• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.6 no.4
• /
• pp.21-28
• /
• 1986

Conversion of anaerobic mesophilic digestion to thermophilic range has been investigated using a synthetic sludge. When temperature was raised at a rate of 2, 1, and $0.5^{\circ}C$ per day with continuous feeding, a lower reaction rate was observed with a high rate of temperature change. Although methane fermentation ceased completely for an digesters at thermophilic temperature, acid fermentation continued. Methane fermentation was never achieved even with neutralization during 6 months of resting. The methane formers were completely inactivated by the temperature shock and accumulation of volatile acids due to continuous feeding, while the acid formers lost biological activity quickly, but gradually acclimated to a high temperature. When temperature was raised without feeding, successful thermophilic digestion was achieved with 1 day of resting at thermophilic temperature at a rate of $1^{\circ}C$ per day, and also achieved with 20 days of resting at a direct increase. Conversion to a thermophilic range is easily achieved with resting. A short period of resting is required at a low rate of temperature increase, while a long period of resting enough to balance methane formers with acid fermers makes a conversion possile when temperature is raised at a high rate. Soured thermophilic digesters were recovered after seeding of mesophilic sludges, and sludge seeding could be a good method of start-up, conversion, or recovery of a thermophilic digester. Significant amount of thermophiles seemed to be present in the mesophilic digesters.

• Journal of Korean Society of Environmental Engineers
• /
• v.31 no.11
• /
• pp.997-1006
• /
• 2009

Organic removal efficiency and methane production rate, a feasibility of power generation from biogas, and the optimum conditions for membrane operation were evaluated for the pilot scale (5 tons/day) two-phase anaerobic digestion coupled with ultra filtration (TPADUF) system fed with garbage leachate. The TPADUF system is consisted of a thermophilic acidogenic reactor, a mesophilic methanogenic reactor, and an UF membrane. When garbage leachate with 150 g/L of TCOD was fed to the TPADUF up to organic loading rate (OLR) of 11.1 g COD/L/d, the effluent TCOD was lower than 6 g/L and the average removal efficiencies of TCOD and SCOD were higher than 95%. The methane composition of the gas was 65%, and the methane yield was 39 $m^3/m^3$ garbage leachatefed, 260 $m^3$/tons $COD_{added}$, or 270 $m^3$/tons $COD_{removed}$, even there was some gas leak. The power production per consumed gas was 0.96 kWh/$m^3$ gas or 1.49 kWh/$m^3$ methane. This lower power production efficiency mainly due to the small capacity of gas engine (15 kW class). The membrane was operated at the average flux of 10 L/$m^2$/hr. When the flux decreased, washing with water and chemical (NaOCl) was conducted to restore the flux. In the TPADUF system, optimum pH could be maintained without alkali addition by recycling the membrane concentrate or mixed liquor of the methanogenic digester to the acidogenic reactor. Also, partial production of methane in the acidogenic reactor had a positive effect on lowering the OLR of the methanogenic reactor.

• Journal of the Korea Organic Resources Recycling Association
• /
• v.10 no.3
• /
• pp.68-73
• /
• 2002

Acidogenic fermentation of primary sludge was investigated for the solution to reduce the sewage sludge and develope external carbon source for BNR process. In a viewpoint to use existing anaerobic digestion tanks, we didn't change environmental factors such as reactor configuration, temperature, pH and investigate the variation of solubilization rates, acidification rates and environmental factors which affected by the variation of HRT. The average solubilization rates were 0.0309 and $0.0204mgSCOD_{prod.}/mgICOD_{inf.}$ at a HRT of 3 and 1.5 days, respectively. The average acidification rates were 0.0068mg HAc/mg $TCOD_{inf.}$ and 0.0652mg HAc/mg $VSS_{destroyed}$ at a HRT of 3day. At a HRT of 1.5 days the average acidification rates were 0.0060mg HAc/mg $TCOD_{inf.}$ and 0.0346mg HAc/mg $VSS_{destroyed}$. For the period of experiments alkalinity and pH were properly maintained without artificial adjusting.

