• Journal of the Korean Society for Precision Engineering
• /
• v.21 no.8
• /
• pp.50-56
• /
• 2004

The directional ability of an automobile has an influence on driver directly, and hence it must be given most priority. Alignment factors of automobile such as the camber, caster and toe directly affect the directional ability of a vehicle. The above mentioned factors are determined by the pose of interlinks in the assembly of an automobile front chassis module. Measuring the position of center point of ball joints in the front lower arm is very difficult. A method to determine this position is suggested in this paper. Pose estimation for front chassis module and dimensional evaluation to find the rotational characteristics of front lower arm were developed based on fundamental geometric techniques. To interpret the inspection data obtained for front chassis module, 3-D best fit method is needed. The best fit method determines the relationship between the nominal design coordinate system and the corresponding feature coordinate system. The least squares method based on singular value decomposition is used in this paper.

• Proceedings of the Korean Society of Precision Engineering Conference
• /
• 2000.11a
• /
• pp.587-590
• /
• 2000

The new core making method economized on core sand requested. The new method is heating core box until it reaches reasonable temperature and then spraying core sand with core binder into core box. Inner temperature distribution have to uniform in order to form core of uniform thickness. Therefore, in this study we treat of inner temperature distribution of core box in priority. First, determine proper torch number. Next, optimize the torch position to minimize the average of absolute deviation(AVEDEV) of inner temperature. The results are as followed : 1. The torch number that makes inner temperature distribution about $300^\circ{C}$ uniformly is 25. 2. When $S_H$ and $S_V$ is 0.7, the torch position is optimized and AVEDEV is 5.85.

• Journal of the Society of Disaster Information
• /
• v.3 no.1
• /
• pp.87-101
• /
• 2007

The definition and concept of disasters and their preparedness have been changing according to the modern situation. The basic change is that the concept of absolute standard and prevention of hardware damage in the past have been changing to the concept of relative standard and mitigation of direct damage to human. For achieving the purpose, advanced countries developed and used their own analysis method of hazard and vulnerability for disaster ; ASHE hazard and vulnerability evaluation method, hazard matrix method by CDC, FEMA model method and SMUG hazard priority method. Because each analysis method cannot evaluate the hazard and vulnerability for specific disaster, the advantages and disadvantages should be applied for specific situation of disaster in Korea and new analysis method should be extracted in the future.

• Journal of the Korean Society for Industrial and Applied Mathematics
• /
• v.22 no.2
• /
• pp.91-100
• /
• 2018

In this paper, we propose a new method for template matching, patch ratio, to inpaint unknown pixels. Before this paper, many inpainting methods used sum of squared differences(SSD) or sum of absolute differences(SAD) to calculate distance between patches and it was very useful for closest patches for the template that we want to fill in. However, those methods don't consider about geometric similarity and that causes unnatural inpainting results for human visuality. Patch ratio can cover the geometric problem and moreover computational cost is less than using SSD or SAD. It is guaranteed about finding the most similar patches by Cauchy-Schwarz inequality. For ignoring unnecessary process, we compare only selected candidates by priority calculations. Exeperimental results show that the proposed algorithm is more efficent than Criminisi's one.

• Journal of Korean Society of Industrial and Systems Engineering
• /
• v.29 no.2
• /
• pp.1-6
• /
• 2006

This study proposes a new approach which combines Data Envelopment Analysis(DEA) and the Analytic Hierarchy Process(AHP) techniques to effectively evaluate Decision Making Units(DMUs). While DEA evaluates a quantitative data set, employs linear programming to obtain input and output weights and ranks the performance of DMUs, AHP evaluates the qualitative data retrieved from expert opinions and other managerial information in specifying weights. The objective of this research is to design a decision support process for managers to incorporate positive aspects of DEA's absolute numerical evaluations and AHP's human preference structure values. It is believed that a pragmatic manager will be more receptive to the results that include subjective opinions incorporated into the evaluation of the efficiency of each DMU efficiency. The WPDEA method provides better discrimination than the DEA method by reducing the number of efficient units.

• Korean Journal of Veterinary Research
• /
• v.46 no.3
• /
• pp.255-261
• /
• 2006

