• Journal of Electrochemical Science and Technology
• /
• v.15 no.2
• /
• pp.253-260
• /
• 2024

Proton exchange membrane water electrolysis (PEMWE) is an efficient method for utilizing renewable energy sources such as wind and solar powers to produce green hydrogen. For PEMWE powered by renewable energy sources, its durability is a crucial factor in its performance since irregular and fluctuating characteristics of renewable energy sources, especially for wind power, can deteriorate the stability of PEMWE. Triangular voltage cycle is well able to simulate fluctuating wind power, but its effect on the durability has not been investigated extensively. In this study, the performance degradation of the PEMWE cell operated with the triangular voltage cycling was investigated at different ramping rates. The measured current responses during the cycling gradually decreased for both ramping rates, and I-V curve measurements before and after the cycling confirmed the degradation of the performances of PEMWE. For both measurements, the degradation rate was larger for 300 mV s^-1 than 30 mV s^-1, and they were determined as 0.36 and 1.26 mV h^-1 (at the current density of 2 A cm^-2) at the ramping rates of 30 and 300 mV s^-1, respectively. The comparison with other studies on triangular voltage cycling also indicate that an increase in the ramping rate accelerates the deterioration of the PEMWE performance. X-ray photoelectron spectroscopy and transmission electron microscopy results showed that the Ir catalyst was oxidized and did not dissolve during the voltage cycling. This study suggests that the ramping rate of the triangular voltage cycling is an important factor for the evaluation of the durability of PEMWE cells.

• 한국생물공학회:학술대회논문집
• /
• 2003.04a
• /
• pp.40-44
• /
• 2003

Soil-borne infectious disease including Pythium aphanidermatum and Rhizoctonia solani causes severe damage to plants, such as cucumber. This soil-borne infectious disease was not controlled effectively by chemical pesticide. Since these diseases spread through the soil, chemical agents are usually ineffective. Instead, biological control, including antagonistic microbe can be used as a preferred control method. An efficient method was developed to select an antagonistic strain to be used as a biological control agent strain. In this new method, surface tension reduction potential of an isolate was included in the ‘decision factor’ in addition to the other factors, such as growth rate, and pathogen inhibition rate. Considering these 3 decision factors by a statistical method, an isolate from soil was selected and was identified as Bacillus sp. GB16. In the pot test, this strain showed the best performance among the isolated strains. The lowest disease incidence rate and fastest seed growth was observed when Bacillus sp. GB16 was used. Therefore this strain was considered as plant growth promoting rhizobacteria (PGPR). The action of surface tension reducing component was deduced as the enhancement of wetting, spreading, and residing of antagonistic strain in the rhizosphere. This result showed that new selection method was significantly effective in selecting the best antagonistic strain for biological control of soil-borne infectious plant pathogen. The antifungal substances against P. aphanidermatum and R. solani were partially purified from the culture filtrates of Bacillus sp. GB16. In this study, lipopeptide possessing antifungal activity was isolated from Bacillus sp. GB16 cultures by various purification procedures and was identified as a surfactin-like lipopeptide based on the Fourier transform infrared spectroscopy (FT-IR), nuclear magnetic resonance (NMR), high performance liquid chromatography mass spectroscopy (HPLC-MS), and quadrupole time-of-flight (Q-TOF) ESI-MS/MS data. The lipopeptide, named GB16-BS, completely inhibited the growth of Pythium aphanidermatum, Rhizoctonia solani, Penicillium sp., and Botrytis cineria at concentrations of 10 and 50 mg/L, respectively. A novel method to prevent the foaming and to provide oxygen was developed. During the production of surface active agent, such as lipopeptide (surfactin), large amount of foam was produced by aeration. This resulted in the carryover of cells to the outside of the fermentor, which leads to the significant loss of cells. Instead of using cell-toxic antifoaming agents, low amount of hydrogen peroxide was added. Catalase produced by cells converted hydrogen peroxide into oxygen and water. Also addition of corn oil as an oxygen vector as well as antifoaming agent was attempted. In addition, Ca-stearate, a metal soap, was added to enhance the antifoam activity of com oil. These methods could prevent the foaming significantly and maintained high dissolved oxygen in spite of lower aeration and agitation. Using these methods, high cell density, could be achieved with increased lipopeptide productivity. In conclusion to produce an effective biological control agent for soil-borne infectious disease, following strategies were attempted i) effective screening of antagonist by including surface tension as an important decision factor ii) identification of antifungal compound produced from the isolated strain iii) novel oxygenation by $H_2O_2-catalase$ with vegetable oil for antifungal lipopeptide production.

