• Journal of the Korea Concrete Institute
• /
• v.19 no.6
• /
• pp.773-783
• /
• 2007

A simple unbonded-type shear strengthening technique for reinforced concrete beams using wire rope units is developed. Six two-span continuous T-beams externally strengthened with wire rope units and an unstrengthened control beam were tested. The main variables investigated were the amount and prestressing force of wire rope units. All specimens had the same geometrical dimension and arrangement of internal reinforcement. Influence of the distribution of vertical stresses in beam web owing to the prestressing force of wire rope units on the diagonal shear cracking load and the ultimate shear capacity of beams tested is presented. Based on the current study, it can be concluded that the amount and initial prestress of wire rope should be limited to be above 2.5 times the minimum shear reinforcement ratio specified in ACI 318-05 and below 0.6 times its own tensile strength, respectively, to ensure the enhancement of shear capacity and ductile failure mode of the strengthened beams. A numerical analysis based on the upper-bound theorem is developed to assess the shear capacity of continuous T-beams strengthened with wire rope units. From the comparisons of measured and predicted shear capacities, a better agreement is achieved in the proposed numerical analysis than in empirical equations recommended by ACI 318-05.

• The Korean Journal of Ecology
• /
• v.4 no.3_4
• /
• pp.114-123
• /
• 1981

Diurnal acid fluctuations, stomatal resistance, and morphology and anatomy were investigated in leaves and stems P. oleracea L. growing under the natural environmental condition. A CAM-like pattern of acid fluctuation was exhibited not in leaves of the young purslane but in its stems. Defoliated stems showed a decreased in diurnal changes of total acidity as compared with normal stems. Excised stems stored in continuous darkness exhibited diurnal acid rhythms, and they showed light deacidifications for three days. Kranz-type arrangement was observed in leaves, but not in stems. Micrography of cross sections of stems showed cells with relatively large vaculoles and a few chloroplasts. The number of stomata was 3,275cm-2 in leaves, while the stomata could not be observed in stems. Stomatal resistance was high at night and low in daytime in leaves of the young purslane, and the range of its value was 5~40 sec.$\textrm{cm}^{-1}$. But stomatal resistance in leaves of the water-stressed plant was comparratively high in day time, and its value was 30 sec.$\textrm{cm}^{-1}$. The result of these studies showed the possibility that the stem of P.oleracea L. possesses CAM under certain stressed conditions.

• Archives of design research
• /
• v.18 no.4 s.62
• /
• pp.247-256
• /
• 2005

This study investigated the status of kitchen of units in elderly housing facilities and the housing needs of residents. Compared with a lot of comprehensive and alternative studies on elderly housing facilities until now, specialized studies of behavior of elderly housing life and detailed dimensional study have hardly made. Therefore we intend to examine the status of kitchen planning on representative elderly housing facilities in Korea. As the methods of this study, we executed a field study into 4 representative elderly housing facilities in Korea. We visited each 2 units out of the outstanding 4facilities and surveyed the total 8 kitchens. Then we analyzed the space planning and kitchen furniture design of them and the state of kitchen commodities, and measured the kitchen equipment. In addition, we executed interview about satisfaction, preference, use from the residents. As a result, we could find out that depending on whether residents were sewed with meal offered from the facilities or not, the pattern of usage and commodities were quite different. It is necessary to supply the simplest spaces just for preparing some refreshment and tea are suitable. And for the self-cooking residents, much larger cabinets and utility rooms are additionally needed. Safety and functional aspect were quite well designed. Washing machines are usually built-in the kitchen cabinets, and residents are satisfied with this arrangement. We hope that the supplementary study about old people habit and behavior will be a good data of kitchen planning for Korean-type elderly housing units of facilities.

• Journal of Environmental Impact Assessment
• /
• v.23 no.6
• /
• pp.477-491
• /
• 2014

The purpose of this study is to develop urban planning for mitigating thermal comfort by analyzing the relationship between various physical environmental factors and radiation fluxes focused on urban areas of Changwon city, Gyeongsangnam-do. Physical environmental factors were analyzed by sky view factor (SVF), land cover and land use types using GIS program. Radiation fluxes were measured upward and downward in solar and terrestrial radiation by mobile measurement during 3 days (2 daytime and 1 nighttime) in summer season. SVF is high in urban park less around buildings. High dense building sites were low. Downward solar radiation fluxes were the highest about $700W/m^2$ at daytime, and decreased in spatial type arranged dense buildings. Upward solar and terrestrial radiations was affected by land cover types that have thermal features such as reflectivity, emissivity, and heat capacity. Therefore, urban space needs appropriate planning with building arrangement, green walls and land cover replacement for mitigating thermal comfort in urban area.

