• 전자공학회논문지A
• /
• 제31A권8호
• /
• pp.91-99
• /
• 1994

Damage induced by Si ion implantation and its annealing behavior during rapid thermal annealing were investigated by cross-sectional TEM (transmission electron microscopy) and RB ( Rutherford backscattering) spectrum. 150keV and 50keV Si ions were implanted in Si (100) at room temperature with doses of 2${\times}10^{15}cm^{-2}$. And 100keV Si ions were implanted in Si with doses from 1${\times}10^{14}cm^{-2}$. A variety of damage structures were generated by Si ion implantation such as continuous amorphous layer extending to the surface buried amorphous layer and damage clusters. Damage clusters are annealed out at the lower annealing temperature of 550 $^{\circ}C$. However, event at the temperature of 110$0^{\circ}C$ end of range loops remain in the original lower amorphous/crystal interface in the case of continuous and buried amorphous layer formation. Extended defects in the shape of zipper dislocations are also observed at the middle of the recrystallized region in the buried amorphous layer.

• Journal of the Optical Society of Korea
• /
• 제14권3호
• /
• pp.199-203
• /
• 2010

A mobile direct detection Doppler LIDAR based on molecular backscattering for measurement of wind in the stratosphere has been developed in Hefei, China. First, the principle of wind measurement with direct detection Doppler LIDAR is presented. Then the configuration of the LIDAR system is described. Finally, the primary experimental results are provided and analyzed. The results indicate that the detection range of the designed Doppler LIDAR reached 50 km altitude, and there is good consistency between the molecular Doppler wind LIDAR(DWL) and the wind profile radar(WPR) in the low troposphere.

• Journal of Advanced Research in Ocean Engineering
• /
• 제2권4호
• /
• pp.202-208
• /
• 2016

In this paper, we propose novel seabed sediment classification algorithm using feature obtained by continuous wavelet transform (CWT). Contrast to previous researches using direct reflection coefficient of seabed which is function of frequency and is highly influenced by sediment types, we develop an algorithm using both direct reflection signal and backscattering signal. In order to obtain feature vector, we employ CWT of the signal and obtain histograms extracted from local binary patterns of the scalogram. The proposed algorithm also adopts principal component analysis (PCA) to reduce dimension of the feature vector so that it requires low computational cost to classify seabed sediment. For training and classification, we adopts K-means clustering algorithm which can be done with low computational cost and does not require prior information of the sediment. To verify the proposed algorithm, we obtain field data measured at near Jeju island and show that the proposed classification algorithm has reliable discrimination performance by comparing the classification results with actual physical properties of the sediments.

• 한국세라믹학회지
• /
• 제35권11호
• /
• pp.1148-1154
• /
• 1998

Ga K-edge EXAFS spectra of PbO-Ga2O3 glasses were recorded at liquid nitrogen temperature and analyz-ed in order to quantitatively understand the medium-range-order arrangement around gallium in the glasses. The second peak was generated from a backscattering of the neighbor balliums and the Ga-Ga distance is ~3.13 A with Ga coordination number of ~2.7 Therefore GaO4 tetrahedra are connected through the cor-ner~sharing mode and form their own clusters made of the tetrahedra sharing more than 3 corners while some chains or rings are also present. These connection schemes of the GaO4 tetrahedra are believed to form the substantial part of the network structure.

• E2M - 전기 전자와 첨단 소재
• /
• 제10권1호
• /
• pp.39-44
• /
• 1997

Bulk type radiation detector of Au/Cd$_{1-x}$ Zn$_{x}$Te(x=20%)/Au structure using Cd$_{1-x}$ Zn$_{x}$Te(x=20%) wafer(3x4xl mm$^{3}$) grown by high pressure Bridgman method has been developed. We etched wafer surfaces with 2% Br-methanol solution and coated gold thin film on the surfaces by electroless deposition method for 5 min. in 49/o HAuCI$_{3}$ 4H20 solution. Initial etch rates of Cd, Zn and Te were 46%, 12% and 42% respectively. After etched, the surface of wafer was slightly revealed to Te rich condition. The leakage current was increased with etch time, but it didn't exceed 3nA at 50volt. The thickness of Au film was about 100nm by Rutherford Backscattering Spectroscopy(RBS). The resolution were 6.7% for 22.1 keV photon from 109 $^{109}$ Cd and 8.2% for 59.5 keV photon from $^{241}$ Am. The radiation detector such as Au/Cd$_{1-x}$ Zn$_{x}$Te(x=20%)/Au structure was more effective to monitor the low energy gamma radiation.iation.