• Korean Chemical Engineering Research
• /
• v.52 no.5
• /
• pp.603-612
• /
• 2014

Lots of networks are constructed in a large scale industrial complex. Each network meet their demands through production or transportation of materials which are needed to companies in a network. Network directly produces materials for satisfying demands in a company or purchase form outside due to demand uncertainty, financial factor, and so on. Especially utility network and hydrogen network are typical and major networks in a large scale industrial complex. Many studies have been done mainly with focusing on minimizing the total cost or optimizing the network structure. But, few research tries to make an integrated network model by connecting utility network and hydrogen network In this study, deterministic mixed integer linear programming model is developed for integrating utility network and hydrogen network. Steam Methane Reforming process is necessary for combining two networks. After producing hydrogen from Steam-Methane Reforming process whose raw material is steam vents from utility network, produced hydrogen go into hydrogen network and fulfill own needs. Proposed model can suggest optimized case in integrated network model, optimized blueprint, and calculate optimal total cost. The capability of the proposed model is tested by applying it to Yeosu industrial complex in Korea. Yeosu industrial complex has the one of the biggest petrochemical complex and various papers are based in data of Yeosu industrial complex. From a case study, the integrated network model suggests more optimal conclusions compared with previous results obtained by individually researching utility network and hydrogen network.

• Journal of Korean Society of Environmental Engineers
• /
• v.29 no.9
• /
• pp.1044-1050
• /
• 2007

In this study, Bio-hydrogen is produced from organic waste mixtures containing food waste and waste activated sludge (WAS). The effects of different operational factor on hydrogen production, including various solubilization methods for pretreatments of WAS, pH and different ratios of food waste and WAS, were investigated. The highest hydrogen production values are obtained as 4.3 mL $H_2/g$ $VS_{consumed}$ in the case of applying the mixed pre-treatments of alkali and ultrasonic. The pH value in bio-reactor increased from 4 to 8 after the ultrasonic treatment with alkali and the hydrogen yield touched its highest value in the pH range of 5.0 to 5.5. Similarly, the hydrogen production reached the level of 13.8 mL $H_2/g$ $VS_{consumed}$ using the same pre-treatment method from the mixture of food waste and WAS. The ratio of 2 : 1 produced a maximum amount of hydrogen of 5.0 L $H_2/L/d$. The amount of volatile fatty acids(VFAs) including acetate, propionate and butyrate, were also varied considerably. Propionate decreased consistently with rising of hydrogen while butyrate comparing to acetate relatively increased in the effluent.

• Journal of Korea Technical Association of The Pulp and Paper Industry
• /
• v.37 no.3
• /
• pp.59-65
• /
• 2005

There are accumulations of remained chemical additives and contaminants in the process water of semi-closed linerboard mill. High temperature of the process water aggravates the anaerobic digestion of contaminated process water and causes the generation of hazardous gases, which are from the biological reaction of varied additives and contaminants. The hydrogen sulfide in the gases easily combine with moisture in the air, and become sulfuric acid, which causes corrosion of paper machinery. This hydrogen sulfide is from the reduction of sulfate ions in the process water, and the sulfate ions are mostly from the alum. We changed the alum to PAC (Poly Aluminum Chloride). The results were preventing generation of hydrogen sulfide, and equivalent sizing effect by the use of PAC.

• Korean Journal of Ecology and Environment
• /
• v.38 no.4 s.114
• /
• pp.435-438
• /
• 2005

We observed the physical, chemical, and biological characteristics of an acidic lake, Lake Katanuma, from 1998 to 2002 at weekly or biweekly intervals, except during the winter. This volcanic lake has a dimictic thermal pattern. In summer, the volcanic heat supply at the lake bottom results in weak thermal stratification. In 1998, 1999, and 2002, short-term holomixis was observed during the stratification period, when the anoxic, hydrogen sulfide-rich water from the hypolimnion spread across the entire lake. In contrast, distinct short-term holomixis did not occur during the stratificatlon period in 2000 and 2001. However, the early onset of the autumn turnover in August 2000 and 2001 caused anoxic conditions to persist throughout the entire water column for more than 2 weeks. The anoxic and hydrogen sulfide-rich conditions affected population densities of chironomid larvae (Chironomus acerbiphilus) and planktonic algae (Chlamydomonas acidophila), both dominant species in Lake Katanuma. Thus, the interannual variations of limnological characteristics influenced the seasonal population changes of these species.

