• Journal of Institute of Control, Robotics and Systems
• /
• v.17 no.12
• /
• pp.1203-1209
• /
• 2011

In this paper, the degradation evaluation method of VLC (Visible Light Communication) wireless module after high dose rate gamma-ray irradiation using the thermal infrared camera is proposed. First, the heating characteristics of the active devices embedded in the VLC wireless module during the condition of normal operation is monitored by thermal infrared camera. By the image processing technique, the trends of the intensity of the heat emitted by the active devices are calculated and stored. The feature of the blob area including the area of the active devices in the thermal infrared image is extracted and stored. The feature used in this paper is the mean value of the gray levels in the blob area. The same VLC module has been gamma irradiated at the dose rate of about 4.0 kGy/h during 72 hours up to a total dose of 288 kGy. And then, the heating characteristics of the active devices embedded in the VLC wireless module after high dose gamma ray irradiation is observed by thermal infrared camera. The high dose gamma-ray induced degradation of the active devices embedded in the VLC module was evaluated by comparing the mean value of the blob area to the one of the same blob area of the VLC module before the gamma ray irradiation.

• Analytical Science and Technology
• /
• v.5 no.4
• /
• pp.359-366
• /
• 1992

Using micro-Raman spectrometer, we investigated the evaluation of microstress on silicon surface after the local thermal oxidation. The induced stress of silicon surface after local thermal oxidation shows maximum value at the interface of silicon oxide and active area. The smaller the size of active area, the larger stress. From the evaluation of three other device isolation processes, A, B and moB, whose active size has $0.45{\mu}m$ in length, moB process is turned out to have the lowest stress value and the smallest bird's beak effect.

• The Korean Journal of Physiology and Pharmacology
• /
• v.2 no.3
• /
• pp.385-393
• /
• 1998

Human neutrophil elastase (HNElastase, EC 3.4.21.37), a causative factor of inflammatory diseases, was purified by Ultrogel AcA54 gel filtration and CM-Sephadex ion exchange chromatography. HNElastase was inhibited by phenylbutazone in a concentration dependent manner up to 0.4 mM, but as the concentration increased, the inhibitory effect gradually diminished. Binding of phenylbutazone to the human neutrophil elastase caused strong Raman shifts at 200, 440, and 1194 $cm^{-1}$. The peak at 1194 $cm^{-1}$ might be evidence of the presence $of\;-N=N-{\Phi}$ radical. The core area of the elastase, according to the visual molecular model of human neutrophil elastase, was structurally stable. A deeply situated active center was at the core area surrounded by hydrophobic amino acids. Directly neighboring the active site was one positively charged atom and two atoms carrying a negative charge, which enabled the enzyme and the drug to form a strong interaction. Phenylbutazone may form a binding, similar to a key & lock system to the atoms carrying opposite charges near the active site of the enzyme molecule. Furthermore, the hydrophobicity of the surrounding amino acid near the active site seemed to enhance the binding strength of phenylbutazone. Binding of phenylbutazone near the active site may cause masking of the active site, preventing the substrate from approaching the active site and inhibiting elastase activity.

• Journal of The Korean Society of Agricultural Engineers
• /
• v.52 no.6
• /
• pp.1-7
• /
• 2010

This study was carried out to investigate the effect of hydro power factors (e.g., irrigation area, watershed area, active storage, gross head) on annual generation capacity and operation ratio for agricultural reservoirs in Chungbuk Province with active storage of over 1 million $m^3$. The annual generation capacity and operation ratio were estimated using HOMWRS (Hydrological Operation Model for Water Resources System) from last 10-year daily hydrological data. The correlation coefficients between annual generation capacity and the hydro power factors except gross head were high (over 0.87), but the correlation coefficients between operational rate and the factors were low (below 0.28). The optimum multiple regression equations of the annual generation capacity were expressed as the functions of watershed area, active storage, and gross head. Also, the simple regression equation of annual generation capacity was expressed as a function of watershed area. The average relative root-mean-square-error (RRMSE) between observed and estimated values by the optimum multiple regression equations was smaller than that by the simple regression equation, suggesting that the former has more accuracy than the latter.

