• Korean Journal of Optics and Photonics
• /
• v.35 no.2
• /
• pp.49-60
• /
• 2024

We analyze the number of phase screens required for the simulation of a high-energy laser beam's propagation over an atmospheric channel. For high-energy lasers exceeding tens of kilowatts (kW) in power, the laser beam is mainly affected by atmospheric turbulence and thermal blooming. When using the split-step method to implement losses due to atmospheric absorption and scattering and distortion of the beam due to turbulence and thermal blooming, the number of phase screens is a critical factor in determining the accuracy and time required for the simulation. By comparing simulation results obtained using a large number of phase screens (e.g., 150 screens) under a wide range of atmospheric turbulence conditions, we provide new guidelines for the number of phase screens required for simulating the beam propagation of a high-power laser below 2.5×10⁶ W/m² (e.g., a 500-kW laser beam having a 50-cm diameter).

• Korean Journal of Remote Sensing
• /
• v.27 no.6
• /
• pp.663-675
• /
• 2011

Sea Surface Temperatures (SSTs) using the equations of NOAA (National Oceanic and Atmospheric Administration) / NESDIS (National Environmental Satellite, Data, and Information Service) were validated over the seas around Korea with satellite-tracked drifter data. A total 1,070 of matchups between satellite data and drifter data were acquired for the period of 2009. The mean rms errors of Multi- Channel SSTs (MCSSTs) and Non-Linear SSTs (NLSSTs) were evaluated to, in most of the cases, less than $1^{\circ}C$. However, the errors revealed dependencies on atmospheric and oceanic conditions. For the most part, SSTs were underestimated in winter and spring, whereas overestimated in summer. In addition to the seasonal characteristics, the errors also presented the effect of atmospheric moist that satellite SSTs were estimated considerably low ($-1.8^{\circ}C$) under extremely dry condition ($T_{11{\mu}m}-T_{12{\mu}m}$ < $0.3^{\circ}C$), whereas the tendency was reversed under moist condition. Wind forcings induced that SSTs tended to be higher for daytime data than in-situ measurements but lower for nighttime data, particularly in the range of low wind speeds. These characteristics imply that the validation of satellite SSTs should be continuously conducted for diverse regional applications.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2013.02a
• /
• pp.582-582
• /
• 2013

Oxide TFT (thin film transistor) active channel layer에 대한 저온 열처리 공정은 투명하고 flexibility을 기반으로하는 display 산업과 AMOLED (active matrix organic light emitting diode) 분야 등 다양한 분야에서 필요로 하는 기술로서 많은 연구가 이루어지고 있다. 과거 active layer는 ALD (atomic layer deposition), CVD (chemical vapor deposition), pulse laser deposition, radio frequency-dc (RF-dc) magnetron sputtering 등과 같은 고가의 진공 장비를 이용하여 증착 되어져 왔으나 현재에는 진공 장비 없이 spin-coating 후 열처리 하는 저가의 공정이 주로 연구되어 지고 있다. Flexible 기판들은 일반적인 OTFT (oxide thin films Transistor)에 적용되는 열처리 온도로 공정 진행시 열에 의한 기판의 손상이 발생한다. Flexible substrate의 열에 의한 기판 손상을 막기 위해 저온 열처리 공정이 연구되고 있지만 기존 열처리와 비교하여 소자의 특성 저하가 동반 되었다. 본 연구에서는 Si 기판위에 SiO2 (100)를 절연층으로 증착하고 그 위에 IZO (indium zinc oxide) solution을 spin-coating 한뒤 $250^{\circ}C$ 이하의 온도에서 열처리하였다. 저온 공정으로 인하여 소자의 특성 저하가 동반 되었으므로 소자의 저하된 특성 복원하고자 post-treatment로 고가의 진공장비가 필요 없고 roll-to roll system 적용이 수월한 remote-type의 APP (atmospheric pressure plasma) 처리를 하였다. Post-treatment로 APP를 이용하여 $250^{\circ}C$ 이하에서 소자에 적용 가능한 on/off ratio를 얻을 수 있었다.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.63 no.1
• /
• pp.80-84
• /
• 2014

The discharge characteristics of Surface Dielectric Barrier Discharge (SDBD) reactor are investigated to find optimal driving condition with adjusting various parameter. When the high voltage with sine wave form is applied to SDBD source, successive pulsed current waveforms are observed owing to multiple ignitions through the long discharge channel and wall charge accumulation on the dielectric surface. The discharge voltage, total charge between dielectrics, mean energy and power are calculated from measured current and voltage according to electrode gap and dielectric thickness. Discharge mode transition from filamentary to diffusive glow is observed for narrow gap and high applied voltage case. However, when the diffusive discharge is occurred with high applied voltage, the actual firing voltage is always lower than that with low driving voltage. The $Si_3N_4$, $MgF_2$, $Al_2O_3$ and $TiO_2$ are considered for dielectric protection and high secondary electron emission coefficient. SDBD with $MgF_2$ shows the lowest breakdown voltage. $MgF_2$ thin film is proposed as a protection layer for low voltage atmospheric dielectric barrier discharge devices.

