• 한국신재생에너지학회:학술대회논문집
• /
• 2007.06a
• /
• pp.713-716
• /
• 2007

Interests have been focused to the renewable energy because energy cost of fossil fuel increased and global climate change caused by CO2 evolution became severe. To overcome these problems, it is essential to develop the energy conversion technologies of renewable resources. Therefore, production and utilization state of wood and woody waste was firstly investigated and then various technologies (pyrolysis, gasification, and combustion) converting the wood and woody waste to energy were summarized. Some case studies of woody waste utilization in europe was introduced with the policy of EU countries. Economical aspect of woody waste was compared with the current fossil fuels and the energy policy of wood and woody waste was suggested.

• Transactions of the Korean hydrogen and new energy society
• /
• v.30 no.1
• /
• pp.35-42
• /
• 2019

Recently, the gradual increase in energy acceptance is mostly satisfied by fossil fuels, but research and development of renewable energy sources are attracting attention due to fossil fuel supply and greenhouse gas problem. The disadvantage is that renewable energy can not be produced continuously. This being so, energy storage is an important technology in renewable energy. In this study, microwave was used to convert carbon receptor-carbon dioxide to gas fuel.

• Journal of Energy Engineering
• /
• v.19 no.4
• /
• pp.221-227
• /
• 2010

In this study, we consider gas generation characteristics on pyrolysis of eco-fuel which were made by mixing of Pitch Pine and Lauan sawdust as biomass and polyethylene, polypropylene, polystyrene as municipal plastic wastes with catalyst in fixed bed reactor. From the result of higher heating value(HHV) measurement and of ultimate analysis, the heating value of plastic wastes and a hydrogen content in plastic sample are higher than biomass. An activation energy was reduced by a catalyst addition. However the catalyst content influence over 5 wt% was insignificant. The yield of hydrogen from gasification of biomass containing plastic wastes such as polyethylene, polypropylene and polystyrene were obtained higher than that of sole biomass. The high temperature and mixture ratio of catalyst conditions induced to high hydrogen yield in most of the samples. As the influence of catalyst, the hydrogen yield by catalytic reaction was higher than non-catalytic reaction. We confirmed that Ni-$ZrO_2$ catalyst is more active in increasing the hydrogen yield in comparison with that of carbonate catalyst. The maximum hydrogen yield was 65.9 vol.%(Pitch Pine / polypropylene / 20 wt.% Ni-$ZrO_2$(1:9) at $900^{\circ}C$).

• Resources Recycling
• /
• v.19 no.2
• /
• pp.45-53
• /
• 2010

During the biomass gasification, tar generation is typically accompanied, which causes many problems, such as pipe plugging and equipment fouling. In the experiments, activated carbon was applied to the upper reactor of the two-stage gasifier in order to remove the tar generated during gasification. In addition, the effects of the upper-reactor temperature and equivalence ratio on the producer gas characteristics (composition, tar content and lower heating value) were investigated. To investigate the effect of the upper reactor-temperature, experiments were performed at 743, 793, $838^{\circ}C$, respectively. To examine the influence of the equivalence ratio, a comparison experiment was carried out at a equivalence ratio of 0.17. In all experiments, tar contents in the producer gases were below $2mg/Nm^3$. The maximum LHV of the producer gas was above $10MJ/Nm^3$, which is much higher than the typical LHV($3\sim6MJ/Nm^3$) in the air gasification of biomass.

• Clean Technology
• /
• v.19 no.3
• /
• pp.226-232
• /
• 2013

A 5 kg/hr scale integral dual fluidized-bed gasifier for producing medium heating value syngas from biomass or combustible wastes was manufactured. The effect of operating variables including gasification temperature, rate of feeding, and weight ratio of steam/feed on the behavior of the gasifier was investigated. The contents of $H_2$ and CO in syngas, flow rate of feeding, cold gas efficiency increased with the increased gasification temperature or rate of feeding, but decreased with the increased weight ratio of steam/feed within the experimental range. With wood powder as the feed, the concentrations of $H_2$ and CO in the syngas were as high as 41% and 32%, and the cold gas efficiency and lower heating value of the syngas were as high as 70.1% and $3,428kcal/Nm^3$. With food wastes as the feed, the concentrations of $H_2$ and CO in the syngas were as high as 37% and 23.9%, and the cold gas efficiency and lower heating value of the syngas were as high as 66.7% and $3,670kcal/Nm^3$.

