• Journal of Applied Biological Chemistry
• /
• v.43 no.1
• /
• pp.49-53
• /
• 2000

The in vitro metabolism of a new herbicide pyribenzoxim, {benzophenone O-[2,6-bis[(4,6-dimethoxy-2-pyrimidinyl)oxy]benzoyl]oxime} was studied using rice, barnyardgrass and rat liver microsomes. No metabolism of pyribenzoxim was observed with rice and barnyardgrass microsomes though the cvtochrome P450 was active, which was evidenced by the metabolism of cinnamic acid. With rat liver microsomes, four metabolites (M1, M2, M3, and M4) were produced while parent compound decreased. M1 and M2 were from the hydrolysis reactions and NADPH-dependent metabolites were M3 and M4 (major metabolite) which were hydroxylated by cytochrome P450. They were identified as bispyribac-sodium (M1), benzophenone oxime (M2), {benzophenone O-[2,6-bis[(5-hydroxy-4,6-dimethoxy-2-pyrimidinyl)oxy]-benzoyl]oxime}(M3), and {benzophenone O-[2[(5-hydroxy-4,6-dimethoxy-2l-pyrimidinyl)6-(4,.6dimethoxy-2-pyrimidinyl)oxy]benzoyl]oxime} (M4) through LC/MS/MS analyses. Based on the results obtained metabolic map of pyribenzoxim is proposed.

• Membrane and Water Treatment
• /
• v.7 no.6
• /
• pp.507-520
• /
• 2016

The effect of ZnO on cellulose acetate in the removal of benzophenone-3 (BP-3) was investigated. The benzophenone-3 (BP-3) which is an endocrine disrupting chemical (EDC) was completely removed (100%) from the drinking water using Cellulose Acetate (CA) and zinc oxide (ZnO) composite membranes. The membranes were prepared by DIPS method and the filtration experiments were conducted by dead end filtration unit. The macrostructure of the membrane were studied by ATR-IR and XRD Spectra's. Atomic force microscopy (AFM) and Scanning electron microscopy (SEM) were used to study the micro properties of the membranes. The laboratory experiments such as water uptake study and pure water flux performed to confirm the increasing hydrophilicity. The enhancing hydrophilicity was confirmed with respect to higher the concentration of nanoparticles. Evaluation of BP-3 removal was carried in different experimental conditions, such as, different Trans membrane pressure and different concentration of feed. The membrane with low pressure showed better performance by rejecting 100% of BP-3. However, 1 ppm, 3 ppm and 6 ppm of feed solution was used and among them 3 ppm of feed solution gives 100% rejection. The ZnO nanoparticales enhances the performance of CA membrane by showing maximum rejection.

• Environmental Analysis Health and Toxicology
• /
• v.16 no.3
• /
• pp.121-126
• /
• 2001

Analytical method of benzophenone (BP) in sediment and soil was developed by gas chromatography/mass selective detector/selected ion monitoring (GC/MSD/SIM). The ultrasonic extraction of US EPA (method 3550B) method and liquid-liquid extraction for sediment and soil samples were used for the analysis of BP from sediment and soil. BP was extracted with n-hexane. Organic layer was washed with 5% sodium chloride solution. 1∼2 l of the concentrated solution of organic layer was applied to GC/MSD. The retention time of BP peak was 11.10 min. Recovery (％) of BP by ultrasonication from sediment and soil samples was 96.0∼100.6％ and 40.0∼83.0％, respectively. Recovery of BP by liquid-liquid extraction was 51∼59％ in soil samples. The detection limit of BP in sediment and soil samples were determined to 0.1 ng/g.

• Analytical Science and Technology
• /
• v.18 no.2
• /
• pp.147-153
• /
• 2005

Benzophenone (BP) which is one of endocrine disrupting chemicals is suspected to contaminate waters (river, lake and industrial drainage) and soils (ground soil and sediment). Analytical method for determination of BP in soil and water was developed by gas chromatography/mass spectrometry. Water sample (100 mL) was extracted with n-hexane, and soil (10 g) was extracted with methanol and n-hexane. Recovery for BP was >71.4% in water and 86.5-94.7% in soil with coefficient variation of less than 19.8%. Calibration curves showed a good linearity ($r^2$ >0.998). In water, soil and sediment collected at nation-wide sites, BP was detected at 5 sites among 43 water sites at the concentration range of 30-200 ng/L. No BP was found in the soil and sediment samples. It is suggested that this method will be useful to the determination of BP in the environmental matrices such as waters, soils and sediments in minute quantities.

