• 한국분말야금학회:학술대회논문집
• /
• 한국분말야금학회 1994년도 추계학술대회강연 및 발표대회 강연및 발표논문 초록집
• /
• pp.8-8
• /
• 1994

• 한국주조공학회지
• /
• 제10권4호
• /
• pp.332-341
• /
• 1990

The structure and tensile properties of the unidirectionally solidified Al-33wt.%Cu alloy have been investigated. Casted Al-33wt.%Cu alloy was unidirectionally solidified with rates (R) between 1㎝/hr and 24cm/hr maintaining the thermal gradient(G) at solid-liquid interface, $32^{\circ}C/cm$ and $21^{\circ}C/cm$. The entectic struture was varied according to the growth condition(G/R radio). When G/R ratio was larger than $8.5{\times}10^3$ $^{\circ}C/cm^2/sec$ the lamellar structure was formed, and colony structure was formed when G/R ratio was smaller than $8.5{\times}10^3$ $^{\circ}C/cm^2/sec$. The interlamellar spacing(${\gamma}$) in the above alloy system was vaired with the growth rate(R) According to "${\gamma}^2{\cdot}R＝8.8{\times}10＾{-11}cm^2/sec$" relationship. The yield stress (${\sigma}$0.001) and UTS for samples in the as-grown condition increased with the interlamellar spacing decrease and the values corresponding to colony structure are lower than those corresponding to amellar structure with the same lamellar spacing. The yield stress for samples in aged condition did not change with the interlamellar spacing.

• 한국세라믹학회지
• /
• 제43권4호
• /
• pp.242-246
• /
• 2006

[ ${\alpha}-Al_2O_3$ ] nanopowders were fabricated by the thermal decomposition and synthetic of Ammonium Aluminum Carbonate Hydroxide (AACH). Crystallite size of 5 to 8 nm were fabricated when reaction temperature of AACH was low, $8^{\circ}C$, and the highest $[NH_4{^+}][AlO(OH)_n{(SO_4){^-}}_{3-n/2}][HCO_3]$ ionic concentration to pH of the Ammonium Hydrogen Carbonate (AHC) aqueous solution was 10. The phase transformation fem $NH_4Al(SO_4)_2$, rhombohedral $(Al_2(SO_4)_3)$, amorphous-, ${\theta}-,\;{\alpha}-Al_2O_3$ was examined at each temperature according to the AACH. A Time-Temperature-Transformation (TTT) diagram for thermal decomposition in air was determined. Homogeneous, spherical nanopowders with a particle size of 70 nm were obtained by firing the 5 to 8 m crystallites, which had been synthesized from AACH at pH 10 and $8^{\circ}C,\;at\;1150^{\circ}C$ for 3 h in air.

• 한국분말재료학회지
• /
• 제30권1호
• /
• pp.41-46
• /
• 2023

In this study, an Al₈₂Ni₇Co₃Y₈ (at%) bulk metallic glass is fabricated using gas-atomized Al₈₂Ni₇Co₃Y₈ metallic glass powder and subsequent spark plasma sintering (SPS). The effect of powder size on the consolidation of bulk metallic glass is considered by dividing it into 5 ㎛ or less and 20-45 ㎛. The sintered Al₈₂Ni₇Co₃Y₈ bulk metallic glasses exhibit crystallization behavior and crystallization enthalpy similar to those of the Al₈₂Ni₇Co₃Y₈ powder with 5 ㎛ or less and it is confirmed that no crystallization occurred during the sintering process. From these results, we conclude that the Z-position-controlled spark plasma sintering process, using superplastic deformation by viscous flow in the supercooled liquid-phase region of amorphous powder, is an effective process for manufacturing bulk metallic glass.

• The Korean Journal of Ecology
• /
• 제22권5호
• /
• pp.295-298
• /
• 1999

산림지역의 강우분석에 의한 중금속 농도를 분석한 결과, Al의 수종별 농도는 공단지역의 해송림이 상수리나무림보다 1.3배 높았고, 도시지역은 해송림이 2.1배 높았다. 공단지역과 도시지역 수간류의 Al 농도는 수관통과우와 임외우 보다 각각 2.3배와 192.5배, 4.8배와 55배 높은 농도였고, 임외우는 두 지역에서 같은 농도로 낮았다. Mn의 농도는 수종별 농도는 도시지역의 해송림이 1,4배 높았다. Mn의 강우별 농도는 수간류가 수관통과우 보다 6.1배 높았고, 임외우 보다 121배 높은 농도였다. 강우의 계절별 농도를 분석한 결과에서 Al은 공단지역에서 12월의 강우가 가장 높았고, 다음으로 3월, 6월, 8월 순으로 분석되었지만, 도시지역은 계절별 뚜렷한 변화가 없었다. 지역별 중금속의 농도는 공단지역에서 Al>Mn>Ni의 순이었고, 도시지역은 Mn>Al>Ni의 순으로 조사되었다.

• 소성∙가공
• /
• 제26권5호
• /
• pp.306-313
• /
• 2017

This study investigated the microstructure, tensile strength, and high cycle fatigue properties of ADC12 aluminum alloys with different $Mg+Al_2Ca$ contents manufactured using die casting process. Microstructural observation identified the presence of ${\alpha}-Al$, eutectic Si, $Al_2Cu$, and Fe-intermetallic phases. The increase of $Mg+Al_2Ca$ content resulted in finer pore size and decreased pore distribution. Room temperature tensile strength tests were conducted at strain rate of $1{\times}10^{-3}/sec$. For 0.6%Mg ADC12, measured UTS, YS, and El were 305.2MPa, 157.0MPa, and 2.7%, respectively. For 0.8%Mg ADC12, measured UTS, YS, and El were 311.2 MPa, 159.4 MPa, and 2.4%, respectively. Therefore, 0.8% ADC12 alloy had higher strength and slightly decreased elongation compared to 0.6% Mg ADC12. High cycle fatigue tests revealed that 0.6% Mg ADC12 alloy had a fatigue limit of 150 MPa while 0.8% Mg ADC12 had a fatigue limit of 160MPa. It was confirmed that $Mg+Al_2Ca$ added ADC12 alloy achieved finer, spherical eutectic Si particles, and $Al_2Cu$ phases with greater mechanical and fatigue properties since size and distribution of pores and shrinkage cavities decreased as $Mg+Al_2Ca$ content increased.

