• Archives of Pharmacal Research
• /
• v.10 no.1
• /
• pp.18-24
• /
• 1987

Mouse monocolonal antibodies to Hepatitis B surface antien (HBsAg) were prepared and their functional capabilities tested by the method of solid phase enzyme linked immuno sorbent assay (ELISA). HBsAg binding studies inicated that one monoclonal antibody 6E-1-1 bound more HBsAg at a faster rate than the other monoclonal antibodies. Also, for the binding inhibition studies with the selected monoclonal antibody 6E-1-1, one monoclonal antibody 8D-3-6 didn't exhibit binding inhibition for HBsAg. Then, a simultaneous ELISA method was developed for the immunodiagnosis of HBsAg. Different combinations of two monoclonal antibodies as solid phase and horseradish peroxidase (HRPO) labeled phase were studied. The combination of monoclonal antibody of higher affinity constant (6E-1-1) immobilized in a solid phase and monoclonal antibody of lower affinity constant (8D-3-6) as a HRPO laeled phase was more sensitive when two monoclonal antibodies of different affinity constants for HBsAg were prepared.

• Proceedings of the Korean Magnestics Society Conference
• /
• 1999.04a
• /
• pp.108-109
• /
• 1999

• Journal of the Korean Ceramic Society
• /
• v.46 no.4
• /
• pp.429-435
• /
• 2009

In this study, we investigated microstructure and the CO gas sensing properties of Ag-CuO-$SnO_2$ thin films prepared by co-evaporation and subsequently thermal oxidation at air atmosphere. The sensitivity of a Cu-Sn films, thermally oxidized at $600^{\circ}C$, is strongly affected by the amount of Cu. At Cu:7 wt%-Sn:93 wt%, the film exhibited a maximum sensitivity of ${\sim}2.3$ to CO gas of 1000 ppm at $300^{\circ}C$. In contrast, the sensitivity of a Sn-Ag film did not change significantly with the amount of Ag. An enhanced sensitivity of ${\sim}3.7$ was observed in the film with a composition of Ag:3 wt%-Cu:4 wt%-Sn:93 wt%, when thermally oxidized at $600^{\circ}C$. In addition, this thin film shows a response time of ${\sim}80$ sec and a recovery time of ${\sim}450$ sec to 1000 ppm CO gas. The results demonstrate that the CO sensitivity of the Ag-CuO-$SnO_2$ thin films may be closely associated with coexistence of $SnO_2$ and SnO phase, decrease in average particle size, and a porous microstructure. We also suggest that co-evaporation and followed by thermal oxidation is a very simple and effective method to prepare oxide gas sensor thin films.

• Journal of Environmental Science International
• /
• v.12 no.8
• /
• pp.871-879
• /
• 2003

The complexation of co-contaminant mixtures between Ag(I) and polycyclic aromatic hydrocarbon (PAH) molecules (naphthalene, pyrene, and perylene) were investigated to quantify the equilibrium constants of their complexes and elucidate the interactions between Ag(I) and PAH molecules. The apparent solubilities of PAHs in aqueous solutions increased with increasing Ag(I) ion concentration. The values, K$_1$ and K$_2$ of equilibrium constants of complexes of Ag(I)-PAHs, were 2.990 and 0.378, 3.615 and 1.261, and 4.034 and 1.255, for naphthalene, pyrene, and perylene, respectively, The K$_1$and K$_2$ values of PAHs for Ag(I) increased in the order of naphthalene ＜ pyrene ＜ perylene and naphthalene ＜ pyrene ≒ perylene, respectively, indicating that a larger size of PAH molecule is likely to have more a richer concentration of electrons on the plane surfaces which can lead to stronger complexes with the Ag(I) ion. For the species of Ag(I)-PAH complexes, a 1:1 Ag(I) : the aromatic complex, AgAr$\^$＋/, was found to be a predominant species over a 2:1 Ag(I) : aromatic complex, Ag$_2$Ar$\^$＋＋/. The PAH molecules with four or more aromatic rings and/or bay regions were observed to have slightly less affinity with the Ag(I) ion than expected, which might result from inhibiting forces such as the spread of aromatic $\pi$ electrons over o wide molecular surface area and the intermolecular electronic repulsion in bay regions.