• Transactions of the Korean hydrogen and new energy society
• /
• v.21 no.5
• /
• pp.452-459
• /
• 2010

This study is aimed to investigate changes of combustion characteristics and heat efficiency when syngas from gasification process using low-rank fuel such as waste and/or biomass is applied partially to an industrial boiler. An experimental study on syngas co-combustion was performed in a 0.7 MW (1 ton steam/hr) water tube boiler using heavy oil as a main fuel. Three kinds of syngas were used as an alternative fuel: mixture gas of pure carbon monoxide and hydrogen, syngas of low calorific value generated from an air-blown gasification process, and syngas of high calorific value produced from an oxygen-blown gasification process. Effects of co-combustion ratio (0~20%) for each syngas on flue gas composition were investigated through syngas injection through the nozzles installed in the side wall of the boiler and measuring $O_2$, $CO_2$, CO and NOx concentrations in the flue gas. When syngas co-combustion was applied, injected syngas was observed to be burned completely and NOx concentration was decreased because nitrogen-containing-heavy oil was partially replaced by the syngas. However, heat efficiency of the boiler was observed to be decreased due to inert compounds in the syngas and the more significant decrease was found when syngas of lower calorific value was used. However, the decrease of the efficiency was under 10% of the heat replacement by syngas.

• Clean Technology
• /
• v.22 no.1
• /
• pp.53-61
• /
• 2016

Steam reforming of tar produced from biomass gasification was conducted using several Ni-based catalysts. In labscale, the catalytic steam reforming of toluene which is a major component of biomass tar was studied. A fixed bed reactor was used at various temperatures of 400-800 ℃. Ru (0.6 wt%) and Mn or K (1 wt%) were applied as a promoter in Ni based catalysts. Generally, Ni/Ru-K/Al₂O₃ catalyst shows higher performance on steam reforming of toluene than Ni/Ru-Mn/Al₂O₃ catalyst. Used catalysts were analyzed by XRD and TGA to detect sintering and carbon deposition. Base on the lab-scale studies, the monolith and pellet type catalysts were tested in 1 ton/day scale biomass gasification system. Ni/Ru-K/Al₂O₃ monolith catalyst shows high tar reforming performance at high temperature. In addition, Ni/Ru-Mn/Al₂O₃ monolith catalyst was showed deactivation with operation time. Reforming performance of Ni/Ru-K/Al₂O₃ pellet catalyst which showed 66.7% tar conversion at 587 ℃ was compared to regenerated one. Overall, Ni/Ru-K/Al₂O₃ pellet catalyst shows higher stability and performance than other used catalysts.

• 한국신재생에너지학회:학술대회논문집
• /
• 2007.06a
• /
• pp.594-597
• /
• 2007

바이오매스를 이용한 분산형 발전 및 에너지화의 경우 기존의 연소법은 단순 열에너지의 이용과 스팀터빈을 이용하는 대규모 시설이 요구된다. 반면 가스화의 경우 가연성 합성가스 생성을 통하여 소규모 분산형 발전이 가능하며, 생성가스를 이용하여 다양한 응용이 가능하다. 기존 상향류식 가스화의 경우의 바이오매스 가스화시 목질계 내 리그닌 성분으로 인하여 다량의 타르가 발생하여 후단 처리 설비에 어려움이 있다. 본 연구에서는 하향류식 가스화 방법을 통하여 목질계 바이오매스의 가스화 특성을 알아보았다. 가스화기 하부로 배출되는 합성가스의 온도는 대략 1000$^{\cdot}C$까지 유지할 수 있었으며, 생성되는 합성가스의 발열량은 약 $1300kcal/Nm^3$의 수준으로 얻을 수 있었다. 또한 발생되는 타르는 $5{\sim}15ppm$ 정도로 기존 상향류식에 비해 매우 적은양의 타르가 발생함을 확인할 수 있었다.

• Proceedings of the Membrane Society of Korea Conference
• /
• 1993.04a
• /
• pp.41-41
• /
• 1993

Recently, the advanced membrane separation technology has even been applied to the post treatment to biological process of wastewater treatment, since the efficiency of biological treatment significantly depends on maintaining a high biomass concentration in the bioreator. Particularly, anaerobic microbes in the biological system have slower growth rates than aerobic microbes and thus it takes a long hydaulic retention time(HRT) to prevent biomass washout in the completely mixed anaerobic digester. The anaerobic sludge also has poor settleability owing to its diffusible and somewhat filamentous nature. Moreover, the residual gasification and consequent sludge rise in the clarifier compartment become a considerable problem, which proves that complete separation of biological solids is difficult.

• Applied Chemistry for Engineering
• /
• v.27 no.2
• /
• pp.171-178
• /
• 2016

Extensive efforts from all over the world have been made to solve energy problems, such as high oil prices, global warning due to the depletion of oil. Among them, biofuel has been drawing attention as a clean energy, which can replace fossil fuels. However, conventional biofuels were often converted from eatable biomass such as sugar cane, corn and soy which should be replaced with uneatable biomass. In this study, a techno-economical evaluation of the gasification of biomass waste with mixed alcohol synthesis process was performed. Considering available domestic biomass wastes, a 2000 ton/day conversion plant were assumed to produce 533000 L/day ethanol. Also, financial data from previous studies were evaluated and used and economical sensitivities with various operation conditions were established. Economic analysis were conducted by the payback period and internal rate of return (IRR) and net present value (NPV). Sensitivity analyses of raw material costs, initial investment, the major process cost, ethanol price changes and operating costs were all performed.