• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2000년도 추계학술대회 논문집
• /
• pp.448-451
• /
• 2000

Normal zone propagation(NZP) characteristics were investigated on Ag sheathed Bi-2223 tape and cylindrical stacked conductor. Normal zone propagation(N2P) experiments with tape were conducted with refrigerator in temperature from 45 K to 77 K, 0 T. Cylindrical stacked conductor was molding with epoxy and experiments were conducted with adiabatic condition in $LN_2$. NZP velocities of tape with two condition of DC and AC were almost same at each temperature. NZP velocities of cylindrical stacked conductor were 1.9-2.4 cdsec in $LN_2$. Numerical analysis was carried out by a one-dimensional heat balance equation. As a result, simulated results of NZP velocity with Bi-2223 tape were similar to experimental results in DC.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2005년도 제36회 하계학술대회 논문집 B
• /
• pp.1225-1227
• /
• 2005

A Bi-2223 tape has beer developed for power applications such as a fault current limiter, a power cable and a superconducting magnetic energy storage system. In such applications, the Bi-2223 tape carries time varying transport current and in addition experiences time varying external magnetic field. It is well known that the external magnetic field not only causes magnetization loss in the Bi-2223 tape, but also drastically increases transport loss due to a so-called "dynamic resistance". We developed an evaluation setup, which can measure transport loss in external at magnetic fields. Using this equipment, we measured the dynamic resistances for various amplitudes and frequencies of an external ac magnetic field perpendicular to the face in the tape. Simultaneously we investigated the effect of an external ac field on transport loss with different experimental conditions. This paper describes test results and discussions on correlation between the dynamic resistance and the transport loss for the Bi-2223 tape.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2005년도 제36회 하계학술대회 논문집 B
• /
• pp.1240-1242
• /
• 2005

In this study, we estimate the transport current loss of Bi-2223/Ag tapes with non-uniform current distribution. The conductor was consisted of three Bi-2223/Ag tapes and the each tapes were attached in parallel. The loss of conductor was investigated both numerical and experimental methods. The numerical code to predict ac loss was developed, and finite element method was introduced. It contained intrinsic properties of superconducting tape, which was obtained from nonlinear current voltage relation with external magnetic field and its orientation. Two results were compared and discussed. They showed good agreements with each other.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2007년도 하계학술대회 논문집 Vol.8
• /
• pp.249-250
• /
• 2007

Applying the AC over-currents over the critical current to Bi-2223/Ag tape having 56 A Ie, resistance increase with the duration of current application was measured and analyzed. In addition, the influence of the tape's electrical insulation on the over-current characteristics was investigated and compared with each other. From the results, we will establish the safe operating condition against the AC over-currents and the protection of the tape for the practical power application such as cable and transformer.

• 한국초전도ㆍ저온공학회논문지
• /
• 제8권3호
• /
• pp.59-62
• /
• 2006

For electric power applications of Bi-2223/Ag superconducting tapes, a transport characteristic is important issue. A transport characteristic is strongly depends on the magnitude and direction of external time-varying magnetic field. To verify a effect of external magnetic field, we manufactured a prototype magnet and obtained transport characteristics with respect to the magnitude, the direction and the frequency of external magnetic field. The data acquired in this paper will be used as a source for the study of HTS electric power applications which is supposed to carry on.

• 한국초전도ㆍ저온공학회논문지
• /
• 제5권1호
• /
• pp.31-34
• /
• 2003

Bi-2223 superconducting wires with 55 filaments were fabricated by stacking, drawing process with different heat-treatment histories. Two kinds of powders were prepared. One was pre-annealed at 760-820 $^{\circ}C$ and low oxygen partial pressure, and the other was only calcined state. Before rolling process, round wires were pre-annealed at 760 -820 $^{\circ}C$ and in a low oxygen partial pressure. We confirmed that pre-annealing step was to transform Bi-2212 orthorhombic structure from Bi-2212 tetragonal structure and to reduce the formation of second phases at superconducting wire. However Bi-2223 phases were formed at higher pre-annealing temperature. Bi-2223 conductor was needed frequently annealing at low temperature because pre-annealing at precursor powder brought about decrease in workability. We could achieve highest Je of 6500 A/$\textrm{cm}^2$ at the tape using Bi-2212 orthorhombic phase by introduced slightly overheating at the 1st sintering process.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2001년도 추계학술대회 논문집 Vol.14 No.1
• /
• pp.304-307
• /
• 2001