• Bulletin of the Korean Chemical Society
• /
• v.34 no.7
• /
• pp.2191-2194
• /
• 2013

• Korean Chemical Engineering Research
• /
• v.52 no.3
• /
• pp.321-327
• /
• 2014

Polymer dispersed liquid crystal lenses of the cell gap of $11{\mu}m$ and $30{\mu}m$ were made from a uniformly dispersed mixture of 40 wt% NOA65 prepolymer - 60 wt% E7 liquid crystal with the variations of the additional photoinitiator. The photoinitiator, benzophenone of 5.0 wt% was originally in the commercial prepolymer NOA65. In this works, the influence of the benzophenone amount intentionally added in the commercial NOA65 on the electrical properties of polymer dispersed liquid crystal lens for smart electronic glasses. The additional quantities of the photoinitiator were 1, 2, 4, 8 and 16 wt% of the weight of NOA65 - E7 mixture. All the electro-optical properties of the sample with added benzophenone such as the driving voltage, the slope of the linear region, the response time and contrast ratio were more improved than that of commercial NOA65 only. These improvements were due to the increase of the average size of E7 liquid crystal droplets in the samples with the increase of the added benzophenon amount. The liquid crystal droplet size was increased from $5.3{\mu}m$ to $12.2{\mu}m$ when the photoinitiator was added from 0 wt% to 8 wt%. At the same concentration range of the photoinitiator, the driving voltage was ranged from 11.1 V to 17.3 V. The slopes of the linear region were in the range of 10.35~13.96 %T/V, which were more enhanced than that of NOA65 without the additional benzophenone. In particular, though the deteriorations by cell gap of $11{\mu}m$ were so effective to offset the influence of the added benzophenone for both rising and falling response time, it is confirmed that there were still somewhat improvement by the additional benzophenone. Response time and contrast ratios of all the samples with excess benzophenone were slightly enhanced.

• Macromolecular Research
• /
• v.14 no.3
• /
• pp.300-305
• /
• 2006

The chemical structure of a semi-aromatic polyimide-I, which was prepared by the chemical imidization of cyclopentanetetracarboxylic dianhydride and 2,2-bis(4-aminophenyl)hexafluoropropane, was characterized by $^{13}C-NMR$ spectroscopy. The chemically imidized polyimide-I was used for the preparation of a photosensitive polyimide (PSPI) through the addition of benzophenone and benzophenone oxime hexamethylene diurethane (BOHD), a photobase generator containing oxime-urethane groups. The polyimide-I film containing benzophenone and BOHD was not soluble in 2.38 wt% tetrabutylammonium hydroxide solution in $H_2O$. However, it became soluble following irradiation with 310 nm UV light. A positive tone image with a resolution of $5{\mu}m$ was obtained with this PSPI, having sensitivity($D_c$) of $1.2J/cm^2$ and contrast(${\gamma}_p$) of 1.08. Thus, a polyimide, which is not intrinsically photosensitive, can become photosensitive through the addition of a photobase generator containing oxime-urethane groups as a photosensitive compound.

• Analytical Science and Technology
• /
• v.16 no.1
• /
• pp.59-69
• /
• 2003

Benzophenone (BZP) and 4-nitrotoluene (4-NT) listed as endocrine disrupting chemicals are suspected to contaminate ground water sites and soil. Analytical method for simultaneous determination of the two chemicals in soil and ground water was developed by gas chromatography-mass spectrometry. Water (100 ml) was extracted with hexane, and soil (10 g) was extracted with methanol and hexane. Recovery in water was >72% for BZP and 90-118% for 4-NT. Recovery for 4-NT and BZP in soil was 51-59% with coefficient variation of less than 19.5%. Calibration curves showed a good linearity with $r^2=0.997$. In water and soil collected at nation-wide sites, BZP was found at 5 sites among 43 water sites at the concentration of $14.87{\pm}3.83ng/100 ml$. No 4-NT was found. It is suggested that this method is appropriate to the simultaneous quantitation of 4-NT and BZP in ground water and soil samples.

• Textile Coloration and Finishing
• /
• v.22 no.3
• /
• pp.214-219
• /
• 2010

Polyethylene(PE) films were photocrosslinked by continuous UV irradiation. Benzophenone addition as low as 1wt% into the PE film increased the gel fraction up to 96%. The photocrosslinking was attributed to the recombination of PE radicals generated upon UV irradiation, which was enhanced by the hydrogen abstraction of the added benzophenone. Also the crossliked PE showed higher thermal stability and decreased crystallinity with increasing UV energy as shown by TGA, XRD and DSC analysis. It was also possible to fix 5.4% octadecane into PE by the photocrosslinking. The crosslinked PE film containing octadecane showed lower tensile strength and modulus coupled with higher extension compared to that without octadecane, which can be used as a new plasticizing method for the crosslinked PE film.

• Journal of the Korean Chemical Society
• /
• v.46 no.2
• /
• pp.139-144
• /
• 2002

The nickel-catalyzed reation of 1,1'-bis(dimethysilyl)ferrocene[1] with carbonyls such as benzaldehyde, 4-cyaonbezaldehyde, trimethylacetaldehyde, acethon, and benzophenone afforded 3-oxa-2,5-disilacyclo-1,1'-ferrocene. In contrast, the reation of [1] with isobutyraldehyde under the same reation condition yielded the diinsertion products formed via the insertion of two aldehyde ligands into the Si-H bond of 1,1'-bis(dimethy)ferrocene.