• Journal of the Korea Organic Resources Recycling Association
• /
• v.15 no.2
• /
• pp.89-97
• /
• 2007

In this study, thermalpretreatment was used to solubilize organic matter contained in sewage sludge before acid fermentation. By thermal pretreatment, solubilization of particulate CODcr, carbohydrate and protein increased. By thermal treatment at $120^{\circ}C$ for 30 minutes, CODcr solubilization efficiency of the primary sludge reached 8.3%. Meanwhile, for the secondary sludge, CODcr solubilization efficiency reached 16.5% because of high solubilization ratio of protein under the same pretreatment conditon. The results of anaerobic biodegradability test showed that both VFAs conversion ratio and hydrolysis rate of organic compounds in sewage sludge were improved by thermal pretreatment. Meanwhile, the optimum thermal pretreatment condition was varied with composition of organic compounds in sludge. In this study, the optimun thermal pretreatment condition of the primary sludge, containing high concentration of carbohydrate, was $80^{\circ}C$ for 30 minutes. Meanwhile, for the secondary sludge, mainly composed of protein, the sludge treated at $120^{\circ}C$ for 30 minutes showed the effective organic removal and VFAs production.

• Journal of the Korea Organic Resources Recycling Association
• /
• v.25 no.1
• /
• pp.15-21
• /
• 2017

In the present work, the synergistic effect of seaweed addition on organic acid production from sludge was investigated. The batch experiment was conducted at various mixing ratios of sewage sludge and seaweed (100:0, 75:25, 50:50, 25:75, 0:100 on a COD basis) under the substrate concentration of 20 g COD/L. The fermentation temperature was conducted under mesophilic condition ($35^{\circ}C$) and a heat-treated ($90^{\circ}C$ for 20 min) anaerobic digester sludge was used as a seeding source to suppress the methanogenic activity, The results showed that the amount of organic acid production increased as the content of seaweed increased: organic acids were 1.45, 3.22, 4.28, 5.24 and 4.82 g COD/L for the mixing ratio of 100:0, 75:25, 50:50, 25:75 and 0:100 respectively. The synergistic effect was calculated based on the organic acid production of individual sludge and seaweed, and was found to be 0.92, 1.14, 1.26 g COD/L at the mixing ratio of 75:25, 50:50 and 25:75, which indicates that 40% of synergy was obtained when 25% of seaweed was added. The synergistic effect could be ascribed to the high C/N ratio and biodegradability of seaweed.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.19 no.1
• /
• pp.25-33
• /
• 2018

Renewable energy has been of interests in the area of modern alternative fuels. Biogas is produced in waste landfill sites through anaerobic digestion processes, including hydrolysis, acidogenesis, organic acid fermentation (acetogenesis), and methane fermentation (methanogenesis). High contents of fine dust and moisture limited its utilization for direct combustion, town gas and vehicle fuel. Thus, this study proposed a new design for a cooling device using a centrifugal cyclone for simultaneous removal of fine dust and moisture as a pretreatment in the purification processes. A heat exchanger and an ID fan, which are installed inside and outside of the cyclone, in order to cool the humid gas below the freezing point and form a foggy mist. Such an atmosphere enhanced to capture fine dust as recirculating the cold mist flow. The water removal rate was 80.8% at a relative humidity of 95%, and the particle removal efficiency was 98.3% for $2.5{\mu}m$. Simultaneous removal efficiency was 70.8% and 99.6% for particle and moisture respectively.