High quality BSCCO thin films have been fabricated by means of an ion beam sputtering at various substrate temperatures, $T_{sub}$, and ozone gas pressures, $PO_3$. The correlation diagrams of the BSCCO phases appeared against $T_{sub}$ and $PO_3$ are established in the 2212 and 2223 compositional films. In spite of 2212 compositional sputtering, Bi220l and Bi2223 phases as well as Bi2212 one come out as stable phases depending on $T_{sub}$ and $PO_3$. From these results, the thermodynamic evaluations of ${\Delta}H$ and ${\Delta}S$ S, which are related with Gibbs' free energy change for single Bi2212 or Bi2223 phase are performed.

• 한국정보통신학회:학술대회논문집
• /
• 한국해양정보통신학회 2002년도 춘계종합학술대회
• /
• pp.623-626
• /
• 2002

High quality BSCCO thin films have been fabricated by means of an ion beam sputtering at various substrate temperatures, Tsub, and ozone gas pressures, pO$_3$. The correlation diagrams of the BSCCO phases with Tsub and pO$_3$are established in the 2212 and 2223 compositional films. In spite of 2212 compositional sputterina Bi2201 and Bi2223 as well as Bi2212 phases come out as stable phases depending on Tsub and pO$_3$. From these results, the thermodynamic evaluation of ΔH and ΔS, which are related with Gibbs' free energy change for single Bi2212 or Bi2223 phase, was performed.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2001년도 추계학술대회 논문집
• /
• pp.304-307
• /
• 2001

High quality BSCCO thin films have been fabricated by means of an ion beam sputtering at various substrate temperatures, T$\sub$sub/, and ozone gas pressures, PO$_3$. The correlation diagrams of the BSCCO Phases appeared against T7ub and PO3 are established in the 2212 and 2223 compositional films. In spite of 2212 compositional sputtering, Bi2201 and Bi2223 phases as well as Bi2212 one come out as stable Phases depending on T$\sub$sub/ and PO$_3$. From these results, the thermodynamic evaluations of ΔH and ΔS, which are related with Gibbs' free energy change for single Bi2212 or Bi2223 phase are performed.

• 한국전기전자재료학회논문지
• /
• 제16권4호
• /
• pp.343-350
• /
• 2003

Using Bi$_2$Sr$_2$Ca$_2$.$_2$Cu$_3$ $O_{x}$ powders prepared by solid state reaction and spray drying method, the nucleation and growth behaviors of superconducting and second phases were investigated during isothermal heat treatment. When the spray drying power was used in contrast with solid state reaction powder, Bi$_2$Sr$_2$Ca$_2$.$_2$Cu$_3$ $O_{x}$ (2223) phase could be formed at the relatively shot time and second phases were much bigger. Quantitative analysis showed that as the heat treatment time increased, more Bi$_2$Sr$_2$Ca$_2$.$_2$Cu$_3$ $O_{x}$ (2212) changed to 2223 and the major second phase was changed from (Sr,Ca)$_{14}$Cu$_{24}$ $O_{x}$(14:24) to (Sr,Ca)$_2$Cu$_1$ $O_{x}$ (2:l). The superconducting phase formed at the relatively short time 14:24 phase. Following the Bi-free phase of 14:24 Phase, but long time was needed in places far from the 14:24 phase. Following the formation of the 2212 phase near the 14:24 phase, the 2223 phase nucleated preferentially at the interface between the 2212 and 14:24 phases. The preferential nuclcation of 2223 was explained by its structural similarity and low Interfacial energy with both the Bi-free and 2212 Phases.12 Phases.