• Journal of Environmental Health Sciences
• /
• v.30 no.2
• /
• pp.167-172
• /
• 2004

In this study, we carried out the research for the recycling potential of the dyeing wastewater treatment sludges as construction materials. The incineration ash of sludges were solidified as interlocking block in condition of sludge/cement ratio 2.5%, 5.0% and 10%, respectively. Those interlocking blocks were cured for 3days, 7days and 28days in ambient air condition, respectively. The results of this research were summarized as follows: The dyeing wastewater treatment sludges was below the Korea Leaching Limit. After incineration, the ash was manufactured as interlocking block. Bendable strength over 50kg$_{f}$/$\textrm{cm}^2$ suitable for interlocking block was obtained only when the sample was cured for 7days at sludge/cement ratio 2.5% and 5.0%. Hygroscopic ratio of interlocking block was above the Korea Industry Standard. We think that recycling of the incineration ash from dyeing wastewater treatment sludges to interlocking block will have high potential possibility.y.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.15 no.3
• /
• pp.187-195
• /
• 2003

The geometric size and the refrigeration capacity of a refrigeration system are strongly dependent on the capacity of heat exchanger, which is one of the key design parameters. In this paper, the effect of the capacities of heat exchangers on the performance of a real refrigeration system operated in a vapor compression cycle was analyzed by the numerical simulation. From the results, the conditions that gave the maximum values of the refrigeration capacity or COP were respectively determined as a function of the capacities of condenser and evaporator under the given ambient and operating condition.

• Journal of ILASS-Korea
• /
• v.13 no.1
• /
• pp.51-57
• /
• 2008

The objective of this study was to investigate the spray characteristics of commercial biodiesel fuel at various fuel injection conditions. To examine the effect of various factors on the development of a biodiesel sprays, experiments were conducted at the various injection pressures, ambient pressures and blending ratio of bio-diesel fuels. As a result of experimental study, it was shown that the increase of blending ratio of biodiesel had little influence on spray behaviors under applied fuel injection condition in this study. Because macroscopic characteristics of biodiesel-blended diesel fuel were almost same as that of petrodiesel fuels, it was found that the commercial biodisel is applicable to conventional diesel engine.

• Proceedings of the Korean Printing Society Conference
• /
• 2000.04a
• /
• pp.35-44
• /
• 2000

Because Image on the CRT change under different illuminants, human is difficult to see original color of object. If what is information of used illuminant on capturing object know, image can be transformed according to viewing condition using the linear matrix method. To know information of used illuminant at an image, the spectral radiance of illuminant can be estimated using the linear model of Maloney and Wandell form an image. And then image can be properly transformed it using color appearance model. In this paper, we predict the spectral radiance of illuminant using spectral power distribution of specular light and using surface spectral reflectance at maximum gray area. and then we perform visual experiments for the corresponding color reproduction according to viewing condition. In results, we ensure that the spectral radiance of illuminant at an image can be well estimated using above algorithms and that human visual system is 70% adapted to the monitor's white point and 30% to ambient light when viewing softcopy images.

• Journal of Sensor Science and Technology
• /
• v.13 no.1
• /
• pp.66-71
• /
• 2004

Pt-doped zinc oxide (ZnO:Pt) films were deposited by ultrasonic spray pyrolysis. Resistivity variation with Pt concentration was measured. The Pt distribution in ZnO:Pt films was studied through Auger Electron Spectroscopy (AES). The ZnO:Pt films were annealed in the ambient of air, water vapor and ozone, respectively. The variation in crystallographic properties and surface morphologies with respect to the annealing condition was observed by X-Ray Diffraction (XRD) and Scanning Electron Microscopy (SEM). The resistivity variation of the films with the annealing condition was measured. Finally, Atomic Force Microscopy (AFM) measurements were carried out to study the effects of the annealing on the roughness of ZnO:Pt films.