• Korean Chemical Engineering Research
• /
• 제58권1호
• /
• pp.52-58
• /
• 2020

본 연구에서는 MgF₂를 이용하여 LiNi_0.8Co_0.15Al_0.05O₂ 양극활물질의 표면을 코팅하여 전기화학적 특성과 열적 안정성을 평가하였다. 코팅된 MgF₂의 비율은 0.5, 1, 3 wt%로 조절하였다. 전기화학적 특성은 CV, 충·방전 프로파일, 출력특성, 수명특성을 분석하였고, 열적 안정성은 DSC 분석을 통하여 이루어졌다. 전기화학적 특성 분석 결과 0.1C에서 초기 방전 용량은 MgF₂ 코팅이 되었을 때 감소하였지만, 2C까지 출력을 향상 시켰을 때는 약간 향상된 방전 용량을 얻을 수 있었고, 수명특성 또한 향상되었다. 또한 DSC 분석 결과 코팅이 되었을 때 발열 온도가 증가하였고, 발열 피크의 세기 또한 감소하였다.

• 한국결정성장학회지
• /
• 제8권4호
• /
• pp.634-639
• /
• 1998

$Y_2O_3$와 $Nb_2O_5$가 첨가된 지르코니아에 입자 크기가 다른 두종류의 Al2O3를 부피비로 10~30% 첨가한 복합체를 155$0^{\circ}C$ 온도에서 5시간 소결하여 $250^{\circ}C$ 온도의 공기 분위기하에서 1000시간 혹은 $180^{\circ}C$ 온도의 0.3MPa H2O vapor pressure 분위기하에서 5시간 열처리를 하여 X-ray 회절분석 방법을 이용하여 저온 상안정성을 조사하였다. 복합체 전부 열처리 후에 정방정 상에서 단사정 상으로 상전이가 발생하지 않는 우수한 저온 상안정성이 관찰되었다. 복합체의 상아정성에 Nb 첨가가 $Al_2O_3$의 첨가보다 더 효과적이었다. 2.8$\mu$m 입자크기를 가진 Al2O3를 부피비로 20% 첨가한 복합체에서 최적의 조건이 관찰되었으며 강도와 인성값은 각각 670MPa와 7.1MPam1/2이었다. Al2O3 입자 크기가 2.8$\mu$m에서 0.2$\mu$m로 감소함에 따라 강도는 다소 증가하였으나 파괴인성값은 감소하였다.

• 한국자기학회지
• /
• 제8권4호
• /
• pp.192-197
• /
• 1998

Ni1-xCdxFeAlO4계의 Mossbauer 스펙트럼은 x가 0.2이하인 경우에는 초상자성 이완 현상을, x가 0.3∼0.5인 경우는 준강자성에 의한 sextet를, x가 0.7, 0.8인 경우에는 강자성 이완 현상, x가 0.8이상인 경우에는 상자성에 dmlgksdoublet가 나타난다. x가 0.2이하인 시료에서 치환된 Cd2+이온은 주로 A-site의 Fe3+이온도 B-site로 이동하게 된다. Ni1-xCdxFeAlO4계의 초상자성 이완 현상은 A-site의 A13+이온에 의한 것으로, 강자성 이완현상은 치환된 Cd2+이온에 의한 것으로 설명할 수 있고, Yafet-Kittel 자기구조에 따라 Ni1-xCdxFeAlO4계의 자기적 성질을 해석할 수 있다.

• Applied Science and Convergence Technology
• /
• 제26권4호
• /
• pp.79-85
• /
• 2017

The crack-free AlGaN template has been successfully grown by using selective area growth with triangular GaN facet. The triangular GaN stripe structure was obtained by vertical growth rate enhanced mode with low growth temperature of $950^{\circ}C$ and high growth pressure of 500 torr. The lateral growth rate enhanced mode of AlGaN for crack-free and flat surface was also investigated. Low pressure of 30 torr and high V/III ratio of 4400 were favorable for lateral growth of AlGaN. It was confirmed that the $4{\mu}m$ -thick $Al_{0.2}Ga_{0.8}N$ was crack-free over entire 2-inch wafer. The dislocation density of $Al_{0.2}Ga_{0.8}N$ was as low as ${\sim}7.6{\times}10^8/cm^2$ measured by cathodoluminescence. Based on the high quality AlGaN with low dislocation density, the ultraviolet laser diode epitaxy with cladding, waveguide and GaN/AlGaN multiple quantum well (MQW) was grown by metalorganic chemical vapor deposition. The stimulated emission at 349 nm with full width at half maximum of 1.8 nm from the MQW was observed through optical pumping experiment with 193 nm KrF laser. We also have fabricated the deep ridge type ultraviolet laser diode (UV-LD) with $5{\mu}m-wide$ and $700{\mu}m-long$ cavity for electrical properties. The turn on voltage was below 5 V and the resistance was ${\sim}55{\Omega}$ at applied voltage of 10 V. The amplified spontaneous emission spectrum of UV-LD was also observed from pulsed current injection.