• 한국가시화정보학회지
• /
• 제17권2호
• /
• pp.25-31
• /
• 2019

A device that consists of an array of hydrofoils (called a vane deployer) is widely used in ocean engineering. In general, the vane deployer has to spread out efficiently, which is possible by enhancing the lift-to-drag ratio. In the present study, using a computational fluid dynamics, we investigate the effect of hydrofoil arrangement on the lift-to-drag ratio to establish the condition in which a reasonable level of constant lift-to-drag ratio is achieved in a wide range of angle of attack, to avoid a degradation of the hydrodynamic performance. First, the flow around two-dimensional hydrofoil array is examined by varying the size of hydrofoil components, gap between the hydrofoils, and arrangement type. As a result, we determine the optimized hydrofoil array configuration whose lift-to-drag ratio is nearly independent on the angle of attack. Finally, a three-dimensional simulation is performed for the optimized geometry to estimate the performance of actual vane deployer.

• 한국군사과학기술학회지
• /
• 제17권1호
• /
• pp.149-157
• /
• 2014

In this paper, we investigated the sensitivity of aerostatic force coefficients of multi-layer radom in the various wind speeds. The test was conducted in KOCED Wind Tunnel Center in Chonbuk National University, and wind speeds were in the range from 5 m/s to 26 m/s in order to determine the Reynolds number independence. The test results of present multi-layer radom were not affected by the Reynolds number, The maximum positive pressure coefficient was found to be 1.08 at the center of the front of the plane in angle of attack of 0 degree, the maximum negative pressure coefficient was -2.03 at the upper right corner in angle of attack of 120 degree, while maximum drag coefficient was 1.11 in angle of attack of 180 degree.

• 한국항공우주학회지
• /
• 제34권8호
• /
• pp.8-15
• /
• 2006

고받음각의 NACA23012익형에 대하여 synthetic jet을 이용하여 박리 제어를 수행하였다. 단일 synthetic jet을 이용하여 익형에 발생하는 앞전 박리를 효과적으로 지연시킬 수 있고, 또한 실속 특성을 개선 할 수 있음을 확인하였다. 그때 발생하는 비정상 유동 특성을 파악하였다. 또한, 현실적으로 구현 가능한 jet 속도를 얻기 위하여 multi-array synthetic jet의 특성을 파악하였다. 그리고, 단일 위치에 장착된 synthetic jet을 이용하여 박리를 제어 하였을 경우 익형 윗면에 발생하는 작은 와동을 제거하기 위하여, multi-location synthetic jet을 이용하였다. 작은 와동을 제거하고 안정적인 유동을 확보하기 위하여, 높은 진동수의 synthetic jet을 이용하여 국부적으로 효과적인 박리 제어를 통한 익형 주변의 유동의 전체적 특성을 안정화 시킬 수 있음을 확인하였다. Multi-location synthetic jet의 phase 변화를 이용하여 multi-array/multi-location synthetic jet의 성능 및 특성을 향상 시킬 수 있음을 확인하였다.

• International Journal of Naval Architecture and Ocean Engineering
• /
• 제7권5호
• /
• pp.906-919
• /
• 2015

The Deep Draft Semi-Submersible (DDS) concepts are known for their favourable vertical motion performance. However, the DDS may experience critical Vortex-Induced Motion (VIM) stemming from the fluctuating forces on the columns. In order to investigate the current-induced excitation forces of VIM, an experimental study of flow characteristics around four square-section cylinders in a square configuration is presented. A number of column spacing ratios and array attack angles were considered to investigate the parametric influences. The results comprise flow patterns, drag and lift forces, as well as Strouhal numbers. It is shown that both the drag and lift forces acting on the cylinders are slightly different between the various L/D values, and the fluctuating forces peak at L/D = 4.14. The lift force of downstream cylinders reaches its maximum at around ${\alpha}=15^{\circ}$. Furthermore, the flow around circular-section-cylinder arrays is also discussed in comparison with that of square cylinders.