• Journal of Korean society of Dental Hygiene
• /
• v.4 no.2
• /
• pp.277-291
• /
• 2004

The purpose of this study is to analyze the dental hygienists' overall performance in operative restoration and the clinical performance in operative restoration according to dental hygienists' career and to provide basic data for establishing the appropriate range of dental hygienists' work. Subjects of this study are 339 dental hygienists working at dental clinic and hospital nationwide, selected by their working place, career, type of clinic, and location of clinical institution. The distribution of people who responded to the survey shows that 81 belong to beginner level(less than 2 years since entering clinic), 115 intermediate level(2 to 3 years since entering clinic), 81 higher level(4 to 5 years since entering clinic) and 62 advanced level(more than 6 years since their entering clinic). In terms of the types of clinical institution, 178 belong to dental clinics and 161 belong to dental hospitals. The survey used in this study are focused on perception about clinical performance in operative dentistry and adequacy of the work. Operative dentistry consists of operative restoration and endodontic therapy. The operative restoration consists of 15 categories such as patient welcoming, examination and diagnosis, planning of treatment, anesthesia, control of moisture, cavity preparation, pulp protection, matrix band application, amalgam filling, resin filling, glass ionomer cement filling, abrasive strip removal, rubber dam removal, bite check and polishing, patient education, and arrangement. The reliability was Cronbach's Alpha .9453. SPSS 10.0 for Windows was used to analyze the responses. One way ANOVA was utilized to verify the differences in the dental hygienists' job performance in operative restoration and their job performance according to career. When significant difference was found. Duncan multi comparison post hoc was done. To sum up the results of this study, patient welcoming look the first place in the operative restoration. It was followed by patient education, examination and diagnosis, introducing treatment plan, resin filling, glass ionomer cement filling, amalgam filling, bite check and polishing, anesthesia, pulp protection, control of moisture, abrasive strip removal, cavity preparation, matrix band application, rubber dam removal, and anesthesia. In terms of the clinical performance by career, there were significant differences in 19 activities such as medical eraluation, oral examination, patient charting, intra oral readio graphs, firm developing fixing mounting, curing light gun, education of attention content after operation. Based on the results of this study, the specific range of operative restoration for dental hygienists should be focused on providing basic data for dentists' diagnosis, alleviation of fear and aching accompanied by injection and anesthesia, data providing for dentists' decision of anesthesia degree, and maximization of control of moisture.

• Polymer(Korea)
• /
• v.34 no.2
• /
• pp.116-125
• /
• 2010

The thermotropic liquid crystalline behavior of the homologous series of combined-type liquid crystalline polymers, tri-O-{4-(4'-cyanophenylazo)phenoxy}alkyl celluloses (CACETn, where n, the number of methylene units in the spacer, is 2~10) have been investigated. The CACETn with n of 5 and 7 exhibited enantiotropic nematic phases, while other polymers showed monotropic nematic phases. The isotropic-nematic transition temperature($T_{iN}$) increased when n is increased up to 4, but it decreased with increasing n more than 5. The entropy change at $T_{iN}$ also reaches a minimum at n=5, before it increases again for n=6. The sharp change at n=5 may be attributed to the difference in arrangement in the side groups. The nematic-crystalline transition temperatures, in contrast with $T_{iNS}$, exhibited a distinct odd-even effect, suggesting that the average shape of the side chains in the crystalline phase is different from that in the nematic phase. The mesophase properties of CACETn were significantly different from those reported for tri-O-alkyl celluloses and poly[1-{4-(4'-cyanophenylazo)phenoxyalkyloxy}ethylene]s. The results were discussed in terms of the difference in the chemical structures of the main and side chains and the number of the mesogenic units per repeating unit.

