• 전기학회논문지P
• /
• 제59권3호
• /
• pp.288-292
• /
• 2010

Recently, in energy storage system, the EDLC is paid attention as a new environmentally friendly energy storage element. This capacitor has higher energy density than the electrolytic capacitor. Also, this capacitor has a lot of advantage such as no maintenance, longer life cycle and faster charge-discharge time than the battery system. But the EDLC must have a each charge-discharge controller to effectively control, an energy design method circuit to use effectively energy, and several compensation techniques to control a optimal operating. In this respect, this study suggests major parameters to effectively represent the characteristics of EDLC, the measurement methods of those parameters have been investigated with experiments, and the interpretation about the buck/boost DC/DC converter for the operation of EDLC.

• Journal of Electrochemical Science and Technology
• /
• 제10권1호
• /
• pp.82-88
• /
• 2019

Here, we report on nanocrystalline Si-Al-M (M = Fe, Cu, Ni, Zr) alloys for use as an anode for lithium-ion batteries, which were fabricated via a melt-spinning method. Based on the XRD and TEM analyses, it was found that the Si-Al-M alloys consist of nanocrystalline Si grains surrounded by an amorphous matrix phase. Among the Si-Al-M alloys with different metal composition, Ni-incorporated Si-Al-M alloy electrode retained the high discharge capacity of 2492 mAh/g and exhibited improved cyclability. The superior $Li^+$ storage performance of Si-Al-M alloy with Ni component is mainly responsible for the incorporated Ni, which induces the formation of ductile and conductive inactive matrix with crystalline Al phase, in addition to the grain size reduction of active Si phase.

• 전력전자학회논문지
• /
• 제21권1호
• /
• pp.72-79
• /
• 2016

Uninterruptible power supplies are extensively used as backup power in various applications such as telecommunication systems, Internet data centers, hospitals, and military technologies. Some of these applications require a considerable number of batteries, and the maintenance of such batteries is critical for the reliability of a system. However, batteries are chemical energy storage devices that deteriorate over time and frequently inspecting their performance and suitability is difficult. A real-time remote battery inspection system that applies electrochemical impedance spectroscopy is proposed and implemented in this study. The proposed system consists of a small inspection circuit and software for control. The former is developed to monitor the impedance variation of the battery and to diagnose its state. The validity and feasibility of the proposed system is proven by experimental results.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2017년도 전력전자학술대회
• /
• pp.126-127
• /
• 2017

An accurate State Of Charge (SOC) estimation of battery is the most important technique for Electric Vehicles (EVs) and Energy Storage Systems (ESSs). In this paper a new integrated Unscented Kalman Filter-Particle Filter (UKF-PF) is employed to estimate the SOC of a $LiFePO_4$ battery cell and a significant improvement is obtained as compared to the other methods. The parameters of the battery is modeled by the second order Auto Regressive eXogenous (ARX) model and estimated by using Recursive Least Square (RLS) method to calculate value of each element in the model. The proposed algorithm is established by combining a parameter identification technique using RLS method with ARX model and an SOC estimation technique using UKF-PF.

• 한국산업정보학회논문지
• /
• 제27권4호
• /
• pp.29-36
• /
• 2022

기존의 IoT 센서 노드는 배터리로부터 에너지를 공급받아 동작하는데, 넓게 분포되어 다양한 정보를 수집해야 하는 센서 노드의 특성상, 주기적으로 배터리를 새로 교체해야 하는 단점이 존재한다. 이 단점을 극복하기 위해 에너지 하베스팅 시스템을 통해 태양광이나 고온 증기 등으로부터 에너지를 수확할 수 있다. 하지만, 기존의 에너지 하베스팅 시스템은 공급전력이 상당히 제한적이기 때문에 통신과 같이 순간적으로 높은 전력을 요구하는 어플리케이션을 활용하기가 어렵다. 이 논문에서 우리가 제안하는 고출력 에너지 하베스팅 시스템은 기존 에너지 하베스팅의 단점을 보완한 Switch Control Unit을 설계하여 수확된 에너지양과 어플리케이션 동작 모드에 따라 수확된 에너지를 에너지 저장장치에 저장하거나 수확 및 저장된 에너지를 순간적으로 모두 어플리케이션에서 사용할 수 있도록 구상하였다. 제안한 시스템을 검증하기 위해 태양광을 기반으로 한 에너지 하베스팅 시스템을 구현하였으며 각각의 동작 모드에 따라 어플리케이션에 공급하는 전력량과 에너지 저장장치의 용량에 따른 최대 공급 시간을 확인하였다.

