• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.26 no.2
• /
• pp.127-134
• /
• 2015

In this paper, we propose 2.6 GHz single band dual polarization MIMO omni antenna for in-building applications. The proposed antenna operates at 2.6 GHz single LTE band, Up-link 2.52~2.54 GHz and Down-link 2.64~2.66 GHz. Horizontal and vertical polarizations of the antenna has been, respectively, constructed by the synthesis of four folded loop antennas and the folded monopole antenna. The height of the MIMO omni-directional antenna is minimized to be less than ${\lambda}/13.5$ from the ground. The measurement results show excellent MIMO omni antenna performance of 2.85 dBi vertical polarization gain, 2.29 dBi horizontal polarization gain, and 19.25 dB port isolation.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.23 no.5
• /
• pp.97-102
• /
• 2023

In this paper, we fabricated transmitting and receiving antennas to realize the low cost radar using two receiving antennas and investigated their characteristics. The antennas are designed with MPA(Microstrip Patch Array) structure for the beam concentration in horizon direction and low cost and used Taylor array pattern synthesis to suppress sidelobes. As a results of measurement in the 24GHz ISM band(24.0-24.25GHz), our using band, antenna gains are placed between 15.2 dBi and 16.26 dBi which are satisfied with the design specification of higher than 15dBi and lower than 17dBi. The sidelobes are -13.15 dBc, -13.1 dBc and -12.8 dBc at the operating frequencies of 24.0 GHz, 24.125 GHz and 24.25 GHz repectively, which are satisfied with the specification of lower than -10 dBc.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.10 no.2
• /
• pp.237-246
• /
• 1999

A miniaturized waveguide bandpass filter is designed by combining a corrugated lowpass structure and a highpass configuration based on the cut-off effect of waveguides. It is smaller than the conventional waveguide bandpass filter composed of half-wavelength resonators and has wider spurious free characteristics. Optimized design data for a seven-order waveguide bandpass filter with the symmetrical structure are given at the center frequency of 10 GHz with 800 MHz bandwidth. Measured bandwidth of the center frequency of 9.97 GHz is 840 MHz and measured insertion loss is 0.97dB, The length of the bandpass filter is 64.38mm. The first spurious response is produced at 26.1 GHz.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.26 no.8
• /
• pp.679-689
• /
• 2015

The 5G mobile communication technologies have been extensively developed with the era of mobile broadband, but spectrum policy for this service has not yet set up. In this paper, We have investigated the 5G mobile service and analyzed the 5G spectrum policy taking the developing technologies into account. Based on the results of these analyses, We propose an expansion of spectrum sharing in the 3~5 GHz bands, spectrum harmonization of 5 GHz bands, and restructuring of spectrum management administration from currently three distributed management to centralized spectrum management structure.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.7 no.1
• /
• pp.53-60
• /
• 1996

The 8W hybrid MIC SSPA has been developed in the frequency range from 14.0 GHz to 14.5 GHz for uplink of KOREASAT's earth station. The whole system was designed of two parts with driving amplifier and high power amplifier to simplify the fabrication process. we reduced weight and volum of power amplifier through arranging the bias circuits in the same housing. The realized SSPA has a small signal gain of $26\pm1dB$within 500 MHz bandwidith, and the input and output return losses are over 7dB and 12dB respectively. The output power of 39.0 ~ 39.2dBm is achieved at the 1dB gain compression point of 14 GHz, 14.25 GHz, and 14.5 GHz. That reveals higher power than 8W of design target. The proposed SSPA manufacture techni- ques in this paper can be applied to the implementation of power amplifiers for some radars and SCPC.

• Journal of Navigation and Port Research
• /
• v.26 no.5
• /
• pp.525-528
• /
• 2002

The proposed EMC filter composed with feed-through capacitors and ferrite beads of high permeability was prepared which satisfy the EMC standard for a wide-band noise signal in the frequence of 10 MHz to 1.5 GHz in power supply line. The optimum structure of ferrite bead was found by calculating the load effect of ferrite beads. As a result, the filter showed excellent differential- and common-mode noises filtering characteristics above 30dB in the frequency band from 10 MHz to 1.5 GHz. The immunity characteristics are improved more than 10 to 30 dB over the frequency band from DC to 1.8GHz.

• Journal of IKEEE
• /
• v.22 no.2
• /
• pp.408-412
• /
• 2018

In this paper, a 26GHz variable gain amplifier fabricated using a 40nm CMOS process is studied. In the case of an automobile radar using 79 GHz, it is advantageous in designing and driving to drive down to a low frequency band or to use a low frequency band before up conversion rather than designing and matching the entire circuit to 79 GHz in terms of frequency characteristics. In the case of a Phased Array System that uses time delay through TTD (True Time Delay) in practice, down conversion to a lower frequency is advantageous in realizing a real time delay and reducing errors. For a VGA (Variable Gain Amplifier) operating in the 26GHz frequency band that is 1/3 of the frequency of 79GHz, VDD : 1V, Bias 0.95V, S11 is designed to be <-9.8dB (Mea. High gain mode) and S22 < (Mea. high gain mode), Gain: 2.69dB (Mea. high gain mode), and P1dB: -15 dBm (Mea. high gain mode). In low gain mode, S11 is <-3.3dB (Mea. Low gain mode), S22 <-8.6dB (Mea. low gain mode), Gain: 0dB (Mea. low gain mode), P1dB: -21dBm (Mea. Low gain mode).

• The Journal of the Korea institute of electronic communication sciences
• /
• v.10 no.1
• /
• pp.7-12
• /
• 2015

In this paper, we studied the design and fabrication of dual T type antenna to be used in LTE communication systems operating at around 1.8 GHz band. In order to improve of frequency properties of antenna, single feed microstrip patch antenna and CPWG antenna was simulated by HFSS(High Frequency Structure Simulator). The fabricated dual T type antennat showed that the measured center frequency, the minimum return loss and -10dB bandwidth were 1.79 GHz, -23.26 dB and 23 MHz, respectively.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.11 no.5
• /
• pp.715-722
• /
• 2000

In this paper, the PLDRO is designed and implemented for X-band. It is comprised of tunable high Q resonator with a varactor diode for frequency tuning, loop filter and a 1/8 prescaler which up to 10GHz. Also, it is implemented a TCXO and a VCO signal into the phase detector and achieved a highly stable signal source. From the measurement, the designed PLDRO has the output power of 2.5dBm at 8GHz and phase noise of -64.33dBc at 10KHz offset from carrier. Its characteristic is 26 dBc. This PLDRO has much better temperature stability.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.32 no.2A
• /
• pp.213-219
• /
• 2007

In this paper, A novel structure of frequency doubler using Phase Delay line and $90^{\circ}$ Hybrid coupler at harmonic output have been designed and implemented to improve suppression. Proposed structure of frequency doubler improve output. coupling and fundamental suppression. Active frequency doubler with band from $2.13{\sim}2.15GHz\;to\;4.26{\sim}4.3GHz$ was designed and fabricated with 10dBm input power, 0.79dB conversion gain and -55.54dBc suppression at fundamental frequency, -44.76dBc suppression at third harmonic frequency 6.42GHz and -39.18dBc suppression at fourth harmonic frequency 8.56GHz.