• Journal of Korean Dental Science
• /
• v.7 no.1
• /
• pp.25-30
• /
• 2014

Subcutaneous emphysema and pneumomediastinum is a relatively uncommon phenomenon. It may occur secondary to dental treatment using high-speed air turbine handpieces, especially after extraction of tooth. Subcutaneous emphysema is often limited only to the areas of head and neck, but also can involve deeper structures. Thorough examination and conservative treatment of these problems are essential in preventing life-threatening complications such as airway obstruction and mediastinitis. The subject of this report is a 57-year-old woman with subcutaneous emphysema and pneumomediastinum during the extraction of maxillary third molar using high-speed air turbine handpiece. If there isn't any appropriate measure, severe complications may occur. Therefore it is important to be well-informed of proper diagnosis and treatment. This article shall present a case report with literature review.

• Maxillofacial Plastic and Reconstructive Surgery
• /
• v.32 no.6
• /
• pp.597-599
• /
• 2010

Subcutaneous emphysema and pneumomediastium is a relatively uncommon phenomenon. Most case of pneumomediastium are caused by iatrogenic injury on the cervical region and chest during tracheostomy. It is also well known that emphysema may occur secondary to dental treatment using high-speed air turbine handpiece, but there have been few cases of emphysema extended to involving the mediastinum. These complications are reported to occur mainly in patients after dental procedures, in particular during mandibular third molar extraction. Early recognition and conservative treatment of these problems is essential in preventing life-threatening complications such as airway obstruction, mediastinitis, pneumothorax and cardiac failure. As we report a case of 25-year-old woman with subcutaneous emphysema and pneumomediastium after mandibular third molar extraction using high-speed air turbine handpiece.

• Korean Journal of Bronchoesophagology
• /
• v.14 no.1
• /
• pp.50-53
• /
• 2008

Subcutaneous cervicofacial, mediastinal emphysemas are complications associated with head and neck surgery, trauma, infectious processes, tooth extraction. Drill cooling stream and dental syringe air ject are the sources of high pressure air that may enter exposed soft tissue. Since the introduction of the high-speed air turbine drill in the 1960s, The incidence of iatrogenic subcutaneous emphysema has increased. Most cases begin to resolve after 2 to 3 days and residual swelling is usually minimal at the end of 7 to 10 days. Surgical approach is not advised because it is likely to be ineffective. The differential diagnosis of neck swelling after dental procedure includes hematoma, cellulitis, angioedema, allergic reaction, subcutaneous emphysema. We report a rare case of patient with subcutaneous cervicofacial emphysema and mediastinal emphysema secondary to third molar extraction.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.20 no.10
• /
• pp.702-709
• /
• 2008

In this paper, the optimal thermal storage time of an air-conditioning system with slab thermal storage in office building was analyzed on the basis of the gradient method algorithm. The sum of room temperature deviation and heat extraction rate was set to the criterion function. It was calculated that four hours is the optimal thermal storage time under the standard evaluation criterion. Furthermore, some case studies were executed by controlling ratio of weight functions of room temperature deviation and heat extraction rate in criterion function. It is possible to design many kinds of optimal operation of an air-conditioning system with slab thermal storage by controlling ratio of the weight functions in criterion function.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.16 no.12
• /
• pp.1175-1182
• /
• 2004

Installations of vertical boreholes for the ground source heat pump system are expensive to install. One way to reduce the initial cost is to increase the specific heat extraction rate of borehole system. However, as the specific heat extraction rate increases the temperature of borehole fluid decreases with the resultant lower Coefficient Of Performance in Heating(COPH) of heat pump system. The purpose of this study is to provide the basic informations about the performance of heat pump system with the specific heat extraction rate and soil thermal properties such as thermal conductivity and temperature. It is shown that the specific heat extraction rate is the most important parameter for the ground source heat pump system. To obtain the reasonable COPH value (COPH > 3) the heat extraction rate should be about 25 W/m or less. Accurate measurements of soil thermal properties are also very important to design the system properly. The effects of borehole thermal resistances are also examined in this study.

