• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.8 no.2
• /
• pp.27-35
• /
• 2009

The roundabout was developed in the United Kingdom to rectify problems associated with these traffic circles. In 1966, the United Kingdom adopted a mandatory "give-way" rule at alt circular intersections, which required entering traffic to give way, or yield, to circulating traffic. However, the roundabout used in United States or Europe do not common use in Korea. The purposes of the study is to comparatively analyze the effectiveness of roundabout. In pursuing the above, this study designs the scenarios which can reflect the directional traffic volumes, and analyzes the average control delay of roundabout and 4-leg signalized intersection by SIDRA. The main study results are as follows. First, when the entering traffic volume are less than 2,000pcph, the single-lane roundabout is analyzed to be more effective than 4-leg signalized intersection. Second, when the entering traffic volume are less than 3,200pcph, the double-lane roundabout is evaluated to be more effective than 4-leg signalized intersection. Third, which is installed left and right turn lane at intersection, area for the roundabout is analyzed to be less than that for general intersection area.

• International Journal of Highway Engineering
• /
• v.17 no.4
• /
• pp.89-98
• /
• 2015

PURPOSES : This study evaluated the feasibility of implementing protected-permissive left-turn (PPLT) signals at three-leg signalized intersections. METHODS: A three-leg signalized intersection with permissive left-turn was first selected. A VISSIM simulation model was constructed using data collected from the test site. The VISSIM network was calibrated by adjusting related parameter values in order to minimize the difference between the simulated and surveyed critical gap. The calibrated network was validated by the number of waiting left-turning vehicles per cycle. Finally, the mobility and safety measures were extracted from simulation runs in which permissive, protected left turns as well as PPLTs were realized based on diverse traffic volume scenarios. RESULTS : The mobility-related measures of effectiveness (MOEs) of the case with PPLT outperformed the other two left-turn treatment scenarios. In particular, the average waiting time per cycle for the left-turn vehicles in the case with PPLT was reduced by 30 s. The safety-related MOEs of the case with PPLT were somewhat higher than those in the case with protected left-turns and much higher than those in the case with permissive left-turns. CONCLUSIONS : Based on the mobility- and safety-related MOEs generated from the VISSIM simulation runs, the use of PPLT seems to be feasible at three-leg signalized intersections where the left-turn is permissive and a pedestrian signal exists at the conflicting approach. However, in order to use the PPLT in earnest, it is necessary to revise the road traffic act, traffic signs, and related manuals.

• International Journal of Highway Engineering
• /
• v.15 no.4
• /
• pp.135-146
• /
• 2013

PURPOSES : This study aimed to analyze the impact the operation of pre-signals at 4-leg signalized intersections and present primary environmental factors of roads that need to be considered in the installation of pre-signals. METHODS : Shift of proportions safety effectiveness evaluation method which assesses shifts in proportions of target collision types to determine safety effectiveness was applied to analyze traffic crash by types. Also, Empirical Bayes before/after safety effectiveness evaluation method was adapted to analyze the impact pre-signal installation. Negative binomial regression was conducted to determine SPF(safety performance function). RESULTS : Pre-signals are effective in reducing the number of head on, right angle and sideswipe collisions and both the total number of personal injury crashes and severe crashes. Also, it is deemed that each factor used as an independent variable for the SPF model has strong correlation with the total number of personal injury crashes and severe crashes, and impacts general traffic crashes as a whole. CONCLUSIONS: This study suggests the following should be considered in pre-signal installation on intersections. 1) U-turns allowed in the front and rear 2) A high number of roads that connect to the intersection 3) Many right-turn traffic flows 4) Crosswalks installed in the front and rear 5) Insufficient left-turn lanes compared to left-turn traffic flows or no left-turn-only lane.

• Journal of Korean Society of Transportation
• /
• v.27 no.3
• /
• pp.81-90
• /
• 2009

The safety management of a road network comprises four basic inter-related components：identification of sites(black spot) requiring safety investigation, diagnosis of safety problems, selection of feasible treatments for potential treatment candidates, and prioritization of treatments given limited budgets(Persaud, 2001). Identification process of selecting black spot is very important for efficient investigation of sites. In this study, the accident prediction model for EB method was developed by using accident data and geometric conditions of black spots selected from four-leg signalized intersections in In-cheon City for three years (2004-2006). In addition, by comparing the rank nomination technique using EB method to that by using accident counts, we managed to show the problems which the existing method have and the necessity for developing rational prediction model. As a result, in terms of total number of accidents, both the counts predicted by existing non-linear regression model and that by EB method have high good of fitness, but EB method, considering both the accident counts by sites and total number of accident, has better good of fitness than non-linear poison model. According to the result of the comparison of ranks nominated for treatment between two methods, the rank for treatment of almost sites does not change but SeoHae intersection and a few other intersections have significant changes in their rank. This shows that, with the technique proposed in the study, the RTM problem caused by using real accident counts can be overcome.