• 한국분말재료학회지
• /
• 제17권6호
• /
• pp.464-469
• /
• 2010

The Cu nanofluid in ethylene glycol was prepared by electrical explosion of wire, a novel one-step method. The X-ray diffraction, field emission scanning electron microscope and transmission electron microscope were used to study the properties of Cu nanoparticles. The results showed that the nanoparticles were consisted of pure face-centered cubic structure and near spherical shape with average grain size of 65 nm. Ultraviolet-visible spectroscopy (UV-Vis) confirmed Cu nanoparticles with a single absorbance peak of Cu surface plasmon resonance band at 600 nm. The nanofluid was found to be stable due to high positive zeta potential value, +51 mV. The backscattering level of nanofluid in static stationary was decreased about 2% for 5 days. The thermal conductivity measurement showed that Cu-ethylene glycol nanofluid with low concentration of nanoparticles had higher thermal conductivity than based fluid. The enhancement of thermal conductivity of nanofluid at a volume fraction of 0.1% was approximately 5.2%.

• Applied Microscopy
• /
• 제45권3호
• /
• pp.183-188
• /
• 2015

Due to the miniaturization of semiconductor devices, their crystal structure on the nanoscale must be analyzed. However, scanning electron microscope-electron backscatter diffraction (EBSD) has a limitation of resolution in nanoscale and high-resolution electron microscopy (HREM) can be used to analyze restrictive local structural information. In this study, three-dimensional (3D) automated crystal orientation and phase mapping using transmission electron microscopy (TEM) (3D TEM-EBSD) was used to identify the crystal structure relationship between an epitaxially grown CdS interfacial layer and a $Cu(In_xGa_{x-1})Se_2$ (CIGS) solar cell layer. The 3D TEM-EBSD technique clearly defined the crystal orientation and phase of the epitaxially grown layers, making it useful for establishing the growth mechanism of functional nano-materials.

• 전기학회논문지
• /
• 제62권2호
• /
• pp.228-231
• /
• 2013

This paper proposes a new method that reduces RCS(rader cross section) of the aluminum plate using a oscillation system composed of a VGA(variable gain amplifier) and a phase shifter. Once the oscillation system receives the external-RF signal through a probe on aluminum plate, it makes an amplified signal with a specific phase to cancel the signal reflected from the aluminum plate. The signal transmitted from the oscillation system has the same amplitude and out of phase with the reflected signal. And it can be controlled by the VGA and the phase shifter in the oscillation system. In order to validate the performance of the proposed oscillation system, FEM simulator was used and we measured how much an amplitude of the signal reflected from the aluminum plate rotated in phi direction is reduced in an anechoic chamber.

• 대한원격탐사학회:학술대회논문집
• /
• 대한원격탐사학회 2003년도 Proceedings of ACRS 2003 ISRS
• /
• pp.667-669
• /
• 2003

A bio-optical model was developed specific for turbid and shallow waters. Special studies were carried out to estimate absorption and scattering properties as well as backscattering probability of suspended matter. The inversion of bio-optical model allows for direct retrieval of turbidity and chlorophyll- a from the visible-near infrared (VNIR) range sensor. Time-series satellite imagery from ASTER AM-1 sensor, were used to monitor the Laguna de Bay water quality condition. Spatial distribution of temperature for the lake was extracted from the thermal infrared (TIR) sensor. Corresponding field surveys were conducted to parameterize the bio -optical model. In-situ measurements include suspended particle and chlorophyll-a concentrations profiles from nephelometric devices and processing of water samples. Hyperspectral measurements were used to validate results of the bio -optical model and satellite- based estimation. This study provides a theoretical basis and a practical illustration of applying space- based measurements on an operational basis.

• 한국진공학회:학술대회논문집
• /
• 한국진공학회 2013년도 제45회 하계 정기학술대회 초록집
• /
• pp.309.1-309.1
• /
• 2013

현재까지 CIGS 박막 태양전지는 습식공정인 화학적 용액성장법을 사용하여 형성된 CdS버퍼층을 적용할 경우에 가장 높은 효율을 보이고 있다. 그러나, Cd의 독성 문제와 진공 공정과 호환되지 않는 습식공정 때문에 비독성 건식 공정 버퍼층에 대한 연구가 활발히 진행되고 있다. 습식 공정 CdS 버퍼층을 대체하기 위하여 CdS에 비해 밴드갭이 커서 단파장에서 광 손실이 적은 ZnS 버퍼층을 cracker 황화법을 이용하여 제작하여 CIGS 박막 태양전지에 적용하였다. ZnS 버퍼층을 성장시키기 위해 DC 스퍼터를 사용하여 Zn 박막을 증착한 후, cracker를 사용하여 황화반응을 시켰다. cracker의 cracking zone 온도에 따른 S 반응성을 ZnS 박막의 투과도 변화를 통하여 관찰하였다. 성장된 ZnS 박막은 X-ray diffraction와 Rutherford backscattering spectrometry을 이용하여 박막의 결정성과 조성을 분석하였고, SEM 측정을 통하여 박막의 단면 및 표면 형상을 관찰하였다. 그리고 reflection electron energy loss spectroscopy 분석을 통해 밴드갭을 측정하였다. $700^{\circ}C$의 cracking zone 온도, 3 nm의 Zn 두께, 1 분의 황화공정 조건에서 제작된 ZnS 박막을 CIGS 태양전지의 버퍼층으로 적용한 결과, 반사방지막 없이 12.6%의 변환효율을 얻었다.