• Current Optics and Photonics
• /
• v.1 no.2
• /
• pp.95-100
• /
• 2017

The transmittance of the three dimensional (3D) transparent display is an important factor and can be enhanced by adding a see-through area to the displayed 3D image in order to transmit an ambient light with maximum transparency. However, there is a side effect that the perceived 3D resolution can be degraded due to the see-through area. In this paper, we propose an advanced method to resolve the above trade-off relation between the transparency and the 3D resolution by using an active parallax barrier (PB) with a see-through area. The experimental results are also presented to prove the proposed principle.

• Journal of Korean Public Health Nursing
• /
• v.13 no.1
• /
• pp.77-87
• /
• 1999

Poverty directly affects health and well-being, The poor population has a higher rate of chronics illness. higher infant morbidity and motality rates. shorter life expectancy. more complex health problems. and greater physical limitations resulting from chronic disease. In order to activate primary health care for the poverty in urban area the following measures should be taken : 1. Health center must be expended or establish subhealth center. 2. Health center must monitor neighbour's workplace's health management for their working population. 3. Health centers must do active home visiting nursing care for the urban-poor. 4. Health center must carry out flexible problem-centered practice according to the area. 5. For the urban-poor's health care must have organization of the health center & practice according to community's characteristics. 6. Public health care must be closely connected with welfare. 7. For the health care of the urban-poor must demand active community participation. 8. Health center is closely connected with Community hospital. 9. Active management of public health resource system is demanded.

• Journal of the Korean Data and Information Science Society
• /
• v.15 no.1
• /
• pp.1-10
• /
• 2004

In the Korean Economically Active Population Survey(EAPS), the sample sizes for small areas are typically too small to provide reliable estimators because the EAPS has been designed to produce unemployment statistics for large areas such as Metropolitan Cities and Province. In this study, we consider the synthetic and composite estimators for the unemployment rate of small areas, and apply them to real data on Choongbook province which is from the Korean EAPS of December 2000. The mean square errors of these estimators were estimated by the Jackknife method, and the efficiencies of small area estimators were evaluated in terms of the relative standard errors and the relative root mean square errors. As a result, the composite estimator is much more efficient than other estimators and it turns out that the composite estimator can produce the reliable estimates of the unemployment rate of small areas under the current EAPS system.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.21 no.9
• /
• pp.81-86
• /
• 2007

Electric utility companies have the responsibility of providing good electricity for their customers. They have introduced the DAS(Distribution Automation System) to automate the power distribution networks. DAS engineers require state-of-the-art applications, such as a way to actively manage the distribution system and gain economic benefits from a flexible DAS architectural design. The existing DAS is not capable of handling these needs. It requires operator intervention whenever feeder overloading is detected while operator error could cause the feeder overload area to be extended. It also utilizes a closed architecture and it is therefore difficult to meet the system migration and future enhancement requirements. This paper represents a web based, platform-independent, flexible DAS architectural design and active database application. Recent advanced Internet technologies are fully utilized in this new DAS architecture allowing it to meet the system migration and future enhancement requirements. By using an active database, the DAS can minimize the feeder overloading area in the distribution system without operator intervention, thereby minimizing mistakes due to operator error.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2001.07a
• /
• pp.753-756
• /
• 2001

This research made a study of MnO$_2$electrode for supercapacitor with a diffuser (Polyvinyl alcohol). Manganese dioxide was used as active material. We tried to increase specific surface area by adding PVA. Manganese dioxide was synthesized by a sol-gel method using fumaric acid and oxalic acid in low temperature with high yield. Therefore, We prepared Manganese dioxide powder. This powder was used by active materials. The electrode was made by a mixture of active material, ketjen-black which is a large specific surface area, and PVdF-co-HFP as binder agent with using Nickel mesh as current collector. Here we reported on the synthesis and electrochemical performance of a enhanced material. All active materials have been submitted to X-ray diffraction and Scanning electron microscopy.

• Proceedings of the IEEK Conference
• /
• 2000.11b
• /
• pp.241-244
• /
• 2000

To investigate the compact effect of the different area of an active layer and the different type of heatsink on the junction to ambient transient thermal impedance, we have characterized the thermal behavior of power MOSFETs that have three different areas of an active layer and two types of heatsink. To do so, the "cooling curve method" has been used in order to measure the junction-to-ambient transient thermal impedance Zthja that represents the thermal behavior of the devices. The measured data depiets that the larger area of an active layer gives the better-in other words. smaller-thermal impedance, and that the larger size of a heatsink improves the thermal impedance.