• 한국항공우주학회지
• /
• 제36권5호
• /
• pp.491-496
• /
• 2008

본 연구에서는 RBCC (Rocket Based Combined Cycle)엔진이나 기존 램제트 추진기관의 초기 추력 제공에 과산화수소 가스발생기를 이용하는 새로운 추진시스템을 제안하였고, 기초 연구 수행으로서 촉매 분해된 과산화수소 제트에 케로신을 분사하여 자연발화 및 연소 특성을 연구하였다. 과산화수소는 촉매 베드를 통하여 분해된 후 축소노즐을 통해 연소실로 분사됐으며 이 제트에 인젝터를 통하여 수직으로 케로신을 액상으로 분무하였다. 연소실내에서의 온도와 압력을 측정하여 점화를 확인하고 자연발화 특성을 조사하였다. 400°C의 연소실 온도와 연료와 산화제 혼합비 0.6이상에서 자연발화와 안정적인 연소가 가능하였다. 이 결과를 통하여 램제트의 새로운 초기 가속장치의 가능성을 확인할 수 있었다.

• 대한기계학회논문집B
• /
• 제30권5호
• /
• pp.465-471
• /
• 2006

Controlled auto-ignition(CAI) combustion, offers the potential to improve fuel economy and reduce emission simultaneously. In this study, CAI-combustion was achieved in a single cylinder gasoline DI engine with modified camshafts in order to restrict the gas exchange process. We investigated the effects of air-fuel ratio, residual EGR rate and injection timing such as early injection and late injection on the attainable CAI combustion region. The effect of injection timings on combustion characteristic such as start of combustion, combustion duration and heat release rate was also investigated. From the result early injection causes the mixture to ignite earlier and burn more quickly due to the exothermic reaction during the recompression and gives rise to good mixing of the fuel/air. On the other hand, late injection extended the operation region more than early injection but the emissions of HC and NOx were more or less increased than early injection.

• 대한기계학회논문집B
• /
• 제22권12호
• /
• pp.1681-1690
• /
• 1998

The aim of this paper is to investigate combustion characteristics of lean premixed mixture stabilized by catalytic surface reaction. The catalytic combustor consisted of a catalyst bed and a thermal combustor. The catalyst bed was made of two stage, Pd catalyst in the first stage and Pt catalyst in the second stage. Auto ignition of lean mixture took place in the thermal combustor. Ignition temperature was about $810{\sim}820^{\circ}C$ at the fuel-air ratio of 1.5~3.0 % and the mixture velocity of 11~18m/sec. The position of flame front in the thermal combustor moved toward back as preheat temperature increased and fuel-air ratio decreased. The f1ame supported by surface reaction was stabilized without any flame stabilizers. NOx emissions from the catalytic combustor were below 2.0 ppm ($O_2$ 15 %) when gas temperature was limited below $1350^{\circ}C$. This result demonstrates that NOx emission from the catalytic combustor is much low comparing with conventional combustors.

• 동력기계공학회지
• /
• 제13권2호
• /
• pp.5-10
• /
• 2009

In recently, studies concerned to the diesel engine uses a natural gas as a fuel oil whose infra has been built already was approached to PCCI or HCCI with keeping a high thermal efficiency and reducing NOx and PM have been researching actively in normally single cylinder. An ignition source is required to bum the natural gas by a spark plug in gasoline engines, due to a higher auto-ignition temperature of natural gas. Then gas oil and DME were introduced as the ignition source. In this study as basic data for practical use of natural gas PCCI and HCCI engines, combustion characteristics and emission characteristics on 4-cylinders natural gas PCCI and HCCI engines with gas oil and DME as ignition sources were analyzed and the engine load range that is main object for practical use of PCCI and HCCI engines was made clearly by empirical experiment.

• 오토저널
• /
• 제25권5호
• /
• pp.34-36
• /
• 2003

• 에너지공학
• /
• 제16권3호
• /
• pp.113-119
• /
• 2007

데칸에 물을 혼합하여 일정한 크기와 간격으로 유화액적배열을 형성하여 물과의 혼합비율, 액적의 수 그리고 액적 간격 등이 연소특성에 어떠한 영향을 주는가를 고온의 연소실에서 파악하였다. 각각 10%, 20%, 30%의 물을 혼합하여 유화액적을 만든 후 일정한 크기의 액적을 각각의 서스펜더에 매달아서 일정한 간격의 액적배열을 만들어 고온에서 자발화를 시켰을 때, 점화지연, 수명시간, 전연소기간 그리고 미소폭발 등의 연소특성을 비교하였다. 대기압에서 연소실의 온도를 920 K로 하고 서스펜더의 수를 3개와 5개로 하였으며 액적배열의 간격은 $3{\sim}7\;mm$ 범위에서 1 mm 간격으로 각각 실험을 수행하였다. 본 실험을 통하여 물의 혼합비율이 높을수록, 그리고 액적배열의 간격이 넓을수록 점화지연현상이 길게 나타났으며, 수명시간은 액적의 간격이 넓을수록 짧게 나타났으며 점화지연시간과 수명시간의 합인 전연소기간은 액적의 수량이 3개인 경우가 점화지연시간이 긴 관계로 5개에 비해 길게 나타남을 확인하였다.

