• 한국가스학회지
• /
• 제23권6호
• /
• pp.90-96
• /
• 2019

셰일가스의 채굴량 확장과 러시아를 통한 PNG (Pipeline Natural Gas)의 도입은 천연가스가 유력한 대체 연료임을 시사해주고 있다. 따라서 향후 증대될 천연가스의 공급에 맞추어 해당 연료의 수요처 증대가 필수적인 상황이다. 이와 같은 상황에서 수송분야는 저탄소 기체 연료인 천연가스를 적용하기 적합한 분야이며, 이를 통해 이산화탄소와 입자상 물질 등의 유해 배기물질을 저감하는 데 큰 역할을 할 것으로 기대된다. 천연가스는 자발화 특성이 낮고, 내노킹(Anti-knocking)성이 우수하기 때문에 전기점화 방식에 적합하다. 최근 가솔린 엔진은 연비 개선을 위해 연소실에 직접 분사하는 방식을 주로 채택하고 있으나,연소실 내로 액상 직분사를 하는 반면 천연가스의 경우 액상분사 혹은 고압 분사가 어렵다. 따라서 포트에 분사하는 방식을 사용하므로 동등 흡기압력에서 연료의 분율이 흡입공기의 체적을 대체하여 가솔린 직분 방식에 비해 출력이 저하되는 현상을 피할 수 없게 된다. 이에 본 연구에서는 터보차저를 천연가스 포트 분사 엔진에 적용하여 흡기 압력 상향을 통한 출력 보상을 도모하고자 하였다.그 결과 천연가스 적용 시 흡기압력을 기존 가솔린 대비 5-27 % 상향 시 가솔린 직분사 엔진과 동등 출력을 확보함과 동시에 향상된 제동 열효율을 확인 할 수 있었다.

• International Journal of Automotive Technology
• /
• 제7권4호
• /
• pp.407-413
• /
• 2006

The liquefied petroleum gas(LPG), mixture of propane and butane, has the potential to reduce toxic hydrocarbon emissions and inhibit ozone formation due to its chemical composition. Conventional mixer systems, however, have problems in meeting the future lower emission standards because of the difficulty in controlling air-fuel ratio precisely according to mileage tar accumulation. Liquid Phase LPG injection(LPLi) system has several advantages in more precise fuel metering and higher engine performance than those of the conventional mixer type. On the other hands, leakage problem of LPLi system at the injector tip is a main obstacle for meeting more stringent future emission regulations because these phenomena might cause excessive amount of THC emission during cold and hot restart phase. The main focus of this paper is the development of a leaked fuel recirculation system, which can eliminate the leaked fuel at the intake system with the activated carbon canister. Leaked fuel level was evaluated by using a fast response THC analyzer and gas chromatography. The result shows that THC concentration during cold and hot restart stage decreases by over 60%, and recirculation system is an effective method to meet the SULEV standard of the LPLi engine.

• 한국자동차공학회논문집
• /
• 제13권3호
• /
• pp.10-16
• /
• 2005

Recently, the international regulations about the exhaust emissions of the motorcycle have been strengthened. The electrically controlled fuel injection type motorcycle has been emphasized to meet with this regulation. However, since the pulsation phenomenon happens in the intake port of the motorcycle because of the characteristic of high speed and the smaller layout than the passenger car, there are many difficulties to select the factor about control parameters needed to develop the ECU system. In this paper, the pulsation values measured from the engine test were compared with the calculated one by WAVE, and it was analyzed the pulsation characteristic according to the driving condition and estimated the mass flow rate. This research showed that the lowest point of the pressure gets lowin the low load and the pulsation of pressure were increased in the high load. Also, the simulation program was verified by showing good prediction of the pulsation and air mass flow rate.

• Asian-Australasian Journal of Animal Sciences
• /
• 제9권6호
• /
• pp.647-650
• /
• 1996

Fifteen sheep were used in a trial which compared the feeding value of whole barley gain and cottonseed cake as supplements to a basal diet of leaves of fourwing saltbush (Atriplex canescens). Diet SB contained 700 g (air-dry matter) of saltbush alone, diet SB + BG contained 700 g SB with 400 g whole barley grain and diet SB + CS contained 700 g SB with 400 g cottonseed cake. The digestibility of the dry matter of diets SB (69%) and SB + CS (70%) were lower (p < 0.001) than of diet SB + BG (76%). Sheep offered SB alone daily lost 80g whereas those fed the other diets gained 11 g (SB + CS) or 17 g (SB + BG) per day. Daily water consumption of the sheep offered the three diets was similar (p > 0.05), but their water consumption was higher (p < 0.001) than that of sheep offered daily 700 g wheat straw and 200 g barley grain. The results indicate that, at the levels of feeding used, barley grain and cottonseed cake had similar value as supplements to fourwing saltbush harvested in summer. The addition of the supplement allowed the sheep to gain some live weight. However, the presence of saltbush leaves in the diet resulted in higher water intakes by the sheep.

