the heat insulators on and bottom of the lunch-box the boiled rice can be eaten without coldness in winter season.

• 한국해양학회지
• /
• v.25 no.2
• /
• pp.106-116
• /
• 1990

The dynamics and seasonal succession of dinoflagellate community, and their correlations with environmental parameters were investigated during the period from April, 1986 to March, 1987 at 6 selected stations in Masan Bay, Korea. The dinoflagellate standing crops varied extensively with months and stations: ranging from 44 to 2,789,900 cella/ l at surface layer and from 52 to 165,714 cells/ l at bottom layer, respectively. The distribution of standing crops by size class of dinoflagellate species showed that a group of 20-um size class was predominant throughout the present survey, since the most of dominant species have belonged to the size category. Among dominant species, Gyrodinium fissum was most dominant throughout the year in all sampling stations, particulary in June. Scripsiella trochoidea was predominant in May, Protoperidinium bipes and Prorocentrum minimum from June to September, Prorocentrum triestinum, P micans and Ceratium fusus from September to December, and Heterocapsa triquetra from December to April. The stepwise multiple regression analysis between dinoflagellate and environmental parameters revealed that salinity, nitrate-N, pH, and transparency were correlated with the variations of standing crops of dinoflagellate.

• Journal of the Korean Society for Marine Environment & Energy
• /
• v.5 no.2
• /
• pp.3-18
• /
• 2002

This study has been carried out to find the water Quality in coastal sea of fungmun area, southern Jeju Island. In-situ observations and water sampling had been made every month from July 1997 to June 2000. The distributions of water temperature and salinity over the study area have been 13.8~27.0℃ and 30.0~34.7‰, respectively. Salinity is showed low salinity from June to September (rainy season) because of rain. Tsushima Warm Waters (TWW) as ≥15℃ and ≥34‰ influence the adjacent sea around Jeju Island all year round. Yangtse Coastal Waters (YCW) influence the surface layer around Jeju from June to September and so strong stratification (termocline, halocline) resulted at the depth of between 20~30m at outer-sea. However the stratification does not happen even in summer at inner-sea, which seem to be caused due to vertical mixing by wind, waves and tides. A water mass of high value of water temperature and salinity (respectively 14.1~17.7℃, 33.9~34.1‰) stayed at the lower layer in outer-sea all the year round. It is probably formed by mixing between TWW and YSBCW(Yellow Sea Bottom Cold Water). The mean value of DO was the lowest in summer and the highest in winter. COD and TH were the highest in summer and the lowest in winter. However, TP showed the lowest value in summer season, because the mean value of N/P ratio was over 16. The mean of N/P ratio was under 16 in other seasons. The phosphate would be a limiting factor in the growth of phytoplanHon in summer. Nitrate would be a limiting factor in other seasons. Distribution of chlorophyll a did not show any seasonal change in the study period, but especially increased during April and May in the first year(1998) and the second year(1999) all over the study area, which suggested that phytoplankton inhabitation distributed widely in the study area. The space averaged values were the highest for TIN in rainy season and lower for TP in rainy season than in other seasons. It suggests that river runoff influences the inner-sea.