• Archives of design research
• /
• v.15 no.4
• /
• pp.129-138
• /
• 2002

Against the projection that the volume of filing would be drastically cut in the Information Age, the needs for filing in this age increases gradually. In this respect, it is critical to study the design of office filing system furniture. Through this study, we could find out what shall be the major requirements for office lijillg system furniture. This study would also provide important raw data for developing more efficient and more satisfactory office filing system furniture. Subject for this study includes 6 representative filing system furniture including a lateral file cabinet. For the design analysis, we used catalogues of foreign and domestic office furniture, particularly filing system furniture. The analysis is classified into the following six categories such as size, shape, color, material, handle, and filing method, mobility, flexibility, and so on. According to the analysis of office furniture in the market, requirements of furniture fit for office environment are found to be as follows. -Instead of the fixed-type furniture, movable furniture is more adaptable to the ever-evolving office environment. -Design the office furniture in accordance with a standardized module would provide a more unity and diversity of arrangement in space particularly when it is arranged with other furniture. -Development of more diverse color, which ranges from achromatic color to wooden color to other various colors, is more favored in the ever-changing office environment. -As the grip provides a variety of image to the furniture let alone its function, its development is required to be more diverse and more conforming 10 the design of Ihe furniture. -The filing methods in general are with drawer and shelf, among which the drawers design is usually fixed. However, under the evolving office furniture environment, the design of Ihe drawer, bolh inlerior and exterior, shall be more diverse and flexible.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.18 no.6
• /
• pp.343-355
• /
• 2017

This study compared the individual, family, environmental factors, and subjective sleep sufficiency according to gender among Korean adolescents and to examine relevance among the individual, family, environmental factors, and subjective sleep sufficiency. The subjects were 65,528 Korean adolescents(male: 33,803, female: 31,725), who were derived from the 12th Korea Youth Risk Behavior Web-based Survey 2016 in South Korea. As a result, the prevalence of the subjective sleep sufficiency in this study was 33.4% male and 19.5% female. The subjective sleep sufficiency was affected by the depression experience, suicidal ideation, school achievement, feeling of stress, feeling of happiness, subjective health status, alcohol experience, smoking experience, substance experience, allergic rhinitis, and atopic dermatitis in individual factors; economic status, educational level of parents and living arrangement in family factors; school grade, school type and emotional support in environmental factors in both males and females. In individual factors, breakfast eating and asthma affected the male's subjective sleep sufficiency and physical activity affected the female's. The mental health of the individual factors was the most influential factor in adolescent's subjective sleep sufficiency. Therefore, nursing intervention to improve Korean adolescent's subjective sleep sufficiency should be applied considering gender differences.

• Journal of Korean Tunnelling and Underground Space Association
• /
• v.19 no.3
• /
• pp.437-447
• /
• 2017

In current, there has not been the evaluation model for the optimum design of the multi-utility tunnel by considering urban type and size, the function of surrounding road and feasibility analyses with respect to construction method, and arrangement of accommodation facilities inside multi-utility tunnel. Thus, in this study, we developed the evaluation model for the optimum design of the multi-utility tunnel before and after the decision of the multi-utility tunnel installation. In this paper, we have selected the Deming cycle which is used in various fields among several decision methods for optimizing the design. For the purpose of reflecting the various factors in the design of the multi-utility tunnel, 11 higher indicators were set up to lead to more detailed approaches. In addition, based on the "Plan-Do-Check-Action (PDCA)" circulation method, we can realize the installation of the multi-utility tunnel and design more efficiently through the first phase for conception and the second phase for optimization, and develop the program for the evaluation model accordingly.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.18 no.11
• /
• pp.138-144
• /
• 2017

With the increase in power consumption due to the surge in the demand for power, it is necessary to improve the quality or design of the power (supply) for the purpose of reducing the energy consumption and so reduce the power loss. The switchboard is a mechanical device that receives electricity from the electricity generation facilities of KEPCO and divides it into the facilities required for each building. Switchboards generally consist of enclosures, switches, power conductors, and control components. This study deals with energized power conductors, which constitute the main element in the switchboard. Through the measurement of the effective ac resistance, it was confirmed that the vertical array structure of the conventional type plate conductor is inefficient. If the effective AC resistance increases significantly, the sectional area of the conductor becomes relatively large due to the skin effect. In this study, we studied the energy and material savings that could be obtained using the asterisk (*) array structure, which minimizes the effective ac resistance by reducing the skin effect. The core technology principle of this study is the energy saving switchgear based on conductor resistance reduction technology utilizing the asterisk array structure. The present invention involves a plate-shaped conductor arrangement structure capable of canceling out the magnetic field generated on each of the plate conductors (rst or abc) of the AC power supply in the power distribution panel by mutual action. The effect of this structure is to reduce the amount of inductive reactance due to the increase in the cross-sectional area and reduction of the effective AC resistance.