• Applied Chemistry for Engineering
• /
• v.10 no.1
• /
• pp.51-57
• /
• 1999

Adsorption characteristics of Ni(II), Co(II) and Ag(I) ions on the Amberite IRN 77 cation exchange resin have been studied to suggest the guide-line for the optimum operation of demineralization process in primary coolant system during the shut-down period of pressurized water reactor(PWR). The adsorption mechanism of each metal ion, Ni(II), Co(II) or Ag(I) ion, on a cation exchange resin was well coincided with Langmuir isotherm. The adsorption and treatment capacities of $H^+$-form resin were higher than those of $Li^+$-form resin. In the continuous ion exchange process for the solution of multi-component system, the selectivity of the resin was in increasing order of Ni(II)${\approx}$Co(II)>Ag(I). In addition, the increase of the flow rate decreased the treatment capacity of the resin as well as the slope of the breakthrough curve.

• Journal of the Korean Magnetics Society
• /
• v.7 no.1
• /
• pp.31-37
• /
• 1997

The magnetoresistance and the saturation field behavior of the Co-Ag nano granular films as a function of the composition and the ferromagnetic underlayer and overlayermaterials were investigated. The maximum magnetoresistance of 23% and the saturation field of 2.3 kOe at room temperature were obtained in the as-deposited 3000$\AA$ $Co_{30}Ag_{70}$ single alloy films. The magnetoresistance and the saturation field of 100$\AA$ $Co_{30}Ag-{70}$ alloy film were 3.65 % and 3.0 kOe respectively. Those of the sandwiched films with 200$\AA$ Fe were 3.3 % and 1.23 kOe respectively. The saturation field of the sandwiched alloy films could be reduced by the exchange coupling between the ferromagnetic layers and the alloy layer. The effective depth of the exchange coupling was approximately 150$\AA$ in each Fe layer. Among the Fe, Co, and FeNi, the most effective materials to reduce the saturation field of the sandwiched alloy films was Fe.

• Proceedings of the Korean Powder Metallurgy Institute Conference
• /
• 2006.09b
• /
• pp.1207-1208
• /
• 2006

We developed the copper core ball electroplated with Sn-Ag-Cu of the eutectic composition which used mostly as Pb free solder ball with high reliability. In order to search for the practicality of this developed copper core ball, the evaluation was executed by measuring the initial joint strength of the sample mounted on the substrate and reflowed and by measuring the joint strength of the sample after the high temperature leaving test and the constant temperature and the humidity leaving test. This evaluation was compered with those of the usual other copper core balls electroplated with (Sn,Sn-Ag,Sn-Cu,Sn-Bi) and the Sn-Ag-Cu solder ball.

• Proceedings of the Korean Magnestics Society Conference
• /
• 1998.10a
• /
• pp.44-45
• /
• 1998

• Economic and Environmental Geology
• /
• v.53 no.4
• /
• pp.363-381
• /
• 2020

The polymetallic Co, Ni, Cu, As, Au, and Ag deposits of Bou Azzer East are located in the western part of the Bou Azzer inlier in the Central Anti Atlas, Morocco. Six stages of emplacement of the mineralization have been identified. Precious metals (native gold and electrum) are present in all stages of this deposit except the early nickeliferous stage. From the Statistical analysis of the Co, As, Ni, Au, and Ag contents of a set of 501 samples, shows that the Pearson correlation coefficient between As-Co elements (0.966) is the highest followed by that of the Au-Ag couple (0.506). Principal component analysis (PCA) and hierarchical ascending classification (HAC) of the grades show, that Ni is associated with the pair (As-Co) and Cu is rather related to the pair (Au-Ag). The kriging maps show that the highest values of the Co, As and Ni appear in the contact of the serpentinite with other facies, as for those of Au and Ag, in addition to anomalous zones concordant with those of Co, Ni and As, they show anomalies at the extreme South and North of the study area. The development of the anomalous Au and Ag zones is mainly along the N40-50°E and N145°E directions.

• Korean Journal of Materials Research
• /
• v.10 no.1
• /
• pp.41-48
• /
• 2000

In this study, microstructure and mechanical properties and electrical conductivities of in situ Cu-Fe-Xi(Xi=Ag, Cr or Co) alloy wires obtained by cold drawing combined with intermediate heat treatments have investigated. During cold working the primary and secondary dendrite arms are aligned along the drawing direction and elongated into filaments after deformation processing. The addition of Ag was found to be more effective in reducing the microstructural scale at the given draw ratio than that of Co or Cr throughout the drawing processing. The ultimate tensile strength and the conductivity of the Cu-Fe based composites containing Ag were higher than those of Cu-Fe composites containing Co or Cr. The good mechanical and electrical properties of Cu-Fe-Ag wires may be associated with the more uniform distribution of the finer filaments in the wires containing silver. The strength of Cu-Fe-Xi composites is dependent on the spacing of the Fe filaments in accord with a Hall-Petch relationship. The fracture surfaces of all the specimens showed ductile-type fracture and iron filaments occasionally observed on the fracture surfaces.