• Geophysics and Geophysical Exploration
• /
• v.11 no.2
• /
• pp.127-136
• /
• 2008

To identify the potential area of gas hydrate in the Ulleung Basin, 2-D and 3-D seismic surveys using R/V Tamhae II were conducted in 2005 and 2006. Seismic survey equipment consisted of navigation system, recording system, streamer cable and air-gun source. For reliable velocity analysis in a deep sea area where water depths are mostly greater than 1,000 m and the target depth is up to about 500 msec interval below the seafloor, 3-km-long streamer and 1,035 $in^3$ tuned air-gun array were used. During the survey, a suite of quality control operations including source signature analysis, 2-D brute stack, RMS noise analysis and FK analysis were performed. The source signature was calculated to verify its conformity to quality specification and the gun dropout test was carried out to examine signature changes due to a single air gun's failure. From the online quality analysis, we could conclude that the overall data quality was very good even though some seismic data were affected by swell noise, parity error, spike noise and current rip noise. Especially, by checking the result of data quality enhancement using FK filtering and missing trace restoration technique for the 3-D seismic data inevitably contaminated with current rip noises, the acquired data were accepted and the field survey could be conducted continuously. Even in survey areas where the acquired data would be unsuitable for quality specification, the marine seismic survey efficiency could be improved by showing the possibility of noise suppression through onboard data processing.

• 한국지구물리탐사학회:학술대회논문집
• /
• 2008.10a
• /
• pp.107-112
• /
• 2008

In the case of the deep reservoirs like the gas reservoirs in the East-sea, it is often difficult to observe AVO responses in CMP gathers. Because the reservoir becomes more consolidated as its depth deepens, P-wave velocity does not decrease significantly when the pore fluid is replaced by the gas. In this study, we analyzed the effects of Poisson's ratio difference on AVO response with a variety of Poisson's ratios for the upper and lower layers. The results show that, as the difference in Poisson's ratio between the upper and lower layers decreases, the change in the reflection amplitude with incidence angle decreases. To consider the limitation of AVO responses shown in the gas reservoir in East-sea, the velocity model was made by simulation Gorae V structure with seismic data and well logs. The results of comparing AVO responses observed from the synthetic data with theoretical AVO responses calculated by using material properties show that the amount of the change in reflection amplitude with increasing incident angle is very small when the difference in Poisson's ratio between the upper and lower layers is small. In addition, the characteristics of AVO responses were concealed by noise or amplitude distortion arisen during preprocessing. To overcome such limitations of AVO analysis of the data from deep reservoirs, we need to acquire precisely reflection amplitudes in data acquisition stage and use processing tools which preserve reflection amplitude in data processing stage.

• Geophysics and Geophysical Exploration
• /
• v.10 no.1
• /
• pp.77-88
• /
• 2007

Following a successful bathymetric mapping demonstration in a previous study, the potential of airborne EM for seafloor characterisation has been investigated. The sediment thickness inferred from 1D inversion of helicopter-borne time-domain electromagnetic (TEM) data has been compared with estimates based on marine seismic studies. Generally, the two estimates of sediment thickness, and hence depth to resistive bedrock, were in reasonable agreement when the seawater was ${\sim}20\;m$ deep and the sediment was less than ${\sim}40\;m$ thick. Inversion of noisy synthetic data showed that recovered models closely resemble the true models, even when the starting model is dissimilar to the true model, in keeping with the uniqueness theorem for EM soundings. The standard deviations associated with shallow seawater depths inferred from noisy synthetic data are about ${\pm}5\;%$ of depth, comparable with the errors of approximately ${\pm}1\;m$ arising during inversion of real data. The corresponding uncertainty in depth-to-bedrock estimates, based on synthetic data inversion, is of order of ${\pm}10\;%$. The mean inverted depths of both seawater and sediment inferred from noisy synthetic data are accurate to ${\sim}1\;m$, illustrating the improvement in accuracy resulting from stacking. It is concluded that a carefully calibrated airborne TEM system has potential for surveying sediment thickness and bedrock topography, and for characterising seafloor resistivity in shallow coastal waters.

