• Proceedings of the IEEK Conference
• /
• 2003.07b
• /
• pp.887-890
• /
• 2003

High Speed data transmission over a long length of cable is limited due to the limited bandwidth of a cable which introduces ISI(Inter Symbol Interference). In order to compensate for the loss and phase dispersion in the cable, a pulse shaping in a transmitter and a line equalizer in receiver can be used. This paper presents a low-power and small-ana analog adaptive pulse shaping circuit and line equalizer, The design was fabricated in a 0.25${\mu}{\textrm}{m}$ mixed-signal CMOS process. The proposed pulse shaping circuit and equalizer operate at 400Mb/s on 50m STP(Shielded Twisted Pair) cable. It consumes 28.5${\mu}{\textrm}{m}$ with a 2.5-V power supply and occupies only 0.098 $\textrm{mm}^2$.

• Journal of Digital Convergence
• /
• v.11 no.6
• /
• pp.1-9
• /
• 2013

The digital signal is terminated on Dec.31, 2012. But most of the analog cable subscribers are faced with the difficult reception of the digital because the government has defined the terrestrial broadcast as digital transition obligation operators. It is estimated that half analog of the total pay-TV subscriber that is approximately 10million households that are directly receiving terrestrial signal must hold the digital TV or DtoA convertor to transit digital. But cable system subscriber should buy Set-top box that are expensive and pay the expensive rates. The cast of analog cable subscribers has been classified as a group that can cause the most damage after digital switch. This study investigate the problem, and cause, solution of the analog cable subscribers that are placed in the blind spots of the digital switch.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.16 no.3
• /
• pp.145-153
• /
• 2016

Cable TV with largest subscription base in pay TV market has difficulty in managing the task of digital switch over. This study analyzed the factors in delay of cable TV switch over and examined the impact of pay TV market structure and competition. The delaying factors turned out to be the lack of incentives and resources of cable TV operators, insufficient policy measures and acceptance tolerance issues of subscribers. Since cable TV operators with monopolistic status in pay TV market had continuous profit from analog service, they were not responsive to digital switch over which requires additional investment. Policy measures including support for the low income household and mandatory cut-off point for stopping analog broadcasting. Subscriber's willingness to accept digital broadcasting in terms of price sensitivity and preference for convenient operation also played a role. Introduction of IPTV in pay TV market influenced the speed of digital switch over of cable TV operators. MSOs with economies of scale showed higher digital switch over rate than independent SO.

• Journal of Broadcast Engineering
• /
• v.23 no.6
• /
• pp.824-835
• /
• 2018

In this study, the impact on the number of cable TV subscribers as well as the profit of cable TV has been examined, and the impact on enlarging the digital broadcast viewing rights of cable TV subscribers and viewers' welfare has also been examined. We investigated the trends in the number of analog and 8VSB subscribers and revenue of cable TV operators by region and analyzed based on changes in the number of channels provided by each operator. The results show that analog subscribers and digital subscribers are delaying their departure through 8VSB conversion, and VOD subscription fees and home shopping transmission fees have a significant impact on operating profit. Subscribers, as they switched over to 8VSB, have become able to view channels of various genres with clear picture quality for a same subscription fee, and the program providers could offer programs to more customers. The government's deregulation policy due to the changes in broadcasting environment led to the facilitation of digital conversion of Pay-TV and improvement of viewers' welfare.

• Aerospace Engineering and Technology
• /
• v.6 no.2
• /
• pp.171-179
• /
• 2007

The Test Equipment for the upper stage of KSLV-I has following functions via umbilical cable interface; external power supply, command output such as discrete and analog, data acquisition, CS-I interface simulation for first stage of KSLV-I and RS-422 serial communication for PDU. The main purpose of UTE is the experiment or function verification of system-level upper stage. To realize this system, we used PXI control system. The UTE is consisted of the PXI control system, power supply, terminal block, internal harness, connector panel and so on. The software functions of UTE are classified by four blocks. These are Discrete/Analog I/O control, PDU RS-422 serial communication control, power supply GPIB control and UTE remote control. In this paper, we will describe the design on the hardware and software of UTE.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.3 no.4
• /
• pp.255-260
• /
• 1991

A voltage measuring system specified for the voltage fluctuation of the Pusan-Hamada submarine cable is developed by adding circuits of differential amplification and analog-to-digital conversion to a microprocessor-based data logger with a data modem. This system is charaterized by its small size. no power failure. fully unmanned operation. and precise instrumental drift correction. In addition to the cable voltage and current it measures an ambient temperature and a mercury cell voltage in order to calibrate temperature effect and check its long-term stability. The data acquired by this system show that the voltage signal. comprising fast random noises with a constant width of about 0.2V. fluctuates within a range of about 1V and the fluctuation frequency is similar to that of tidal motion. The source voltage of power feeding equipment (PFE) for the cable system seems to be affected when the room temperature changes rapidly.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.35 no.11B
• /
• pp.1588-1595
• /
• 2010

DVB-C2 is the next generation digital broadcasting standard which will replace the analog cable broadcasting. LDPC and BCH significantly increase performance of forward error correction and allows for the application of higher constellation. Additionally, DVB-C2 is based on OFDM instead of single-carrier modulation, which gives additional flexibility and robustness in typical cable channels. This paper will give an introduction to the DVB-C2 system and spectral efficiency of DVB-C2 compare with DVB-C. Finally, The the simulation which is using BICM and OFDM structure show the performance of the DVB-C2.

• Journal of information and communication convergence engineering
• /
• v.9 no.6
• /
• pp.743-746
• /
• 2011

An implementation for surface EMG network analysis and vertical control system of robotic arm is presented in this paper. The transmembranes are simulated by equivalent circuit and cable equation for propagation to be converted to circuit networks. The implementation is realized to be derived from the detecting EMG signal from 3 electrodes, and EMG transmembrane signals of human arm muscles are detected by several surface electrodes, high performance amplifier and filtering, converting analog to digital data and driving a servomotor for spontaneous robotic arm. The system is experimented by monitoring multiple steps vertical control angles corresponding to biceps muscle movement. The experimental results are that the vertical moving control level is measured to around 2 degrees and mean error ranges are lower 5%.

• 제어로봇시스템학회:학술대회논문집
• /
• 1990.10a
• /
• pp.79-84
• /
• 1990

Analog systems could not fully deal with instrumentation and control facilities in power plants since these facilities have become more and more complex on account of various needs for large power generation capacity highly cost effective operation to conserve energy and operation management to prevent pollution. Digitalizations of control device and augmentations of control informations increased the necessity of fiber optic data networks which have excellent noise immunity and high quality wide-band with information transfer capability. The goal of this study is to offer a fiber optic data-way system which has high reliabilities, high data transmission rates and small cable ducts with large transmission capacities for the instrumentation and control of power plants.

• Proceedings of the Korean Society of Broadcast Engineers Conference
• /
• 1996.06b
• /
• pp.115-121
• /
• 1996

Interactive CATV system is under development to provide multimedia applications such as movies on demand, home shopping, etc. In addition to the conventional analog cable TV services. This system applies international standard DAVIC, ATM forum, DSM-CC etc. The system adopts modular architecture design approach so that the system can be adaptive to the fast moving technology wavefront. In this article, interactive CATV system and essential elements such as video server, delivery network and Set-Top-Box(STB) and related international standardization are introduced.