• Journal of the Korea Organic Resources Recycling Association
• /
• v.8 no.4
• /
• pp.121-128
• /
• 2000

Landfill and lysimeter experiments were conducted to estimate the optimum air injection method for the degradation of waste in landfill and the pre-stabilization. Continuous injection with low pressure and quantity can be effective for pre-stabilization of old landfill due to the lower contents of volatile solids in landfill. Air injection and landfill gas (LFG)extraction showed that the SVE (Soil Vapor Extraction) effect by air ventilation was more significant than the biodegradation of organics. Theses results suggested that they could accelerate the biological stabilization of organic waste in landfills. It is also expected that they would reduce the problems including gas emission during the landfill mining, separation and/or transportation to such levels that might be discharged directly to the atmosphere or with minimal treatment, if required.

• Journal of the Korean Society for Geothermal and Hydrothermal Energy
• /
• v.14 no.4
• /
• pp.7-12
• /
• 2018

Energy performance of electric heater and geothermal source heat pump type hot air dryers are compared in this study. For set temperatures of $30^{\circ}C$, $35^{\circ}C$ and $40^{\circ}C$, radish is dried from initial mass 60 kg until it gets 5 kg, where the difference equals the amount of water removed. As set temperature is increased, drying time is shortened for both electric heater and heat pump types, however energy efficiency is decreased due to increasing electricity consumption. Moisture extraction rate(MER) of electric heater is 2.58~2.84 kg/h, and for heat pump type 2.56~2.71 kg/h, showing little difference between the two types. Specific moisture extraction rate (SMER) of electric heater is 0.94~0.96 kg/kWh, and for heat pump type 1.72~2.21 kg/kWh. SMER of heat pump type is greater by 0.78~1.25 kg/kWh than the electric heater hot air dryer, which is 1.8~2.3 times better in terms of energy efficiency.

• Journal of Chest Surgery
• /
• v.24 no.12
• /
• pp.1225-1227
• /
• 1991

Pneumomediastinum and subcutaneous emphysema produced by air turbine dental drills, although widely reported in dental publications, are rarely reported in the thoracic journals. We report a case of 38-year-old man with pneumomediastinum and subcutaneous emphysema after use of a air turbine dental drill for dental extraction.

• Korean Journal of Optics and Photonics
• /
• v.20 no.3
• /
• pp.182-188
• /
• 2009

The surface plasmon resonance ellipsometer (SPRE), using a multiple air injection system with an extraction of air system, has been proposed and developed to minimize measurement error of signals due to diffusion of reagent into running buffer. Since the diffusion of reagent into running buffer affects the refractive index of the running buffer by changing the concentration, characteristics of binding between various bio-molecules don't appear clearly in measurement results. The diffusion between running buffer and reagent can be blocked by using an air bubble injection system. An extraction of air system is used to remove the noise signal due to unnecessary air bubbles flowing in a channel. Reliability of measurement results has been improved by using the valve system.

• Korean Journal of Food Science and Technology
• /
• v.48 no.1
• /
• pp.15-19
• /
• 2016

Drying process was applied to increase the antioxidant activity of onion powder: freeze-drying or air-drying at 50, 70, and $90^{\circ}C$ and onion extracts were obtained from each powder using water or aqueous ethanol (50%) at $25^{\circ}C$ and $60^{\circ}C$. In the color analysis, the freeze-dried powders showed higher $L^*$ and lower $a^*$ and $b^*$ values than did the air-dried ones. The browning index of powders air-dried at $90^{\circ}C$ was significantly higher than that of freeze-dried powders or those air-dried at temperatures below $90^{\circ}C$. Phenolic content in the extracts was 4.02-23.12 mg gallic acid equivalent/g sample, and was the highest in the extract from the sample air-dried at $90^{\circ}C$, regardless of the extraction condition. The highest antioxidant activity, measured by 2,2-azinobis-3-ethylbenzothiazoline-6-sulfonic acid and 1,1-diphenyl-2-picrylhydrazyl methods, was found in the powder air-dried at $90^{\circ}C$, which induced browning. These findings indicate that antioxidant activity depends more on browning during drying than on extraction conditions.