• Journal of Korean Vacuum Science & Technology
• /
• v.6 no.4
• /
• pp.143-148
• /
• 2002

Method of plasma-immersion ion deposition of hydrogenated DLC films on relatively thick flat dielectric substrates from plasma of not-self-sustained low-pressure gas arc discharge is suggested. Coating properties have been investigated experimentally, average energy Per a deposited carbon atom depending on discharge current has been calculated. Optimum deposition parameters lot obtaining sufficiently hard and transparent high-adhesive a-C:H films on a 4-mm thick glass substrates have been determined. Possibility to use these coatings for photo-tools protection from abrasion wear at low operating loads is shown in general.

• Proceedings of the KIEE Conference
• /
• 2002.07c
• /
• pp.1757-1759
• /
• 2002

Global simulator for $CF_4$ discharge in transformer coupled plasma (TCP) source is developed and simulations arc performed under various conditions. The developed simulator is based on a set of space averaged fluid equations for electrons, positive ions, neutrals and radicals of $CF_4$ plasma. And the used absorbed power by electrons is calculated by a 2-dimensional heating model[1].

• Journal of Wetlands Research
• /
• v.2 no.2
• /
• pp.147-157
• /
• 2000

The objective of this study is to develop a NGIS-GUI (National Geographic Information System-Graphic User Interface) system for the computation of peak discharge at drainage basin outlet. The developed system is composed of GIS data extraction module, peak flow computation module and output display module. The selected study area is the Sungjun reservoir area near the Milyang, Kyungnam province and the peak flows depending on various recurrence intervals are computed and graphically displayed. The developed system will be useful for the scientific water flow management in the study area.

• Proceedings of the KIEE Conference
• /
• 1999.07e
• /
• pp.2251-2252
• /
• 1999

In this paper, the effect of magnetic field was measured on NOx removal characteristics for wire-plate plasma reactor with magnetic field applied to electric field vertically. NOx from simulated diesel engine flue gas are decomposed by the corona discharge of DC, AC and Pulsed voltages in wire-plate reactor. Consumption power increased with increasing discharge voltage. When magnetic field was applied to electric field vertically, consumption power decreased. NOx removal rate and arc transition voltage of plasma reactor with magnetic field were higher than those of plasma reactor without magnetic field.

• Journal of Surface Science and Engineering
• /
• v.37 no.3
• /
• pp.169-174
• /
• 2004

MgO thin films were reactively deposited using an internal inductively coupled plasma assisted sputtering method varying reactive gas ratio to get stoichiometric film composition, and bipolar dc substrate bias to suppress micro arcs. The minimum frequency required for arc suppression was about 10KHz depending on ICP power. Their crystallinity was analyzed using X-ray diffraction and surface morphology using AFM. The surface was very smooth with rms roughness less than 0.42nm. The preferred orientation of the films were changing from (200) to bulk-like characteristics as Ar: $O_2$ratio was controlled to 10 : 2. Optical emission spectroscopy revealed that there were two distinct discharge modes: a blue one and a green one, where enhanced emission from Ar and Mg were observed. This cannot simply be understood by metallic or oxide mode of reactive sputtering due to ICP coupled to magnetron discharge.

• Proceedings of the KIEE Conference
• /
• 2003.07c
• /
• pp.1800-1802
• /
• 2003

This paper describes a study on gas dissolved distribution in oil for simulated transformer thermal faults. Experimental chamber was setup for simulation of transformer thermal faults or discharge in oil with or without insulation paper. The experimental results showed that dissolved gases in oil excluding the paper did not evolved upto $150^{\circ}C$. Hereafter the planned gas dissolved analysis will be continuously carried out for transformer fault conditions with or without insulation paper related to water absorption, arc and partial discharge.

• The Proceedings of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.2 no.3
• /
• pp.47-58
• /
• 1988

본 논문에서는 고광도방전등의 전기적 특성을 해석하기 위한 아아크모델을 제시하였다. 방전관내에서 반경방향의 온도분포가 포물선형태로 변화하는 것으로 가정하고 방전관의 단위체적에서의 에너지평형식을 단면적에 대해 적분함으로서 단위길이당의 에너지평형식으로 변환하였다. 이 에너지평형식과 회로방정식, 그리도 오옴의 법칙을 이용하여 아아크의 전류와 전압의 1주기에서의 변화를 계산하여 좋은 결과를 얻었다. 또한 방전관의 축온도와 이에 따른 방사에너지의 값을 계산하는 간단한 방법을 제시하였다.

• Proceedings of the Polymer Society of Korea Conference
• /
• 2006.10a
• /
• pp.283-283
• /
• 2006

Multigram-scale product exclusively containing magnetic carbon nanoparticles (MNCPs) with uniform size was successfully fabricated without a specific separation process. The iron-doped PPy nanoparticles were synthesized by micelle templating and used as the carbon precursor in order to generate MCNPs. The magnetic carbon nanoparticles possessed a microporous structure and exhibited ferromagnetic properties at room temperature. This approach may be an effective alternative to generate magnetic carbon nanoparticles against the conventional arc-discharge technique.

• The Proceedings of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.4 no.2
• /
• pp.33-40
• /
• 1990

고압 수은등의 전기적 특성을 예측하기 위한 컴퓨터 프로그램을 작성하였다. 즉 고압기체방전에서 성립되는 단위체적당 에너지 평형식과 입자의 밀도에 대한 연속방정식을 방전관의 반경과 시간에 대하여 풀어서 전류값을 예측하였다. 프로그램의 수행결과, 방전광에 입력된 에너지는 방사에너지로 가장 크게 손실되며, 전도손실은 시간에 무관하게 거의 일정한 것으로 나타났다. 또한 비교적 길이가 짧은 방전관의 특성을 예측하기 위하여 음극강하를 고려하여 산정한 길이를 추정하는 방법을 개발하였다.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2008.02a
• /
• pp.101-101
• /
• 2008