• 한국전산유체공학회:학술대회논문집
• /
• 2004.03a
• /
• pp.27-34
• /
• 2004

In the Smart UAV Development Program, one of the 21c Frontier R&D Program, the tiltrotor has been studied as the concept of vehicle. The tiltrortor aircraft take-off and land in rotary wing mode like conventional helicopter, and cruise in fixed wing mode like conventional propeller airplane. For the conversion of the flight mode from helicopter to airplane, the nacelle located at wing tip has to be tilted from about 90 degrees of helicopter mode to about 0 degree of airplane mode. In this study, the aerodynamic characteristics of the wing with tilted nacelle is investigated using computation fluid dynamics technique. In order to feature out aerodynamic interferences between wing and nacelle, the flow calculations are conducted for the wing and the nacelle separately and for the combined geometry of wing and nacelle, respectively. Through this computations, not only the aerodynamic data-base for the wing-nacelle is constructed but also its contribution to the configuration design of the wing-nacelle is anticipated.

• Wind and Structures
• /
• v.20 no.6
• /
• pp.811-827
• /
• 2015

This study presents experimental and numerical aerodynamic investigation of a prototype vehicle. Aerodynamics forces examined which exerted on a prototype. This experimental study was implemented in a wind tunnel for the Reynolds number between $10^5-3.1{\times}10^5$. Numerical aerodynamic analysis of the vehicle is conducted for different Reynolds number by using FLUENT CFD software, with the k-$\varepsilon$ realizable turbulence model. The studied model aims at verifying the aerodynamic forces between experimental and numerical results. After the Reynolds number of $2.8{\times}10^5$, the drag coefficient obtained experimentally becomes independent of Reynolds number and has a value of 0.25.

• 한국전산유체공학회:학술대회논문집
• /
• 2007.10a
• /
• pp.264-271
• /
• 2007

The flow simulations around ducted-prop of tilt-duct aircraft were conducted in this study. For the investigation of aerodynamic characteristics of various configurations of duct, the axisymmetric flow calculation method combined with actuator disk model for prop were used. The rapid two-dimensional calculation and fast grid generation enable aerodynamic analysis for various duct configurations in a very short time and anticipated to active role in optimal configuration design of duct exposed to various flight modes. For the case of angle of attack or tilt angle, the three dimensional flow calculation is conducted using the three dimensional grid simply generated by just revolving the axisymmetric grid around center axis. Through the three dimensional calculation around duct, the aerodynamic effectiveness of duct as a lifting surface in airplane mode was investigated. The flow calculations around the control vane (wing) installed in the rear section of duct were conducted The aerodynamic data of wing were compared with the data of the ducts to evaluate the aerodynamic effectiveness of ducts.

• 한국전산유체공학회:학술대회논문집
• /
• 2008.03a
• /
• pp.245-250
• /
• 2008

For simulation of a wing unfolding motion for the various aerodynamic conditions, equation governing unfolding motion and moments applying to the unfolding wing were modelled. Aerodynamic roll moment consists of the static roll moment and the damping moment, which were obtained through wind tunnel tests and numerical analyses respectively. Panel method was used to compute the roll damping coefficient with twisted wing, whose deflection angle was equivalent to angle of attack due to the deployment motion. Roll damping coefficient is a function of angle of attack, sideslip angle, and deployment angle but not of angular velocity of deployment. Simulation with aerodynamic damping model gave more similar deployment time compared to wing deployment test results.

• 한국전산유체공학회:학술대회논문집
• /
• 2008.10a
• /
• pp.245-250
• /
• 2008

For simulation of a wing unfolding motion for the various aerodynamic conditions, equation governing unfolding motion and moments applying to the unfolding wing were modelled. Aerodynamic roll moment consists of the static roll moment and the damping moment, which were obtained through wind tunnel tests and numerical analyses respectively. Panel method was used to compute the roll damping coefficient with twisted wing, whose deflection angle was equivalent to angle of attack due to the deployment motion. Roll damping coefficient is a function of angle of attack, sideslip angle, and deployment angle but not of angular velocity of deployment. Simulation with aerodynamic damping model gave more similar deployment time compared to wing deployment test results.

