• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.23 no.6
• /
• pp.1409-1418
• /
• 1998

The recent audio CODEC(Coding/Decoding) algorithms are complex of several coding techniques, and can be divided into DSP tasks, controller tasks and mixed tasks. The traditional DSP processor has been designed for fast processing of DSP tasks only, but not for controller and mixed tasks. This paper presents a new architecture that achieves high throughput on both controller and mixed tasks of such algorithms while maintaining high performance for DSP tasks. The proposed processor, YSP-3, operates four algorithms while maintaining high performance for DSP tasks. The proposed processor, YSP-3, operates functional units (Multiplier, two ALUs, Load/Store Unit) in parallel via 4-issue super-scalar instruction structure. The performance evaluation of YSP-3 has been done through the implementation of the several DSP algorithms and the part of the AC-3 decoding algorithms.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.21 no.6
• /
• pp.617-626
• /
• 2010

In this paper, we have proposed and experimentally performed a polarization and phase control method of an optical signal which has same wavelength with the optical carrier to improve phase characteristics of a continuous wave(CW) generated by the double sideband-suppressed carrier(DSB-SC) as one of the famous photomixing technique for making sub-millimeter and terahertz waves. A polarization and phase controlled optical signal has been coupled with the general DSB-SC on an optical coupler. The output of the optical coupler is then photomixed by a photomixer. From our analysis and measurement results, we have found that the amplitude of the generated sub-mm and terahertz CW signal is higher 1.5 dB and the phase noise is lower about 3 dB@10 kHz offset frequency than the general DSBSC. Consequently, since our proposed method has improved the amplitude and phase noise of CW signals in the sub-mm and terahertz bands, it can be helpful results to make low cost CW generator in sub-millimeter and subterahertz bands.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2008.08a
• /
• pp.67-72
• /
• 2008

본 논문에서는 하이브리드 차량 내부 전기모터의 등판 마력값과 회전 RPM, 흡기온도 센서의 온도 변화와 공기 및 연료의 혼합비율인 공연비에 대해 퍼지 제어 기법을 적용하여 차량의 연료 소비를 제어하는 방법을 제안한다. 제안된 기법에서는 초기 가속부분에서 등판 마력간과 회전 RPM을 퍼지제어 규칙에 의해 전기모터와 엔진의 사용비율을 제어하고, 엔진이 가동될 때 각각의 공기유입량과 연료 분사량을 이용하여 공연비 수치를 구한 후, 공연비, 흡기온도, 최종 연료 보정량에 대해 설정된 피지 소속 함수와 퍼지 추론 규칙에 따라 차량 연료를 제어한다. 시뮬레이션을 통하여 실험한 결과, 제안된 퍼지 제어 기법을 이용한 엔진 및 연료 제어 방법이 퍼지기법을 적용하지 않은 제어방법보다 평균연비가 개선되어 제안된 연료 제어 방법이 효율적임을 확인하였다.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.4 no.3
• /
• pp.285-293
• /
• 1999

In this paper, the novel digital frequency/phase controller, to control the invelter fed traveling wave type ultra-sonic m motor(USM) is proposed. This controller is used to control the drive frequency, phase difference and applied voltages of e each phase of the motor. Proposed digital controller has constructed with digital logic only, no more use digitallongleftarrowanalog h hybrid method of the conventional controller, in order to generate drive frequency and phase difference. Therefore, the c control system has become to velY simple structure. T\rvo types of controllers are designed, one is to control drive f frequency and phase difference, another has added voltage control function of each phase. Two full digital voltage/phase c controllers are implemented by using custom LSI and EPLD, the control pelformance and the simplicity ofthe proposed c controller is verified by expeJimental results.

• Journal of Bio-Environment Control
• /
• v.20 no.4
• /
• pp.247-252
• /
• 2011

Electrical conductivity, drainage, and irrigation amount of nutrient solution are important factors for determination of the mixing ratio of fresh and reused nutrient solutions in closed-loop soilless culture. Generally a fixed mixing ratio is applied in commercial scale greenhouses using solar radiation-based irrigation system. Although it ensures continuous supply of fresh nutrient solution in the mixing process, occasional discharge of the drainage is inevitably required. This study was conducted to compare the nutrient replenishing effect under different mixing processes and to investigate appropriate mixing process. For this experiment, a fixed mixing ratio (FR), modifiable mixing ratio (MR), and open-loop (OP) as control were applied. Mixing ratio was determined by a set value of EC for dilution of collected drainage in FR and the set values of 1.0 and $2.0dS{\cdot}m^{-1}$ were used as treatments (FR 1.0 and FR 2.0), respectively. In MR, mixing ratio was determined based on EC and volume of drainage within irrigation volume per event. The volume of drainage stored in the drainage tank tended to increase in FR 1.0. Although such trend was not observed in FR 2.0 and MR, the volume of drainage stored in MR was lower than that in FR 2.0. The ion balance of $Mg^{2+}:K^+:Ca^{2+}$ or $SO^{2-}_4:NO^-_3:PO^{3-}_4$ in the drainage and reused nutrient solution changed within a narrow range regardless of treatment.