• 한국해양학회지
• /
• v.29 no.1
• /
• pp.42-49
• /
• 1994

A series of radiocarbon dating from intertidal, subtidal, and inner continental shelf deposits investigated along the west coast of Korea as well as from its offshore sea floor (namely, the eastern Yellow Sea Basin) how (1) the Holocene sea level rise, i.e., the ecstatic sea-level history during the oxygen isotope stage 1, and (2) pre-Holocene sea-level fluctuations during the oxygen isotope stages 2 and 3. Marine geophysical investigations in the Yellow Sea reported a possible development of desert and loses deposits due to dieselization under the cold and dry climate during the Last Glacial Maximum. The Kanweoldo deposit overlain unconformably by the Holocene intertidal deposits, which is mainly exposed along the tidal channels and intertidal flats in the Cheonsu Bay, the west coast of Korea, shows the characteristic cryogenic structure (cryoturbation). Such cryoturbation structure of the Kanweoldo deposit appears to indicate the cold and dry climate under the ecstatic sea-level paleoshoreline standing before and after of the pre-Holocene interstitial period (about 30000 y BP is suggested and its shoreline curve is constructed.

• Journal of the Korean Geophysical Society
• /
• v.2 no.1
• /
• pp.39-44
• /
• 1999

High-resolution images are drawn from existing seismic data which were originally obtained by Korea Ocean Research & Development Institute (KORDI) during 1994-1997 for deep seismic studies on the East Sea of Korea. These images are analyzed for mapping Quaternary faults and near-bottom gas pockets. First 12 channels are selected from shot gathers for reprocessing. The processing sequence adopted for high-resolution seismic images comprises data copy, trace editing, true amplitude recovery, common-midpoint sorting, initial muting, prestack deconvolution, bandpass filtering, stacking, highpass filtering, poststack deconvolution, f-x migration, and automatic gain control (AGC). Among these processing steps, predictive deconvolution, highpass filtering, and short window AGC are the most significant in enhancement of resolution. More than 200 Quaternanry faults are interpreted on the migrated sections in the shallow depths beneath the seafloor. Although numerous faults are found mostly at the western continental slope and boundaries of the Ulleung Basin, significant amount of the faults are also indicated within the basin. Many of these faults are believed to be formed with reactivation of basement, from geotectonic activities including volcanism, and often originated in Tertiary, indicating that the tectonic regime of the East Sea might be unstable. Existence of shallow gas pockets casts real hazardous warnings to deep-sea drillings and/or to underwater constructions such as inter-island cables and gas pipelines. On the other hand, discovery of these gas pockets heightens the interests in developing natural resources in the East Sea. Reprocessed seismic sections, however, show no typical seismic characteristics for gas hydrates such as bottom-simulating reflectors in the western continental slope and ocean floor.

• Geophysics and Geophysical Exploration
• /
• v.8 no.3
• /
• pp.201-206
• /
• 2005

Interpretation of high-resolution seismic profiles from the southeastern continental shelf of Korea reveals that the sedimentary deposits consist of seven seismic units formed during the late Quaternary. These units comprise lowstand, transgressive, and highstand systems tracts. The lowstand systems tract consists of a lowstand prograding wedge (SU1) and a mass flow deposit (SU2) including slumps and slides. The transgressive systems tract contains four seismic units: an ancient beach/shoreface deposit (SU3), a channel-fill deposit (SU4), a transgressive sand layer (SU5), and a transgressive sand ridge (SU6). The highstand systems tract consists of an inner-shelf mud deposit (SU7) derived from the Nakdong and Seomjin rivers during the last 6 ka when sea level was close to the present level.

• Geophysics and Geophysical Exploration
• /
• v.21 no.2
• /
• pp.103-111
• /
• 2018

The recent research aim of seismic trace interpolation is to effectively interpolate the data with spatial aliasing. Among various interpolation methods, the Matching Pursuit interpolation, that finds the proper combination of basis functions which can best recover traces, has been developed. However, this method cannot interpolate aliased data. Thus, the multi-component Matching Pursuit interpolation and moveout correction method have been proposed for interpolation of spatially aliased data. It is difficult to apply the multi-component Matching Pursuit interpolation to interpolating the OBC (Ocean Bottom Cable) data which is the multi-component data obtained at the ocean bottom because the isolation of P wave component is required in advance. Thus, in this study, we dealt with an effective single-component matching Pursuit interpolation method in OBC data where P-wave and S-wave are mixed and spatial aliasing is present. To do this, we proposed the Ricker wavelet based single-component Matching Pursuit interpolation workflow with moveoutcorrection and systematically investigated its effectiveness. In this workflow, the spatial aliasing problem is solved by applying constant value moveout correction to the data before the interpolation is performed. After finishing the interpolation, the inverse moveout correction is applied to the interpolated data using the same constant velocity. Through the application of our workflow to the synthetic OBC seismic data, we verified the effectiveness of the proposed workflow. In addition, we showed that the interpolation of field OBC data with severe spatial aliasing was successfully performed using our workflow.

