• Steel and Composite Structures
• /
• v.18 no.4
• /
• pp.925-946
• /
• 2015

This paper presents a new cost-effective hybrid GFRP-Concrete deck system that the GFRP panel serves as both tensile reinforcement and stay-in-place form. In order to understand the fatigue behavior of such hybrid deck, fatigue test on a full-scale specimen under sagging moment was conducted, and a series of static tests were also carried out after certain repeated loading cycles. The fatigue test results indicated that such hybrid deck has a good fatigue performance even after 3.1 million repeated loading cycles. A three-dimensional finite element model of the hybrid deck was established based on experimental work. The results from finite element analyses are in good agreement with those from the tests. In addition, flexural fatigue analysis considering the reduction in flexural stiffness and modulus under cyclic loading was carried out. The predicted flexural strength agreed well with the analytical strength from finite element simulation, and the calculated fatigue failure cycle was consistent with the result based on related S-N curve and finite element analyses. However, the flexural fatigue analytical results tended to be conservative compared to the tested results in safety side. The presented overall investigation may provide reference for the design and construction of such hybrid deck system.

• Journal of Environmental Science International
• /
• v.17 no.4
• /
• pp.451-459
• /
• 2008

This study was carried out forecasting of pollution inflow of the Small Mountainous Catchment, namely; Seolma-cheon experimental catchment. Pollutographs of DO, BOD, T-N, Conductivity, T-p, pH. COD, SS from this catchment were obtained from in-situ data of total ten events using QUAL2E-PULS model. From the analysis results, between up stream(Sabang-bridge) and down stream (Memorial-bridge, outlet) obtained relation formula of water quality component. Determination coefficient of relation formula, Conductivity, COD, BOD, DO, pH, T-N, T-P, and SS showed high relation of $0.87{\sim}0.99$. The increases of DO, BOD, COD, and pH concentration of Memorial-bridge were associated with pollution inflow by road building far 2.25km from Sabang-bridge to down stream. The analysis results of QUAL2E-PULS simulation and up/down stream relation formula, pollution amounts of DO, BOD, COD and pH increased at Memorial-bridge and pollution source site. Therefore, pollution inflow can be forecasted exactly by up/down stream relation formula at pollution source site.

• Water for future
• /
• v.26 no.4
• /
• pp.35-46
• /
• 1993

The variations of water surface elevation due to bridge are studied using one_dimensional dynamic wave equation. The preissmann scheme is used to solve the dynamic wave equation and the bridges was treated as internal boundary conditions. Main causes of bridge backwater are the proportion of the contracted area due to bridge, roughness coefficient and discharge coefficient. The effect of discharge coefficient in weir flow condition is comparatively small. This model is verified by applying to the Suyoung River. which suffered a severe damage by typoon Gladys. The rise of water level through bridge is 1.53-1.08m in the reach of 4.25-6.20km from the downstream of river. The simulation results of the model have good agreements with the observed data.

• Wind and Structures
• /
• v.13 no.4
• /
• pp.309-326
• /
• 2010

CFD techniques try to find their way in the bridge engineering realm nowadays. However, there are certain fields where they offer superior performance such as conceptual bridge design and bidding design. The CFD studies carried out for the conceptual design of a 425 m length cable-stayed bridge are presented. A CFD commercial package has been employed to obtain for a set of cross-sections the aerodynamic coefficients considering 2D steady state. Additionally, for those cross-sections which showed adequate force coefficients, unsteady 2D simulations were carried out to detect the risk of vortex shedding. Based upon these computations the effect on the aerodynamic behavior of the deck cross-section caused by a number of modifications has been evaluated. As a consequence, a new more feasible cross-section design has been proposed. Nevertheless, if the design process proceeds to a more detailed step a comprehensive set of studies, comprising extensive wind tunnel tests, are required to better find out the aerodynamic bridge behavior.

• Advances in Computational Design
• /
• v.2 no.4
• /
• pp.283-291
• /
• 2017

High frequency full bridge series resonant inverters have become increasingly popular among power supply designers. One of the most important parameter for a High Frequency Full Bridge Series Resonant Inverter is optimal coil design. The optimal coil designing procedure is not a easy task. This paper deals with the New Approach to Optimal Design Procedure for a Real-time High Frequency Full Bridge Series Resonant Inverter in Induction Heating Equipment devices. A new design to experimental modelling of the physical properties and a practical power input simulation process for the non-sinusoidal input waveform is accepted. The design sensitivity analysis with Levenberg-Marquardt technique is used for the optimal design process. The proposed technique is applied to an Induction Heating Equipment devices model and the result is verified by real-time experiment. The main advantages of this design technique is to achieve more accurate temperature control with a huge amount of power saving.