• 유체기계공업학회:학술대회논문집
• /
• 유체기계공업학회 2001년도 유체기계 연구개발 발표회 논문집
• /
• pp.325-333
• /
• 2001

The present study investigates convective heat/mass transfer and flow characteristics inside the cooling passage of the gas-turbine blades. It is important to increase not only the heat transfer rates but also the uniformity of heat transfer in the cooling passage. The square duct has compound-angled ribs with $60^{\circ},\;70^{\circ}$ and $90^{\circ}$ attack angles, which are installed on the test plate surfaces. a naphthalene sublimation technique is employed to determine the detailed local heat transfer coefficients using the heat and mass transfer analogy. The ribs disturb the main flow resulting in the recirculation and secondary flows near the ribbed wall and the vertices near the side-wall. The local heat transfer and the secondary flow in the duct are changed largely according to the rib orientation. Therefore, geometry and arrangement of the ribs are important fur the advantageous cooling performance. The angled ribs increase the heat transfer discrepancy between the wall and center regions because of the interaction of the secondary flows. The average heat/mass transfer coefficient and pressure drop of the ribs with the $60^{\circ}$ $-90^{\circ}$ compound-angle are higher than those with the $60^{\circ}$ attack angle. Also, the thermal efficiency of the compound-angled rib is higher than that with the $60^{\circ}$ attack angle. The uniformity of heat/mass transfer coefficient on the cross ribs may is higher than that on the parallel ribs array.

• 대한기계학회논문집B
• /
• 제22권11호
• /
• pp.1603-1609
• /
• 1998

Numerical solutions of Stokes flow through periodic arrays of cylinders were sought using Darcy's law and homogenization theory. Drag and lift forces of each cylinder were computed for various attack angles and pitch-to-diameter ratios. It was found that drag force decreased as principal pressure gradient direction deviated from array direction and that drag force increased exponentially as pitch-to-diameter ratio approached unity. Similar tendency was found in lift force except that lift force increased and then decreased in quadratic manner as attack angle varied.

• 한국전산유체공학회:학술대회논문집
• /
• 한국전산유체공학회 2007년도 추계 학술대회논문집
• /
• pp.60-66
• /
• 2007

Separation control has been performed using synthetic jets on airfoil at high angle of attack. Computed results demonstrated that stall characteristics and control surface performance could be substantially improved by resizing separation vortices. It was observed that the actual flow control mechanism and flow structure is fundamentally different depending on the range of synthetic jet frequency. For low frequency range, small vortices due to synthetic jet penetrated to the large leading edge separation vortex, and as a result, the size of the leading edge vortex was remarkably reduced. For high frequency range, however, small vortex did not grow up enough to penetrate into the leading edge separation vortex. Instead, synthetic jet firmly attached the local flow and influenced the circulation of the virtual airfoil shape which is the combined shape of the main airfoil with the separation vortex. Theses results show the characteristic of unsteady flow of single synthetic jet. Beside, we researched on multi-array synthetic jet to obtain applicable synthetic jet velocity. Multi-location synthetic jet is proposed to eliminate small vortex on suction surface of airfoil. With the results, we concluded that the flow around airfoil is stable by high frequency synthetic jet with elimination of small vortex and confirmation of stable flow. Moreover, performance of multi-array/multi-location synthetic jet can be improved by changing phase angle of multi-location synthetic jet.

• 한국수산과학회지
• /
• 제34권6호
• /
• pp.661-665
• /
• 2001

해상가두리의 안정성 및 기능성 향상을 위한 최적 계류시스템을 개발하기 위하여 천해역에 적합한 계류시스템을 검토하여 유연부 이 계류시스템을 선정하였다. 이를 위한 해석프로그램을 정립하고, 수리모형실험 결과와 비교하였다. 해석프로그램의 타당성을 확인 한 후, 적용할 만한 계류시스템을 구성하고 수치계산을 통하여 해상가두리를 위한 적정 계류시스템을 제시하였다. 해상가두리의 계류시스템은 유연부이 계류시스템이 권장되며, 계류배치는 탁월 외력환경과 일치하는 방향으로 하고, 수평계류삭인 나일론 로프는 해상가두리 길이의 0.5배 이상, 경사 와이어 로프는 수심의 2배 이상이 바람직한 것으로 나타났다. 또한, 중간부 이의 증설은 계류장력 및 표류변위를 감소시키는 효과를 가질 것으로 판단된다. 차후, 해상가두리의 동적응답 특성을 계류시스템 해석모델의 개발과 계류시스템의 설계가 요구된다.