• Journal of Mechanical Science and Technology
• /
• 제17권8호
• /
• pp.1234-1245
• /
• 2003

An experimental study was carried out to investigate the reduced frequency effect on the near-wake of an elliptic airfoil oscillating in pitch. The airfoil was sinusoidally pitched around the center of the chord between -5$^{\circ}$and ＋25$^{\circ}$angles of attack at an airspeed of 3.4 m/s. The chord Reynolds number and reduced frequencies were 3.3 ${\times}$10$^4$, and 0.1, 0.7, respectively Phase-averaged axial velocity and turbulent intensity profiles are presented to show the reduced frequency effects on the near-wake behind the airfoil oscillating In pitch. Axial velocity defects in the near-wake region have a tendency to increase in response to a reduced frequency during pitch up motion, whereas it tends to decrease during pitch down motion at a positive angle of attack. Turbulent intensity at positive angles of attack during the pitch up motion decreased in response to a reduced frequency, whereas turbulent intensity during the pitch down motion varies considerably with downstream stations. Although the true instantaneous angle of attack compensated for a phase-lag is large, the wake thickness of an oscillating airfoil is not always large because of laminar or turbulent separation.

• 수산해양기술연구
• /
• 제45권1호
• /
• pp.34-45
• /
• 2009

In this study, the hydrodynamic coefficients were measured using various nettings to analyze the change of drag coefficients and lift coefficients as a basic study for deriving hydrodynamic coefficients. The data on hydrodynamic force obtained from the flume tank tests were used to compare and analyze the hydrodynamic coefficients based on Reynolds number. Standardized hydrodynamic coefficients were then assumed during the analysis procedures. The hydrodynamic coefficients were measured using the 9 kinds of nettings in which had the same total projected area with different diameters and mesh-grouping ratio. These different netting systems : mesh-grouping ratio. The results of the test of nettings were as follows; First, the drag coefficients of nettings increased when the higher attack angles applied, and decreased with the increased flow speed and netting twine diameter. Second, the lift coefficients of nettings showed the increased values until the attack angle 30 degree, but decreased for the attack angle over 40 degree. Third, the hydrodynamic coefficients of netting decreased as the Reynolds number increased, and reach at slightly states in the highest numbers. Fourth, the hydrodynamic coefficients were derived from a functional formula considering attack angles and Reynolds number, and presented in the three dimensional space.

• 한국군사과학기술학회지
• /
• 제16권5호
• /
• pp.607-612
• /
• 2013

The effect of the flow actuator on the asymmetric vortex structure around the ogive-cylinder body with fineness ratio of 4 flying at the speed of Mach 0.1 at angle of attack of 50 degree is studied. The ogive-cylinder model is developed with the actuator placed near the nose tip and numerically simulated using the in-house CFD code named KFLOW. The numerical simulation employs two different actuator modeling: one is the boundary condition given by blowing normal to the surface and another shearing on the surface. The numerical simulation reveals that response of the vortex structure to the actuation is dependent on the type of modeling as well as the strength and direction of the actuation.

• 대한기계학회논문집
• /
• 제18권6호
• /
• pp.1590-1597
• /
• 1994

The aerodynamic analysis of a $6{\times}6$ counter-rotating propfan around a missile-like-body has been completed analytically using a frequency domain panel method. The present method requires Fourier transformation of flow field around the propfan in computing the velocities normal to the propfan lifting surfaces. The aerodynamic performance curve is determined by angle of attack and nonuniform inflow conditions. The inflow conditions result from the variations of missile flight speed, angle of attack, propfan location relative to control surfaces and control surface deflection angle. The two cases of propfan location relative to control surface, front and behind, are analyzed and the aerodynamic results are presented.

• 대한기계학회논문집
• /
• 제18권10호
• /
• pp.2664-2674
• /
• 1994

Drag, lift, and pitching moment measurements have been made on a range of slanted-base ogive cylinders, using the KANOMAX wind tunnel and balance system. Test Reynolds numbers(based on model maximum diameter) varied from $0.54{\times}10^{5}{\;}to{\;}1.56{\times}10^{5}$. Crossflow velocity maesurement was conducted by 5-hole pitot tube at $Re_{D}=1.46{\times}10^{5}$. For two base angle $({\theta}=30$ and 45 deg.), aerodynamic forces and moment were measured with increasing angle of attack(0~30 deg.). Two types of wake flow were observed, a quasisymetric turbulent closure or a longitudinal vortex flow. Aerodynamic characteristics differ dramatically between the two wake types. It was found that the drag, lift and pitching moment coefficients increased with increasing angle of attack.

• EDISON SW 활용 경진대회 논문집
• /
• 제1회(2012년)
• /
• pp.53-56
• /
• 2012

항공기에 작용하는 공기역학적 힘인 양력과 항력은 항공기 날개 설계에서 성능을 좌우하는 성능지수로 주로 이용된다. 본 연구에서는 NACA0012 airfoil 모델의 공력특성을 EDISON 열유체 시뮬레이션 프로그램(이하 EDISON)을 이용해 분석하고 검증해 보았다. 아음속 유동의 특정 조건에서 받음각과 유동형태에 따른 공력특성 분석을 수행하여 받음각에 따라 변하는 양력계수, 항력계수, 양항비, 실속각과 천음속 유동 조건에 맞추어진 마하수 0.5~1.22 영역에서 변하는 항력계수를 기존 데이터와 비교 검증했다.