• 정보처리학회논문지B
• /
• 제18B권6호
• /
• pp.397-404
• /
• 2011

본 논문에서는 헬륨가스 흡입에 따른 조음기관의 특성이 변화되는 것을 측정하기 위해 음성분석학적 요소의 적용을 통한 실험을 수행하였다. 헬륨가스는 기존에 잠수부가 사용하던 질소가스가 인체에 치명적인 공기 색전증을 유발하게 되면서 이를 극복하기 위한 대체 호흡용 가스로 사용되고 있다. 그러나, 헬륨가스는 명료도가 낮은 squeaky voice를 유발하기 때문에 잠수부들의 비정상적인 음성에 대한 해석에 어려움이 많다. 따라서, 헬륨가스가 음성기관에 미치는 영향을 음성분석학적 특성 변화로 측정하기 위해 헬륨가스 흡입 전과 후의 음성을 기반으로 피치 및 스펙트로그램 측정, 분석에 대한 실험을 수행하였다.

• 대한기계학회논문집
• /
• 제18권3호
• /
• pp.751-767
• /
• 1994

Recent developments of S.I. engine, aiming to higher power, better fuel economy, lower air pollution and better driveability, have much focused on the importance of the role of computer simulation in engine research and development. In this point of view, improving engine performance requires finding some means to improve volumetric efficiency. Up to now there have been several attempts to optimize the intake and exhaust system of internal system of S.I. engine by computer simulation. There appear to be few studies available, however, of such simulation & experimental studies applied to the optimization of exhaust manifold configuration. In this study, gas exchange & power process of 4 cylinder S.I. Engine was studies numerically & experimentally, and governing equation of a one-dimensional unsteady compressible flow and combustion process were respectively solved by a characteristics method and 2-zone model. The aim of this study is to predict and investigate the influence of pressure wave interaction at the exhaust systems on engine performance with widely differing exhaust manifold configuration.

• 한국자동차공학회논문집
• /
• 제8권4호
• /
• pp.26-33
• /
• 2000

In-cylinde flow and mixture formation are key contributors to both idle stability and combustion stability at part load condition in SI engine. The real time measurements of air-fuel ration and in- cylinder residual gas fraction are particularly important to obtain a better understanding of the mechanisms for combustion and emissions especially during cold start and throttle transient condition. This paper reports the cycle resolved measurements of residual gas fraction and equivalence ration near speak plug with value timing change and their effects on combustion characteristics at part load. The results showed that the effect of intake value opening on the residual gas fraction was smaller than that of exhaust valve closing because of the decreases of exhaust gas reverse flow from exhaust port. The variation of equivalence ratio near spark plug increased with the increase of value overlap and it closely related with heat release rate and combustion stability

• 한국분무공학회지
• /
• 제10권1호
• /
• pp.43-52
• /
• 2005

The effect of fuel injection spray on engine performance has been known as one of the major concerns for improving fuel economy and reducing emissions. In general, reducing the spray droplet size could prevent HC emission in gasoline engine. As far as PFI (Port Fuel Injection) gasoline engine is concerned, the mixture of air and fuel may not be uniform under a certain condition, because breakup and production of spray droplets are made in a short distance between the fuel injector and intake valve. This study, by constituting PFI gasoline spray system, was performed to study the transient spray characteristics and dynamic behavior of droplets from 2hole 2spray type injector used in DOHC gasoline engine. Mean droplet size and optical concentration in accordance with various conditions were measured by LDPA and CCD camera. Through this study, the variation of drop size and optical concentration could be used for understanding the behavior of unsteady spray was declared and the existing the small droplets between each pulse spray could be estimated caused to the development of wall film was conformed.

• 한국유체기계학회 논문집
• /
• 제19권6호
• /
• pp.19-25
• /
• 2016

Anti-icing is important in gas turbines because ice formation on compressor inlet components, especially inlet guide vane, can cause performance degradation and mechanical damages. In general, the compressor bleeding anti-icing system that supplies hot air extracted from the compressor discharge to the engine intake has been used. However, this scheme causes considerable performance drop of gas turbines. A new method is proposed in this study for the anti-icing in combined cycle power plants(CCPP). It is a heat exchange heating method, which utilizes heat sources from the heat recovery steam generator(HRSG). We selected several options for the heat sources such as steam, hot water and exhaust gas. Performance reductions of the CCPP by the various options as well as the usual compressor bleeding method were comparatively analyzed. The results show that the heat exchange heating system would cause a lower performance decrease than the compressor bleeding anti-icing system. Especially, the option of using low pressure hot water is expected to provide the lowest performance reduction.

• 한국수소및신에너지학회논문집
• /
• 제13권1호
• /
• pp.65-73
• /
• 2002

Because of low flame ion density in hydrogen-air mixture, many residual electric energy could be existed in the ignition system of hydrogen engine, If these residual energy discharged abnormally during intake stroke, it may be the cause of backfire occurrence which is serious problem in development of hydrogen fueled engine but unsolved in spite of many concerned research on it. In this study, the possibility of backfire occurrence by abnormal electric discharge and countermeasure of that were investigated by using the experimental single cylinder hydrogen fueled engine with two types of ignition system. The results show that abnormal electric discharge appeared in low load with low ion density and then results in back fire occurrence, It is also seen that countermeasure method installing larger earth resistance in high tension code is effective to control abnormal electric discharge.