• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.14 no.2
• /
• pp.111-118
• /
• 2003

Notch Antenna is a travelling wave type antenna and can provide multioctave operation in phased arrays that scan over wide angle. In this paper, we designed a wideband E-plane phased array antenna using E-plane waveguide simulator which has a bandwidth of 3 : 1 and a scan volume of $\pm$45$^{\circ}$ in E-plane. We compared impedance of single antenna and infinite array antenna using equivalent circuit modeling. We analyzed full structure of 1$\times$9 phased array antenna and we evaluated active reflection coefficient with variation of beam scan angle through mutual coupling coefficient acquired from simulation and investigated the variation of antenna gain with variation of active element pattern as beam scan angle is varied.

• Journal of Broadcast Engineering
• /
• v.16 no.3
• /
• pp.483-489
• /
• 2011

In this paper, we propose a new antenna, which has wide bandwidth, good radiation patterns, and high-gain characteristics. We analysis the antenna using FDTD(Finite Difference Time Domain) method. And the antenna parameters are optimized to get maximum bandwidth. From the measured results, the bandwidth of the antenna is 0.839 octave, for the S11${\leq}$-10 dB. And the measured cross polarization level of the proposed antenna is less than -25 dB at the center frequency. Experimental data of the return loss and the radiation pattern of the proposed antenna are also presented, and the experimental bandwidth characteristics are relatively in good agreement with the FDTD results. The proposed antenna can be applied to MIMO, LAN, biomedical instruments, broadcasting-network system.

• The Journal of Korea Institute of Information, Electronics, and Communication Technology
• /
• v.8 no.2
• /
• pp.147-151
• /
• 2015

In this paper, the performance variation of a planar circular monopole antenna is studied, when this antenna is fabricated to film type and installed in the space between case and PCB of UWB terminal. When the circular monopole part has the 'ㄷ' folded structure, the input impedance and return loss, bandwidth, radiation pattern of this antenna are simulated and measured. Then the performance variation is compared with conventional planar antenna. As the results, the folded type circular antenna is usable as a intenna of UWB communication terminal, because of the good return loss and radiation pattern performance in the 2.6 - 12 GHz including the UWB frequency band.

• Journal of electromagnetic engineering and science
• /
• v.19 no.1
• /
• pp.20-30
• /
• 2019

A wide-band multiple-input multiple-output (MIMO) antenna with dual-band (2.4 and 5 GHz) operation is proposed for premium indoor access points (IAPs). Typically, an omni-directional pattern is used for dipole antennas and a directional radiation pattern is used for patch antennas. In this paper, both antenna types were used to compare their performance with that of the proposed $2{\times}2$ MIMO antenna. We simulated and measured the performance of the MIMO antenna, including the isolation, envelope correlation coefficient (ECC), mean effective gain (MEG) for the IAPs, and the throughput, in order to determine its communication quality. The performance of the antennas was analyzed according to the ECC and MEG. The proposed antenna has sufficient performance and excellent characteristics, making it suitable for IAPs. We analyzed the communication performance of wireless networks using the throughput data of a typical office environment. The network throughput of an 802.11n device was used for the comparison and was conducted according to the antenna type. The results showed that the values of the ECC, MEG, and the throughput have unique characteristics in terms of their directivity, antenna gains, isolation, etc. This paper also discusses the communication performance of various aspects of MIMO in multipath situations.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.18 no.3 s.118
• /
• pp.273-281
• /
• 2007

This paper presented design for a dipole antenna operated at 900 MHz band RFID tag, and antenna performance varied by the sticked material was experimentally evaluated. When dipole antenna was sticked by the material having a difffrent electric characteristic such as dielectric material, fero-magnetic material and conductor, variations of antenna return loss and radiation pattern according to the sticked material kinds, size, and height between antenna and the sticked plate were experimentally observed and evaluated. When antenna was sticked by dielectric surface, the measured return loss and radiation pattern by affection of different dielectric permittivity ratio showed resonant frequency shift of about 40 MHz and relative attenuation of 1 dB to 3 dB. Even though frequency shift by size variation of the sticked plate was observed, the measured radiation pattern of dipole antenna located on the sticked plate was similar with one without backside plate. In the case of conductor or fero-magnetic material as the sticked ground plate, because of frequency shift and phase difference by distance between dipole antenna and the sticked ground plate, amplitude decrease of radiation pattern at 910 MHz was observed about 5 dB above.

• Journal of Broadcast Engineering
• /
• v.21 no.3
• /
• pp.404-411
• /
• 2016

In this paper, we investigate the radio wave radiation pattern to measure the actual field strength for the transmission antenna dipole antenna and the CP-ring antenna being used in our country as FM station, and the comparison was for field application. Compare results, If the transmitting station and the relay station which is located in the middle of a service area has been a useful CP-dipole antenna (four directions). CP-ring antenna having a directivity because the reflection effect of the tower was able to adjust the orientation to prevent the spread of menstrual another service area in the main direction was able to radiate high propagation 5~9dB. Especially, If the transmitting station and the relay station is located on one side of the service area for radiating radio waves in three directions by using the CP-ring antennas focus the orientation of the antenna in populated areas and road area can improve the broadcast reception environment.

• Journal of Advanced Navigation Technology
• /
• v.15 no.2
• /
• pp.197-203
• /
• 2011

A triple-band antenna which can be used at GSM900, PCS1900 and Bluetooth(or Wi-Fi) frequency band is proposed. The proposed antenna is designed based upon switching between IFA(Inverted F Antenna) that has a resonant length of ${\lambda}/4$ and loop antenna that has a resonant length of ${\lambda}/2$. It can be applied to triple-band only by use of single printed pattern due to the switching characteristic. It is designed by use of the IFA for the application to the GSM900, while it is designed by use of the loop antenna for the application to the PCS1900 and by use of additional pattern of IFA for the application to the Bluetooth(or Wi-Fi) respectively. As a result, it has been observed that the proposed antenna satisfies the required return loss(${\leq}10dB$) and also has efficiency(${\geq}80%$) over the whole band. Moreover the proposed antenna has omni-directional radiation pattern which is suitable to apply to the mobile phone.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.17 no.2
• /
• pp.257-262
• /
• 2017

In this paper, we proposed a rectangular planar monopole antenna with a double sleeve that applied to a half-cut and a discontinuous feed structure. A rectangular planar monopole antenna with a double sleeve was cut in half along the magnetic symmetry line, and impedance matching was achieved by a discontinuous structure was applied to a feeder and by adjusting the double sleeve gap. We used the HFSS simulator of ANSYS company to confirm the antenna parameter property, and the antenna size was $21{\times}40mm^2$. In the proposed antenna, the simulation frequency range with VSWR of 2 or less was 2.6GHz to 10.25GHz. The bandwidth was 7.65GHz. The frequency range of the fabricated antenna was 3.3GHz to 9.75GHz, and the bandwidth was 6.45GHz. The measured radiation pattern frequencies were 3.5GHz, 5.5GHz, 7.5GHz, and 9.5GHz. A radiation pattern similar to the dipole antenna pattern was obtained at all frequencies.

• 한국ITS학회:학술대회논문집
• /
• 2003.11a
• /
• pp.316-319
• /
• 2003

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.3 no.1
• /
• pp.3-11
• /
• 1966

An optimum pattern control procedure for the TV, FM broadcasting antennas being constructed in Seoul & Pusan is described. For the pattern control, 4 antenna elements were romoved from Seoul toward Inchen. Resulting pattern was measured and compared to the results of theoretical value. Similar results were obtained for Pusan antenna.