• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.7 no.12
• /
• pp.2987-3002
• /
• 2013

The problem of optimal channel sensing in heterogeneous cognitive networks is considered to maximize the system throughput performance. The characteristics of an optimal operating sensing point maximizing the overall system rate are investigated under several rate criteria including the sum rate, the minimum of the primary and secondary rates, and the secondary rate with a guaranteed primary rate. Under the sum rate criterion, it is shown that the loss by imperfect sensing is no greater than half of the sum rate achieved by the perfect time sharing approach in a two user case if the sensing point is optimally designed.

• ETRI Journal
• /
• v.33 no.2
• /
• pp.176-183
• /
• 2011

This paper presents a new analytical approach and experimental verification for the improvement of noise performance in phased-array receivers. For analysis purposes, a multi-channel array system is converted into an equivalent single-channel system, such that the two presents the identical signal and noise powers at the output, respectively. We define an effective gain, noise figure, and signal-to-noise ratio in the equivalent system. Through the proposed approach, the noise performance of the array receiver is analyzed in a general and straightforward manner and then compared to that of each individual array channel. In addition, the phase noise of the array system is analyzed in a rigorous manner, showing its effective reduction by a factor of the array size. The predicted improvement of the noise performance is experimentally confirmed with a CMOS integrated phased-array receiver.

• Journal of computational fluids engineering
• /
• v.12 no.3
• /
• pp.47-54
• /
• 2007

A periodic CFD approach for the performance analysis of compact high temperature heat exchangers is introduced and applied to selected benchmark problems, which are a fully developed 2D laminar heat transfer, a conjugate heat transfer between parallel plates which have exact solutions, and a heat transfer in a real high temperature heat exchanger module. The results for the 2D laminar heat transfer and the 2D conjugate heat transfer showed a very good agreement with the exact solutions. For the high temperature heat exchanger module, the pressure drops were predicted well but some difference was observed in the temperature parameters when compared to the full channel CFD analysis due to assumptions introduced into the periodic approach. Considering its assumptions and simplicities, however, the results showed that the periodic approach provides physically reasonable results and it is sufficient to predict the performance of a heat exchanger within an engineering margin and with much less CPU time than the case of a full channel analysis.

• Nuclear Engineering and Technology
• /
• v.49 no.1
• /
• pp.267-276
• /
• 2017

In any reactor physics analysis, the instantaneous power distribution in the core can be calculated when the actual bundle-wise burnup distribution is known. Considering the fact that CANDU (Canada Deuterium Uranium) utilizes on-power refueling to compensate for the reduction of reactivity due to fuel burnup, in the CANDU fuel management analysis, snapshots of power and burnup distributions can be obtained by simulating and tracking the reactor operation over an extended period using various tools such as the $^*SIMULATE$ module of the Reactor Fueling Simulation Program (RFSP) code. However, for some studies, such as an evaluation of a conceptual design of a next-generation CANDU reactor, the preferred approach to obtain a snapshot of the power distribution in the core is based on the patterned-channel-age model implemented in the $^*INSTANTAN$ module of the RFSP code. The objective of this approach is to obtain a representative snapshot of core conditions quickly. At present, such patterns could be generated by using a program called RANDIS, which is implemented within the $^*INSTANTAN$ module. In this work, we present an alternative approach to derive the patterned-channel-age model where a simulated-annealing-based algorithm is used to find such patterns, which produce reasonable power distributions.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.5 no.1
• /
• pp.68-82
• /
• 2011

Wireless mesh networks (WMNs) provide high-speed backbone networks without any wired cable. Many researchers have tried to increase network throughput by using multi-channel and multi-radio interfaces. A multi-radio multi-channel WMN requires channel assignment algorithm to decide the number of channels needed for each link. Since the channel assignment affects routing and interference directly, it is a critical component for enhancing network performance. However, the optimal channel assignment is known as a NP complete problem. For high performance, most of previous works assign channels in a centralized manner but they are limited in being applied for dynamic network environments. In this paper, we propose a simple flow estimation algorithm and a hybrid channel assignment algorithm. Our flow estimation algorithm obtains aggregated flow rate information between routers by packet sampling, thereby achieving high scalability. Our hybrid channel assignment algorithm initially assigns channels in a centralized manner first, and runs in a distributed manner to adjust channel assignment when notable traffic changes are detected. This approach provides high scalability and high performance compared with existing algorithms, and they are confirmed through extensive performance evaluations.

• Journal of information and communication convergence engineering
• /
• v.9 no.6
• /
• pp.652-656
• /
• 2011

In this paper, a transmitter-based multipath processing and inter-channel interference (ICI) cancellation scheme for a ultra-wideband (UWB) spatial multiplexing (SM) multiple input multiple output (MIMO) system is presented. It consists of taps delayed lines and zero-forcing (ZF) filters in the transmitter and correlators in the receiver. For a UWB SM MIMO system with N transmit antennas, M receive antennas, and Q resolvable multipath components, the BER performance of a linear transmit ZF scheme is analyzed in a log-normal fading channel and also compared with that of a receiver-based ICI rejection approach. It is found that when M ${\leq}$ N, the transmit ZF processing approach outperforms the ZF receiver while making the mobile units low-cost and low-power.

• Proceedings of the KSRS Conference
• /
• 2003.11a
• /
• pp.363-365
• /
• 2003

This paper presents an object oriented approach(OOA) for classification of multi-channel and multi-polarization NASA/JPL POLSAR images. Some test results in Taiwan are also given and analyzed. It is concluded that this approach can utilize as more information of both low- and high-levels involved in all images as possible for image classification and thus provides a better classification accuracy. For instance, the OOA has a better overall classification accuracy(98.27%) than the nearest-neighbor classifier(91.31%) and minimum-distance classifier(80.52%).

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.19 no.4
• /
• pp.660-668
• /
• 1994

In this paper, a new approach to estimate nonmlinear distortions (second-harmonic, second-intermodulation, third-harmonic, and third-intermodulation) in digital communication systems is proposed. In contrast to the relatively common sine-wave input approach which requires repetition of the same experiments by changing frequencies of oscillators and filters over the band of frequencies of interest, the proposed approach uses digital random input (transmitted signal in digital communication system) to adaptively estimate parameters of a nonlinear channel in time-domain. Nonlinear distortion of the channel is estimated on line by transforming the estimated parameters into frequency-domain. Comparison between the classical two-tone input approach and the proposed approach is made through computer simulation.

• The Journal of the Acoustical Society of Korea
• /
• v.22 no.1E
• /
• pp.43-48
• /
• 2003

The effects of linear acoustic channels have been analyzed and compensated at mel-frequency feature domain. Unlike popular RASTA filtering our approach incorporates separate filters for each mel-frequency band, which results in better recognition performance for heavy-reverberated speeches.

• Journal of the Korean Operations Research and Management Science Society
• /
• v.23 no.3
• /
• pp.37-47
• /
• 1998

Under the cutoff priority discipline, the prioritized channel allocation problem is formulated, which minimizes the overall blocking probability while ensuring the co-channel interference constraints. To deal with the problem more conveniently, the concept of pattern is used. A simulated annealing approach is applied to the problem, and computational experiments show that a high-quality solution is obtained.