• Journal of the Korean Institute of Educational Facilities
• /
• v.24 no.2
• /
• pp.13-17
• /
• 2017

• Communications of the Korean Mathematical Society
• /
• v.4 no.2
• /
• pp.303-320
• /
• 1989

• Journal of The Korea Institute of Healthcare Architecture
• /
• v.28 no.2
• /
• pp.41-47
• /
• 2022

• Ocean Systems Engineering
• /
• v.2 no.1
• /
• pp.33-47
• /
• 2012

This study revealed the behavior of droplets formed through leak process in deep water. There was a threshold depth named the universal attraction depth (UAD). Droplets rose upward in the zone below the UAD called the rising zone, and settled down in the zone above the UAD called the settling zone. Three mass loss modes were identified and formulated: dissolution induced by mass transfer, condensation by heat transfer and phase separation by pressure decrease. The first two were active for the settling zone, and all the three were effective for the rising zone. In consequence, the life time of the droplets in the rising zone was far shorter than that of the droplets in the settling zone.

• 한국초전도학회:학술대회논문집
• /
• v.9
• /
• pp.165-170
• /
• 1999

We have investigated the mixed-state Hall effect in HgBa$_2CaCu_2O_6$, HgBa$_2Ca_2Cu_3O_8$, and Tl$_2Ba_2Cau_2O_8$ thin films as functions of the magnetic field up to 18 T. At high fields and low temperatures, the scaling exponent in ${\rho}_{xy}$ = A${\rho}_{xx}\;^{\beta}$ shows a universal behavior, ${\beta}$ = 1 ${\pm}$ 0.1, regardless of the field, the number of CuO$_2$ layers, the types of defects, and even the types of compounds. At low fields and high temperatures, p = 1 ${\pm}$ 0.1 also appears as a universal number although the observed field range is rather limited. These observations show the universal scaling of Hall resistivity in the regions of the clean and the moderately clean limit, consistent with a theory based on the midgap states in the vortex core.

• Applied Chemistry for Engineering
• /
• v.35 no.2
• /
• pp.115-121
• /
• 2024

This study analyzed the influence of process variables affecting the thermodynamic equilibrium and fluid dynamics of interfaces such as reverse micelle, salt concentration, interfacial tension, and viscosity of fluids to optimize the microencapsulation process using the W1/O/W2 double emulsion method. The process variable with the greatest impact on encapsulation efficiency was found to be the difference in osmotic pressure between the W1 and W2 phases. It was observed that increasing the salt concentration in the W2 phase or decreasing the ascorbic acid concentration in the W1 phase resulted in higher encapsulation efficiency. Additionally, a larger difference in osmotic pressure led to increased damage to the surface of the microparticles, as confirmed by SEM images. The introduction of reverse micelles, which was anticipated to increase encapsulation efficiency, either had a low contribution or even decreased encapsulation efficiency. The yield of microcapsules was expressed as a universal function, applicable to all process conditions or solution compositions. According to this universal function, no further increase in yield was observed beyond the Ca (capillary number) of approximately 20.

• Clinical and Experimental Pediatrics
• /
• v.51 no.7
• /
• pp.696-703
• /
• 2008

Korea is now classified as an area of intermediate endemicity for hepatitis B virus (HBV), due to the implementation of universal HBV vaccination and national preventive programs for HBV infection. A national program of HBV vaccination was launched in Korea in 1988 for school-going children and was listed on a vaccination guideline in 1991. In 1995, universal vaccination for newborn infants was started for the prevention of perinatal HBV transmission. The prevalence of HBsAg among Korean middle school students has shown marked decreased from 3.2% in the late 1990s to 0.44% in 2007. HBsAg positivity in preschool children was 0.9% in 1995, decreased to 0.2% in 2007 by national prevention program of hepatitis B vertical transmission, launched in 2002. Vaccine failure rate of HBV immunoprophylaxis is 4.2% by this program. The infected children should be monitored per 6-12 months interval. Lamivudine and interferon are approved therapies for children with chronic hepatitis B in immune-clearance phase in Korea.

