• Bulletin of the Korean Space Science Society
• /
• 2003.10a
• /
• pp.48-48
• /
• 2003

A precision orbit determination (POD) system of low Earth orbiter using the GPS dual frequency measurements has been developed. It is an option of KOMPSAT-2 POD process system. In this research, the orbit determination using the real dual frequency carrier phase measurements of the SAC-C satellite was conducted to verify KOMPSAT-2 POD system reliability. The SAC-C satellite is an international cooperative mission between NASA, the Argentine Commission on Space Activities (CONAE), Centre National d'Etudes Spatiales (CNES or the French Space Agency), Instituto Nacional De Pesquisas Espaciais (Brazilian Space Agency), Danish Space Research Institute, and Agenzia Spaziale Italiana (Italian Space Agency). The SAC-C was launched at November 21, 2000. The altitude of SAC-C is 702 km and it carries a TurboRogue III GPS and four high gain antennas developed by the JPL. The receiver is able to generate the dual frequency code and carrier phase data. Double-differenced carrier phase measurements were formed using 25 IGS stations. The data were sampled at 30 seconds interval. Fully dynamic approach was adopted for POD. The POD results were compared with those of JPL using GOA n software. The comparison verifies that deci-meter level 3D position accuracy of low Earth orbiting satellite could be achieved. The POD system has been developed successfully.

• Geomechanics and Engineering
• /
• v.14 no.5
• /
• pp.407-419
• /
• 2018

In order to investigate flow characteristics after water inrush from the working face in process of karst tunnel construction, numerical calculation for two class case studies of water inrush is carried out by using the FLUENT software on the background of Qiyueshan tunnel. For each class water inrush from the tunnel face, five cases under different water-inrush velocity are simulated and researched. Three probing lines are selected respectively in the left tunnel, cross passage, right tunnel and in the height direction of the tunnel centerline. The variation characteristics of velocity and pressure on each probing line under the five water-inrush velocities are analyzed. As for the selected four groups probing lines in the tunnels, the change rules of velocity and pressure on each group probing lines under the same water-inrush velocity are discussed. Finally, the water flow characteristics after inrush from the tunnel face are summarized by comparing the case studies. The results indicate that: (1) The velocity and pressure change greatly at the intersection area of the cross passage and the tunnels. (2) The velocity nearby the tunnel side wall is the minimum, while it is the maximum in the middle position. (3) The pressure value of every cross section in the tunnels is basically fixed. (4) As water-inrush velocity increases, the flow velocity and pressure in the tunnels also increase. The former is approximately proportional to their respective water-inrush velocity, while the latter is not. The research results provide a theoretical basis for making scientific and rational escape routes.

• 제어로봇시스템학회:학술대회논문집
• /
• 2005.06a
• /
• pp.1417-1422
• /
• 2005

Among the sensors mainly used for displacement measurement, there are a linear CCD(Charge Coupled Device) and a PSD(Position Sensitive Detector) as a non-contact type. Their structures are different very much, which means that the signal processing of both sensors should be applied in the different ways. Most of the displacement measurement systems to get the 3-D shape profile of an object using a linear CCD are a computer-based system. It means that all of algorithms and mathematical operations are performed through a computer program to measure the displacement. However, in this paper, the developed system has microprocessor and other digital components that make the system measure the displacement of an object without a computer. The thing different from the previous system is that AVR microprocessor and FPGA(Field Programmable Gate Array) technology, and a comparator is used to play the role of an A/D(Analog to Digital) converter. Furthermore, an ATC(Automatic Threshold Control) algorithm is applied to find the highest pixel data that has the real displacement information. According to the size of the light circle incident on the surface of the CCD, the threshold value to remove the noise and useless data is changed by the operation of AVR microprocessor. The total system consists of FPGA, AVR microprocessor, and the comparator. The developed system has the improvement and shows the better performance than the system not using the ATC algorithm for displacement measurement.

• The Journal of Information Technology
• /
• v.4 no.3
• /
• pp.35-48
• /
• 2001

Information technology leadership roles have undergone fundamental change over the past decade. Despite increase interest in recent years, little empirical research on Information Technology has been done. This paper suggests results from a survey in Korea on Information Technology. The survey collected data on general leadership roles such as information roles, decisional role and interpersonal role, as well as on specific Information Technology leadership roles such as planning leader, R&D manager, general manager, chief operating strategist. The role of a change leader is positively influenced by the number of years, the extent of strategic responsibility and the organization's revenue while it is negatively influenced by the number of years in the current position. R&D manager can be predicted by strategic responsibility and chief executive's IT use, Manager can be predicted by the extent of strategic responsibility. Although several significant predictors of Information Technology leadership roles were identified, the more signigicant study should continue in the future.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.27 no.3
• /
• pp.13-20
• /
• 1990

This paper describes an interframe image coding using motion compensated and classified vector quantizer (MC-CVQ). It is essential to carefully encode blocks with significant pels in motion compensated vector quantizers (MCVQ). In this respect, we propose a new CVQ algorithm which is appropriate to the coding of interframe prediction error after motion compensation. In order to encode an image efficiently at a low bit rate, we partition each block, which is the processing element in MC, into equally sized 4 vectors, and classify vectors into 15 classes according to the position of significant pels. Vectors in each class are then encoded by the vector quantizer with the codebook independently designed for the class. The computer simulation shows that the signal-to-noise ratio and the average bit rate of MC-CVQ are 35-37dB and 0.2-0.25bit/pel, respectively, for the videophone or video conference type image.