• Proceedings of the KSRS Conference
• /
• 2007.10a
• /
• pp.518-521
• /
• 2007

To retrieve Sea Surface Temperature(SST) from NOAA-AVHRR imagery the spilt window atmospheric correction algorithm is generally used. Recently, there have been various new algorithms developed to process these data, namely the variable-coefficient split-window, the R54 transmittance-ratio method, fixed-coefficient nonlinear algorithm, dynamic water vapour (DWV) correction method, Dynamic Water Vapour and Temperature algorithm (DWVT). We used MCSST (Multi-Channel Sea surface temperature) and NLSST(Non linear sea surface temperature) algorithms in this study. The study area is around the Korea sea area (Yellow Sea). We compared and analyzed with various methods by applying each Ocean in-situ data and satellite data. The primary aim of study is to verify and optimize algorithms. Finally, this study proposes an optimized algorithm for SST retrieval.

• Proceedings of the KSRS Conference
• /
• 2003.11a
• /
• pp.331-333
• /
• 2003

KMA successfully began to receive and utilize the GOES-9 GVAR data since May 22nd 2003 when GOES-9 replaced the long-lived GMS-5 for Western Pacific and East Asian region until operation of MTSAT-1R in 2004. To take advantage of improvements of the GOES-9 data over the GMS-5 data, such as the increase of the temporal and spat ial resolution and addition of 3.9${\mu}$m channel, we have improved several algorithms to derive the meteorological products. Here we show two examples of algorithms, sea surface temperature and atmospheric motion vector, and preliminary results of validation of the improved algorithm.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.20 no.12
• /
• pp.1-7
• /
• 2019

This paper presents low-complexity single-image dehazing to enhance the visibility of outdoor images that are susceptible to degradation due to weather and environmental conditions, and applies it to various devices. The conventional methods involve refinement of coarse transmission with high computational complexity and extensive memory requirements. But the proposed transmission estimation method includes excellent edge-preserving performance from comparison of the pixel-based dark channel and the patch-based dark channel in the vicinity of edges, and transmission can be estimated with low complexity since no refinement is required. Moreover, it is possible to accurately estimate transmissions and adaptively remove haze according to the characteristics of the images via prediction of the atmospheric light for each pixel using joint bright and dark channel (JBDC). Comprehensive experiments on various hazy images show that the proposed method exhibits reduced computational complexity and excellent dehazing performance, compared to the existing methods; thus, it can be applied to various fields including real-time devices.

• Journal of Advanced Marine Engineering and Technology
• /
• v.31 no.3
• /
• pp.272-281
• /
• 2007

A numerical simulation on nitrogen gas flow in a long parallel plate microchannel was performed to obtain the effect of compressibility and rarefaction on gaseous flow in microchannels. The simulation was based on steady. two dimensional compressible Navier-Stokes and energy equations with noslip and first order slip boundary conditions. The channel was $1.2{\mu}m$ deep and $3000{\mu}m$ long. The Reynolds numbers were in the range of order from $10^{-2}$ to $10^{-1}$. So the flow was assumed to be laminar. The computations were performed on various pressure ratios. The outlet pressure was fixed to atmospheric pressure. The outlet Knudsen number was 0.0585, consequently the flow was in the slip flow regime. The computations were performed with the assumption of isothermal channel walls. The results were compared with the experimental data. The agreement was good.

• Journal of Fisheries and Marine Sciences Education
• /
• v.25 no.5
• /
• pp.1102-1109
• /
• 2013

An numerical analysis was performed to obtain the design parameters for parallel micro-channels. The parallel micro-channels consist of 10 square channels with a hydraulic diameter of 300 ${\mu}m$ and inlet/outlet manifolds. The channel length is 5mm, 10mm and 40mm respectively. Mass flux was set between 200~600kg/m2s as inlet boundary condition and atmospheric pressure was set as outlet boundary condition. The pressure drop in channels and manifolds were estimated by using the Shah and London correlation and the flow uniformity was represented by the velocity distributions with dimensionless velocity. The results show that the flow uniformity in channels depends on shapes of manifolds, length and mass flux.

• Journal of the Optical Society of Korea
• /
• v.20 no.4
• /
• pp.451-463
• /
• 2016

The misalignment errors and fluctuations in irradiance due to atmospheric turbulence can severely degrade the performance of free-space optical (FSO) systems. In this paper, we investigate the asymptotic bit error rate (BER) performance and diversity orders of FSO links using parallel transmit-diversity schemes. The BER expressions of FSO links with the switch-and-examine transmit (SET), switch-and-examine transmit with post-selection (SETps), dual-branch transmit laser selection (Dual-TLS), and group transmit laser selection (Group-TLS) schemes are derived, based on an approximate channel model. Then numerical simulations for these four schemes in the region of high average signal-to-noise ratio (SNR) are presented under different channel conditions. The results show that the four transmit-diversity schemes can reduce system complexity and overcome the limitation of peak power, without much BER deterioration.