• The Journal of the Korea institute of electronic communication sciences
• /
• v.16 no.6
• /
• pp.1075-1080
• /
• 2021

In this paper, we designed a 24.4GHz 2-channel TX and 4-channel RX patch array antenna mounted on a short-range vehicle radar system to simultaneously measure the range and speed of a single object within a single measurement cycle. The antenna was designed and fabricated using Rogers' RO4350B(ε_r=3.48, 0.5T) board. Through measurement, it was confirmed that the design specifications of antenna gain (> 10dBi or more) and radiation pattern (Elevation HPBW > 10deg.) were satisfied at 24.4 GHz frequency.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.23 no.5
• /
• pp.97-102
• /
• 2023

In this paper, we fabricated transmitting and receiving antennas to realize the low cost radar using two receiving antennas and investigated their characteristics. The antennas are designed with MPA(Microstrip Patch Array) structure for the beam concentration in horizon direction and low cost and used Taylor array pattern synthesis to suppress sidelobes. As a results of measurement in the 24GHz ISM band(24.0-24.25GHz), our using band, antenna gains are placed between 15.2 dBi and 16.26 dBi which are satisfied with the design specification of higher than 15dBi and lower than 17dBi. The sidelobes are -13.15 dBc, -13.1 dBc and -12.8 dBc at the operating frequencies of 24.0 GHz, 24.125 GHz and 24.25 GHz repectively, which are satisfied with the specification of lower than -10 dBc.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.17 no.5
• /
• pp.187-192
• /
• 2017

We investigated the effects of the CSRR-metamaterial on microstrip comb-line array antennas. Microstrip comb-line array antennas was designed with 12 radiators, gain of 16.09dBi and bandwidth of 0.24GHz in the 24GHz ISM band. The designed antenna had radiation beam perpendicular to the antenna plane, co-polarization gain of 16.09dBi and cross-polarization gain of -10.86dBi. the CSRR-metamaterial increased largely the impedance bandwidth of the antenna from 0.24GHz to 3.6GHz. however as co-polarization gain became 10.08dBi and cross-polarization gain became 14.1dBi, co-polarization was mixed with cross-polarization. And the antenna gain lowered by 1.99dB. On the investigation of the dependence on the split-direction of the CSRR rings, it showed nearly the same characteristics for up-splitted ring used case and down-splitted ring used case. However in the case of arranging up-splitted ring and down-splitted ring in alternation, co-polarization gain decreased to -1.29dBi and cross-polarization gain increased to 13.9dBi, which meant the wave was transited to cross-polarization majority wave.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.24 no.1
• /
• pp.103-107
• /
• 2024

This paper is a study on a triangle patch antenna using a rectangle slot and strip conductor. The length and spacing of the slot were adjusted to confirm the characteristics of the triangle patch antenna with rectangle slot, and the area and shape of the radiation patch were changed to triangle, rectangle, and hexagon for impedance matching. The HFSS simulator was used to check the antenna parameter characteristics, and the antenna size was 26 mm ×26 mm. In this proposed antenna, the simulation frequency range with VSWR of 2 or less was 5.27 to 6.24 GHz. The bandwidth was 970 MHz. The frequency range of the fabricated antenna was 5.24 to 6.38 GHz, and the bandwidth 1140 MHz. The maximum radiation gain is 5.01 dBi. It was confirmed that all radiation patterns had directional characteristics.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.24 no.9
• /
• pp.1165-1171
• /
• 2020

In this study, we designed a single antenna taking into account the performance, such as return loss and radiation pattern, of 28 GHz and 38 GHz array antennas for 5G mobile devices. In millimeter wave band communication, high path loss occurs between transmission and reception, unlike in conventional microwave bands. In the design of array antennas for 5G millimeter wave terminals, antenna performance such as antenna gain, bandwidth, isolation between antenna elements, side-lobe level(SLL), etc. should be further considered. The performance of the designed array antennas was analyzed by spacing the antenna elements at half a wavelength. Our results proved the validity of the design and its suitability for applications in mm-Wave by showing that the 28 GHz and 39 GHz array antennas had antenna gains of 13.5 dBi and 11.3 dBi and return losses below -18.4 dB and -20 dB, correspondingly.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.21 no.10
• /
• pp.1116-1120
• /
• 2010