• 한국지구물리탐사학회:학술대회논문집
• /
• 2008.10a
• /
• pp.85-92
• /
• 2008

National Oceanographic Research Institute is carrying out an oceanographic survey for the entire sea areas around Korean Peninsula annually starting with the East Sea from 1996 by establishing a national oceanographic basic map survey plan for the sea areas under the jurisdiction of Korea, so this paper used the oceanographic geomagnetism data measured at the southern area of the Yellow Sea using 'Hae Yang 2000' in 1999, aiming at clarifying the cause of geomagnetic abnormality zone during the course of treating and analyzing the geomagnetic data. For treatment of magnetic data, we obtained electromagnetic force values and geomagnetic abnormality values around the investigated sea area through a process of searching and removal of bad data, correction of sensor positions, correction of magnetic field effects around the hull, correction of diurnal variation, normal correction, correction of cross point errors, etc. The electromagnetic force distribution around the investigated sea area was $49000\;{\sim}\;51600\;nT$, which is judged to be within the normal electromagnetic force intensity distribution range around the Yellow Sea. The isodynamic lines are distributed in Northeast-Southwest direction, and electromagnetic force values are increasing toward the northwest. The result of comparing the magnetic abnormality around the sea area among $124^{\circ}$ 49' 48" E, $35^{\circ}$ 10' 48" N $\sim$ $125^{\circ}$ 7' 48" E, and $35^{\circ}$ 33' 00" N sections with the elastic wave cross section and the result of modeling coincide well with the underground geological structure clarified from the existing elastic wave survey cross section. Therefore, it is judged that the distribution of magnetic force abnormality generally shows the effect pursuant to the distribution of the sedimentary basins in the Tertiary period and the bedrocks in the Cretaceous period which are well developed in the bottom of the sea.

• Geophysics and Geophysical Exploration
• /
• v.11 no.1
• /
• pp.52-59
• /
• 2008

We have developed a new deep-towed marine DC resistivity survey system. It was designed to detect the top boundary of the methane hydrate zone, which is not imaged well by seismic reflection surveys. Our system, with a transmitter and a 160-m-long tail with eight source electrodes and a receiver dipole, is towed from a research vessel near the seafloor. Numerical calculations show that our marine DC resistivity survey system can effectively image the top surface of the methane hydrate layer. A survey was carried out off Joetsu, in the Japan Sea, where outcrops of methane hydrate are observed. We successfully obtained DC resistivity data along a profile ${\sim}3.5\;km$ long, and detected relatively high apparent resistivity values. Particularly in areas with methane hydrate exposure, anomalously high apparent resistivity was observed, and we interpret these high apparent resistivities to be due to the methane hydrate zone below the seafloor. Marine DC resistivity surveys will be a new tool to image sub-seafloor structures within methane hydrate zones.

• Journal of the Korean Society of Fisheries and Ocean Technology
• /
• v.41 no.1
• /
• pp.46-53
• /
• 2005

This paper describes the mean grain size and shear strength properties related to subsidence characteristics using sediment samples and acoustic images obtained from artificial reef areas in Tongyoung and Jangsungpo offshore. The acoustic images collected from chirp sonar and side scan sonar show well the attitude/orientation, the distribution pattern, and the degree of subsidence of artificial reefs, suggesting the possibility of suitable site investigation and the management of the reefs using acoustic sonar. The sediments were largely composed of clayey silt and silty clay. The mean grain sizes in Tongyoung and Jangsungpo offshore show the ranges of 5${\sim}$9${\Phi}$ and 8${\sim}$9${\Phi}$, respectively. The shear strength was significantly increased at the depths of 20cm in Tongyoung offshore and 80cm in Jangsungpo offshore, corresponding to the subsidence depth of artificial reefs. The relationship between mean grain size and shear strength did not show a correlation, suggesting the shear strength does not totally depend on mean grain size. Provided subsidence characteristics with respect to various artificial reefs and seabed condition are investigated in more details, the constructing area of the reef can be more extended.