• Journal of the Korean Magnetic Resonance Society
• /
• v.27 no.1
• /
• pp.1-4
• /
• 2023

Transthyretin (TTR) is an indispensable transporter protein of thyroxine and a retinol molecule in humans. TTR has a stable homo-tetrameric structure in its native state, while upon dissociation into monomers, it becomes aggregation-prone and can form an amyloid fibril. Although the amyloidogenic propensity of TTR has been known and investigated since the late 1990s, the structural information regarding TTR's amyloidogenic species is still elusive. Here, we employed high-pressure nuclear magnetic resonance (HP-NMR) approaches on the monomeric variant of TTR (TTR[F87M/L110M]; M-TTR) and observed that it experiences a two-step transition in response to the pressurized condition. Our study demonstrated that M-TTR in an ambient condition has heterogeneous structural features, which is likely related to the amyloidogenic propensity of TTR.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.23 no.6
• /
• pp.754-757
• /
• 1986

Boron monophosphide(100) was eitaxially grown on Si(100) substrate by thermal reaction of B2H6 and PH3 in hydrogen ambient. In an LPCVD system, the growth condition was studied as a function of gas mixture composition and temperature. For the growth temperature of 950\ulcorner in the constant flow rate (partial pressure) of B2H6, n-BP with c(2x2) surface structure was obtained in the PH3 partial pressure of 300-500 cc/min. On the other hand, for the growth temperature of 1080\ulcorner, p-BP with surface structure was observed for the PH3 partial pressure of 400-500cc/min.

• Bulletin of the Korean Chemical Society
• /
• v.35 no.9
• /
• pp.2758-2764
• /
• 2014

We demonstrated the synthesis of organic carbonates using alkyl/aryl 4,5-dichloro-6-oxopyridazine-1(6H)-carboxylates and alcohol in the presence of aluminum chloride. Alkyl/aryl 4,5-dichloro-6-oxopyridazine-1(6H)-carboxylates were reacted with alcohol in the presence of $AlCl_3$ in toluene at room temperature to afford the corresponding unsymmetric and symmetric organic carbonates in good to excellent yields. These are efficient and convenient processes. Alkyl/aryl 4,5-dichloro-6-oxopyridazine-1(6H)-carboxylates are solid, stable and non-toxic $CO_2/CO_2R$(Ar) source. It is noteworthy that the reaction is carry out under an ambient and acidic conditions, the easy-to prepare and readily available starting materials and the quantitative isolation of reusable 4,5-dichloropyridazin-3(2H)-one.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.20 no.5
• /
• pp.654-664
• /
• 2017

The temperature profiles upon high speed impact of reactive structural materials were analyzed. A two color pyrometer, which included high-speed camera, spectral splitter, and band pass filters, was utilized to measure transient temperature profiles during and after reactive metal samples impacted into steel plate with velocities of 1600~1700 m/s. The spatial temperature distribution was analyzed from the ratio of spectral radiances at two different wavelength in infrared zone, i.e. 700 and 900 nm. The measured temperatures were calibrated with black body source. Two different types of metal samples, namely aluminum and nickel, were employed to understand reaction behavior upon the impact of samples in ambient condition. According to our experiments, the Ni sample appeared to barely react with ambient air producing an instant small fireball, while Al sample reacts violently with air generating a relatively prolong fireball.

• The Plant Pathology Journal
• /
• v.26 no.2
• /
• pp.178-184
• /
• 2010

Four major diseases of chili pepper including two fungal diseases, anthracnose (Colletotrichum acutatum) and Phytophthora blight (Phytophthora capsici), and two bacterial diseases, bacterial wilt (Ralstonia solanacearum) and bacterial spot (Xanthomonas campestris pv. vesicatoria), were investigated under future climate-change condition treatments in growth chambers. Treatments with elevated $CO_2$ and temperature were maintained at $720ppm{\pm}20ppm$ $CO_2$ and $30^{\circ}C{\pm}0.5^{\circ}C$, whereas ambient conditions were maintained at $420ppm{\pm}20ppm$ $CO_2$ and $25^{\circ}C{\pm}0.5^{\circ}C$. Pepper seedlings or fruits were infected with each pathogen, and then the disease progress was evaluated in the growth chambers. According to paired t-test analyses, bacterial wilt and spot diseases significantly increased by 24% (p=0.008) and 25% (p=0.016), respectively, with elevated $CO_2$ and temperature conditions. On the other hand, neither Phytophthora blight (p=0.906) nor anthracnose (p=0.125) was statistically significant. The elevated $CO_2$ and temperature accelerated the progress of bacterial wilt by two days and bacterial spot by one day compared to the ambient treatment. Temperature regime studies of the diseases without changes in $CO_2$ confirmed that the accelerated bacterial disease progress was mainly due to the increased temperature rather than the elevated $CO_2$ conditions.