• Wind and Structures
• /
• v.31 no.1
• /
• pp.31-41
• /
• 2020

A new type of bridge deck section consisting of four-box decks, two side decks for vehicular traffic lanes and two middle decks for railway traffic, has been experimentally investigated for determining its aerodynamic properties. The eight flutter derivatives were determined by the Iterative Least Squares (ILS) method for this new type of four-box deck model, with two windshields of 30 mm and 50 mm height respectively. Wind tunnel experiments were performed for angles of attack α = ±6°, ±4°, ±2° and 0° and Re numbers of 4.85×105 to 6.06×105 and it was found that the four-box deck with the 50 mm windshields had a better aerodynamic performance. Also, the results showed that the installation of the windshields reduced the values of the lift coefficient CL for the negative angles attack in the range of -6° to 0°, but the drag coefficient CD increased in the positive angle of attack range. However, galloping instability was not encountered for the tested reduced wind speeds, of up to 9.8. The aerodynamic force coefficients and the flutter derivatives for the four-box deck model were consistent with the results reported for the Messina triple-box bridge deck, but were different from those reported for the twin-box bridge decks.

• Journal of Power Electronics
• /
• v.12 no.4
• /
• pp.567-577
• /
• 2012

This paper introduces a new scheme to balance the DC bus voltages of a cascaded H-bridge converter which is used as a Distribution Static Synchronous Series Compensator (D-SSSC) in electrical distribution network. The aim of D-SSSC is to control the power flow between two feeders from different substations. As a result of different cell losses and capacitors tolerance the cells DC bus voltage can deviate from their reference values. In the proposed scheme, by individually modifying the reference PWM signal for each cell, an effective balancing procedure is derived. The new balancing procedure needs only the line current sign and is independent of the main control strategy, which controls the total DC bus voltages of cascaded H-bridge. The effect of modulation index variation on the capacitor voltage is analytically derived for the proposed strategy. The proposed method takes advantages of phase shift carrier based modulation and can be applied for a cascaded H-bridge with any number of cells. Also the system is immune to loss of one cell and the presented procedure can keep balancing between the remaining cells. Simulation studies and experimental results validate the effectiveness of the proposed method in the balancing of DC bus voltages.

• Journal of the Korean Geotechnical Society
• /
• v.18 no.2
• /
• pp.13-21
• /
• 2002

A new method called S-SRICOS is proposed to predict the local scour depth around bridge piers. The S-SRICOS method is a simplified version of the SRICOS method which was developed to predict the scour depth versus time curve around bridge piers. The SRICOS method which considers the time effect based on the soil properties and the hydraulic parameters can handle a multi-flood hydrograph and multi-layer soil systems with the SRICOS program. An attempt was made to simplify the method to the point where only hand calculations would be required. The concept of the equivalent time was developed leer this purpose. The S-SROICOS method requires only 4 parameters such as pier width, design bridge life, design velocity corresponding to the design bridge life, and initial scour rate of the soil. The S-SRICOS method was verified against 55 cases of the scour depth results using the SRICOS method.

• Journal of the Earthquake Engineering Society of Korea
• /
• v.12 no.4
• /
• pp.45-54
• /
• 2008

The purpose of this study was to investigate the performance of precast segmental PSC bridge columns with regard to P-delta effects. A model of precast segmental PSC bridge columns was tested under a constant axial load and a cyclically reversed horizontal load. A computer program, RCAHEST(Reinforced Concrete Analysis in Higher Evaluation System Technology), was used for the analysis of reinforced concrete structures. In addition to the material nonlinear properties, an algorithm for the problem of large displacement that may result in additional deformation has been formulated using total Lagrangian formulation. This study documents the testing of precast segmental PSC bridge columns under cyclic loading, and presents conclusions based on the experimental and analytical findings.

• Journal of the Earthquake Engineering Society of Korea
• /
• v.13 no.4
• /
• pp.57-65
• /
• 2009

This study is an evaluation of seismic fragility function using the HAZUS program for railway bridge systems, based on the results of previous research on seismic safety factor. First, a fragility function for each of the bridge members was evaluated according to the damage criteria and failure mode. Subsequently, bridge system fragility was evaluated using a fault tree to describe damage status. Finally, a fragility evaluation method for the bridge system was developed, based on the safety factor derived from the previous research.