• Bulletin of the Korean Chemical Society
• /
• v.30 no.12
• /
• pp.2979-2983
• /
• 2009

Nanowires of polytetrakis(o-aminophenyl)porphyrin (PTAPPNW) were fabricated by electrochemical polymerization with the cyclic voltammetric method in anodic aluminum oxide (AAO) membranes. The glassy carbon electrode (GCE) modified by PTAPPNW, single-walled carbon nanotubes (SWNT) and Nafion as a binder was investigated with voltammetric methods in a phosphate buffer saline (PBS) solution at pH 7.4. The PTAPPNW + SWNT + Nafion/GCE exhibited strongly enhanced voltammetric and amperometric sensitivity towards hydrogen peroxide ($H_2O_2$), which shortened the response time and enhanced the sensitivity for $H_2O_2$ determination at an applied potential of 0.0 V by amperometric method. The PTAPPNW + SWNT + Nafion/GCE can be used to monitor $H_2O_2$ at very low concentrations in biological pH as an efficient electrochemical $H_2O_2$ sensor.

• Journal of Industrial Technology
• /
• v.39 no.1
• /
• pp.41-45
• /
• 2019

Hydrogen sulfide ($H_2S$) is mainly produced along with methane and hydrocarbons in many gas fields as well as hydrodesulfurization processes of crude oils containing sulfur compounds and the emission of $H_2S$ has a considerable effect on both environmental problem and human health aspects due to formation of, e.g. acid rain and smog. In recent years, ionic liquids (ILs) have been proposed as the most promising solvents for $CO_2$ and hazardous pollutants capture, such as $H_2S$ and sulfur dioxide ($SO_2$). In this work, we demonstrate the use of the predictive COSMO-SAC model for the prediction of Henry's law constant of $H_2S$ in ILs. Furthermore, the method is used to screen for potential IL candidates for $H_2S$ capture from a set of 2,624 ILs formed from 82 cations and 32 anions. The effects of cation on the Henry's law constant of $H_2S$ such as (i) the variation of the alkyl chain length on cation, (ii) the substituent of methyl group ($-CH_3$) for H in C(2) position and (iii) the change of ring structure for cation family are clearly predicted by COSMO-SAC model.

• Journal of the Korean Chemical Society
• /
• v.65 no.2
• /
• pp.106-112
• /
• 2021

12 kinds of (-)-catechin derivatives were designed and synthesized. The catechin derivatives were evaluated their antioxidant activities using DPPH method. Most of them showed good antioxidant activity, particularly compounds 1d, 1e and 1j exhibited more activity than butylated hydroxytoluene (BHT). Molecular docking studies for compounds 1d, 1e and 1j with STAT1 showed not only sufficent characteristics binding cavity but also agreement with the observed biological activity. Acording to docking results, the compounds showed greater than hydrogen bonding, hydrophobic interactions, electrostatic interactions, and Van der Waals interactions as compared to the reference compound. They formed hydrogen bonds with important residues such as Lys566, His568, Leu570, and Phe644. The compounds showed a novel hydrogen bonding interaction with Arg649, which was not reported previously. Our results might suggest the compounds could serve as a novel anti-oxidant agent.

• Journal of the Korean Magnetic Resonance Society
• /
• v.24 no.4
• /
• pp.117-122
• /
• 2020

Transcription factors are proteins that bind specific sites or elements in regulatory regions of DNA, known as promoters or enhancers, where they control the transcription or expression of target genes. MEIS1 protein is a DNA-binding domain present in human transcription factors and plays important roles in various biological functions. The hydrogen exchange rate constants of the imino protons were determined for the wild-type containing the consensus DNA-binding site for the MEIS1 and those of the mutant DNA duplexes using NMR spectroscopy. The G2A-, A3G- and C4T-mutant DNA duplexes lead to clear changes in thermal stabilities of these four consensus base pairs. These unique dynamic features of the four base pairs in the consensus 5'-TGAC-3' sequence might play crucial roles in the effective DNA binding of the MEIS1 protein.