• 설비공학논문집
• /
• 제29권12호
• /
• pp.638-644
• /
• 2017

Optimal cooling operation algorithm was developed based on a simulation case of a single family house model equipped with renewable energy facility. EnergyPlus simulation results were used as virtual test data. The model contained three energy storage elements: thermal heat capacity of the living room, chilled water storage tank, and battery. Their charging and discharging schedules were optimized so that daily electricity bill became minimal. As an optimization tool, linear programming was considered because it was possible to obtain results in real time. For its adoption, EnergyPlus-based house model had to be linearly approximated. Results of this study revealed that dynamic cooling load of the living room could be approximated by a linear RC model. Scheduling based on the linear programming was then compared to that by a nonlinear optimization algorithm which was made using GenOpt developed by a national lab in USA. They showed quite similar performances. Therefore, linear programming can be a practical solution to optimal operation scheduling if linear dynamic models are tuned to simulate their real equivalents with reasonable accuracy.

• 태양에너지
• /
• 제17권2호
• /
• pp.43-53
• /
• 1997

Characteristics and properties of batteries applicable to the photovoltaic system are described in this paper. The use of a number of different types of batteries and designs depends on the many and varied requirements for battery power and the different environmental and electrical conditions under which they must operate. Most of the batteries used in PV systems are lead/acid batteries, though nickel/cadmium batteries are used for small applications in locations with extreme climates or where high reliability is essential such as spacecraft. The vanadium redox battery has been acknowledged as a promising energy storage system for a wide range of applications.

• 전기전자학회논문지
• /
• 제23권2호
• /
• pp.350-357
• /
• 2019

본 연구에서는 전체 태양광발전소의 80%를 차지하고 있는 소규모 태양광발전소의 에너지저장장치 연계에 따른 시스템 효율을 분석하였다. 설치용량이 100kW인 태양광발전소의 데이터를 수집하고 각 발전소의 PCS와 배터리의 용량에 따른 ESS 효율의 상관관계를 도출하였으며 결론적으로 배터리의 방전속도에 영향을 미치는 C-Rate의 수치가 높을수록 ESS의 방전효율이 높아지는 것으로 나타난다.

• Journal of information and communication convergence engineering
• /
• 제21권4호
• /
• pp.316-321
• /
• 2023

In this study, we developed a conversion core that produces power by utilizing the unused magnetic field in a switchboard. The conversion core makes it possible to utilize power that is normally wasted. The conversion core is composed of a core, filter, and battery. A prototype was installed in a switchboard to conduct tests on the output, battery storage, and output boosting of multiple batteries. Energy was harvested from the magnetic field generated by a busbar of the switchboard, and the power conversion ratio of the core yielded 1.08-1.01 mW per 1 A of bus current. Supplying this technology to the market after further R&D and commercialization is expected to greatly assist in the dissemination of energy harvesting, which has not yet spread widely to the general public.

• Korean Chemical Engineering Research
• /
• 제51권6호
• /
• pp.671-676
• /
• 2013

최근에 대용량 에너지 저장 시스템으로 레독스 흐름전지(Redox Flow Battery, RFB)가 활발히 연구 개발되고 있다. 불소계막을 대신할 저가의 탄화수소막이 RFB막으로 주목받고 있다. 본 연구에서는 Poly(arylene ether sulfone) (PAES) 막을 사용해 고가의 불소계막과 그 특성을 바나듐 레독스 흐름전지(VRB, Vanadium Redox Flow Battery)조건에서 비교하였다. 바나듐 이온투과도, 이온 교환 용량, OCV 변화, 팽윤, 충 방전 곡선, 에너지 효율 등을 측정했다. PAES 막은 Nafion 117막에 비해 바나듐 이온투과도가 낮고, 이온교환용량은 커서 Nafion 117을 사용한 RFB보다 에너지 효율이 높았다.