Low cost patch array antenna for high sensitivity electromagnetic(EM) sensor is presented. The operating frequency band of the antenna is 24.05~24.25 GHz. Array structure is the symmetrical pattern by Chebyshev polynomial and the feed point is located in the middle of the array. Also, the gain of the array antenna can be increased by the side wings which are connected with the ground plane. It is proved through simulation and the measurement results that the operating frequency and the side-lobe level(SLL) are rarely changed when the inclined angle of the side wings is varied.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.13 no.8
• /
• pp.827-833
• /
• 2002

In this paper, a microstrip array antenna for LMDS(Local Multipoint Distribution Service) receiver with corporate feeding network using Chebyshev polynomials is proposed to get the high gain and low side lobe level. The Chebyshev array method is proposed to design the corporate feeding network. LMDS uses 24~27 GHz microwave frequency band to send and receive broadband signals. Measured antenna shows 23.4 dBi gain, 24.96 GHz center frequency, -29.15 dB return loss and 1.2 GHz bandwidth.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.29 no.10
• /
• pp.758-765
• /
• 2018

This paper presents a 24-GHz frequency-modulated continuous wave(FMCW) radar transceiver with two Rx and one Tx channels in 65-nm complementary metal-oxide-semiconductor(CMOS) process and implemented it on a radar system using the developed transceiver chip. The transceiver chip includes a $14{\times}$ frequency multiplier, low-noise amplifier, down-conversion mixer, and power amplifier(PA). The transmitter achieves >10 dBm output power from 23.8 to 24.36 GHz and the phase noise is -97.3 GHz/Hz at a 1-MHz offset. The receiver achieves 25.2 dB conversion gain and output $P_{1dB}$ of -31.7 dBm. The transceiver consumes 295 mW of power and occupies an area of $1.63{\times}1.6mm^2$. The radar system is fabricated on a low-loss Duroid printed circuit board(PCB) stacked on the low-cost FR4 PCBs. The chip and antenna are placed on the Duroid PCB with interconnects and bias, gain blocks and FMCW signal-generating circuitry are mounted on the FR4 PCB. The transmit antenna is a $4{\times}4$ patch array with 14.76 dBi gain and receiving antennas are two $4{\times}2$ patch antennas with a gain of 11.77 dBi. The operation of the radar is evaluated and confirmed by detecting the range and azimuthal angle of the corner reflectors.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.19 no.2
• /
• pp.265-271
• /
• 2015

In this paper, Dualband meander microstrip antenna is proposed for Wireless Body Area Network application. Designed antenna is mounted on the phantom to maintain a constant distance of the substrate, and studied the characteristics related to change in several meaningful parameters to improve performance. Characteristics of antenna, returnloss, radiation pattern, gain, bandwidth, are analyzed using Computer Simulation Technologes(CST) software. The proposed antenna operates at 4.33Ghz and 6.09GHz ~ 9.88GHz for UWB. The antenna showed that returnloss and -10dB bandwidth are -42.30dB and 410Mhz at 4.33GHz, maximum -29.11dB and 3.75GHz at 6.1GHz ~ 9.8GHz.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.12 no.4
• /
• pp.549-554
• /
• 2017

In this paper, we studied the design and fabrication of $2{\times}2$ microstrip array antenna at around 5 GHz band.. To improve of frequency properties of antenna, feed microstrip patch antenna was simulated by HFSS(High Frequency Structure Simulator). A $2{\times}2$ array antenna was designed and fabricated by photolithograph on an FR4 substrate (dielectric constant of 4.4 and thickness of 1.6 mm). The fabricated $2{\times}2$ array antenna showed a center frequency, the minimum return loss and bandwidth were 5.3 GHz, -24dB, and 390MHz, respectively.