• Journal of the Korean Society of Propulsion Engineers
• /
• v.15 no.5
• /
• pp.35-47
• /
• 2011

Dynamic characteristics of a flow control valve, which plays an important role in thrust and O/F control of liquid rocket engines, have been analyzed by the AMESim simulator modeling. The speed control method was proposed for the control of the flow valve equipped with a BLDC motor. The experimental results demonstrated the feasibility of systematical application as well as the performance of the speed control method. Moreover, the speed control method for BLDC motor is much simpler than the P control method in complex flow systems. With the speed control method, the control flow characteristics were evaluated according to plunger shapes. Consequently, same plunger shape proved to be more efficient in the mixture ratio control operated by two flow valves. It was also shown that the appropriate modification of plunger shapes could reduce the mixture ratio perturbation by 0.5%.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• v.9 no.2
• /
• pp.366-369
• /
• 2005

Background subtraction is mainly used for the real-time extraction and tracking of moving objects from image sequences. In the outdoor environment, there are many changeable factor such as gradually changing illumination, swaying trees and suddenly moving objects, which are to be considered for the adaptive processing. Normally, GMM(Gaussian Mixture Model) is used to subtract the background adaptively considering the various changes in the scenes, and the adaptive GMMs improving the real-time performance were worked. This paper, for on-line background subtraction, applied the improved adaptive GMM, which uses the small constant for learning rate ${\alpha}$ and is not able to speedily adapt the suddenly movement of objects, So, this paper proposed and evaluated the dynamic control method of ${\alpha}$ using the adaptive selection of the number of component distributions and the global variances of pixel values.

• Journal of the Korean Institute of Telematics and Electronics S
• /
• v.35S no.6
• /
• pp.55-65
• /
• 1998

In industrial fields, RTP(rapid thermal processing) system is widely used for improving the oxidation and the annealing in semiconductor manufacturing process. The main control factors are temperature control of wafer and uniformity in the wafer. In this paper, we propose an $H^{\infty}$ controller design of RTP system satisfying robust stability and performance using weighted mixed sensitivity miniimization and loop shaping technique. And we need reduction technique because of the difficulty of implementation with the obtained high order controller for original model and reduced models, namely, Hankel, square-root balanced, and Schur balanced methods. An example is proposed to show the validity of the proposed method.

• Proceedings of the Korean Institute of IIIuminating and Electrical Installation Engineers Conference
• /
• 2007.11a
• /
• pp.71-76
• /
• 2007

본 논문에서는 고 연색성의 실시간으로 색온도 제어 가능한 승강기용 조명제품 개발을 위하여 제품에 사용될 LED Package를 제작하고 고연색성 실현을 위한 색온도 제어 기초실험을 행하였다. 그리고 20W 급의 LED 광원모듈 구동회로와 색온도 제어를 위한 제어회로를 설계하였다. 또한 음영 제거 및 글레어 차단, 효과적인 광색혼합을 위하여 확산배광을 달성하기 위한 R, G, B, A, W LED의 최적 배치 및 렌즈의 광학설계를 수행하였고 LED에서 발생하는 열을 효과적으로 발산하여 LED 조명모듈의 온도를 낮추기 위한 방열설계를 실시하였다.

• 한국HCI학회:학술대회논문집
• /
• 2007.02a
• /
• pp.150-155
• /
• 2007

운전자지원시스템과 같은 자동화 시스템은 필연적으로 시스템에 대한 운영자의 신뢰와 적응을 초래하는 데, 이는 결국 동시에 긍정적인 효과와 부정적인 효과를 가져온다. 적응순항제어시스템은 대표적인 운전자지원시스템으로서 앞 차량과의 안전 거리와 속도를 자동적으로 제어하여 운전자의 편의성과 안전성을 향상시킨다. 본 연구에서는 적응순항제어시스템에 대한 운전자의 신뢰와 방심 효과를 조사하였다. 차량 시뮬레이터를 이용하여 왕복 2차선과 4차선이 혼합된 자동차 전용도로의 가상 주행 환경을 구축하고, 다양한 주행 상황하에서 운전자의 조종 능력과 대처 능력을 파악하였다. 연구 결과, 적응순항제어시스템에 대한 운전자의 신뢰와 적응은 운전자의 성향에 관계없이 일관된 차간 거리 시간, 가감속값 등을 설정하도록 유도하였고, 결과적으로 안전도와 편의성을 향상시킴을 확인할 수 있었다. 그러나 맹목적인 신뢰와 적응은 돌발 상황에 대한 대처 능력의 저하, 주의 산만, 방심 등을 초래하였고, 결과적으로 안전도를 저하시킴도 확인할 수 있었다. 운전자지원시스템의 이러한 부정적인 효과를 방지하고, 보다 견실하게 운전자의 편의성과 안전도를 향상시킬 수 있는 방안이 요구된다.