• Wind and Structures
• /
• v.14 no.3
• /
• pp.209-220
• /
• 2011

The cable system is generally considered to be a structural solution to increase the spanning capacity of suspension bridges. In this work, based on the Runyang Bridge over the Yangtze River, three case suspension bridges with different 3D cable systems are designed, structural dynamic characteristics, the aerostatic and aerodynamic stability are investigated numerically by 3D nonlinear aerostatic and aerodynamic analysis, and the cable system favorable to improve the wind-induced instability of long-span suspension bridges is also proposed. The results show that as compared to the example bridge with parallel cable system, the suspension bridge with inward-inclined cable system has greater lateral bending and tensional frequencies, and also better aerodynamic stability; as for the suspension bridge with outward-inclined cable system, it has less lateral bending and tensional frequencies, and but better aerostatic stability; however the suspension bridge is more prone to aerodynamic instability, and therefore considering the whole wind-induced instability, the parallel and inward-inclined cable systems are both favorable for long-span suspension bridges.

• International Journal of Railway
• /
• v.4 no.3
• /
• pp.70-73
• /
• 2011

Controlling the exterior and interior noise emission has become an important issue in the research and development of high speed trains. As the operating speed of the train increases, the noise emission characteristics are expected to deviate from that of the existing trains due to several changes in the basic train layout. For train speed in excess of 350 km/h in particular, the aerodynamic noise component starts to exceed the structure-borne noise component, and even an incremental speed increase is accompanied by a rapid elevation in the noise level. The present study presents an engineering approach for predicting the aerodynamic noise level at the design stage for high speed trains. The experimental noise measurements from test run of Korean high speed train under development are presented as a partial validation of the proposed approach. While the overall aerodynamic noise can be cast in a single power law relationship against the train speed, different parts of the train show power law relationships unique to each component.

• International Journal of Railway
• /
• v.4 no.3
• /
• pp.74-79
• /
• 2011

Recent years have witnessed speed up of moving vehicles such as high-speed of trains. Increase in speed entails concomitant increase in turbulent air flow which contributes toward increased aerodynamic noise. The proposed method for aerodynamic noise reduction is based on a biomimetic design of owl feather. The five morphological parameters of the owl feather are extracted from close observation, and simulation cases are constructed by applying design of experiments methodology. Swirling strength for each case is obtained through steady-state CFD analysis, and key morphological parameters that affect the turbulence are identified. Large eddy simulations (LES) are then performed on selected cases to predict the air turbulence. Different cases show varying vortex distributions which are expected to lead to varying aerodynamic noise levels.

• Phonetics and Speech Sciences
• /
• v.6 no.3
• /
• pp.57-62
• /
• 2014

The present study was performed to investigate and discuss the aerodynamic characteristics of whispered and normal speech during reading paragraph tasks. 39 normal females(18-23 yrs.) read 'Autumn' paragraph with whispered and normal phonation. Their readings were recorded and analyzed by 'Running Speech' in Phonatory Aerodynamic System(PAS) instrument. As results, during whispered speech, the total duration was longer and the numbers of inspiration were more frequently shown than normal speech. The Peak expiratory and inspiratory rate were higher in normal speech, but the expiratory and inspiratory volume were higher in whispered speech. By correlation analysis, both whispered and normal speech showed significantly high correlation between total duration and expiratory/inspiratory airflow duration; numbers of inspiration and inspiratory airflow duration; expiratory and inspiratory volume. These results show that whispered speech needs more respiratory effort but shows poorer aerodynamic efficacy during phonation than normal speech.

• 연구논문집
• /
• s.25
• /
• pp.13-22
• /
• 1995

At the running speed higher than 250 km/h, several aerodynamic problems such as the increase of aerodynamic resistance, aerodynamic noise, pressure fluctuation at the tunnel entry, impulsive wave at the tunnel exit bring about the power consumption, deterioration of riding quality, and severe environmental noise. To solve these aerodynamic problems, the flow phenomena around the high speed train have to be analyzed in detail. In this study, the flow around the train is modelled as the 2-dimensional viscous compressible flow and the flow field is calculated numerically for the three different types of geometry and running speed. The aerodynamic drag coefficient and the pressure coefficient are evaluated each case.