• 한국안전학회지
• /
• 제25권1호
• /
• pp.17-21
• /
• 2010

The chemistry and ignition delay of hydrogen/air/HFP premixed mixtures was investigated numerically with unsteady perfectly stirred reactor(PSR). The detailed chemistry of 93 species and 817 reaction mechanism was introduced for hydrogen/air/HFP mixtures. The results shows the temporal concentration variations of major or reactants such as hydrogen and oxygen during autoignition were similar to the spatial distribution of premixed flame while water vapor produced at the ignition temperature was decomposed later, which can be clarified with the relate species production rates that the the re-growth (or shoulder) of OH concentration is a result of F radicals attacking $H_20$ forming OH and HF. For the stoichiometric $H_2$/air mixture inhibited by 20% HFP, HFP thermal decomposition reaction prevails over the radical attack such as H at initial stage. Even though relatively large HFP addition contributes to delay the ignition, chemical effect on the ignition delay is not effective because of late thermal decomposition of HFP. The most small ignition delay was observed at a slightly fuel lean condition ($\phi$ = 0.9), and temperature dependency of ignition delay was clearly shown near 900 K.

• 한국자동차공학회논문집
• /
• 제12권2호
• /
• pp.83-90
• /
• 2004

A flywheel-driven rapid compression and expansion machine is developed and utilized for experimental study of homogeneous charge compression ignition combustion. Compression ignition of homogeneous charge in IC engines offers possibilities of realizing ultra-lean engine operation with greatly reduced NOx and particulate formation. Fundamental investigations are carried out in order to better understand this ideal engine combustion mechanism. Perfectly premixed propane-air mixtures of various equivalence ratio are compression-ignited in the rapid compression and expansion machine, and the characteristics of the auto-ignition and the following combustion process are analyzed.

• 오토저널
• /
• 제13권6호
• /
• pp.57-64
• /
• 1991

Spart-ignition engine knock is an abnormal combustion phenomenon originated from auto- ignition of a portion of or the entire end-gas during the later stage of combustion process. And engine knock is accompanied by a vibration of engine cylinder block and a high-pitched metallic noise. Engine knock is characterized in terms of its intensity, its occurrence crank angel and the percentage of engine knock cycles. To characterize engine knock, a precise measurements of cylinder pressure and a statistical analysis of cylinder pressure data are needed. The purpose of this study is to develope a technique to measure engine knock and its characteristics as a function of ignition timing change. A 4-cylinder spark-ignition engine and unleaded gasoline, whose octane number was 94, were used for experiments. To measure engine knock and to analyze engine knock characteristics, cylinder pressure data were sampled by a high speed data acquisition system which was developed in this study. Cylinder pressure data were sampled at each 0.1.deg. crank angle and the number of cycles continuously sampled was 80.

• 한국분무공학회지
• /
• 제16권4호
• /
• pp.167-175
• /
• 2011

The HCCI engines have been known with high efficiency and low pollution and can be actualized as the new internal combustion engines. However, As for(??) the ignition and combustion depend strongly on the oxidation reaction of the fuel, so it is difficult to control auto-ignition timing and combustion duration. Purpose of this paper is creating the database for development of multi-dimensional simulation and investigating the influence of different molecular structure. In this research, the effect of n-heptane mole ratio in fuel (XnH) on the ignition delay from homogeneous charge compression ignition(HCCI) has been investigated experimentally. By varying the XnH, it was possible to ascertain whether or not XnH is the main resource of ignition delay. Additionally, the information on equivalence ratio for varying XnH was obtained. The tests were performed on a RCM (Rapid Compression Machine) fueled with n-heptane and iso-octane. The results showed that decreasing XnH (100, 30, 20, 10,0), the ignition delays of low temperature reaction (tL) and high temperature reaction (tH) is longer. And the temperature of reaction increases by about 30K. n-heptane partial equivalence ratio (fnH) affect on tL.and TL. When ${\phi}$nH was increased as a certain value, tL was decreased and TL was increased.