• Journal of Korean Society of Environmental Engineers
• /
• v.38 no.9
• /
• pp.469-475
• /
• 2016

The study is the result of an practical operation analysis for the full scale fishery product wastewater treatment plant with immersed MBR (iMBR) process. Since fishery product industries show a wide range of wastewater generation by the season, design and operation of the equalization basin are very important factor. The aeration system for the equalization basin mixing can save the chemical consumption for followed system through the restriction of acid fermentation. The concentrations of wastewater primary DAF process treated were BOD 2,291 mg/L, $COD_{Mn}$ 530 mg/L, SS 256.8 mg/L, T-N 38 mg/L, T-P 13.5 mg/L respectively. It was considered that iMBR is the most efficient biological process for high salinity content wastewater since It is irrelevant to the capability of the sludge precipitation. SADp and SADm were 0.31, $26.5m^3/hr{\cdot}m^3$ respectively. In iMBR process, the critical F/M ratio was derived at 0.08~0.10 gBOD/gMLSS by analysing the correlations between MLSS, normalized TMP and temperature. The effluent concentrations were BOD 1.8 mg/L, $COD_{Mn}$ 12.4 mg/L, SS 1.0 mg/L, T-N 7.85 mg/L, T-P 0.1 mg/L and removal efficiencies were 99.9%, 97.6%, 96.3%, 95.7%, 97.8% respectively.

• Journal of Korean Society of Water and Wastewater
• /
• v.28 no.1
• /
• pp.13-23
• /
• 2014

A lab-scale Anaerobic Baffled Reactor (ABR) was applied to treat a primary sludge taken from a municipal wastewater treatment plant. In this experiment, acidogenic reaction was promoted by operating the ABR with short hydraulic retention time (HRT) to produce sufficient volatile fatty acids (VFA) instead of production of methane. The performance of ABR on the VFA production and total solids reduction was observed with different operating conditions with 2, 4, 6, and 8 days of HRT. Corresponding organic loading rates were 6.7, 3.4, 2.2, and $1.6kgCOD_{cr}/m^3{\cdot}day$. As HRT increased the removal rate of TCOD was also increased (82.5, 84.2, 96.9, and 95.9 % in average for HRT of 2, 4, 6, and 8 days, respectively) because the settlement of solids was enhanced in the baffle by the decrease of upflow velocity. At HRT of 2 days the average concentration of VFA in the effluent was measured at $1,306{\pm}552$ mgCOD/L corresponding to 107 % increment as compared to the VFA concentration in the influent. However, as HRT increased VFA concentraiotn was decreased to $143{\pm}552$ mgCOD/L at HRT of 8 days. The reduction rates of total solids were 12.2, 26.5, 24.8, and 43.0 % for HRT of 2, 4, 6, and 8 days. As HRT increased the hydrolysis of organic particulate matters in the reactor was enhanced due to the increasing of solids retention time in the baffle zone with low upflow velocity in long HRT condition. Consequently, we found that a primary sludge became a good source of VFA production by the application of ABR process with HRT less than 4 days and the 12-26 % of total solids reduction was expected at these conditions.

• Journal of the Korea Organic Resources Recycling Association
• /
• v.11 no.4
• /
• pp.105-113
• /
• 2003

Successful operation of a reactor can be accomplished when it is operated at proper D depending on the state of degradation. Operation at high D leads to the washout of biomass in the reactor while operation at low D leads to product inhibition due to the accumulation of excess VFA. These appear to limit the production of hydrogen to reach a higher level. Operation by D control was performed to improve the efficiency of hydrogen fermentation of food waste. Although simple organic matters were rapidly degraded in the early stage (day 1-2), proper VFA concentration and pH values were kept in the reactor at D of $4.5d^{-1}$, which was previously reported to be optimum initial D. High butyrate/acetate (B/A) ratios over 3.2 were obtained. Without D control, the reduction of simple organic matters after day 2 caused the decrease of VFA production and the increase of pH. Hydrogen production also decreased, as microbial proliferation was less than microbial loss by washout. However, the reactor performance was dramatically improved at D control from 4.5 to $2.3d^{-1}$. It showed the highest B/A ratios over 2.0 among the reactors on day 4-7. The second hydrogen peak appeared on day 4, resulting in the highest fermentation efficiency (70.8%) among the reactors. It was caused by the enhanced degradation of slowly degradable matters. The COD removed was converted to hydrogen (19.3%), VFA (36.5%), and ethanol (15.0%). Therefore, the strategy using D control, depending on the state of degradation, was effective in improving the efficiency of hydrogen fermentation.