• Radiation Oncology Journal
• /
• v.2 no.2
• /
• pp.271-280
• /
• 1984

The peripheral dose, defined as the dose outside therapeutic photon fields, which is responsible for the functional damage of the critical organs, fetus, and radiation. induced carcinogenesis, has been investigated for $^{60}Co\;\gamma$ ray and 10 MV Xray. It was measured by silicon diode controlled by semiautomated water phantom without any shielding or with lead plate of HVL thickness put horizontally or vertically to shield stray radiations. Authors could obtain following results. 1. The peripheral dose was larger than $0.7\%$ of central axis maximum dose even at 20cm distance from field margin. That is clinically significant, so it should be reduced. 2. Even for square fields of 10 MV Xray, radial peripheral dose distribution did not coincide with transverse distribution, because of the position of collimator jaws. 3. Between surface and $d_m$, the peripheral dose distributions show a pattern of the dose distribution of electron beams and the maximum doss was approximately proportional to the length of a side of square field. 4. The peripheral doses depended on radiation quality, field size, distance from field margin and depth in water. Distance from field margin was the most important factor. 5. Except for near surface, the peripheral dose from phantom was approximately equal to that from therapy unit. 6. To reduce the surface dose outside fields, therapist should shield stray radiations from therapy unit by lead plate of at least one HVL for 10 MV X-ray and by bolus equivalent to tissue of 0.5cm thickness for $^{60}Co$. 7. To reduce the dose at depth deeper than $d_m$, it is desirable to shield stray radiations from therapy unit by lead.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.41 no.1
• /
• pp.61-67
• /
• 2008

Acoustic technology is commonly used to estimate the biomass and distribution of fisheries resources in coastal areas and the open ocean. Acoustic surveys were conducted on 24-26 May and 20-21 June, 2005, and 15-18 June and 27-30 July, 2006, near the Tongyoung, Geojae, and Namhae anchovy fishing grounds using a dual beam echo sounder. Information was obtained on the distributions of adult and juvenile anchovy (depth and position). We calculated and compared anchovy biomass using simple summation. In this study, all backscatter was attributed to anchovy. We assumed that the average target strength of anchovy was -70 dB and the average body weight was 3 g in May and June 2005, and that the target strength of anchovy was -65 dB and the average body weight was 5 g for pelagic individuals in July 2006. The anchovy biomass in May 2005 was estimated to be 0.147 million tons using the traditional method, while using the summation method, the estimated anchovy biomass was 0.062 million tons in June 2005, 0.21 million tons in June 2006, and in 0.43 million tons in July 2006.

• Journal of the Korean Society of Food Culture
• /
• v.9 no.2
• /
• pp.131-136
• /
• 1994

The ethylacetate extract of Lactuca dentata Makino showed 6 flavonoidal components as detected by ferric chloride solution. The flavonoidal constituent of Lactuca dentata Makino was isolated and purified by the series of column chromatography. The chemical structure of one of the flavonoidal component named as compound E was identified by UV, IR and NMR spectrometry. The melting point range of compound E was $249.5^{\circ}C-251^{\circ}C$. The UV and IR spectra of purified compound E, and its genin were measured with the various shifting agents. The results of UV analysis showed the free state of hydroxy group at 3rd and 4th carbon and binding of sugar at the 7th carbon of compound. The sugar bound to the compound E was identified as glucose by TLC. The IR spectrum showed the presense of hydroxy group, conjugated carbonyl group and aromatic group. The analysis of NMR spectrum was done to the purified compound and its derivatives. The chemical shifts against hydrogen atom, hydroxy group, and the moiety of luteolin were observed in the NMR spectrum along with their position and number as well as type of sugar bound. The isolated and purified compound was identified as $luteolin-7-0-{\beta}-D-glucoside$.

• Journal of Convergence for Information Technology
• /
• v.10 no.3
• /
• pp.16-21
• /
• 2020

This paper describes the jamming characteristics of a stand-off jammer jamming the LPI radar. The LPI radar reduces the side lobes of the receiving antenna to reduce the effect of jamming. It is easy a radar to predict the effect of jamming on a self-protection jammer where the jammer is in the same position as the target. However, for stand-off jammer jamming at different locations from the target, the prediction of jamming effect is complex. In this paper, the jamming effect of LPI radar is analyzed using signal to jamming ratio and burn-through range. Also, when the antenna's side lobe decreases below -30 dB, the stand-off jamming effect in the side lobe direction is weak. So we proposed a new jamming method for the main lobe and analyzed the jamming effect. This study is expected to be useful for the design and operation of aircraft jammers.

• Korean Journal of Plant Tissue Culture
• /
• v.27 no.3
• /
• pp.191-195
• /
• 2000

Adventitious shoots were induced from cotyledon and hypocotyl explants of apple hybrid seedlings (P.16$\times$ Malus prunifolia) on MS medium supplement with 2,4-D and various cytokinine (Kn. BA, TDZ) The shoot regeneration from the cotyledon culture was the highest on MS medium supplemented with 1.0 mg/L NAA and 2.0 mg/L BA. Whereas in case of hypocotyl culture, it was the highest on MS medium supplemented with 0.5 mg/L NAA and 0.5 mg/L BA. However, in the MS medium without BA there was no shoot regeneration. Hypocotyl culture seemed to be more effective than cotyledon culture in shoot regeneration. Specially, the top position of the hypocotyl found to be the best explant for shoot induction among the other segments of hypocotyls. Regenerated shoots were rooted on half-stength MS medium with 1.0 mg/L NAA. Above results suggest that Apple hybrid (P.16 $\times$ Malus prunifolia) can be multiplied via cotyledon or hypocotyl culture systems.