Experimental animals have been used to biological and medical purposes and the animals must be, for these purposes, healthy and clean to microbial infection. However, the animals can be easily exposed to pathogenic microorganism via several routes. Of the routes, environmental conditions are the most important factors to keep the animals healthy and clean, especially air condition. Monitoring of air-condition has been required to keep the animal healthy and clean. However, any guideline is not available for experimental conditions with pigs. Therefore, the sampling times and points were compared in different conditions to establish an optimal protocol for monitoring of air borne bacteria. Tryptic soy agar(TSA), blood agar containing 5% defibrinated sheep blood and Sabraud dextrose agar(SDA) were used as media to capture total bacteria, pathogenic bacteria and fungi, respectively. Two methods, compulsive capture using an air-sampler and capturing fall-down bacteria were used to capture the microorganisms in the air. The points and time of capturing were different at each experiment. Air borne microorganisms were captured at three and five points in the open and closed equipments, respectively. Air was collected using an air-sampler for 1 min and 5 min and the agar plates as open status were left from 30 min to 2hr. At first, we monitored an experimental laboratory which dealt with several pathogenic bacteria and then, a protocol obtained from the investigation was applied to open or close experimental conditions with pigs. Number of bacteria was high from 10:00 to 15:00, especially on 13:30-15:30 but sharply decreased after 17:00. The tendency of the number of bacteria was similar between two methods even though the absolute number was higher with air sampler. Critical difference in the number of cells was observed at 5 min with air sampler and 2 hr with fall-down capturing method. However, 1 min with air sampler and 1 hr with fall-down capturing were the best condition to identify bacterial species collected from the air. Number of bacteria were different depending on the sampling points in closed condition but not in opened condition. Based on our results, a guide-line was suggested for screening air-borne microorganism in the experimental conditions with pigs.

• Journal of Korean Society on Water Environment
• /
• v.31 no.5
• /
• pp.543-555
• /
• 2015

The existing standard for soil erosion risk assessment has limitations in sustainable topsoil management since the fixed criteria are applied to determination of soil erosion risk areas regardless of land use types. It may not be necessary to apply soil erosion best management practices to agricultural areas with high potential of soil erosion because human or economic damage derived from soil erosion might be tiny in that region. Furthermore, the fixed criterion with absolute values can select too many hot spots of soil erosion to conduct efficient soil erosion management. Thus, objective of this study was to suggest the relative criteria using statistical analysis for efficient soil erosion management. In future, the relative indices for soil erosion prevention should be improved to provide a priority of soil erosion management considering economic damage from soil erosion or functional values of soil with quantitative soil erosion. Additional researches will be needed to reflect a regional characteristics and to consider various land use types and different criteria.

• Journal of Korea Water Resources Association
• /
• v.38 no.9 s.158
• /
• pp.737-746
• /
• 2005

Optimization is a process that searches an optimal solution to obtain maximum or minimum value of an objective function. Many researchers have focused on effective search algorithms for the optimum but few researches were interested in establishing the objective function. This study compares two approaches for the objective function: one allows a tradeoff among the objectives and the other does not allow a tradeoff by assigning weights for the absolute priority between the objectives. An optimization model using sampling stochastic dynamic programming was applied to these two objective functions and the resulting optimal policies were compared. As a result, the objective function with no tradeoff provides a decision making process that matches practical reservoir operations than that with a tradeoff allowed. Therefore, it is more reasonable to establish the objective function with no a tradeoff among the objectives for multi-purpose dam operation plan in Korea.

• Journal of The Korean Digital Architecture Interior Association
• /
• v.11 no.3
• /
• pp.79-88
• /
• 2011

In the context of sustainability which is understood as equilibrium among three elements; human, space and time, the imbalance within the Seoul metropolitan area hinders its own area or the nation from development. Claims for the balanced development in the area are set up on the premise that there is a locational order of priority among the zones named 'overpopulation suppression', 'growth management' and 'conservation'. Based on the systematic consideration of competitiveness this study adopts the premise as a research hypothesis. Factor scales derived from the factor analysis, a kind of multivariate dependence analysis play an important role in this research process since they are measured by interval-ratio level and can be used for dependent variables in the statistical analysis. The hypothesis test carried out by means of the analysis of variance(ANOVA) concludes that the hypothesis assuming no difference in the competitiveness is rejected but the alternative hypothesis of the locational order mentioned above should be adjusted. Eigenvalues derived from the factor analysis could be used as weights for aggregate factor scales and the scales show that the priority is in the order of growth management - overpopulation suppression - conservation zones. This finding has also a significant implication that the countermeasures to cope with the lowering of the competitiveness resulted from the continuous and absolute restraints should be provided. And strategic approaches which are composed of key factors for each zone are deducted from in-depth review. (1) overpopulation suppression zone; health-welfare, educational base, public service factors, focusing on health-welfare one, (2) growth management zone; public service factor and (3) conservation zone; health-welfare, educational base factors, also focusing on health-welfare one.

• Proceedings of the KSR Conference
• /
• 2011.10a
• /
• pp.343-352
• /
• 2011

For optimizing railroad designs, setting up shape and specifications of facilities harmonized and coincide with local topography based on absolute location information, correct construction quantity's output and proper land's security etc are key matters, and also clear and advanced surveying standards and technical provision shall become priority so as to satisfy them. Therefore, this study analyzed and researched on surveying standards and technical provision's status in current railroad design's cases, and then attempts to suggest establishment of design surveying standard, procedures, and methods together with its practical scheme.