• 수산해양기술연구
• /
• 제26권4호
• /
• pp.333-340
• /
• 1990

평판형과 만곡형전개판 주위에서의 유체특성을 파악하기 위하여 회유수조에서 수조기포법에 의한 하시화실험을 유속 0.05 및 0.1m/sec, 영각과 타임라인에 대해서 실시하였다. 그 결과를 요약하면 다음과 같다. 1. 만곡형전개판에서의 유선은 영각 20。까지는 균일한 분포를 이루다가 영각 25。에서 후면에 인접한 유선이 익현장의 1/2지점에서부터 작은 과가 발생되기 시작하고, 영각 30。에서는 익현자의 1.3지접에서 박리가 시작되며 인접한 유선은 전개판의 후면쪽으로 휘어들어가고, 그리고 영각 35。이상에서는 전연에서부터 박리가 시작되며 영각이 증가할수록 박리층이 증가하는 것으로 나타났다. 2. 평판형전개판에서는 영각 20。부터 전연에서 과와 박리가 발생하며, 박리층은 만곡형과 마찬가지로 영각에 비례하는 것으로 나타났다. 3. 후연에서 발생한 과의 크기가 전연의 것보다 약 2~3배 큰 것으로 나타났다. 4. 전개판의 후연에서 유선은 양 전개판 모두 전개판의 방향과 같은 방향으로 흐르다가 점차 유체흐름과 같은 방향이 되는 것으로 나타났다. 5. 전개판 전후면에서의 유속차는 영각 0。~30。에서 점차 증가하다가 영각 35。이상에서는 그 차가 비슷하게 나타났다. 6. 영각 20~30。에서 전후면의 유속차는 만곡형의 경우 후면의 유속이 전면보다 약 1.4~1.5배 빠르게 나타났으며, 평판형은 약 1.2배 빠르게 나타났다.

• 수산해양기술연구
• /
• 제42권3호
• /
• pp.169-178
• /
• 2006

This research aims at establishing the fundamental characteristics of the kite through the analysis of the flow field around various types of kites. The approach of this study were adopted for the analysis; visualization by CFD(computational fluid dynamics). Also, the lift/drag and PIV(particle image velocimetry) tests of kites had been performed in our previous finding. For this situation, models of canvas kite were designed by solidworks(design program) for the CFD test using the same conditions as in the lift/drag tests. And we utilized FloWorks as a CFD analysis program. The results obtained from the above approach are summarized as follows: According to comparison of the measured and analyzed results from mechanical tests, PIV and CFD test, the results of all test were similar. The numerical results of lift-coefficient and drag-coefficient were 5-20% less than those of the tests when attack angle is $10^{\circ},\;20^{\circ}\;and\;30^{\circ}$. In particular, it showed the 20% discrepancy at $40^{\circ}$. The numerical results of the ratio of drag and lift were 8-13% less than those of the tests at $10^{\circ}$ and 10% less than those of the tests at $20^{\circ},\;30^{\circ}\;and\;40^{\circ}$. Pressure distribution gradually became stable at $10^{\circ}$. In particular, the rectangular and triangular types had the centre of the high pressure field towards the leading edge and the inverted triangular type had it towards the trailing edge. The increase of the attack angle resulted in the eddy in order of the rectangular, triangular and inverted triangular type. The magnitude of the eddy followed the same order. The effect of edge-eddy was biggest in the triangular type followed by the rectangular and then the inverted triangular type. The action point of dynamic pressure as a function of the attack angle was close to the rear area of the model with the small attack angle, and with large attack angle, the action point was close to the front part of the model.

• 한국항공우주학회지
• /
• 제46권1호
• /
• pp.1-9
• /
• 2018

람다 날개 형태의 무인전투기는 동체-날개 융합익의 형태를 띄고 있어 일반적인 항공기에 비해 상대적으로 항력이 작고 레이더 반사 면적이 작아 우수한 스텔스 성능을 갖는다. 그러나 앞전 후퇴각에 의해 생성되는 앞전 와류의 영향으로 특정 받음각에서 피칭모멘트가 급격히 증가하는 현상이 나타난다. 본 연구에서는 무미익 람다 날개 형상을 기반으로 한 UCAV 1303 모델을 사용하여 풍동시험과 전산해석을 수행하였다. 실험 풍속은 50 m/s, 받음각 범위는 $-4^{\circ}{\sim}28^{\circ}$ 으로 하였으며 전산해석 또한 실험 조건과 동일하게 연구를 수행하였다. 본 연구를 통해 UCAV의 날개 비틀림이 피칭모멘트의 안정성에 미치는 영향을 확인하였다. 그 결과 날개에 음의 비틀림 각을 적용하였을 때 날개 바깥쪽에서의 유동 박리가 지연되면서 Pitch-break가 발생하는 받음각이 증가하였고, 양의 비틀림 각을 적용하였을 때 Pitch-break가 발생하는 받음각이 감소하였지만 양항비가 증가하는 것을 확인하였다.

• 대한기계학회논문집B
• /
• 제33권7호
• /
• pp.506-511
• /
• 2009

Insect flight is adapted to cope with each circumstance by controlling a variety of the parameters of wing motion in nature. Many researchers have struggled to solve the fundamental concept of insect flight, but it has not been solved yet clearly. In this study, to find the most effective flapping wing dynamics, we conducted to analyze CFD data on fixing some of the optimal parameters of wing motion such as stoke amplitude, flip duration and wing rotation type and then controlled the deviation angle by fabricating wing tip motion. Although all patterns have the similar value of lift coefficient and drag coefficient, pattern A(pear-shape type) indicates the highest lift coefficient and pattern H(pear-shape type) has the lowest lift coefficient among four wing tip motions and three deviation angles. This result suggest that the lift and drag coefficient depends on the angle of attack and the deviation angle combined, and it could be explained by delayed stall and wake capture effect.