• Aerospace Engineering and Technology
• /
• v.4 no.2
• /
• pp.7-14
• /
• 2005

This paper describes development of automatic flight control system for an unmanned target drone. Current target drone is operated by pilot control of on-board servo motor via remote control system. Automatic flight control system for the target drone greatly reduces work load of ground pilot and can increase application area of the drone. Most UAVs being operated nowdays use high-priced sensors as AHRS and IMU to measure the attitude, but those are costly. This paper introduces the development of low-cost automatic flight control system with low-cost sensors. The integrated automatic flight control system has been developed. The performance of automatic flight control system is verified by flight test.

• Journal of the Korean Society for Aviation and Aeronautics
• /
• v.20 no.2
• /
• pp.18-25
• /
• 2012

The availability of the GPS signal has been expanded greatly in the field of society overall through the development and construction of the GNSS(Global Navigation Satellite System). Furthermore, in the military, aviation and field of space, the GPS signal is applied widely through the combination of INS consisting of gyroscope and accelerometer, IMU, AHRS with the addition of magnetic sensor. Particularly, the performance of these equipments or sensors is very important with GPS and PAR(Precision Approach Radar) in the flight control of the aircraft. This paper deals with MATLAB simulation and ROLSO(Reduced Order Luenberger State Observer) design to reduce the load of system and realize the stable lateral direction approach control in an appropriate time for reduction of the horizontal error which is importantly considered while an aircraft lands instead of the FOLSO(Full Order Luenberger State Observer) using all measurement values. Consequently, ROLSO is expected to be used for the aircraft's attitude control in the aircraft landing causing the burden to the pilots.

• Proceedings of the Korean Society of Surveying, Geodesy, Photogrammetry, and Cartography Conference
• /
• 2004.04a
• /
• pp.59-64
• /
• 2004

In this paper, the error compensation method of the low-cost IMU is proposed. In general, the position and attitude error calculated by accelerometers and gyros grows with time. Therefore the additional information is required to compensate the drift. The attitude angles can be bound accelerometer mixing algorithm and the heading angle can be aided by single antenna GPS velocity. The Kalman filter is used for error compensation. The result is verified by comparing with the attitude calculated by Attitude Heading Reference System with Micro Electro Mechanical System for a basis

• International journal of advanced smart convergence
• /
• v.13 no.1
• /
• pp.37-47
• /
• 2024

This study presents the results of designing a system that determines the location of a person in an indoor environment based on a single IMU sensor attached to the tip of a person's shoe in an area where GPS signals are inaccessible. By adjusting for human footfall, it is possible to accurately determine human location and trajectory by correcting errors originating from the Inertial Measurement Unit (IMU) combined with advanced machine learning algorithms. Although there are various techniques to identify stepping, our study successfully recognized stepping with 98.7% accuracy using an artificial intelligence model known as Long Short-Term Memory (LSTM). Drawing upon the enhancements in our methodology, this article demonstrates a novel technique for generating a 200-meter trajectory, achieving a level of precision marked by a 2.1% error margin. Indoor pedestrian navigation systems, relying on inertial measurement units attached to the feet, have shown encouraging outcomes.

• Journal of Advanced Navigation Technology
• /
• v.8 no.1
• /
• pp.19-26
• /
• 2004

This paper deals with the automatic flight control system for an unmanned target drone which is operated by an army as an anti-air gun shooting training. By automation of unmanned target drone that is manually operated by external pilot, pilot can reduce workload and an army can reduce the budget. Most UAVs which are developed until today use high-cost sensors as AHRS and IMU to measure the attitude, but those are contradictory for the reduction of budget. This paper says the development of low-cost automatic flight control system which makes possible of automatic flight with low-cost sensors. We have developed the integrated automatic flight control system by integrating electricity module, switching module, monitoring module and RC receiver as an one module. We also prove the performance of automatic flight control system by flight test.

• Journal of Institute of Control, Robotics and Systems
• /
• v.22 no.11
• /
• pp.967-976
• /
• 2016

This paper presents a 3D carrier-smoothed GNSS/DR (Global Navigation Satellite System/Dead Reckoning) integrated system for precise ground-vehicle trajectory estimation. For precise DR navigation on sloping roads, the AHRS (Attitude Heading Reference System) methodology is employed. By combining the integrated carrier phase of GNSS and DR sensor measurements, a vehicle trajectory with an accuracy of less than 20cm is obtained even when cycle slip or change of visibility occur. In order to supplement the weak GNSS environment with DR successfully, the DR sensor is precisely compensated for using GNSS Doppler measurements when GNSS visibility is good. By integrating a multi-GNSS receiver with low-cost IMU, a precise 3D navigation system for land vehicles is proposed in this paper. For real-time implementation, a decoupled Kalman filter is employed in the integrated system. Through field experiments, the performance of the proposed system is verified in various road environments, including sloping roads, good-visibility areas, high multi-path areas, and under-ground parking areas.

• 제어로봇시스템학회:학술대회논문집
• /
• 2004.08a
• /
• pp.367-371
• /
• 2004

This paper describes development of automatic flight control system for an unmanned target drone which is operated by Korean army as for anti-air gun shooting training. Current target drone is operated by pilot control of on-board servo motor via remote control system. Automatic flight control system for the target drone greatly reduces work load of ground pilot and can increase application area of the drone. Most UAVs being operated now days use high-priced sensors as AHRS and IMU to measure the attitude, but those are costly. This paper introduces the development of low-cost automatic flight control system with low-cost sensors. The integrated automatic flight control system has been developed by integrating combining power module, switching module, monitoring module and RC receiver as an one module. The performance of automatic flight control system is verified by flight test.

• Journal of the Korean Society for Aviation and Aeronautics
• /
• v.10 no.1
• /
• pp.35-44
• /
• 2002

Inertial Navigation System(INS) has been used in the field of air navigation for a long time but is not popular in general aviation due to high price. Recently low-price GPS is available but vulnerable to radio interference. As an alternative on these problems, GPS/INS integrated navigation system has been considered. GPS/INS is capable of implementing navigation with low-price inertial sensors but its accuracy is dependent upon how much drift of INS may be calibrated by using GPS. In order to apply GPS/INS to air navigation, it must be investigated how long drift of INS in case of no GPS aiding will be bounded within requirements for safe flight. From the above motivation, the flight test for GPS/INS navigation system was conducted in order to make sense its performance in air navigation and its result was shown.

• Journal of Advanced Navigation Technology
• /
• v.8 no.2
• /
• pp.105-111
• /
• 2004

This paper describes the design of navigation system for an unmanned target drone which is operated by Korean army as for anti-air gun shooting training. Current target drone is operated by pilot control of on-board servo motor via remote control system. Automatic flight control system for the target drone greatly reduces work load of ground pilot and can increase application area of the drone. Most UAVs being operated nowdays use high-priced sensors as AHRS and IMU to measure the attitude, but those are costly. This paper introduces the development of low-cost automatic flight control system with low-cost sensors. The integrated automatic flight control system has been developed by integrating combining power module, switching module, monitoring module and RC receiver as an one module. The performance of navigation for low cost unmanned aerial vehicle, unmanned target drone as our test bed in this paper is verified by both Hardware in the loop simulation(HILS) to test performance of GPS as GPS output frequency high and results of flight test.