• The Journal of Korean Society for Radiation Therapy
• /
• v.27 no.2
• /
• pp.123-129
• /
• 2015

Purpose : The goal of this study was to verify and analyze the source position according to the curvature of the universal applicator and 4 different angle applicators when using RALS(Remote After Loading System). Materials and Methods : An interval of 1 cm and 15 second dwell times in each source position were applied for plan. To verify the accuracy of source position, we narrowed the distance between MultiSource container and GAFCHROMIC$^{(R)}$ EBT3 film by 5 cm, 10 cm, 20 cm so that the universal applicator transfer tube had some curvature. Also 4 applicators(Intrauterine tube: $0^{\circ}$, $15^{\circ}$, $30^{\circ}$, Ovoid tube: $65^{\circ}$) were used in the same condition. The differences between desired and actual source position were measured by using Image J. Results : In case of using 4 different angles of applicator with the straight universal applicator transfer tube, the average error was the lowest for $0^{\circ}$ applicator, greatest for $65^{\circ}$ applicator. However, All average errors were within ${\pm}2mm$ recommended in TG-56. When MultiSource container was moved 5 cm, 10 cm, 20 cm towards the EBT3 film, the average errors were beyond ${\pm}2mm$. The first dwell position was relatively located in accuracy, while the second and third dwells were displaced by an increasing magnitude with increasing curvature of the transfer tube. Furthermore, with increasing the angle of applicators, the error of all other dwell positioning was increased. Conclusion : The results of this study showed that both the curvature of universal applicator transfer tube and the angle of applicators affect the source dwell position. It is recommended that using straight universal applicator transfer tubes is followed in all cases, in order to avoid deviations in the delivered source dwell position. Also, It is advisable to verify the actual dwell position, using video camera quality control tool prior to all treatments.

• Restorative Dentistry and Endodontics
• /
• v.21 no.2
• /
• pp.530-545
• /
• 1996

The purpose of this study was to investigate by spectrophotometry the changes in color parameters of composite resins after exposure to distilled water, filtered coffee, and artificial saliva. Five kinds of fine particle composite resin in experiment 1, and six kinds of composite resin in experiment 2 were used. In experiment 1, each group of composite resin was stored in distilled water at $4^{\circ}C$, $50^{\circ}C$, and filtered coffee solution at $4^{\circ}C$, $50^{\circ}C$. And then each specimen was measured by spectrophotometer. Measurements were repeated in 1 hour, 2 hours, 4 hours, 8 hours, 16 hours, 24 hours, and 48 hours. In experiment 2, all specimens of each brand were stored in distilled water at $37^{\circ}C$, artificial saliva not contained mucin at $37^{\circ}C$, and artificial saliva contained mucin at $37^{\circ}C$. All specimens of each brand were measured by spectrophotormeter in 1 week, 2 weeks, 4 weeks, 8 weeks, and up to 12 weeks. The results were as follows : 1. In cold coffee, five of fine particle composite resins showed ${\Delta}E{^*}_{ab}$ values less than 2. However, in hot coffee ${\Delta}E{^*}_{ab}$ values of Amelogen Universal and Prisma TPH were higher than those of Conquest Crystal, ${\AE}$litefil and Z100. 2. Z100 and ${\AE}$litefil had better cleansibility of extrinsic coffee staining than Amelogen Universal, Conquest Crystal and Prisma TPH. 3. In distilled water and artificial saliva not contained mucin, five of fine particle composite resin showed ${\Delta}E{^*}_{ab}$ values less than 2 up to 12 weeks. However, Silux Plus showed higher than ${\Delta}E{^*}_{ab}$ values of fine particle composite resin. 4. As an immersion solution for discoloration experiment, artificial saliva not contained mucin showed similar appearance as distilled water. However, artificial saliva contained mucin had different appearance from the others. 5. In artificial saliva contained mucin, ${\AE}$litefil, Prisma TPH and Z100 showed ${\Delta}E{^*}_{ab}$ values less than 1 up to 12 weeks. However, Silux Plus, Amelogen Universal and Conquest Crystal showed ${\Delta}E{^*}_{ab}$ values more than 1 up to 12 weeks. But, Conquest Crystal showed different characteristics of chromacity difference value(less chromatic) and lightness difference value(lighter) from Silux Plus and Amelogen Universal.

• The Korean Journal of Rheology
• /
• v.11 no.2
• /
• pp.91-96
• /
• 1999

Semiconductive polyaniline and its derivatives such as poly(aniline-co-sodium diphenylamine sulfonate), poly (aniline-co-o-ethoxyaniline), poly (o-methylaniline), and poly (o-methoxyaniline) were synthesized, and then adopted as suspending particles of the electrorheological (ER) fluids. All suspensions of these polyaniline derivatives showed typical ER properties under high applied electric fields. However, flow behaviors are observed to be quite different depending on the polyaniline derivatives, especially in the stress plateau regions obtained at low shear rates. Using a scaling law, we also obtained universal cures of ER fluids from the flow curves at each applied electric field based on the relationship between the dynamic yield stress with the applied electric field and flow curve changes according to the electric fields.